无污泥持留序批式预处理反应器渗滤液预处理的正交试验研究

以黑石子垃圾填埋场渗滤液强化预处理-生物接触氧化为依托,针对其处理效果的局限性,研究无污泥持留序批式预处理(WSIP)反应器正交试验,旨在优化运行参数,提高低温期间渗滤液处理效果.实验表明,COD、NH 4-N、TN去除率较高,出水可生化性较好;优化碳氮质量比,为后续好氧微生物降解创造条件;曝气时间、HRT、进水磷浓度、序批周期对NH 4-N、TN去除效果影响显著;低温期间,获得较好出水水质的最佳运行参数为曝气时间9h、HRT4d、进水磷质量浓度50mg/L、序批周期6h.     

异养硝化-好氧反硝化菌粪产碱杆菌的脱氮特性

为了对粪产碱杆菌(Alcaligenes faecalis No.4)的脱氮特性进行研究,提出了不同环境因子对菌株脱氮性能影响的对比实验。结果表明,该菌能利用柠檬酸钠和乙酸钠作为惟一碳源,以柠檬酸钠为碳源时脱氮活性最高,硝酸铵、氯化铵、碳酸铵和硫酸铵4种铵盐均能作为惟一氮源,而硝态氮和亚硝态氮几乎不能被该菌代谢转化;当温度在30~37℃、摇床转速超过120 r/min、p H为6~8之间时,该菌对氨氮的去除效果最好;该菌对高中低浓度的氨氮都具有很好的去除效果,对高浓度的氨氮有很好的耐受性;该菌对0%、3%盐度的适应期较短,对6%的盐度经过较长时间的适应期后,也能够快速地处理氨氮,具有良好的耐盐性。     

The sedimentation capabilities of hexadecyltrimethylammonium-modified montmorillonites

Natural montmorillonite was modified with a quaternary ammonium compound, hexadecyltrimethylammonium (HDTMA). The sedimentation capabilities of unmodified and modified montmorillonites were then investigated. The sedimentation velocity of modified montmorillonites increased if the amounts of adsorbed HDTMA were from 0.3 to 1.0 times the cation exchange capacitity (CEC). It also emerged that the sedimentation capability of modified montmorillonites was improved and that the variously CEC-modified montmorillonites had similar sedimentation capabilities after they had sorbed organic matter from oily wastewater. Thus, modified montmorillonites (especially 0.5 CEC treatment) had good sedimentation capabilities for sorbing organic substance and can act as carriers in wastewater biotreatment.     

多孔硅酸钙滤料吸附床除磷试验研究

以多孔硅酸钙滤料为吸附载体处理含磷的二沉池出水.通过静态吸附试验和动态吸附试验,研究了滤料粒径及投加量、初始pH、反应时间、温度以及滤料填充高度对除磷效果的影响.在静态吸附试验中,取初始磷质量浓度为4.98 mg/L的含磷废水100 mL,当多孔硅酸钙滤料粒径为4～14目,投加量为1.0g,吸附时间为2.5h,温度为25℃,溶液初始pH为7.0～9.0时,磷的去除率可达95％以上,出水磷满足《城镇污水处理厂污染物排放标准》(GB 18918-2002)的一级A标准(≤0.5 mg/L).动态吸附试验表明,在长期运行条件下,多孔硅酸钙滤料吸附床能持续有效地去除污水中的磷,综合考虑吸附率和运行费用,选择水力停留时间为30 min,滤料填充高度为60 cm为宜.     

ASBBR处理超高盐榨菜腌制废水

研究以超高盐榨菜腌制废水为对象,考察填料种类、负荷和温度对ASBBR启动及处理效能的影响。研究结果表明,在温度为30℃,盐度为7%（NaCl计）,负荷为1 kg COD/（m³·d）的条件下,采用聚氨酯泡沫填料的反应器经67 d可成功构建超高盐榨菜腌制废水厌氧生物处理系统,较未设置填料、投加半软性组合填料、球形组合填料和聚苯乙烯泡沫填料的反应器分别缩短了26、6、24和18 d,且运行至第79天,可使出水COD降至375 mg/L,COD去除率为92.86%;通过对负荷的阶段逐步提高,可提升反应器有机负荷至15 kg COD/（m³·d）,使进水COD为（27 000±2 000）mg/L的超高盐废水,出水COD均值降至2 200 mg/L ,平均去除率达到92.03%;温度对反应器处理效能影响显著,温度分别为30、25、20、15和10℃时,反应器COD去除率分别为92.63%、84.07%、67.13%、54.61%和44.19%。     

Positive matrix factorization as source apportionment of soil lead and cadmium around a battery plant (Changxing County,China)

