Law of variation for low density polyethylene dust explosion with different inert gases

To reveal the effects of different inert gases on explosion characteristics during low density polyethylene (LDPE) dust explosion and optimize the explosion-proof process, eight N₂ (CO₂)/air mixed inerting conditions were experimentally studied. Typical inerting conditions with 12 L cylindrical explosive tank were used to study the characteristics on the flame propagation. The thermogravimetric analysis with related theories were used to further explain the mechanism and quantities in low density polyethylene (LDPE) dust explosion with different inert gases. The results showed that the reduction of O₂ concentration could effectively delay the progress of flame growth process and weaken the effect of dust combustion reaction. The flame growth process of condition (N₂/air (18% O₂)) was 2.05 times slower than that of the non-inert condition. The explosion strength was obviously reduced, and the characteristic parameters such as explosion pressure and flame propagation speed were also affected by the decrease of O₂ concentration. For LDPE powder, the smaller the median diameter, the greater the explosion intensity and the lower the limiting oxygen content (LOC). The LOC with CO₂ was usually higher than that with N₂ and the effect of CO₂ was significantly better than N₂ in inerting.     

火灾科学的研究与展望

火灾科学应社会需求而产生,目前已经形成了自己的研究框架及体系。我国火灾科学基础研究已初具结构和规模,而且确定了相应的社会定位。展望了火灾科学研究的发展前景 。     

Preparation and characterization of visible-light-active nitrogen-doped TiO2 photocatalyst

A visible-light photocatalyst was prepared by calcination of the hydrolysis product of Ti(SO4)2 with ammonia as precipitator. The color of this photocatalyst was vivid yellow. It could absorb light under 550 nm wavelength. The crystal structure of anatase was characterized by XRD. The structure analysis result of X-ray fluorescence(XRF) shows that doped-nitrogen was presented in the sample. The photocatalytic activities were evaluated using methyl orange and phenol as model pollutants. The photocatalytic activities of samples were increasing gradually with calcination temperature from 400℃ to 700℃ under UV irradiation. It can be seen that the degradation of methyl orange follows zero-order kinetics. However, the calcination temperatures have no significant influence on the degradation of phenol under sunlight. The N-doped catalyst shows higher activity than the bare one under solar irradiation.     

Methane fluxes from tundra soils and snowpack in the maritime Antarctic

Methane fluxes were measured from three exposed tundra sites and four snowpack sites on the Fildes Peninsula in the maritime Antarctic in the summertime of 2002. The average fluxes at two normal tundra sites were −15.3 μg m⁻² h⁻¹ and −14.3 μg m⁻² h⁻¹, respectively. The fluxes from tundra site with fresh penguin dropping addition showed positive values with the average of 36.1 μg m⁻² h⁻¹, suggesting that the deposition of fresh droppings greatly enhanced CH₄ emissions from the poor Antarctic tundra during penguin breeding periods. The summertime variation in CH₄ flux was correlated with surface ground temperature and the precipitation. The correlation between the flux and PT₀, which is the product of the precipitation and surface ground temperature, was quite strong. The diurnal cycle of CH₄ flux from the tundra soils was not obtained due to local fluky weather conditions. The fluxes through four snowpack sites were also obtained by the vertical CH₄ concentration gradient and their average fluxes were −46.5 μg m⁻² h⁻¹, −28.2 μg m⁻² h⁻¹, −46.4 μg m⁻² h⁻¹ and −17.9 μg m⁻² h⁻¹, respectively, indicating that tundra soils under snowpack also consume atmospheric CH₄ in the maritime Antarctic; therefore these fluxes could constitute an important part of the annual CH₄ budget for Antarctic tundra ecosystem.     

Nitrous oxide emissions from tundra soil and snowpack in the maritime Antarctic

The nitrous oxide emissions were measured at three tundra sites and one snowpack on the Fildes Peninsula in the maritime Antarctic in the summertime of 2002. The average fluxes at two normal tundra sites were 1.1 ± 2.2 and 0.6 ± 1.7 μg N₂O m⁻² h⁻¹, respectively. The average flux from tundra soil site with penguin dropping addition was 3.7 ± 2.0 μg N₂O m⁻² h⁻¹, 3–6 times those from the normal tundra soils, suggesting that the deposition of fresh droppings enhanced N₂O emissions during penguin breeding period. The summer precipitation had an important effect on N₂O emissions; the flux decreased when heavy precipitation occurred. The diurnal cycle of the N₂O fluxes from Antarctic tundra soils was not obtained due to local fluky weather conditions. The N₂O fluxes through four snowpack sites were obtained by the vertical N₂O concentration gradient and their average fluxes were 0.94, 1.36, 0.81 and 0.85 μg N₂O m⁻² h⁻¹, respectively. The tundra soils under snowpack emitted N₂O in the maritime Antarctic and increased local atmospheric N₂O concentrations; therefore these fluxes could constitute an important part of the annual N₂O budget for Antarctic tundra ecosystem.     

研究星载IPDA激光雷达探测CO2光谱纯度

光谱纯度是积分路径差分吸收激光雷达最重要的系统参数之一,光谱纯度直接影响CO₂数据的探测精度.在模式研究中要求输入观测的CO₂数据误差小于1×10^-6,对激光器光谱纯度参数设计提出很高要求.本文采用有效吸收截面分析探测反演误差的方法,研究了由光谱纯度带来的CO₂柱浓度探测误差,并基于窄带滤波器对光谱不纯能量的抑制作用,对不同带宽的窄带滤波器进行选择和分析,从而达到降低对光谱纯度的要求,提升探测精度的目的,最后讨论了由于窄带滤波器造成的能量衰减所对随机误差的影响.结果表明：当光谱纯度为99.9%,窄带滤波器带宽1GHz,透射率为0.86,脉冲能量为100mJ时CO₂探测的系统误差小于0.084×10^-6,随机误差小于0.02×10^-6,满足探测精度要求.     

