基质结构对潜流人工湿地氮磷降解规律的影响

构建单层结构及多层结构水平潜流人工湿地小试实验系统,对城市污水处理厂尾水进行深度处理,研究基质结构对人工湿地床体中氮、磷沿程变化规律的影响。实验结果表明,单层基质结构人工湿地氮、磷的降解主要集中在深度为50~85 cm之间的床体表层,底层区域(0~50 cm)浓度变化不显著;多层结构人工湿地床体中氮、磷的降解由进水口到出水口呈较为规律的推流变化,与单层结构系统相比,污染物降解主要发生区域有所扩大,集中在深度为40~85 cm的床体表层,且床体底层0~40 cm氮磷降解同样存在,只是降解速率略有降低。按照填料渗透系数进行多层填充的设计方式能够显著提升潜流人工湿地对污染物的净化性能,单层结构人工湿地系统对氨氮和总磷的平均去除率分别为40.1%和52.9%,而多层结构的平均去除率则为60.4%和73.1%。     

Assessment of plant-driven uptake and translocation of clofibric acid by Scirpus validus

Pharmaceutical compounds are now considered as emerging contaminants of environmental concern. The overall objective of this study was to evaluate the uptake and translocation of clofibric acid (CA) by the macrophyte Scirpus validus growing hydroponically. A set of the three replicates was established for each exposure time and for each CA concentration. Plants were grown in 4 L vessels (four plants per vessel corresponding to the three exposure period studies, i.e., 7, 14, 18, and 21 days) which contained an aerated modified Hoagland nutrient solution that was spiked with CA at concentrations of 0.5, 1.0, and 2.0 mg?L^?1. At each exposure period, CA concentration was measured in the nutrient solutions. A sea sand disruption method was employed for the extraction of CA from plant tissues. The determination of the pharmaceutical concentration was carried out using solid phase extraction (SPE) followed by chromatographic analysis. The quantification of CA concentrations in both nutrient solutions (after SPE) and plant tissues (after extraction) was conducted by chromatographic analysis. CA concentrations of 5.4–26.8 μg?g^?1 (fresh weight) were detected in the roots and 7.2–34.6 μg?g^?1 (fresh weight) in the shoots after 21 days. Mass balance calculations showed that S. validus uptake alone accounted for a significant contribution (6–13 % for the roots and 22–49 % for the shoots) of the total loss of CA. The bioaccumulation factors (BAFs) based on fresh weight for the roots ranged from 6.6 to 23.2, while values for the shoots ranged from 9.5 to 32.1. All the BAFs for the shoots were greater than those in the roots, implying that CA has greater tendency to be translocated to the shoots, rather than the roots of S. validus. All the shoot-to-root concentration ratios were more than 1, denoting that the shoots of S. validus do preferentially accumulate CA. We demonstrated that CA can be actively taken up, subsequently translocated and accumulated by aboveground tissues of S. validus. Since S. validus could account for the removal of 28–62 % of the total mass loss of CA from the system, such phytoremediation technology has great potential for the removal of pharmaceuticals such as CA from inflowing waters.     

Integrating urban ecosystem sustainability assessment into policy-making: insights from the Gold Coast City

This paper introduces a policy-making support tool called ‘Micro-level Urban-ecosystem Sustainability IndeX (MUSIX)’. The index serves as a sustainability assessment model that monitors six aspects of urban ecosystems – hydrology, ecology, pollution, location, design, and efficiency – based on parcel-scale indicators. This index is applied in a case study investigation in the Gold Coast City, Queensland, Australia. The outcomes reveal that there are major environmental problems caused by increased impervious surfaces from growing urban development in the study area. The findings suggest that increased impervious surfaces are linked to increased surface runoff, car dependency, transport-related pollution, poor public transport accessibility, and unsustainable built environment. This paper presents how the MUSIX outputs can be used to guide policy-making through the evaluation of existing policies.     

4A沸石分子筛处理中低浓度氨氮废水

利用天然沸石、采用水热合成法制备4A沸石分子筛,用XRD和SEM进行了表征。通过考察吸附剂用量、pH、共存金属阳离子、吸附时间、氨氮废水初始浓度、温度对吸附性能的影响,结合动力学方程、吸附等温线、热力学函数等研究了吸附性能和机理。结果表明,当4 g/L的4A沸石分子筛在废水pH值为4~8的条件下对中低浓度氨氮吸附120min后,去除率可达88%;废水中共存单一金属阳离子(Pb2+、Cu2+、Ca2+和Mg2+)浓度大于100 mg/L时,对中低浓度的NH+4有强烈的竞争吸附;氨氮的吸附过程较好地符合准二级动力学方程、Freundlich模型,是一种混乱度增加、自发的放热过程。     

