Simulation of dam/levee-break hydrodynamics with a three-dimensional implicit unstructured-mesh finite element model

Dam failures usually cause huge economic and life losses , especially in urban areas where there is a high concentration of inhabitants and economic actors. In order to understand the physical mechanisms of the formation and development of dam-break flooding, lots of efforts have been put into different types of modelling techniques. However, most of existing models are 1D (one-dimensional) or 2D models based on the shallow water equations. In this paper, we present a 3D numerical modelling investigation of dam-break flow hydrodynamics in an open L-shape channel. A newly developed 3D unstructured mesh finite element model is used here. An absorption-like term is introduced to the Navier–Stokes equations in order to control the conditioning of the matrix equation in the numerical solution process and thus improve the stability. A wetting and drying algorithm is used here to allow the free surface height to be treated with a high level of implicitness and stability. The 3D model has been validated by comparing the results with the published experimental data. Good agreement has been achieved at six selected locations. This study shows that the 3D unstructured mesh model is capable of capturing the 3D hydraulic aspects and complicated local flows around structures in simulation of dam-break flows.     

夹具连接方式对冲击响应谱模拟能力影响效应分析

文章介绍了夹具结构特性与冲击响应谱模拟试验能力之间的关系,通过典型夹具的有限元分析和试验验证的方式说明夹具连接方式对冲击响应谱模拟能力影响效应。结果表明,利用振动夹具进行冲击试验时,可以通过减少连接螺钉数量,提供冲击响应谱模拟能力。该方法可以为作为试验人员进行冲击响应谱试验的操作指导。     

A full-scale sequencing batch reactor system for swine wastewater treatment

A full-scale sequencing batch reactor (SBR) system was evaluated for its ability to remove carbon and nitrogen from swine wastewater. The SBR was operated on four, six-hour cycles each day, with each cycle consisting of 4.5 hours of “React,” 0.75 hours of “Settling”, 0.75 hours for “Draw” and “Fill.” Within each cycle, an amount of wastewater equivalent to about 5% of the reactor volume (5,500 litres) was removed and added. The SBR system was able to remove 82% of biochemical oxygen demand (BOD) and more than 75% of nitrogen. Even though the SBR effluent, with an average effluent BOD₅ of about 588 mg L^{? 1}, did not meet the discharge criteria, it enabled a reduction of the land base required for land application of swine wastewater by about 75%. Results indicated that the SBR system was a viable method for the treatment of swine wastewater.     

Treating solid dairy manure using microwave-enhanced advanced oxidation process

The microwave enhanced advanced oxidation process (MW/H₂O₂-AOP) was used to treat separated solid dairy manure for nutrient release and solids reduction. The MW/H₂O₂-AOP was conducted at a microwave temperature of 120°C for 10 minutes, and at three pH conditions of 3.5, 7.3 and 12. The hydrogen peroxide dosage at approximately 2 mL per 1% TS for a 30 mL sample was used in this study, reflecting a range of 0.53–0.75 g H₂O₂/g dry sludge. The results indicated that substantial quantities of nutrients could be released into the solution at pH of 3.5. However, at neutral and basic conditions only volatile fatty acids and soluble chemical oxygen demand could be released. The analyses on orthophosphate, soluble chemical oxygen demands and volatile fatty acids were re-examined for dairy manure. It was found that the orthophosphate concentration for untreated samples at a higher % total solids (TS) was suppressed and lesser than actual. To overcome this difficulty, the initial orthophosphate concentration had to be measured at 0.5% TS.     

Microwave enhanced advanced oxidation process for treating dairy manure at low pH

This study investigated the treatment of dairy manure using the microwave enhanced advanced oxidation process (MW-AOP) at pH 2. An experimental design was developed based on a statistical program using response surface methodology to explore the effects of temperature, hydrogen peroxide dosage and heating time on sugar production, nutrient release and solids destruction. Temperature, hydrogen peroxide dosage and acid concentration were key factors affecting reducing sugar production. The highest reducing sugar yield of 7.4% was obtained at 160°C, 0 mL, 15 min heating time, and no H₂O₂ addition. Temperature was a dominant factor for an increase of soluble chemical oxygen demand (SCOD) in the treated dairy manure. The important factors for volatile fatty acids (VFA) production were microwave temperature and hydrogen peroxide dosage. Temperature was the most important parameter, and heating time, to a lesser extent affecting orthophosphate release. Heating time, hydrogen peroxide dosage and temperature were significant factors for ammonia release. There was a maximum of 96% and 196% increase in orthophosphate and ammonia concentration, respectively at 160°C, 0.5 mL H₂O₂ and 15 min heating time. The MW-AOP is an effective method in dairy manure treatment for sugar production, nutrient solubilisation, and solids disintegration.     

