克雷伯氏菌NY1产絮凝剂的阳离子修饰研究

为简化微生物絮凝剂投加步骤,消除由于助凝剂添加而引起的环境二次污染问题,以3-氯-2-羟丙基三甲基氯化铵(CTA)修饰荷负电的微生物絮凝剂(~-54mV),从而获得荷正电的改性絮凝剂.实验结果显示,CTA与NaOH的摩尔比值是影响阳离子修饰效果的主要因素;阳离子修饰的的最佳条件为:10g微生物絮凝剂, 0.015mol CTA,20%含水率,CTA与NaOH的摩尔比为0.95,80℃反应2h后.在最佳条件下所得阳离子化微生物絮凝剂的Zeta电位可达+16mV,其对高岭土的絮凝率也由阳离子化前的60.5%上升至91%.由阳离子化絮凝剂的结构表征可知,阳离子修饰过程并未改变微生物絮凝剂的根本结构,只是在原微生物絮凝剂基础上引入阳离子基团,从而增加了絮凝剂整体分子量;同时,由于阳离子基团的大量引入,絮凝剂的结晶度增加,从而使其溶解度增加.将阳离子化前后微生物絮凝剂应用于去除铜绿微囊藻,当阳离子化后微生物絮凝剂添加量为40mg/L时,其对藻类的去除率超过98%;而未阳离子修饰的微生物絮凝剂对该藻几乎没有去除效果.     

利用蚀刻废液生产碱式氯化铜过程中二英类污染物的去除

针对蚀刻废液及其回收后生产的碱式氯化铜产品中二英(PCDD/Fs)和二英类多氯联苯(dl-PCBs)进行了分析研究,并比较了采用去除工艺前后两类污染物含量水平的变化特征.利用高分辨气相色谱/高分辨质谱对样品中PCDD/Fs和dl-PCBs进行分析,结果表明,氯化铜废液中PCDD/Fs和dl-PCBs的平均总浓度分别为264、139 pg·mL-1,而铜氨液中浓度分别为0.09、0.50 pg·mL-1;碱式氯化铜产品中浓度分别为106 pg·g-1(2.79 pg WHO-TEQ2005·g-1)和27.8 pg·g-1(0.69 pg WHO-TEQ2005·g-1);而经过吸附和过滤等去除工艺后,产品中PCDD/Fs和dl-PCBs的TEQ浓度水平分别降低至0.10—0.25 pg WHO-TEQ2005·g-1和0.05—0.72 pg WHO-TEQ2005·g-1,满足欧盟对于矿物源性饲料添加剂中PCDD/Fs和dl-PCBs的限量标准要求.研究表明该工艺能够有效去除利用蚀刻废液生产碱式氯化铜过程中的二英类污染物.     

Comparative study on the efficiency and environmental impact of two methods of utilizing polyvinyl chloride waste based on life cycle assessments

Two processes of utilizing polyvinyl chloride （PVC） waste, an incineration process and a vacuum pyrolysis process, for energy conversion were compared to determine their efficiency and environmental perfor- mance. We carried out a life cycle assessment with each of the two processes to evaluate their environmental impact and defined the goals and limits of our remit. As well, we established an inventory of PVC waste from incineration and vacuum pyrolysis based on process analysis, data collection and calculations. The results show that electrical power output per unit mass of PVC waste in the incineration process was twice as high as that of the vacuum pyrolysis process. Incineration had a larger total environmental impact potential than vacuum pyrolysis. The total environmental impact potential of PVC waste from incineration was three times higher than that from vacuum pyrolysis. Incineration of PVC disposed 300 ng. 100 kgI of dioxins and vacuum pyrolysis 98.19 ng- 100 kgI of dioxins. As well, we analyzed the data for their uncertainty with results quantified in terms of three uncertainties： basic uncertainty, additional uncertainty, and computational uncertainty. The coefficients of variation of the data were less than 25% and the quality of the inventory data was acceptable with low uncertainty. Both PVC waste disposal processes were of similar quality and their results comparable. The results of our life cycle impact assessment （LCIA） showed considerable reliability of our methodology. Overall, the vacuum pyrolysis process has a number advantages and greater potential for development of PVC disposal than the incineration process.     

Cu(NO3)2在亚甲蓝湿式氧化处理中的应用

用CWAO技术处理COD为2 000 mg/L的亚甲蓝水溶液.以Cu(NO3)2为催化剂,考察了催化剂投加量、反应温度、压力及进水pH值对亚甲蓝水样COD去除率、脱色率、出水pH值的影响.实验表明,亚甲蓝的氧化效率随催化剂投加量的增加,反应温度及压力的升高而升高.然而,综合考虑亚甲蓝的氧化效率、试剂费用、设备成本及能量消耗,实验确定Cu(NO3)2的投加量以Cu2 计为150 mg/L,反应温度及压力分别为200℃和2.0 MPa.在酸性进水条件下,COD去除率随进水pH值的降低而升高;而在碱性进水条件下,COD去除率随进水pH值的升高而升高.pH值按COD去除率由高到低的排列顺序是:3.87、11.23、5.50、7.25、9.47,实验确定最佳进水pH值是3.87.在以上最佳的操作条件下,反应150 min,水样COD去除率达97.4%,脱色率达99.97%,出水pH值3.63.     

