酸性废水处理试验研究

精细化工厂生产过程中排放酸性废水,盐化工厂产生碱性盐泥,可用之中和酸性废水。用两种方案确定反应比例关系。经过讨论建议选用方案二为实际应用方案。     

A Bayesian approach to multi-source forest area estimation

In efforts such as land use change monitoring, carbon budgeting, and forecasting ecological conditions and timber supply, there is increasing demand for regional and national data layers depicting forest cover. These data layers must permit small area estimates of forest area and, most importantly, provide associated error estimates. This paper presents a model-based approach for coupling mid-resolution satellite imagery with plot-based forest inventory data to produce estimates of probability of forest and associated error at the pixel-level. The proposed Bayesian hierarchical model provides access to each pixel’s posterior predictive distribution allowing for a highly flexible analysis of pixel and multi-pixel areas of interest. The paper presents a trial using multiple dates of Landsat imagery and USDA Forest Service Forest Inventory and Analysis plot data. The results describe the spatial dependence structure within the trial site, provide pixel and multi-pixel summaries of probability of forest land use, and explore discretization schemes of the posterior predictive distributions to forest and non-forest classes. Model prediction results of a holdout set analysis suggest the proposed model provides high classification accuracy, 88%, for the trial site.

定量RT-PCR检测雌二醇诱导的青鳉鱼基因表达

采用实时定量RT-PCR(Q-RT-PCR)方法,对暴露60d雌二醇的雄性青鳉鱼肝脏内卵黄蛋白原(VTG)和卵壳前体蛋白(CHG)基因表达进行研究.结果表明,0.1,1.0,10.0,100.0ng/L的雌二醇使肝脏内VTG-I,VTG-II,CHG-L和CHG-H基因表达被显著诱导.其中VTG-I显示出较好的剂量—效应关系,是较为理想的生物标记物基因.在0.1ng/L雌二醇暴露组中,VTG-I和VTG-II的表达量均显著高于对照组(P<0.05),表明本方法具有检测环境中低剂量雌二醇暴露的潜力.     

间苯三酚比色法测定微量甲醛研究

研究了用间苯三酚比色定量测定甲醛的方法,确定了显色剂的使用条件。此方法简便、高效、快速、所用试剂种类少,具有较高的准确度和精密度。     

乳化液膜法提取活性艳蓝KN-R工艺研究

利用表面活性剂TH-1、民用煤油、载体N235和内水相NaOH溶液组成的液膜体系,采用正交试验法,对提取活性艳蓝KN-R工艺进行了研究。结果表明:以5%TH-1,5%N235,10%NaOH,油内比Roi为1∶1.5的乳状液膜体系,处理初始浓度为6000mg/L活性艳蓝KN-R废水,在pH值为1,传质温度为25℃,乳水比Rew为1∶5的传质条件下,提取率可达94.8%。     

生物填料塔处理餐厅污水传质反应研究

从传质和生化反应基本过程出发,经合理简化,将复杂的生物填料塔中三相传质生化反应过程综合为一个有效生化反应过程并得到其数学模型。模型中综合参数——总传质有效因数η可通过容易测定的本征反应和实际反应速率来确定;实验研究了不同入塔污水CODCr和入塔水量对η的影响。结果表明：入塔污水CODCr较高时,有较大的孕;当入塔水量增大,传质效果增加η增大。     

颗粒活性炭吸附染料的类分形动力学特征的研究

建立了复杂分子吸附反应时指数h与分形子谱维数ds、分形介质的表面分形维数Ds 的关系式.对吸附动力学数据的模拟表明,不同温度下6种染料在颗粒活性炭表面的吸附过程符合非线性动力学.吸附速率一般随着温度的升高而增加,反应活化能在0 2 0～1 75kJ·mol- 1 之间.上述反应为快速反应.进一步分析表明,该吸附过程具有类分形动力学特征,吸附反应的逐时速率系数k与反应时间t呈指数关系;相应的分形子谱维数ds<2 .随着染料的初始浓度的增加,ds 也随之增加,而h和k0 值通常会随之降低.吸附3种酸性染料时,h和k0 值在本实验的温度范围内均随着温度的升高而增加;其它3种直接性染料也大都呈现h随着温度的升高而增加的趋势.上述吸附反应中有效反应级数x也与ds、Ds 有关,呈现分数反应级数     

Treatment of 2-phenylamino-3-methyl-6-di-n-butylaminofluoran production effluent by combination of biological treatments and Fenton＇s oxidation

High strength refractory organic stream is produced during the production of 2-phenylamino-3-methyl-6-di-n-butylaminofluoran （One Dye Black 2, abbr. ODB 2）, a novel heat-sensitive material with a promising market. In this study, a combination of acidificationprecipitation, primary biological treatment, Fenton＇s oxidation and another biological treatment was successfully used for the removal of COD from 18000-25000 mg/L to below 200 mg/L from the ODB 2 production wastewater in a pilot experiment. A COD removal of 70%-80% was achieved by acidification-precipitation under a pH of 2.5-3.0. The first step biodegradafion permitted an average COD removal of 70% under an hydraulic residence time （HRT） of 30 h. By batch tests, the optimum conditions of Fenton＇s oxidation were acquired as： Fe^2＋ dose 6.0 mmol/L; H2O2 dose 3000 mg/L; and reaction time 6 h. The second step biological treatment could ensure an effluent COD below 200 mg/L under an HRT of 10 h following the Fenton＇s treatment.     

用溶解氧浓度作为SBR法过程和反应时间控制参数

进行了以DO作为SBR法过程和反应时间控制参数的试验研究。结果表明,无论使曝气量或初始污泥浓度大幅度变化,还是逐渐或突然改变初始有机物浓度等各种试验条件,都会在反应阶段开始不久出现所谓平衡DO浓度现象;当有机物达到其难降解浓度时DO浓度迅速地大幅度升高。因此,在目前还没有简易、快速的有机物浓度传感器的情况下,DO不仅可作为反应时间的指示性控制参数,而且也能可靠地作为反应阶段的过程控制参数。     

改性生物炭负载纳米零价铁去除水体中头孢噻肟

抗生素对环境的危害已经引起了人们的广泛重视.本实验以改性生物炭(MB)为载体制备了负载纳米零价铁的功能生物炭(Fe/MB).以头孢噻肟(CFX)为目标抗生素,研究了该材料对头孢噻肟的降解特性及影响因素,并探讨了去除机理.实验结果表明,50 min内头孢噻肟的去除率为92%(Fe/MB用量为0.4 g·L~(-1),溶液p H=5.0,头孢噻肟浓度为20 mg·L~(-1),振荡速率为200 r·min~(-1),柠檬酸浓度为1.47 mmol·L~(-1)).头孢噻肟的去除过程存在改性生物炭的吸附和纳米零价铁还原降解的协同作用,数据符合伪二级反应动力学方程(R20.99).采用紫外可见光谱结合质谱分析了降解产物的结构并提出头孢噻肟的降解途径.