泡沫层生化反应降解表面活性剂

在含有表面活性剂的废水中进行微孔曝气,形成稳定的泡沫层,泡沫层与固定化微生物接触,使表面活性剂得到降解、研究结果表明泡沫层生化反应有助于优势微生物的富集,表面活性剂降解速度从21mg（L·h）提高到35mg（L·h）;表面活性剂的去除率从71％提高到95％,而且这种方法可以解决含表面活性剂废水处理过程中泡沫四处外溢的现象。     

复配表面活性剂水溶液处理甲苯气体的研究

以非离子表面活性剂吐温-20(Tween-20)为主表面活性剂,添加助表面活性剂十二烷基苯磺酸钠(SDBS)以及助剂氯化钠,形成复配水溶液吸收剂处理VOCs废气.以甲苯为VOCs的典型代表,研究了Tween-20,Tween-20/SDBS和Tween-20/SDBS/氯化钠3种水溶液吸收剂的临界胶束浓度(CMC)及其对甲苯去除率的影响.结果表明,当表面活性剂浓度达到CMC时,水溶液对甲苯的吸收效果开始明显增强,加入助表面活性剂SDBS和助剂氯化钠有利于甲苯的去除,同时可降低溶液的CMC,减少表面活性剂的用量,降低水溶液吸收法处理VOCs成本.当空气流量G为300mL/min、液体喷淋量L为75mL/min、进口甲苯浓度800mg/m3、温度T为30℃时,分别以Tween-20、Tween-20/SDBS(摩尔比1/4)和Tween-20/SDBS/氯化钠(摩尔比1/4/0.1)的水溶液为吸收剂,且浓度均为1CMC时,甲苯去除率分别为56%、70%和77%,三元复配表面活性剂水溶液的吸收效果最佳.     

水和废水中阴离子表面活性剂测定的影响因素

亚甲蓝分光光度法测定水和废水中阴离子表面活性剂时受到多种因素的影响。分别从pH、显色剂用量、破乳剂用量、萃取次数、干扰物质等方面进行了条件实验,得到了最佳实验条件,以保证阴离子表面活性剂测定结果的准确性。     

PVDF ultrafiltration membranes of controlled performance via blending PVDF-g-PEGMA copolymer synthesized under different reaction times

PVDF blended different graft ratio of PVDF-g-PEGMA were systematically studied. Tuning the amphiphilic copolymer synthesis time to control membrane performance. The PVDF membrane with PVDF-g-PEGMA at 19 h possesses most surface oxygen content. The synthesis time of PVDF-g-PEGMA at 9 h is good for high flux UF membrane. Polyvinylidene fluoride grafted with poly(ethylene glycol) methyl ether methacrylate (PVDF-g-PEGMA) was synthesized using atomic transfer radical polymerization (ATRP) at different reaction times (9 h, 19 h, and 29 h). The corresponding conversion rates were 10%, 20% and 30%, respectively. PVDF was blended with the copolymer mixture containing PVDF-g-PEGMA, solvent and residual PEGMA under different reaction times. In this study, we explored the effect of the copolymer mixture additives with different synthesis times on cast membrane performance. Increasing the reaction time of PVDF-g-PEGMA causes more PVDF-g-PEGMA and less residual PEGMA to be found in the casting solution. Incremental PVDF-g-PEGMA can dramatically increase the viscosity of the casting solution. An overly high viscosity led to a delayed phase inversion, thus hindering PEGMA segments in PVDF-g-PEGMA from migrating to the membrane surface. However, more residual PEGMA contributed to helping more PEGMA segments migrate to the membrane surface. The pure water fluxes of the blended membrane with reaction times of 9 h, 19 h, and 29 h are 5445 L·m⁻²·h⁻¹, 1068 L·m⁻²·h⁻¹and 1179 L·m⁻²·h⁻¹, respectively, at 0.07 MPa. Delayed phase inversion can form smaller surface pore size distributions, thus decreasing the water flux for the membranes with PVDF-g-PEGMA at 19 h and 29 h. Therefore, we can control the membrane pore size distribution by decreasing the reaction time of PVDF-g-PEGMA to obtain a better flux performance. The membrane with PVDF-g-PEGMA at 19 h exhibits the best foulant rejection and cleaning recovery due to its narrow pore size distribution and high surface oxygen content.