纳米级铁粉脱氯降解四氯化碳

四氯化碳的生产和使用,给人类带来了较大危害.为此,采用纳米铁粉这一新方法对其进行脱氯处理.试验以纳米级铁粉对四氯化碳的脱氯率为考察指标,选用L25(56)正交试验方案,考察了降解介质的初始pH值、纳米铁粉的质量、降解温度、摇床转速和脱氯时间5个影响因素.结果表明,pH值这一因素有极显著影响;在得出的纳米铁粉对四氯化碳脱氯的最佳工艺条件下,获得了99.5%的脱氯率,为有机氯化物脱氯开辟了一条新途径.     

A novel, simple and sensitive resonance scattering spectral method for the determination of chlorite in water by means of rhodamine B

A new resonance scattering method was proposed for the determination of chlorite, basing on the resonance scattering effect of rhodamine dye. In HCl-sodium acetate buffer solution, chlorite oxidizes 1- into 12 and the reaction of 12 and excess 1- results in If. It is respectively combined with rhodaminc dyes, including rhodamine B （RhB）, butyl rhodamine B （b-RhB）, rhodamine G （RhG） and rhodamine S （RhS）, to form association complex particles, which exhibit stronger resonance scattering （RS） effect at 400 nm. The chlorite concentration of ClO2 in the range of 0.00726-0.218 μg/ml, 0.0102-0.292 μg/ml, 0.00726-0.145 μg/ml and 0.0290- 0.174 μg/ml is respectively linear to the RS intensity of association complex particle systems at 400 nm for the RhB, b-RhB, RhG and RhS. The detection limits of the four systems were respectively 0.00436, 0.00652, 0.00580 and 0.01450μg/ml ClO2^-. In the four systems, the RhB system possesses good stability and high sensitivity. It has been applied to the analysis of chlorite in wastewater with satisfactory results.     

Study of the influence of melamine polyphosphate and aluminum hydroxide on the flame propagation and explosion overpressure of aluminum magnesium alloy dust

When aluminum magnesium alloy dust floats in the air, a certain ignition energy can easily cause an accidental explosion. To prevent and control the occurrence of accidental explosions and reduce the severity of accidents, it is necessary to carry out research on the explosion suppression of aluminum magnesium alloy dust. This paper uses a vertical glass tube experimental device and a 20 L spherical explosive experimental device to carry out experimental studies on the suppression of the flame propagation and explosion overpressure of aluminum magnesium alloy dust with melamine polyphosphate (MPP) and Al(OH)₃. With increasing MPP and Al(OH)₃ concentrations, the flame brightness darkened, the flame velocity and propagation distance gradually decreased, and P_max and (dp/dt)_max decreased significantly. When the amount of MPP added reached 60%, the flame propagation distance decreased to 188 mm, which is a decrease of 68%, and the explosion overpressure decreased to 0.014 MPa, effectively suppressing the explosion of aluminum magnesium alloy dust. The experimental results showed that MPP was more effective than Al(OH)₃ in inhibiting the flame propagation and explosion overpressure of the aluminum magnesium alloy dust. Finally, the inhibitory mechanisms of the MPP and Al(OH)₃ were further investigated. The MPP and Al(OH)₃ endothermic decomposition produced an inert gas, diluted the oxygen concentration and trapped active radicals to terminate the combustion chain reaction.     

基于云模型的高校消防安全标准化评估研究

为评估高校消防安全标准化程度,明确高校消防安全标准化体系,结合高校消防安全标准化体系的模糊性,将高校消防安全标准化等级划分为5个级别,采用黄金分割法将权重云、评价云划分成5个云模型,建立能够反映高校消防安全标准化等级模糊性的云模型。该模型运用于某高校消防安全标准化等级评估中,评估结果客观合理,实用性较强,为后续标准化提升提供了参考依据。     

抛光铝粉爆炸及ABC粉体抑爆特性的实验研究

为研究抛光铝粉的爆炸危险和ABC粉体的抑爆特性,在对实验粉体粒径分布进行分析的基础上,采用20 L粉尘爆炸特性实验装置,分别对不同铝粉尘浓度、不同抑爆剂浓度条件下的爆炸特性参数进行测试。研究结果表明:在实验条件下,铝粉的爆炸下限为45 g/m3＜C＜60 g/m3;随铝粉浓度增加,爆炸烈度呈现出先增强后减弱的变化趋势,在浓度为400 g/m3时爆炸烈度最大。ABC抑爆剂能够有效抑制铝粉爆炸超压和爆炸反应进程,随着惰性粉体浓度的增加,抑制效果愈加明显,爆炸逐渐减弱。当ABC惰性粉体的质量占比增加到50%时,相较单一铝粉爆炸,反应过程时间由72 ms增加至785 ms,爆炸最大压力、最大压力上升速率分别下降了61.7%,89.5%;当ABC粉体质量占比为53%时,铝粉被完全惰化,未发生爆炸。     

Study on explosion risk of aluminum powder under different dispersions

This paper mainly studied the influence of particle size distribution on the explosion risk of aluminum powder under the span of large particle size distribution. The measurement was carried out with the 20 L explosion ball and the Hartmann tube. The statistical analysis was used to analyze the relevance between the parameters of explosion risk and the particle size parameters. Test results showed that with the increase of particle size, the sensitivity parameter increases and the intensity parameter deceleration decreases. The effect of particle size change on MEC and MIE of small particle size aluminum powder is relatively small but greater impact on Pm and (dP/dt)m. The small particle size components greatly increasing the sensitivity of the explosion and accelerating the rate of the explosion reaction; while the large particle size component contributes to the maximum explosion pressure. D_3,2 particle size dust determines the risk of aluminum powder explosion.     

