北京市PM2.5水溶性有机物污染特征

用离子色谱技术对北京市2001~2002年大气PM2.5中7种水溶性有机物(WSOC)(甲酸、乙酸、甲磺酸、乙二酸、丙二酸、丁二酸、戊二酸)及12种无机离子(F-、Cl-、NO2-、NO3-、SO32-、SO42-、PO43-、Na 、NH4 、K 、Mg2 、Ca2 )的污染水平进行了同步测定.结果表明,SO42-、NO3-及NH4 为PM2.5中主要的水溶性物种,分别占PM2.5质量的10.6%、7.4%和5.7%;7种WSOC的浓度为0.011~0.118靏/m3,占PM2.5质量浓度的0.01%~0.1%,其中浓度最高的为乙二酸,其次为乙酸、丙二酸、丁二酸等;对PM2.5各化学组分浓度的季节变化特征的分析表明,PM2.5及OC的高浓度污染均出现在冬季采暖期,而WSOC则出现在夏季;对乙二酸与其他各组分进行相关性分析表明,乙二酸与SO42-、K 、NH4 、NO3-有较强的线性相关性(r=0.83,0.57,0.49,0.33),而与Cl-、Na 、Mg2 、Ca2 、EC、OC相关性较差(r=0.24, 0.22,0.12,0.05,0.13,0.10).由乙二酸季节变化特征及与其他物种相关性等特征初步推断,北京市PM2.5二元羧酸的主要来源为光化学反应而形成的二次污染物,而非来源于机动车、海盐或土壤的一次排放.     

硫磺/石灰石自养反硝化系统脱氮除磷性能研究

为了考察硫磺/石灰石系统对于低C/N的城市污水进行同步脱氮除磷的性能,设计了体积比为1∶1的硫磺/石灰石柱式反应器,以人工配水为处理对象,采用厌氧生物滤池运行方式,研究了HRT、初始磷浓度、pH、温度等因素对其脱氮除磷性能的影响.结果表明,在进水NO 3^--N为30 mg/L左右,PO4^3--P为15 mg/L条件...     

汽车尾气净化催化剂Ag/SAPO-34选择性催化还原NO

评价了Ag/SAPO-34分子筛催化剂选择性还原NO的活性,并运用漫反射红外光谱原位研究NO在Ag/SAPO-34催化剂上的选择性催化还原机理.结果表明Ag/SAPO-34有良好的低温活性,在氧气浓度为3.6%和温度为573K～673K时NO还原成N2的转化率达70%;催化剂活性随C3H6浓度的增加而升高,随空速的增加而稍有下降.基于漫反射红外光谱,认为反应机理为:NO、丙烯和氧反应,在Ag/SAPO-34催化剂上生成吸附的有机-氮氧化物,再由这些吸附物种分解成N₂,催化还原的关键是形成有机-氮氧化物中间体.氧的作用是充分促进丙烯活化以及增加NO_x吸附态含量,并且氧的存在是有效产生一系列中间物不可缺少的条件.     

Pd-Fe/石墨烯多功能催化阴极降解4-氯酚机制研究

制备出Pd-Fe/石墨烯多功能催化阴极,与Ti/Ir O2/Ru O2阳极、有机涤纶滤布构成隔膜电解体系,将阴极催化加氢脱氯作用和阴阳极氧化作用耦合起来对含4-氯酚的有机废水进行降解,采用TOC仪、紫外扫描、高效液相色谱、离子色谱分析方法研究其降解效果及反应历程.结果表明,在最佳反应条件下,Pd-Fe/石墨烯催化体系阴阳极室中4-氯酚转化率分别为98.1%和95.1%,优于Pd/石墨烯催化体系阴阳极室的93.3%和91.4%.Pd-Fe/石墨烯催化体系脱氯效果高于95%,表明双金属催化剂具有更强的析氢能力.在阴阳极的协同作用下,反应120 min时4-氯酚被完全转化.通过阴极加氢脱氯作用,4-氯酚被还原成苯酚.随后苯酚在阴阳极的共同氧化作用下,被氧化生成对二苯酚、苯醌等中间产物,继而被氧化为小分子有机酸,最后被矿化为CO2和H2O,据此提出了4-氯酚降解的可能历程.     

C/N比和曝气量影响MBR同步硝化反硝化的研究

通过连续运行MBR研究了C/N比和曝气量对同步硝化反硝化的影响,结果表明,在环境温度13～23℃,MLSS为6.0～6.8 g/L,进水NH⁺₄-N浓度50 mg/L,曝气量0.5 m³/h,HRT为6 h实验条件下,总氮去除率随着进水C/N比的增加而增加,在C/N比为6∶1～8∶1时,TN去除率达到79%～89%,低的C/N比抑制反硝化,过高的C/N比增加了碳源补加的成本。改变反应曝气量,当C/N比为6∶1,曝气量为0.4 m³/h时,TN的去除率达到了最大值85%。曝气量过高或过低,TN去除率均下降。并对在不同曝气量下MBR 内的DO 值分布进行了初步研究。     