合肥市典型交通干道大气苯系物的特征分析

为研究合肥市交通干道大气苯系物污染状况,采用自主研制的差分吸收光谱(DOAS)系统,于2016年3月期间对合肥市交通主干道大气苯系物(苯、甲苯、间二甲苯和邻二甲苯)以及常规污染物NO_2、SO_2等进行了连续观测.观测结果显示,观测期间苯、甲苯、间二甲苯和邻二甲苯的平均浓度分别为:21.7、63.6、33.9和98.7μg·m~(-3).与国内外其它城市比较显示,合肥市交通干道大气苯和甲苯的污染处于中等水平,二甲苯的污染较为严重.结合观测期的间风速风向、T/B特征比值以及与CO等污染物的相关性,对上述苯系物来源进行了分析,结果显示观测期间T/B值为0.8~4.5,苯、甲苯与CO的相关性系数R分别为0.55和0.34.表明机动车尾气排放是观测区域苯和甲苯的主要排放源之一,同时也受到周边工业园区排放的影响,二甲苯的主要排放源为观测地点北偏东方向的涂料行业工业园区.苯和甲苯的夜间高浓度峰值分析结果表明,夜间的高浓度苯和甲苯可能主要来源于观测地点周边工业园区的排放.观测区域苯系物的臭氧生成潜势(OFP)表现为邻二甲苯间二甲苯甲苯苯,其中二甲苯的OFP占总OFP的85%,表明周边工业园区的排放对该地区臭氧生成的贡献较大.     

合肥科学岛低对流层二氧化碳时空分布特征

依据合肥市科学岛2013~2016年的CO₂体积比浓度廓线,分别从夜间、季节和年度分析了亚热带季风气候的CO₂分布特点和合肥科学岛的CO₂源汇特征.（1）大气CO₂体积比浓度随高度增加而减小,390m的CO₂浓度约为15m浓度的95%,夜间随时间推移浓度增加幅度约5%,天亮时CO₂浓度有减小的趋势;（2）测量点高度大于100m时,季节特征较明显,CO₂体积比浓度夏季最低,冬季最高,浓度相差约10×10^-6;（3）测量点高度大于100m时,2013~2016年CO₂体积比浓度的年分布随高度变化的梯度相关系数大于0.9,体积比浓度年增长约2.1648×10^-6.通过三个时间尺度的CO₂体积比浓度廓线分析得出,CO₂浓度特征是动植物活动和大气运动等共同作用的结果;CO₂长期循环过程中,存在近地面CO₂向高空的传输效应.     

Experimental study on the competing effect of ceramic pellets on premixed methane-air flame propagation in a duct

It is urgent to explore effective suppression methods for gas fires and explosions to ensure the safe utilizations of combustible gases in industrial processes. In this work, experiments are performed to study the effect of spherical ceramic pellets on premixed methane-air flame propagation in a closed duct. High-speed schlieren photography and pressure transducers are used to record the flame propagation and pressure transient, respectively. Behaviors of the flame propagating through a section of the duct filled with ceramic pellets in mixtures at different equivalence ratios are scrutinized. Three different diameters of pellets are considered in the experiments. The result shows that the flame can be quenched in the case with a smaller pellet diameter (3 mm) for a wide range of equivalence ratios from fuel-lean to fuel-rich mixture. For larger pellet diameter (5 or 10 mm), flame extinction occurs in fuel-rich mixtures (e.g. Φ = 1.1, 1.2). For the cases of flame surviving through the pellets bed, the pellets show a significant influence on the flame structure and behavior. The flame propagation depends on the porosity and the mean void diameter of the porous media in the pellets bed. Small void diameter is beneficial to flame quenching, while large porosity can accelerate the flame propagation. The pressure dynamics evolution is closely related to the interaction of flame with the pellets, and it depends on whether the flame quenches in the pellets bed. Overall, d = 3 mm ceramic pellets display the best suppression effect on flame propagation and pressure buildup in this study. The results of this study are of great significance to guide the safety design of spherical suppression materials in engineering applications for process safety researchers and engineers.     

Coupling effects of the explosion shock wave and heat radiation on the dynamic response of a fixed-roof tank

The occurrence of leakage in large tank farms or oil deposits can lead to fire or explosion accidents. Coupling effects of fire and explosion loadings can cause considerably more damage to adjacent tanks or buildings than either loading individually does. In this study, the combined loadings of the explosion shock wave and heat radiation from a pool fire on a neighboring empty fixed-roof tank were numerically investigated. The effects of the explosion shock wave intensity and relative height of the explosion center [the ratio of the height of the explosion center to the height of the tank (h_r)] were analyzed. The results indicate that tanks damaged by explosion shock waves have decreased fire resistance and critical buckling temperature. Moreover, the thermal buckling deformation of the predamaged tank largely depends on the explosion shock wave. With an increase in the explosion shock wave intensity or a decrease in h_r, the explosion shock wave has greater influence on the fire resistance of the tank, and the critical buckling temperature decreases. This paper can provide an understanding of the dynamics of a tank under explosion shock wave loading, and of the critical failure criterion and failure modes of a target tank under the coupled loading of the explosion shock wave and an adjacent pool fire.