柴油机Urea-SCR系统喷射雾化的数值模拟

为研究柴油机Urea-SCR系统喷射雾化规律,应用CFD软件建立喷射雾化模型,对喷嘴喷射距离、喷射位置与方向、喷孔数目与孔径对催化剂载体入口处的浓度分布情况的影响进行了数值模拟。结果表明,喷嘴距反应器距离为排气管直径5倍为宜;采用四喷孔、孔径为0.5 mm、喷嘴处于管道中心,喷射方向为径向时喷射雾化均匀性最好。通过台架实验,验证了采用喷距5D、径向、四孔、小孔径喷嘴方案可使NOx的转化率达到95%以上。     

非金属矿物对柠檬酸残液中酸类吸附工艺

分析了柠檬酸残液的营养成分,并探索了膨润土、凹凸棒石黏土、沸石等非金属矿物对柠檬酸残液中酸类的吸附工艺,以期筛选出对柠檬酸残液中酸类吸附效果优良的吸附剂并优化其吸附工艺参数条件。结果表明,凹土与热处理凹土在几种非金属矿物材料吸附剂中的总酸去除率最佳,选择凹土来进一步研究。理想的吸附条件为:凹土添加量5%,振荡时间70 min,振荡速度180 r/min,温度30℃,总酸去除率约为89.48%,为柠檬酸残液处理和饲料资源开发提供理论依据。     

氨基功能化碳材料的水热制备及其对活性艳红K-2BP的吸附性能

以葡萄糖为前驱物,以氨水或谷氨酸为添加物,通过一步水热法制备出氨基功能化碳材料,并研究了这些碳材料对活性艳红K-2BP的吸附性能。结果表明,在葡萄糖水热过程中加入不同添加物可以得到不同形貌的碳材料(从微球到不规则形状)。当以只有葡萄糖为前驱物制备的碳微球作为K-2BP的吸附剂时,其对K-2BP的最大吸附量为6.28 mg/g。当在水热体系中加入氨水和谷氨酸作为共聚物后,两者会产生协同作用,使得到的碳材料对K-2BP的吸附性能大大提高,最大吸附量达到37.0 mg/g。单纯的葡萄糖水热体系得到的碳微球对K-2BP的吸附符合Langmuir吸附等温线,而氨基功能化的碳材料对K-2BP的吸附符合Freundlich吸附等温式,吸附过程符合准一级动力学模型。低的溶液pH有利于K-2BP的吸附。     

Application and appreciation of chemical sand fixing agent-poly (aspartic acid) and its composites

The sand fixing agent-poly (aspartic acid) (PASP) and its composites were applied in the field by two forms (spraying around by PASP solution and PASP powder directly). It was found that the sand fixing effect in powder form was not as good as in solution form, but it was more practical in dry region. It needed 9, 6 and 7 days for PASP, xanthan gum-PASP (X2) and ethyl cellulose-PASP (E3) to attain the maximal mechanical strength after they were applied, respectively. The sand fixing effect decreased when the material was subjected to repeated hydration-dehydration cycles and the material had no negative influence on plant growth. The PASP and its composites had water-retaining ability and could reduce the water evaporation.     

基于谓词逻辑的应急指挥系统的设计研究

世界各国在“9．11”事件以后都开始了应急指挥系统的设计和建设,我国也建立了不少的应急指挥系统,但是从近几年紧急事件的处理情况来看,这些系统有一共同的缺陷：对应急指挥系统的设计理论没有深入的分析,系统的设计没有明确的方向,也缺乏对应急流程的分析思考,忽视计算机的智能处理能力,造成应急指挥系统的使用低效。针对这两个问题,先阐述了应急指挥系统设计通用的理论原则,之后着重分析了应急流程的数字化问题,提出了一种以谓词逻辑为核心构建应急指挥系统的设计方法,解决了智能分析辅助指挥的关键问题。     

Application of magnetoelastic sensors for quantifying sediment deposition rates and sizes

This paper describes the application of magnetoelastic sensors for quantifying the size and deposition rate of sediment samples in costal areas, lakes, and rivers. The magnetoelastic sensor, which is made of inexpensive amorphous ferromagnetic alloy, measures parameters of interest by tracking the changes in its resonant frequency and/or amplitude. Since an increase in mass loading on the sensor surface changes its resonant frequency and amplitude, the deposition rate of sediment particles can be determined in real time by tracking these two quantities. Based on a theoretical model, the size distribution of the sediment particles was also estimated from the deposition rate.