利用水泥处理垃圾渗滤液生物处理出水的研究

利用水泥的表面吸附和水化反应性质处理垃圾渗滤液生物处理出水可以取得很好的效果,COD的去除率可达69.5%.处理效果与水灰比、反应时间密切相关,低水灰比和较长反应时间对COD的去除更为有利.对处理前后水样的COD和TOC分析表明,水泥对非TOC贡献的COD有很强的去除效果.     

纤维改性硫酸亚铁还原铬渣水泥固化体研究

以浸出毒性、表面浸出率、抗日晒能力和抗压强度为指标考察了纤维改性硫酸亚铁还原铬渣水泥固化体的性能。实验结果表明：纤维改性硫酸亚铁还原铬渣水泥固化体养护7d和28d后的浸出毒性均低于国家标准、抗压强度均大于10MPa,可以做最终处置或进行综合利用;与普通铬渣水泥固化体相比,纤维改性硫酸亚铁还原铬渣水泥固化体在加入植物纤维为0．8g时的处理效果最好,浸出毒性、表面浸出率分别降低了76．I％和76．8％;抗日晒能力、抗压强度分别提高了36．4％和52．1％。     

Techno-Economic Study of CO2 Capture from an Existing Cement Plant Using MEA Scrubbing

Carbon dioxide is the major greenhouse gas responsible for global warming. Man-made CO₂ emissions contribute approximately 63% of greenhouse gases and the cement industry is responsible for approximately 5% of CO₂ emissions emitting nearly 900 kg of CO₂ per 1000 kg of cement. CO₂ from a cement plant was captured and purified to 98% using the monoethanolamine (MEA) based absorption process. The capture cost was $51 per tonne of CO₂ captured, representing approximately 90% of total cost. Steam was the main operating cost representing 39% of the total capture cost. Switching from coal to natural gas reduces CO₂ emissions by about 18%. At normal load, about 36 MW of waste heat is available for recovery to satisfy the parasitic heat requirements of MEA process; however, it is very difficult to recover.     

Formulation of criteria for pollution control on cement products produced from solid wastes in China

The process of producing cement products from solid waste can increase the level of pollutants in the cement products. Therefore, it is very important to establish a pollution control standard for cement products to protect the environment and human health. This paper presents acceptance limits for the availability of heavy metals in cement products which have been produced from solid wastes and explains how the limits have been calculated. The approach and method used to formulate these criteria were based on EN 12920. The typical exposure scenarios used in this paper involve concrete being used for drinking water supply pipelines and concrete pavements and are based on an analysis of typical applications of cement in China, and the potential for contact with water. The parameters of a tank test which was based on NEN 7375 were set in accordance with the environmental conditions of typical scenarios in China. Mechanisms controlling the release of heavy metals in concrete and a model for that release were obtained using the leaching test. Finally, based on acceptance criteria for drinking water and groundwater quality in China, limit values for the availability of heavy metals in concrete were calculated.     

Assessment of popular techniques for co-processing municipal solid waste in Chinese cement kilns

• Municipal solid waste (MSW) was fermented, screened, gasified, then co-processed. • Co-processing MSW in cement kilns could cause excessive pollutant emissions. • Bypass flue gas can be disposed of through the main flue system. • Popular MSW co-processing methods do not affect cement quality. Cement kiln co-processing techniques have been developed in the past 20 years in China, and more than 60 factories now use fermentation, screening, and gasification pre-treatment techniques to co-process municipal solid waste (MSW). There three complete MSW pre-treatment techniques, co-processing procedures, and environmental risk assessments have been described in few publications. In this study, we assessed the effectiveness of each technique. The results suggested that the pollutant content released by each pre-treatment technology was lower than the emission standard. To reveal the mechanisms of pollutant migration and enrichment, the substances in the kiln and kiln products are investigated. The input of co-processing materials (Co-M) produced by fermentation caused formation of polychlorinated dibenzo-p-dioxins and dibenzofuran (PCDD/Fs) in the bypass flue gas (By-gas) in excess of the regulatory standard. The Co-M input produced by the screening and gasifier technologies caused the total organic carbon (TOC) concentration to exceed the standard. In addition, the NO_x, TOC, and PCDD/Fs in the By-gas exceeded the regulatory standard. Raw meal was the primary chlorine and heavy metals input stream, and clinker (CK) and cement kiln dust (CKD) accounted for>90% of the total chlorine output stream. Flue gas and CKD were the primary volatile heavy metal (Hg) output streams. Greater than 70% of the semi-volatile heavy metals (Cd, Pb, Tl and Se) distributed in hot raw meal and bypass cement kiln dust. The low-volatility heavy metals were concentrated in the CK. These results indicated that co-processing techniques used in China still require improvement.     