Chemical compositions of soil samples are multivariate in nature and provide datasets suitable for the application of multivariate factor analytical techniques. One of the analytical techniques, the positive matrix factorization (PMF), uses a weighted least square by fitting the data matrix to determine the weights of the sources based on the error estimates of each data point. In this research, PMF was employed to apportion the sources of heavy metals in 104 soil samples taken within a 1-km radius of a lead battery plant contaminated site in Changxing County, Zhejiang Province, China. The site is heavily contaminated with high concentrations of lead (Pb) and cadmium (Cd). PMF successfully partitioned the variances into sources related to soil background, agronomic practices, and the lead battery plants combined with a geostatistical approach. It was estimated that the lead battery plants and the agronomic practices contributed 55.37 and 29.28 %, respectively, for soil Pb of the total source. Soil Cd mainly came from the lead battery plants (65.92 %), followed by the agronomic practices (21.65 %), and soil parent materials (12.43 %). This research indicates that PMF combined with geostatistics is a useful tool for source identification and apportionment.     

微生物絮凝剂有效真菌的筛选

通过真菌培养基（马铃薯培养基），对旱田土壤和活性污泥中的微生物进行筛选分离，得到3株絮凝率超过67％的菌株，其中絮凝率超过75％的高絮凝活性菌株1株——MZ52。将MZ52在产絮凝剂的培养基中进行发酵培养后，对1000mg／L高岭土悬浮液絮凝，得出MZ52菌产絮凝剂最佳培养条件，分别为摇床转速160r／min，培养时间90h，初始pH值为8．0，培养温度为40℃。     

Sorption of tylosin on clay minerals

The equilibrium sorption of tylosin (TYL) on kaolinite and montmorillonite was measured at different solution pH using batch reactor systems. The results showed that all the sorption isotherms were nonlinear and that the nonlinearity decreased as the solution pH increased for a given clay. At a specific aqueous concentration, the single-point sorption distribution coefficient (K_D) of TYL decreased rapidly as the solution pH increased. A speciation-dependent sorption model that accounted for the contributions of the cationic and neutral forms of TYL fit the data well, suggesting that the sorption may be dominated by both ion exchange and hydrophobic interactions. The isotherm data also fit well to a dual mode model that quantifies the contributions of a site-limiting Langmuir component (ion exchange) and a non-specific linear partitioning component (hydrophobic interactions). X-ray diffraction analyses revealed that the interlayers of montmorillonite were expanded due to the uptake of TYL. TYL molecules likely form a monolayer surface coverage.     

对苯二酚对海洋底栖双壳类毛蚶和紫贻贝毒性效应研究

通过对中国近岸常见底栖双壳类毛蚶（Scapharca subcrenata）、紫贻贝（Mytilus edulis）急性和慢性毒性试验,运用Log-logistic模型及Weibull毒性效应阈值模型计算对苯二酚对2种受试生物的半致死效应浓度（LC₅₀）、非检测效应浓度（NDEC)及无观测效应浓度（NOEC）;分析慢性毒性试验对受试生物体质量、体长及消化腺超氧化物歧化酶（SOD）活性的影响。结果显示,对苯二酚对毛蚶、紫贻贝的LC₅₀分别为34.10和66.50 mg/L,NDEC分别为0.36和0.50 mg/L,NOEC分别为0.40和0.60 mg/L。慢性试验周期内受试生物体质量、体长的组内与组间差异不显著（P>0.1）;SOD酶活性仅在个别时间段对照组和处理组间存在显著差异（P<0.05）。     

不同温湿度条件下微米硼的氧化过程研究

目的 探究不同温湿度条件下微米硼的氧化层结构特征。方法 利用高温水浴浸泡处理去除原料微米硼的表面氧化层,然后在恒温恒湿条件下对微米硼进行加速氧化,利用扫描电子显微镜、透射电子显微镜和X射线光电子能谱对加速氧化后硼颗粒的氧化层厚度及组成进行分析,总结表面氧化层结构及成分组成变化规律,揭示温湿度条件下微米硼的氧化机制。结果 微米硼经高温水浴浸泡处理后,表面氧化层去除率达到50%。随着加速氧化时间的延长,硼颗粒氧化层的厚度逐渐增大,由内向外硼颗粒表面可以用B-BxOy-B2O3三层结构来表示,BxOy总是伴随着B2O3同时出现的,且随着氧化反应的进行,颗粒表面BxOy的含量将超过B的含量。结论 不同温湿度条件下微米硼的氧化机制为O2向B颗粒内部单向扩散的反应机制,B先与O2反应,形成低氧化物BxOy,BxOy进而与O2反应生成B2O3。随着氧化层厚度的增加,O2向B颗粒内部扩散的阻力增大,氧化反应速率随之降低。相比湿度的影响,温度的升高可显著加快硼表面氧化层的形成;温度一定时,湿度的增加可促进硼氧化层的形成。