电动交通工具的污染减排及对策

燃油交通工具是城市温室气体的重要来源之一,因此使用电动交通工具成为解决城市污染减排的重要措施.文章就正确认识电动交通工具污染减排的作用,蓄电池的生产管理、回收利用等进行了讨论,并提出了相应的对策和建议.     

高温状态下受热时间对膨润土物性指标的影响∗

高温状态下膨润土的物性指标变化是高放核废物深地质处置库设计的重要参数之一。通过高温状态下不同受热时间MX80钠基膨润土的比重、液塑限、自由膨胀率试验,研究了受热时间对膨润土基本物性指标的影响规律;并通过热重分析(TGA)、X衍射(XDR)、电镜扫描(SEM)试验,从微观角度对上述变化规律进行了合理解释。研究结果表明:随着受热时间的增加,膨润土的比重、液塑限、自由膨胀率在受热15～30天内急剧下降,降幅分别为2.5%、3.1%和28.3%,之后各值变化量很小;高温状态下,膨润土的矿物成分转化、结合水脱附、微观形貌改变是膨润土物性指标发生变化的根本原因,三者之间相互作用和彼此影响。     

基于快速聚类方法分析常州市区PM2.5的统计特性

运用统计方法研究常州市区2013~2014年6个国控点六项基本污染物(SO_2、NO_2、CO、O_3、PM_(2.5)和PM_(10))月平均浓度变化,结果表明,除O_3外,其它五项污染物月平均浓度夏季较低冬季较高.颗粒物与风速之间的关系为PM_(2.5)浓度随风速的升高一直降低,PM_(10)随风速的升高浓度先降低后升高.采用快速聚类分析(k-means)并运用SWV和DIV指数对六项基本污染物进行分类,得到4个样本分类.与依据颗粒物化学成分或粒径谱对PM进行源解析方法不同,本研究更多是从PM_(2.5)与其它污染物相关关系以及污染程度等角度按照欧式距离进行分类.不同类中PM_(2.5)来源明显不同,类1中PM_(2.5)与化石燃料燃烧排放密切相关,类2与O_3密切相关,类3与城市不完全燃烧排放、区域灰霾污染密切相关,类4可以归类于城市"背景"类.快速聚类分析结果也表明常州市区PM_(2.5)有着复杂的来源.     

新气候变迁报告:减排若不控制恐将引发大灾难

正联合国气候变迁专家小组于11月2日推出第五个全球气候变迁评估报告.据法国国际广播电台报道,联合国气候变迁问题专家组11月2日在丹麦首都哥本哈根推出对全球气候状况的最新评估报告,报告以超乎寻常的强烈用词警告,人类面对地球生态环境快速恶化的风险,各国政府必须尽快行动,降低温室气体排放,实现在2100年前将温室气体排放量减至零,否则恐将引发生态和社会灾难.同时报告也指出,减排     

市政污泥深度脱水滤液水质特性研究

以武汉市五座污水处理厂剩余污泥经Ⅰ、Ⅱ、Ⅲ三种污泥调理方法调理及脱水的污泥深度脱水滤液为研究对象,分析测定了水样的常规水质指标。结果表明,配方Ⅰ所得脱水滤液pH为12.8左右,呈强碱性,配方Ⅱ、Ⅲ所得脱水滤液pH=3.0~6.2,呈酸性。污泥深度脱水滤液的水质随脱水污泥的来源、污泥调理方法不同而异,稳定、氧化程度高的污泥其深度脱水滤液水质较好。经调理后的深度脱水滤液ρ(COD)为180~1200 mg/L,为中低浓度有机废水;BOD5/COD=0.49~0.66,可生化性良好;氨氮浓度为20~200 mg/L,差异较大,但普遍较高,C/N在2.2~13.4,属低C/N比废水;TP在0.4~5.5 mg/L,C∶N∶P对微生物生长来说并不协调。污泥调理剂中的破胞试剂对污泥脱水滤液水质影响较大,配方Ⅱ、Ⅲ调理剂中含破胞试剂,调理后的污泥深度脱水滤液COD和氨氮值较大。最后,建议对氨氮负荷过高而不适合回流的深度脱水滤液采用高效的生物脱氮工艺进行处理。     

丙烯气体最小点火能研究

为研究丙烯气体最小点火能随温度的变化规律,首先采用最小点火能测试系对甲烷气体进行了测试和评估,得到了不同温度下的最小点火能及其随温度的变化趋势。结果表明,可燃气体(或液体蒸气)敏感浓度均略高于其当量浓度。气体最小点火能随温度升高而增大。     