Experimental investigation of the lower flammability limit of volatile liquid fuel-aluminum powder mixtures in air

Aluminum powder was always chosen as an additive to improve the explosive performance. In this work, experiments were performed to investigate the lower flammability limit (LFL) of volatile liquid fuel-aluminum powder mixtures using a 20 L closed spherical stainless steel vessel at a temperature of 20 °C (293 K) and 40 °C (313 K). The volatile liquid fuels tested in the work were diethyl ether (DEE), epoxypropane (PO), n-pentane and n-hexane. DEE, PO and n-pentane are in the liquid phase at room temperature and can easily transition to the gas phase at 40 °C (313 K). Through a series of experiments carried out, it was found that the change in phase would affect the interaction between the components. Aluminum powder always has an inhibitory effect on the flammability of the mixtures when it is mixed with gas-phase fuels. The inhibition effect was most obvious when the aluminum powder concentration reached 200 g/m³. While the interaction between aluminum powder and liquid-phase volatile fuels was promotion and was influenced by the component proportion and the type of the volatile fuels.     

基于变权灰色云模型的江苏省水环境系统脆弱性评价

水环境系统脆弱性是水资源利用与生态环境研究的热点问题,通过研究水环境系统的内在机理,综合考虑影响水环境系统脆弱性的资源、环境、经济、社会等因素,借助驱动力-压力-状态-影响-响应-管理（DPSIRM）框架构建水环境系统脆弱性评价指标体系。在此基础上,构建基于变权灰色云模型的评价方法,对2004~2014年江苏省水环境系统脆弱性进行评价。结果表明：2004~2014年水环境系统脆弱性指数由47.056提高到63.210,脆弱性等级由“重度脆弱”演化为“中度脆弱”,并长期维持在“中度脆弱的”等级,2014年出现了向“轻度脆弱”状态转变的趋势。分析各个子系统对水环境系统脆弱性影响程度可知,影响子系统和响应子系统对江苏省水环境脆弱性系统的影响程度逐年增加;而压力子系统和管理子系统对水环境系统脆弱性的影响程度逐年下降;其它子系统对水环境系统脆弱性的影响维持在一定水平小幅度波动。     

Potential effects of particulate matter from combustion during services on human health and on works of art in medieval churches in Cyprus

Indoor and outdoor particulate matter (PM_0.3-10) number concentrations were established in two medieval churches in Cyprus. In both churches incense was burnt occasionally during Mass. The highest indoor PM_0.5-1 concentrations compared with outdoors (10.7 times higher) were observed in the church that burning of candles indoors was allowed. Peak indoor black carbon concentration was 6.8 μg m⁻³ in the instances that incense was burning and 13.4 μg m⁻³ in the instances that the candles were burning (outdoor levels ranged between 0.6 and 1.3 μg m⁻³). From the water soluble inorganic components determined in PM₁₀, calcium prevailed in all samples indoors or outdoors, whilst high potassium concentration indoors were a clear marker of combustion. Indoor sources of PM were clearly identified and their emission strengths were estimated via modeling of the results. Indoor estimated PM_0.3-10 mass concentrations exceeded air quality standards for human health protection and for the preservation of works of art.     

Appraisal of measurement methods, chemical composition and sources of fine atmospheric particles over six different areas of Northern Belgium

Daily and seasonal variation in the total elemental, organic carbon (OC) and elemental carbon (EC) content and mass of PM_2.5 were studied at industrial, urban, suburban and agricultural/rural areas. Continuous (optical Dustscan, standard tapered element oscillating micro-balance (TEOM), TEOM with filter dynamics measurement system), semi-continuous (Partisol filter-sampling) and non-continuous (Dekati-impactor sampling and gravimetry) methods of PM_2.5 mass monitoring were critically evaluated. The average elemental fraction accounted for 2-6% of the PM_2.5 mass measured by gravimetry. Metals, like K, Mn, Fe, Cu, Zn and Pb were strongly inter-correlated, also frequently with non-metallic elements (P, S, Cl and/or Br) and EC/OC. A high OC/EC ratio (2-9) was generally observed. The total carbon content of PM_2.5 ranged between 3 and 77% (averages: 12-32%), peaking near industrial/heavy trafficked sites. Principal component analysis identified heavy oil burning, ferrous/non-ferrous industry and vehicular emissions as the main sources of metal pollution.