微氧环境下无色硫细菌和硫酸盐还原菌脱硫

通过间歇曝气形成微氧环境让SRB和CSB实现共生,使含硫酸盐有机废水中硫酸根最终转化成单质硫达到脱硫目的.研究考察了曝气量对SRB还原和CSB氧化的影响,确定了合适的曝气强度和水力停留时间,使得单质硫占系统内总硫比值最大.实验结果显示,在进水COD/SO42-=2000/1500 mg/L、曝气开关时间为2 s/2 min、生化时间为10 h时,单质硫产率最大,为89.53％,SO42-浓度降至最低值72.7 mg/L,还原率达95.1％,此时脱硫效果较好.     

羧酸盐型双子表面活性剂的合成及性能研究

以月桂酰氯、乙二胺与丁二酸酐为原料合成了一种羧酸盐型双子(gemini)表面活性剂。采用IR、1 HNMR对中间产物和目标产物进行结构表征,并考察了合成所得羧酸盐型gemini表面活性剂的表面活性。结果表明:合成产物即为目标产物。合成产物的临界胶束浓度为0.027mmol/L,比普通单链表面活性剂低2～3个数量级,表面张力最低可降至29.5mN/m。     

油井远程监控与综合评价系统开发

为解决油田管理中面临的用工总量多、生产建设成本高和管理难度大的问题,胜利油田进行了大规模数字化建设。通过电参数、示功图、产液量自动采集传输,对油井进行综合评价分析,提出节电意见,确保油井安全正常运转,有效地减少了油田生产用工需求,进一步促进了油田管理的现代化。     

Microwave enhanced advanced oxidation process for treating dairy manure at low pH

This study investigated the treatment of dairy manure using the microwave enhanced advanced oxidation process (MW-AOP) at pH 2. An experimental design was developed based on a statistical program using response surface methodology to explore the effects of temperature, hydrogen peroxide dosage and heating time on sugar production, nutrient release and solids destruction. Temperature, hydrogen peroxide dosage and acid concentration were key factors affecting reducing sugar production. The highest reducing sugar yield of 7.4% was obtained at 160°C, 0 mL, 15 min heating time, and no H(2)O(2) addition. Temperature was a dominant factor for an increase of soluble chemical oxygen demand (SCOD) in the treated dairy manure. The important factors for volatile fatty acids (VFA) production were microwave temperature and hydrogen peroxide dosage. Temperature was the most important parameter, and heating time, to a lesser extent affecting orthophosphate release. Heating time, hydrogen peroxide dosage and temperature were significant factors for ammonia release. There was a maximum of 96% and 196% increase in orthophosphate and ammonia concentration, respectively at 160°C, 0.5 mL H(2)O(2) and 15 min heating time. The MW-AOP is an effective method in dairy manure treatment for sugar production, nutrient solubilisation, and solids disintegration.     

Cosorption of organic chemicals with different properties: their shared and different sorption sites

Complementary sorption of different chemicals was expected and investigating the relationship between the sorption inhibition of primary sorbate (ΔQ(pri)) and sorption of secondary sorbate (Q(sec)) could provide a new angle to understand coadsorption of different chemicals. This study used bisphenol A (BPA) as the primary adsorbate, sulfamethoxazole (SMX) as the competitor, and carbon nanotubes as model adsorbents to study their complementary and competitive adsorption. At low BPA concentrations, the sorption of SMX (Q(sec)) exceeded BPA sorption inhibition (ΔQ(pri)), indicating that these two chemicals complementarily adsorbed on their respectively preferred sorption sites. At high BPA concentrations, higher ΔQ(pri) was observed in comparison to Q(sec), which may be resulted from different packing efficiencies of the adsorbed SMX and BPA. This study emphasized that both competitive and complementary sorption should be discussed in binary sorption system.