水泥工业生产废水治理及回用技术探讨

本文通过具体工程实例对水泥生产废水处理回用工程可行性、经济性等进行探讨,并提出切实可行的工艺流程,即：无机混凝剂（PAC）＋高分子助凝剂（PHM）的混凝沉淀处理工艺。     

利用工业废渣生产水泥新工艺

介绍利用合成氨造气渣、锅炉渣、干煤灰、湿煤灰以及硫酸渣、氟化渣、碎砖等工业废渣生产水泥，并实现水泥无煤生产。     

水泥对垃圾焚烧飞灰的固化处理试验研究

对垃圾焚烧飞灰的化学成分、重金属物质的含量及浸出浓度进行测试分析.结果表明,飞灰中Pb和Cr等重金属物质浸出量超过浸出毒性标准,因而被认为是危险废物,必须进行固化处理.还考察了水泥对焚烧飞灰中重金属物质固化的效果,研究表明当飞灰掺量适当时,重金属物质的固化效果良好.重金属物质通过物理固封、替代,沉淀反应和吸附等形式可固化进水泥水化产物结构中.     

Diffusion of tritiated water and Na through non-degraded hardened cement pastes

Diffusion experiments through hardened cement pastes (HCP) using tritiated water (HTO) and ²²Na⁺, considered to be conservative tracers, have been carried out in triplicates in a glove box under a controlled nitrogen atmosphere. Each experiment consisted of a through-diffusion test followed by an out-diffusion test.The experimental data were inversely modelled applying an automated Marquardt–Levenberg procedure. The analysis of the through-diffusion data allowed the extraction of values for the effective diffusion coefficients, D_e, and the rock capacity factor, α. Good agreement between measured and calculated tracer breakthrough curves was achieved using both a simple diffusion model without sorption and a diffusion/linear sorption model. The best-fit K_d-values were found to be consistent with R_d-values measured in previous batch-sorption experiments.The best-fit values from the through-diffusion tests were then used to predict the results of subsequent out-diffusion experiments. Good agreement between experimental data and predictions was achieved only for the case of linear sorption.Isotopic exchange can only partially account for both the amount of tracer taken up in the batch-sorption tests and the measured retardation in the diffusion experiments and, hence, additional mechanisms have to be invoked to explain the data.     

上海电厂FGD产物循环利用的可行性分析

按照上海市第三轮环保三年行动计划的要求,未来3年,上海电厂烟气脱硫规模已经确定,650.8×10~4kW 装机容量.35台燃煤机组在3年中,将先后安装湿法烟气脱硫装置,届时可减少约(16～20)×10~4t/a的 S0_2排放量,将产生约(54～72)×10~4t 的脱硫石膏。文章分析了上海市电厂烟气脱硫产物在生产石膏、水泥中循环利用的可行性,对上海市未来3年中脱硫产物的循环利用,进行了经济分析,按上海市目前 SO_2排污费0.63元/kg计,若煤含硫量以0.8%、1%计算,预计每年可节省 SO_2排污费用约1.02、1.28亿元:电厂脱硫石膏销售将获得约2160～2880万元/a;上海石膏板或水泥企业利用(54～72)×10~4t/a 的脱硫石膏,可使企业的原料购买成本节约3250～3650万元/a;提出了促进上海市电厂脱硫及其产物应用的建议。