十六烷基三甲基氯化铵与荧蒽对小球藻的联合毒性及其作用机制

以普通小球藻(Chlorella vulgaris)为受试生物,采用批量培养方法研究了阳离子表面活性剂十六烷基三甲基氯化铵(CTAC)与多环芳烃荧蒽(Flu)的联合毒性及其作用机制.结果表明,当CTAC初始浓度固定为100μg/L时,随Flu浓度的升高(0~100.84μg/L), CTAC与Flu的联合毒性由协同效应(0~22.50μg/L)转为拮抗效应(22.50~100.84μg/L).当Flu浓度为1.13μg/L时,协同效应达到最大(RI＝2.01),与对照组相比,生物量抑制率从37.5%增加至80.9%;对氮和铁单位吸收量分别从0.27mg和9.18μg降至0.09mg和2.14μg;藻细胞Zeta电位从-10.0mV提高至-8.3mV;叶绿素a和可溶性蛋白质含量分别从5.00mg/L和80.65μg/mg降为2.57mg/L和50.36μg/mg.根据实验结果分析, CTAC与Flu复合污染体系提高了藻细胞Zeta电位,抑制了小球藻对氮和铁的吸收,降低了藻细胞体内叶绿素和蛋白质的含量.     

Thermodynamic investigation of the effect of oxygen and hydrogen chloride potential upon generation and decomposition behavior of dioxins

The thermodynamic equilibrium of the C‐H‐O‐Cl system has been calculated to elucidate the generation and decomposition behavior of dioxins, and is discussed from the viewpoint of the oxygen and hydrogen chloride potential. The dioxins behavior is greatly dependent on the oxygen potential, i.e. higher temperature and oxygen potential lead to the complete decomposition of dioxins, while low hydrogen chloride potential under insufficient oxygen condition leads to an increase of multi‐chlorine displacement of dioxins.     

氯化蒸馏废酸还原回收锗

以锗烟尘氯化蒸馏后的废盐酸为原料,以废铁为还原剂,使废酸中的有价金属锗以还原态沉淀富集在渣中,强化氧化氯化蒸馏回收四氯化锗,锗的综合回收率达94．10％。同时生产净水剂用液体氯化铁产品。     

Optimization of the recovery of plastics for recycling by density media separation cyclones

Material recovery processes are presented as the optimum option for recycling plastic wastes as a means of recovering hydrocarbon resources. There exist a large variety of automated material recovery processes for recycling of such wastes but each with significant limitations. Of these, the separation based on differences in densities is advocated as the optimum process either for producing recycled products or preparing wastes for subsequent recovery processing.Density separation processes based on cyclone type density media separation (DMS) is presented as an important, potential method for increasing plastics recycling process capacities. It is demonstrated to have the capacity to separate a significantly larger range of particle sizes than those presently processed industrially. The mathematical relationship for the prediction of quality of typical LARCODEMS type density media separations by particle size and density as expressed by the Ecart Probable is presented.A proposed device configuration is presented for density media separation to optimize the recovery and purity of both density fractions produced. It is also suggested that to be economically viable, a large scale of operation is required for industrial plastics recycling operations recovering and producing a number of different plastics with a purity to be used as a substitute for virgin material.     

Modelling spills of water-reactive chemicals

This paper describes part of a programme of work undertaken at the Health and Safety Laboratory (HSL) to investigate the behaviour of selected water-reactive chemicals. Following an accidental release, such substances react exothermically with any water present, generating acidic vapours. The STAWaRS (Source Term Assessment of Water Reactive Substances) software was developed for the Health and Safety Executive (HSE) by ESR Technology to model this complex process. The aims of the study described here were to provide experimental validation of the heats of hydrolysis used within STAWaRS, and to perform sensitivity studies on selected STAWaRS input parameters.The heat of hydrolysis of acetyl chloride was measured and showed good correlation with the value used within STAWaRS. Some of the variables that influence the severity of acetyl chloride spills are examined, with reference to predictions made by the STAWaRS model. The heats of hydrolysis of titanium tetrachloride previously measured at HSL are also discussed, and the effect of adopting these experimentally derived values for modelling spills is shown for a hypothetical land use planning case. This study demonstrates the importance of using experimentally validated values for STAWaRS input parameters.     

改性阴极生物电芬顿系统降解罗丹明B

分别采用十八烷基三甲基氯化铵（OATC）和磷酸改性电极并负载铁涂覆在碳布表面,制得Fe/OC-OATC电极和Fe/PC电极用于构建生物电芬顿系统,提高电芬顿技术中H₂O₂的原位生产能力,达到高效降解印染废水的目的.通过极化曲线、功率密度曲线以及循环伏安曲线对2种复合电极的电化学性质进行分析,结果表明,Fe/OC-OATC的电流密度、最大功率密度以及氧还原能力等均优于Fe/PC,最大功率密度为4.89W/m³,相应的电流密度可达22.9A/m³.然后探究了2种复合电极构建的生物电芬顿系统对罗丹明B的降解效果,结果显示,Fe/OC-OATC体系﹥ Fe/PC体系,Fe/OC-OATC体系对罗丹明B的去除率最高达96.4%.最后根据动力学分析和反应机理的研究,分析了2种系统对罗丹明B的降解机理.