Measurement of tire tread in urban air by pyrolysis-gas chromatography with flame photometric detection

The concentration of tire tread in suspended particulate matter (SPM) was measured by a new method based on benzothiazole generated by pyrolysis of vulcanization accelerator. The variation of production yields of benzothiazole was examined for 24 kinds of tire treads currently used in Japan Pyrolysis was carried out at 670°C using a Curie-point pyrolyzer.The vertical profile and diurnal pattern of tire tread were investigated with 4-h samples continuously collected for 24 h at a heavy traffic density area in Tokyo. The diurnal percentage of tire tread in SPM at the sampling site of 86 m height showed two peaks following the trend of traffic density throughout the day. The concentration of tire tread collected at the 86 m level was about 30% of that at the 0 m level during the daytime. The seasonal variation of concentration of tire tread in SPM was measured at the sampling site located 20 km SW of Tokyo. The weight percentage of tire tread in SPM varied between 1.3 and 3% in winter with NE-NW wind and varied between 0.5 and 1.5% in spring with SE-SW wind.     

Chlorine,Bromine AND Iodine in arctic aerosols

Weekly suspended particulate samples were collected at three stations in the Canadian Arctic between 1979 and 1984. The halogens, Cl, Br and I were determined, along with a comprehensive suite of elements and ions. As was previously observed in Alaska, Br was found to peak every year just after the Arctic dawn, reaching concentrations of two orders of magnitude greater than could be explained by marine, automotive and crustal sources. Chlorine concentration correlated closely with that of Na, indicating a marine origin. It was found to be strongly depleted relative to Na during periods of high sulphate concentration. Iodine was found to be enormously enriched relative to seawater by a factor of 1000 –10,000. The enrichment was least during the early winter when marine aerosol concentrations were at their highest. At locations remote from open oceans I concentrations exhibited two annual peaks, one in the spring, and one during the early autumn. No clear correlations with other parameters could be found for these peaks. At locations close to open ocean, concentrations were higher than at the inland sites and did not vary seasonally.     

The mountain view controlled landfill project field experiment

The Mountain View controlled landfill project was undertaken in response to the need to optimize energy recovery from landfills, accelerate stabilization, and control gas migration and explosion hazards in the vicinity of landfills. The major objectives of the project were (1) to test the hypothesis that both yield and rate of landfill methanogenesis can be increased by controlling specific conditions within a landfill bioreactor, and (2) to quantify landfill gas production in a field-scale experiment with complete gas recovery so that a measure of landfill gas recovery efficiency can be established. Of particular importance for the design of the field experiment were the synergistic effects of moisture content, seed, and buffer additions on methanogenesis in landfilled municipal solid wastes. The experiment included six landfill cells considered as representative of actual landfills. The effect of moisture content, seed, and buffer was studied in terms of the water content of the refuse additions mixture on a total weight basis, the ratio of organic sludge dry solids to refuse dry solid (seed/nutrient), and the ratio of buffer solids to water present in the refuse/additions mixture.     

The inhibitory combustion reaction performance and tail gas analysis of composite ultra-fine dry powder extinguishing agent containing different additives

For lack of an extinguishing agent with high-efficiency, non-toxic and environmentally friendly, a new type of extinguishing agent was fabricated to solve such an urgent problem. In this study, the zinc borate (ZB) and ferrocene (Fe(Cp)₂) were utilized as two additives for extinguishants to suppress combustion reaction and the toxicity of the tail gas was detected. The mass fraction of ZB corresponding to the optimal inhibitory effect was determined to be 0.5–1.5%, by contrast, the optimum interval of Fe(Cp)₂ was detected as 0.5–1.0%. Similarly, with the increasing proportion of the two additives, the homologous inhibitory action was gradually weakened. From the perspective of thermogravimetric analysis (TGA), it was indicated that the ZB accelerated the pyrolysis process of the extinguishant, making its thermal decomposition process more thoroughly. Meanwhile, the differential scanning calorimetry (DSC) demonstrated that the decomposition efficiency was markedly improved when the amount of ZB was maintained at 0.5–1.5%. Besides, the tail gas tests were implemented to assess the extent of toxic and harmful properties. In terms of the carbon monoxide (CO) and carbon dioxide (CO₂) generated, once the mass fraction of ZB and Fe(Cp)₂ was less than 1.5% and 1.0% respectively, the concentration of CO and CO₂ was distinctly lower than that without additives. Moreover, the inhibitory ability on nitrogen oxides (NOx) was enhanced when the mass fraction of the two additives was kept below 1.0%. The results confirmed that a more practical extinguishant was proposed and it can provide guidance for the application and development of extinguishants.     

