铁锰复合氧化物滤料去除地下水中四环素的效能

以化学挂膜成熟运行5a的铁锰复合氧化物滤料为研究对象,利用静态与连续流柱实验相结合的方式,探究了该滤料去除四环素的效果与机理.结果表明,去除过程符合准二级反应动力学模型;且滤料质量越大,初始浓度越高,对四环素去除的效果越好;当水中共存阳离子浓度为0.01mol/L时,Mg²⁺抑制四环素的去除,而Ca²⁺、K⁺对四环素的去除过程无显著影响.连续流柱实验与发光细菌毒性检测分析,表明,铁锰氧化物滤料对四环素去除效果显著高于石英砂,且铁锰复合氧化物滤料去除四环素后急性毒性降低.此外,机理探究实验结果证实了铁锰复合氧化物滤料去除四环素是吸附与氧化的过程.     

MnCeOx/沸石催化剂对工业典型VOCs的催化性能

以沸石为载体制备了锰铈复合氧化物催化剂（记为:MnCeO_x/沸石催化剂）,探究了催化剂对工业典型VOCs的二元催化性能,并对催化剂进行BET、XRD及SEM表征。结果表明:Ce的加入,促进了Mn的分散,提高了MnCeO_x/沸石催化剂的活性;当n（Mn）∶n（Ce）为1∶1,负载率为20%,焙烧温度为500℃时,催化剂的活性最高,其对甲苯的起燃温度（T₅₀）和完全燃烧温度（T₉₀）分别为155,255℃;单组分实验中,催化剂对3种有机物均表现出较高活性,转化率达到90%时的反应温度均在275℃以下,其活性顺序为乙酸乙酯>甲苯>丙酮,主要受反应活化能大小及分子极性的影响;二元催化实验中,由于竞争吸附的影响,3种物质的T₅₀和T₉₀较单组分均分别提高了8~13,14~38℃。     

悬浮填料投加对AnMBR性能及膜污染的影响

研究了悬浮填料投加对分置式厌氧膜生物反应器（AnMBR）的COD去除效果、污泥混合液特性及膜污染的影响。试验结果表明:在反应器有机负荷为2.09 kg/（m3·d）,污泥负荷为0.54 kg/（kg·d）,水力停留时间（HRT）为48 h,温度为（35±2）℃的条件下,与未投加悬浮填料阶段比较,投加填料后AnMBR的COD总去除率由96.6%提高至97.9%,甲烷产率提高16.0%。同时投加悬浮填料后AnMBR混合液污泥平均粒径增大,滤饼层阻力、总阻力、滤饼层阻力在总阻力中的占比较未投加悬浮填料时分别降低7.8、6.5和1.3百分点,溶解性胞外聚合物（SEPS）和结合性胞外聚合物（BEPS）浓度分别降低了20.5%和29.4%,跨膜压差（TMP）线性增长速率降低,膜污染速率明显减缓。因此,投加悬浮填料可在不增加能耗的情况下改善污泥混合液特性,起到强化AnMBR处理效果和控制膜污染的作用。     

Influence of floc dynamic protection layer on alleviating ultrafiltration membrane fouling induced by humic substances

Cake layer formation is inevitable over time for ultrafiltration (UF) membrane-based drinking water treatment. Although the cake layer is always considered to cause membrane fouling, it can also act as a “dynamic protection layer”, as it further adsorbs pollutants and dramatically reduces their chance of getting to the membrane surface. Here, the UF membrane fouling performance was investigated with pre-deposited loose flocs in the presence of humic acid (HA). The results showed that the floc dynamic protection layer played an important role in removing HA. The higher the solution pH, the more negative the floc charge, resulting in lower HA removal efficiency due to the electrostatic repulsion and large pore size of the floc layer. With decreasing solution pH, a positively charged floc dynamic protection layer was formed, and more HA molecules were adsorbed. The potential reasons were ascribed to the smaller floc size, greater positive charge, and higher roughness of the floc layer. However, similar membrane fouling performance was also observed for the negative and positive floc dynamic protection layers due to their strong looseness characteristics. In addition, the molecular weight (MW) distribution of HA also played an important role in UF membrane fouling behavior. For the small MW HA molecules, the chance of forming a loose cake layer was high with a negatively charged floc dynamic protection layer, while for the large MW HA molecules it was high with a positively charged floc dynamic protection layer. As a result, slight UF membrane fouling was induced.     

普伐他汀的光催化降解性能及机理研究

通过水热法合成Bi₂WO₆,并利用XPS,XRD,BET,UV-Vis和SEM等方法对样品进行了表征;通过光催化性能实验考察了Bi₂WO₆投加量,溶液pH值对普伐他汀（PR）降解效果的影响;通过自由基捕获实验及中间产物的鉴定探明了Bi₂WO₆光催化降解PR过程的主要活性自由基,中间产物及降解机理,并采用发光细菌急性毒性试验评估了PR降解前后的毒性.结果表明,所制备的Bi₂WO₆是由大量纳米片组成的正交晶系花瓣状微球,各元素物质的量比为Bi：W：O=2.5：1：6.7,比表面积为26.67m²/g,带隙能为2.74eV;光催化性能结果表明,对于10mg/L PR,当溶液pH=6.5,Bi₂WO₆投加量为0.4g/L时降解效果最佳,降解率可达80.6%,矿化度为40.2%;自由基捕获实验结果表明降解过程中h⁺起主要的氧化作用,·OH和·O₂^-的氧化起辅助作用.基于活性自由基和中间产物的鉴别结果提出了Bi₂WO₆光催化降解PR的机理,即以h⁺为主,·OH和·O₂^-为辅联合攻击PR分子中C－C键,C＝C双键,酯键等化学键,进而将其分解为易降解小分子有机物.另外,毒性测试结果表明PR经光催化降解后的小分子产物与PR原液相比毒性并没有增强.     