混凝-生物接触氧化处理合成橡胶碱洗废水

对化学合成橡胶碱洗废水进行了有机组分和可生化性分析,废水主要含有氯甲烷、六甲苯、异丁醇、甲醇等污染物质,生化降解实验中废水TOC可在6d内从60．9mg／L下降至0．0mg／L,可生化降解性好,适于生化处理。选择混凝．生物接触氧化组合工艺对废水进行处理,采用优化条件（pH=8、PAC=40mg／L、PAM=8mg／L）进行混凝,碱洗废水COD去除率为9．95％～72．94％（平均31．51％）;混凝后的碱洗废水与冲洗废水1：5混合进行接触氧化处理,在HRT为36h的情况下,COD去除率为65．6％-72．6％（平均70．4％）,出水COD为134～331mg／L,满足企业废水排放市政管网的要求;同时,实验发现COD去除率与COD容积负荷存在指数函数变化关系。     

Estimation and characterization of PCDD/Fs and dioxin-like PCBs from Chinese iron foundries

The iron foundry industry is considered to be a potential source of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs). This study investigated the emission factors and total emission amounts of PCDD/Fs and dioxin-like polychlorinated biphenyls (DL-PCBs) from iron foundries in China. The concentrations and the World Health Organization toxicity equivalents (WHO-TEQs) are presented and the congener profiles are discussed in this paper.In the present work, 26 fly ash samples were collected and tested to quantify the PCDD/Fs and DL-PCBs generated by 14 plants of different scales, and five stack gas samples were collected from two (named as EFG and LFG) of those plants. The emission levels of PCDD/Fs and DL-PCBs indicated that hot-air cupolas had lower emissions than cold-air cupolas. When iron ore lump and sinter were used as raw material, the emission factors were about 250 ng TEQ t⁻¹ of product. However, if the raw material was scrap, the emission factors varied owing to the different contents of organic materials in the raw materials. It was found that the mean WHO-TEQ values of PCDD/Fs and DL-PCBs were 144 and 34.2 pg Nm⁻³ in stack gas and 20.0 and 1.58 pg g⁻¹ in fly ash. In multiple tests, it was estimated that the mean emission factors of PCDD/Fs and DL-PCBs were 365 and 10.9 ng WHO-TEQ t⁻¹ released to residue and 2719 and 555 ng TEQ t⁻¹ released to air. The total emission amounts of PCDD/Fs and DL-PCBs from Chinese iron foundries with cupola furnaces released to residue and air were 16.8 and 146 g WHO-TEQ in 2008, respectively.     

饮用水除砷技术研究进展

饮用水中的砷对人体健康危害很大。介绍了从饮用水中去除砷的各种方法,总结了目前除砷技术存在的不足,指出混凝微滤工艺具有除砷效率高、能耗低、操作简单等优点,应成为今后饮用水除砷技术的发展方向。     

Altered toxicity of organic pollutants in water originated from simultaneous exposure to UV photolysis and CdSe/ZnS quantum dots

The paper reports unforeseen results of increased toxicity of water, subsequent to interactions between CdSe/ZnS quantum dots (QDs), phenol and toluene under UV irradiation. The consistent pattern of changes in measured toxicity (TU) was observed and correlated with degradation of phenol and/or toluene. Spearman rank coefficients (SRCs) for data pairs sum-parameters vs. TU were calculated. The highest correlation between toxicity and degradation by-products was observed for hydroquinone (0.86) and catechol (0.89). The presence of QDs in tested concentration range in the absence of UV has shown low toxicity and no interactions with phenol and/or toluene. The leak of constituent core and shell metal ions was observed. The minor differences in physical characteristics of tested QDs of the same chemical composition led to rather different degradation patterns of phenol and toluene, and the amount of leak of the metal ions as well.     

Nationwide monitoring of atmospheric PCDD/Fs and dioxin-like PCBs in South Korea

Polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) and dioxin-like polychlorinated biphenyls (DL-PCBs) were measured in ambient air samples collected from different parts of South Korea in 2008, and the measured levels were used for assessing the spatial and temporal distribution of atmospheric PCDDFs and DL-PCBs in South Korea. The average concentrations of atmospheric PCDD/Fs and DL-PCBs among the 37 sites were 28 fg I-TEQ m⁻³ (ND ∼ 617) and 1 fg WHO-TEQ m⁻³ (ND ∼ 0.016). Elevated atmospheric levels of PCDD/Fs and DL-PCBs observed at residential/industrial sites and in the north-west of Korea, indicated a potential contribution and impacts of anthropogenic sources of PCDD/Fs and DL-PCBs. These levels were similar or lower than those previously reported in other ambient air surveys. Average concentrations of PCDD/Fs showed small seasonal variations (ANOVA analysis, p = 0.144). The highest concentrations of PCDD/Fs were observed during winter, followed by spring, autumn and summer. Atmospheric PCDD/Fs and DL-PCBs in South Korea rapidly decreased during the last 10 years (1998-2008), demonstrating the efficiency of stricter regulations and the application of best available technologies/best environmental practices at emission sources. Comparison of the congener profiles and principal component analysis showed that current atmospheric PCDD/Fs are mostly influenced by industrial sources and PCBs from old commercial PCB uses. Nationwide POPs monitoring will continue and allows an effective evaluation of the implementation of the Stockholm Convention on POPs.