CFD simulations of dust dispersion in the 1 m3 explosion vessel

According to standard procedures, flammability and explosion parameters for dusts and dust mixtures are evaluated in 20 L and/or 1 m³ vessels, with equivalent results provided a correct ignition delay time (60 ms in the 20 L vessel; 600 ms in the 1 m³ vessel). In this work, CFD simulations of flow field and dust concentration distribution in the 1 m³ spherical vessel are performed, and the results compared to the data previously obtained for the 20 L. It has been found that in the 1 m³ vessel, the spatial distribution of the turbulent kinetic energy is lower and much more uniform. Concerning the dust distribution, as in the case of the 20 L, dust is mainly concentrated at the outer zones of the vortices generated inside the vessel. Furthermore, an incomplete feeding is attained, with most of the dust trapped in the perforated annular nozzle. Starting from the maps of dust concentration and turbulent kinetic energy, the deflagration index K_St is calculated in both vessels. In the conditions of the present work, the K_St is found to be 2.4 times higher in the 20 L than in the 1 m³ vessel.     

Optimization of capture–recapture monitoring of elusive species illustrated with a threatened grasshopper

Information on population sizes and trends of threatened species is essential for their conservation, but obtaining reliable estimates can be challenging. We devised a method to improve the precision of estimates of population size obtained from capture–recapture studies for species with low capture and recapture probabilities and short seasonal activity, illustrated with population data of an elusive grasshopper (Prionotropis rhodanica). We used data from 5 capture–recapture studies to identify methodological and environmental factors affecting capture and recapture probabilities and estimates of population size. In a simulation, we used the population size and capture and recapture probability estimates obtained from the field studies to identify the minimum number of sampling occasions needed to obtain unbiased and robust estimates of population size. Based on these results we optimized the capture–recapture design, implemented it in 2 additional studies, and compared their precision with those of the nonoptimized studies. Additionally, we simulated scenarios based on thresholds of population size in criteria C and D of the International Union for Conservation of Nature (IUCN) Red List to investigate whether estimates of population size for elusive species can reliably inform red-list assessments. Identifying parameters that affect capture and recapture probabilities (for the grasshopper time since emergence of first adults) and optimizing field protocols based on this information reduced study effort (−6% to −27% sampling occasions) and provided more precise estimates of population size (reduced coefficient of variation) compared with nonoptimized studies. Estimates of population size from the scenarios based on the IUCN thresholds were mostly unbiased and robust (only the combination of very small populations and little study effort produced unreliable estimates), suggesting capture–recapture can be considered reliable for informing red-list assessments. Although capture–recapture remains difficult and costly for elusive species, our optimization procedure can help determine efficient protocols to increase data quality and minimize monitoring effort.     

Protective effects of thymoquinone against acrylamide-induced liver,kidney and brain oxidative damage in rats

Environmental Science and Pollution Research - Acrylamide (AA), an industrial monomer, may cause multi-organ toxicity through induction of oxidative stress and inflammation. The antioxidant...     

“Modern agriculture” transfers many pesticides to watercourses: a case study of a representative rural catchment of southern Brazil

Environmental Science and Pollution Research - The total cultivated area in Brazil reached to 62 million ha in 2018, with the predominance of genetically modified soybean and corn (36 and 17...