两株假单胞菌对蒽菲芘的降解作用

从污染污泥中分离出两株假单胞菌PCN5及PCB2。研究了它们对蒽、菲、芘的降解性能及生长繁殖情况。结果表明，单基质存在下，10h，PCN5对蒽的降解转化率为91．8％，芘为75．6％，菲仅为26．25％；相反PCB2对菲的降解效果最好，蒽最差；混合基质体系中，两菌株都有良好的降解效果，对芘的降解效果较差；130h，PCN5对蒽、菲、芘混合体系中的TOC去除率为38．9％，PCB2对相应体系的去除率为73．7％；混合体系中两株的生长曲张相似，细菌浓度均呈指数增长趋势，PCN5的最大浓度约是原加入量的10000倍，PCB2是原加入量的8000倍。     

废水中有机物对铁盐除磷的影响

通过批次实验探究了不同有机物对铁盐化学除磷的影响.结果显示，有机物对铁盐化学除磷的不利影响由强到弱依次为柠檬酸、黄腐酸、聚山梨酯-80、牛血清蛋白、葡萄糖、淀粉，柠檬酸的影响程度为其他五种有机物的5~20倍.较之含羟基有机物，含羧基有机物对铁盐除磷的不利影响更大.研究表明：铁盐化学除磷的实质是通过形成铁羟基氧化物（HFO）来除磷.含羧基有机物，如柠檬酸，可与磷酸根竞争HFO，有机物"抢占"HFO表面结合位点导致磷酸盐与HFO结合减少，从而使铁盐除磷效果下降.在所试柠檬酸浓度范围内，铁盐除磷率最高下降了90.70%.     

First step towards preventing losses due to mechanical damage from abnormal actions: Knowledge-based forecasting the actions

This paper presents a simulation-based procedure of forecasting abnormal mechanical actions (effects) induced during man-made accidents. The procedure is based on the so-called predictive, epistemic approach to risk assessment. It provides formal means for combining hard data and subjective information and allows forecasting the abnormal actions in the form of mathematical models, which quantify epistemic (state-of-knowledge) uncertainties in characteristics of the actions. A result of this forecasting can be used to form (quantify) an engineer's subjective confidence in future values of abnormal actions. The epistemic models allow a rough, knowledge-based estimation of probabilities of damage from abnormal actions. These models are considered to be the first step towards preventing (reducing) losses associated with damage from abnormal actions.     

Current status of urban wastewater treatment plants in China

The study reported and analyzed the current state of wastewater treatment plants (WWTPs) in urban China from the perspective of treatment technologies, pollutant removals, operating load and effluent discharge standards. By the end of 2013, 3508 WWTPs have been built in 31 provinces and cities in China with a total treatment capacity of 1.48 × 10⁸ m³/d. The uneven population distribution between China's east and west regions has resulted in notably different economic development outcomes. The technologies mostly used in WWTPs are AAO and oxidation ditch, which account for over 50% of the existing WWTPs. According to statistics, the efficiencies of COD and NH₃–N removal are good in 656 WWTPs in 70 cities. The overall average COD removal is over 88% with few regional differences. The average removal efficiency of NH₃–N is up to 80%. Large differences exist between the operating loads applied in different WWTPs. The average operating loading rate is approximately 83%, and 52% of WWTPs operate at loadings of < 80%, treating up to 40% of the wastewater generated. The implementation of discharge standards has been low. Approximately 28% of WWTPs that achieved the Grade I-A Discharge Standard of Pollutants for Municipal Wastewater Treatment Plant (GB 18918–2002) were constructed after 2010. The sludge treatment and recycling rates are only 25%, and approximately 15% of wastewater is inefficiently treated. Approximately 60% of WWTPs have capacities of 1 × 10⁴ m³/d–5 × 10⁴ m³/d. Relatively high energy consumption is required for small-scale processing, and the utilization rate of recycled wastewater is low. The challenges of WWTPs are discussed with the aim of developing rational criteria and appropriate technologies for water recycling. Suggestions regarding potential technical and administrative measures are provided.     

流态对生物添加强化硝化效果的影响

在15℃、相同氮负荷和添加强度条件下运行SBR和CSTR以对比分析两种典型流态(推流式和完全混合式)对硝化菌添加强化硝化效果的影响.结果表明,添加期间,SBR中氨氧化速率(AUR)和亚硝酸盐氧化速率(NUR)分别为添加前的2.34和2.39倍,停止添加后又分别降为添加前的2.01和1.78倍;添加期间CSTR中AUR和NUR分别为添加前的2.63和2.44倍,停止添加后又分别降为添加前的1.48和1.31倍.荧光原位杂交结果显示,添加期间,SBR中氨氧化菌(AOB)和亚硝酸盐氧化菌(NOB)的个数百分比分别为添加前的2.67和2.71倍,添加停止后,又分别降至原来的2.14和1.95倍;CSTR中AOB和NOB分别为添加前的2.91和1.77倍,但在添加停止后CSTR中AOB和NOB分别降至添加前的1.25和1.50倍.因此,硝化菌添加期间,两种流态的添加效果接近,但是在添加停止后,由于流态对硝化菌中K-决策者(Nitrosospira、Nitrospira)和r-决策者(Nitrosomonas europaea、Nitrobacter)的选择作用,添加的硝化菌在完全混合式条件下比推流式条件下更容易被系统淘汰.