盘管式冰蓄冷器释冷过程实验研究

提出一种应用于相变蓄冷冷却系统的盘管式蓄冰装置,实验研究了不同翅密度的蓄器在不同制冷剂温度下的释冷特性。结果表明:蓄冷器在释冷过程中,蓄冷盘管轴向温差大,且换热量随时间有明显的初始阶段和稳定阶段。对于固定翅密度的蓄冷器,制冷剂入口温度对换热影响较大,入口温度越高,初始阶段和稳定阶段的换热量均较高。对于固定的制冷剂入口温度,蓄冷器的释冷特性受翅密度影响较小。     

Evaluation of accuracy of linear regression models in predicting urban stormwater discharge characteristics

Stormwater runoff has been identified as a source of pollution for the environment, especially for receiving waters. In order to quantify and manage the impacts of stormwater runoff on the environment, predictive models and mathematical models have been developed. Predictive tools such as regression models have been widely used to predict stormwater discharge characteristics. Storm event characteristics, such as antecedent dry days （ADD）, have been related to response variables, such as pollutant loads and concentrations. However it has been a controversial issue among many studies to consider ADD as an important variable in predicting stormwater discharge characteristics. In this study, we examined the accuracy of general linear regression models in predicting discharge characteristics of roadway runoff. A total of 17 storm events were monitored in two highway segments, located in Gwangju, Korea. Data from the monitoring were used to calibrate United States Environmental Protection Agency＇s Storm Water Management Model （SWMM）. The calibrated SWMM was simulated for 55 storm events, and the results of total suspended solid （TSS） discharge loads and event mean concentrations （EMC） were extracted. From these data, linear regression models were developed. R2 and p-values of the regression of ADD for both TSS loads and EMCs were investigated. Results showed that pollutant loads were better predicted than pollutant EMC in the multiple regression models. Regression may not provide the true effect of site-specific characteristics, due to uncertainty in the data.     

Antimony smelting process generating solid wastes and dust：Characterization and leaching behaviors

A large amount of solid waste has been produced by the antimony smelting process in the＂World Capital of Antimony＂, Xikuangshan area in China. This study comprehensively investigated the physical and chemical characteristics of the various solid wastes, as well as the leaching behavior of the solid wastes, which included water-quenched slag,arsenic-alkali residue, desulfurized slag and blast furnace dust. These four types of waste were enriched in a variety of heavy metals and metalloids and more specifically with As and Sb levels up to 8.6 × 104 and 3.16 × 105mg/kg, respectively, in arsenic-alkali residue. For desulfurized slag and water-quenched slag, the leaching concentration of Sb significantly exceeded the acceptable limits during the leaching tests using the toxicity characteristic leaching procedure and the synthetic precipitation leaching procedure. In addition, As leaching in arsenic-alkali residue was extraordinarily hazardous, being three orders of magnitude higher than the regulatory level of As. According to the results of the extraction tests, all the tested wastes were classified as hazardous waste.     

Origin of major ions in monthly rainfall events at the Bamenda Highlands, North West Cameroon

Rainwater characteristics can reveal emissions from various anthropogenic and natural sources into the atmosphere. The physico-chemical characteristics of 44 monthly rainfall events （collected between January and December 2012） from 4 weather stations （Bamenda, Ndop plain, Ndawara and Kumbo） in the Bamenda Highlands （BH） were investigated. The purpose was to determine the sources of chemical species, their seasonal inputs and suitability of the rainwater for drinking. The mean pH of 5 indicated the slightly acidic nature of the rainwater. Average total dissolved solids （TDS） were low （6.7 mg/L）, characteristic of unpolluted atmospheric moisture/air. Major ion concentrations （mg/L） were low and in the order K＋ 〉 Ca2＋ 〉 Mg2~ 〉 Na＋ for cations and NO3 〉〉 HCO3 〉 SO] 〉 CI- 〉 PO3- 〉 F- for anions. The average rainwater in the area was mixed Ca-Mg-SO4-CI water type. The CI-/Na＋ ratio （1.04） was comparable to that of seawater （1.16）, an indication that N a＋ and CI originated mainly from marine （Atlantic Ocean） aerosols. High enrichments of Ca2＋, Mg2＋ and SO2- to Na＋ ratios relative to seawater ratios （constituting 44% of the total ions） demonstrated their terrigenous origin, mainly from Saharan and Sahelian arid dusts. The K＋/Na＋ ratio （2.24）, which was similar to tropical vegetation ash （2.38）, and NO3 was essentially from biomass burning. Light （〈 100 mm） pre-monsoon and post-monsoon convective rains were enriched in major ions than the heavy （〉 100 mm） monsoon rains, indicating a high contribution of major ions during the low convective showers. Despite the acidic nature, the TDS and major ion concentrations classified the rainwater as potable based on the WHO guidelines.