多相催化湿式氧化法处理高浓度难降解有机废水的研究

在高压反应釜内，采用自制颗粒贵金属催化剂催化湿式氧化法处理高浓度饲料抗氧化剂合成废水，探讨了温度、压力、进水pH等反应条件对废水处理效果的影响。在温度为220℃、总压为8MPa条件下，COD，TOC，TN和色度的去除率分别达到77．0％，66．1％，70．2％，91％；处理后的废水pH很低，催化剂显示出较好的耐酸性；随进水pH的增加，COD的去除率逐渐降低，出水pH增加。     

ClO2去除废水中石油类污染物的研究

就如何使用ClO2和O3对水中石油类污染物氧化去除进行了研究，确定了最佳反应时间、pH和氧化剂用量对去除率的影响。ClO2的最佳投加量应为有机物总量的1．5倍，反应时间可控制在20min上。ClO2处理pH5．0～6．5溶液时的去除效果最好。同时进行了O3的对照实验。分析了ClO2和O3在水处理应用中的优缺点。     

The challenges of sustainability in mining regions: The coal mining region of Santa Catarina, Brazil

Throughout history, mining communities have invariably found themselves striving for a good quality of life and a long‐term future. In the 21st century, problems of maintaining the economic vitality of mining regions are now compounded by concerns about the biophysical integrity of the local environment. In regions of the world where the economic viability of the resource is marginal and achieving a reasonable quality of life is a daily struggle, sustainable mining may seem to be a dubious prospect at best. Yet the twin imperatives of global political forces and burgeoning environmental concerns are requiring industry, governments and other interests to re‐conceptualize the way in which mining takes place in communities. Although mining itself may not be seen as an industry that contributes to the achievement of environmental objectives, it could — with careful planning — be used as a tool to foster a more sustainable and healthier community. This argument is considered in the context of the coal mining region of Santa Catarina, Brazil.     

Nitrogen evolution during the co-combustion of hydrothermally treated municipal solid waste and coal in a bubbling fluidized bed

Nitrogen evolution was studied during the co-combustion of hydrothermally treated municipal solid wastes (HT MSW) and coal in a bubbling fluidized bed (BFB). HT MSW blending ratios as 10%, 20% and 30% (wt.%) were selected and tested at 700, 800, 900 °C. Emissions of NO and N₂O from blends were measured and compared with the results of mono-combustion trials. Moreover, concentrations of precursors like NH₃ and HCN were also quantified. The results are summarized as follows: NO emissions were predominant in all the cases, which rose with increasing temperature. The blending of HT MSW contributed to the NO reduction. N₂O emissions decreased with temperature rising and the blending of HT MSW also presented positive effects. At 30% HT MSW addition, both NO and N₂O emissions showed the lowest values (391.85 ppm and 55.33 ppm, respectively at 900 °C). For the precursors, more HCN was detected than NH₃ and both played important roles on the gas side nitrogen evolution.     

不同CDPF贵金属负载量对柴油公交车VOCs组分排放影响

基于重型底盘测功机,利用质子转移反应质谱(PTR-MS)研究了柴油公交车在中国典型城市公交车循环(CCBC)下,不同CDPF贵金属负载量对尾气中挥发性有机物(VOCs)组分排放特性的影响.结果表明,柴油公交车VOCs主要组分为含氧有机物(OVOCs)、芳香烃和烯烃等,且OVOCs占比达50%以上;在贵金属成分、配比相同时,VOCs减排率随CDPF贵金属负载量增加而增加:贵金属负载量为15 g·ft~(-3)(A型后处理装置)、25 g·ft~(-3)(B型)和35 g·ft~(-3)(C型)时,VOCs总量的减排率依次为36.2%、40.1%和41.4%.C型后处理装置对烷烃全循环减排率高达70.2%,且对OVOCs的催化有微弱优势;对于不饱和烃类,3种不同贵金属负载量的后处理装置均有一定催化效果,但无明显差异;A型对含氮有机物减排率可达50.5%,但减排率随贵金属负载量增加而降低.采用DOC+CDPF后能较好地降低公交车VOCs排放量进而降低臭氧生成潜势(OFP).同时考虑不同方案减排效果与成本因素,当加权系数分别为0.8和0.2时,B型为最优方案.     

Fenton法处理竹制品废水生化出水的研究

采用Fenton法对竹制品废水生化出水的脱色和有机物去除进行了研究.在综合考虑经济性和去除效果的基础上,起始COD质量浓度为430 mg·L-1、色度为1 500倍的废水,在反应条件:t=30℃,pH为3.5,ρ(H2O2)=1 665 mg·L-1,c(Fe2+)/c(H2O2)=0.072,反应时间3 h的情况下,Fenton氧化处理后,COD和色度的去除率分别高达87.5%和94.4%.研究发现,色度的去除率要优于有机物(以COD计)的去除率,且受外界因素影响小.GC-MS分析结果表明:经过Fenton处理后,废水中的发色团和助色团基本上完全被去除.中间产物主要是脂类衍生物,副产品有1-碘十三烷和正辛基醚等.     

西安市重污染与清洁天PM2.5组分及其活性氧物质对比

针对重霾污染,在西安市冬季重污染日(2015-11-30~2015-12-09)和清洁日(2016-01-13~2016-01-22)各进行了为期10d的PM_(2.5)采集,测量其中的有机碳、元素碳,及NH_4~+、NO_3~-、SO_4~(2-)等无机水溶性离子,探讨两种污染条件下的组分特征及其成因.结果表明:观测期,重霾日和清洁日PM_(2.5)质量浓度分别为(170±47.5)μg·m~(-3)和(48.6±17.9)μg·m~(-3),且重霾日伴随低能见度、高湿静风等多种不利气象条件;重霾日二次无机离子(NH_4~+、NO_3~-、SO_4~(2-))组分占PM_(2.5)质量浓度的49.8%±13.1%,而清洁日为19.4%±5.95%,并且重霾日硫氧化速率(sulfur oxidation ratio,SOR)和氮氧化速率(nitrogen oxidation ratio,NOR)分别为0.282±0.157和0.269±0.124,远高于清洁日(SOR和NOR分别为0.189±0.057和0.077±0.046),重霾日二次有机组分浓度[(6.22±3.87)μg·m~(-3)]是清洁日[(1.44±1.63)μg·m~(-3)]的5倍,表明二次污染及不利气象条件是造成重霾期间相关组分浓度升高的重要原因.最后,通过二氯荧光黄双乙酸盐(2',7'-DCFH)化学荧光分析法测定了其中活性氧物质(reactive oxygen species,ROS)的浓度,探讨其对于二次无机组分形成的影响,结果表明观测期ROS平均浓度(以H_2O_2计)分别为(4.99±1.54)nmol·m~(-3)(重霾期),(0.492±0.356)nmol·m~(-3)(清洁期),二次反应及积累效应可能是西安重霾条件下ROS浓度升高的主要原因.NO_3~-、SO_4~(2-)与ROS均呈现正相关(P0.05),表明ROS可能通过二次氧化过程参与到二次无机组分形成过程中.     

氯代挥发性有机物CVOCs催化氧化的研究进展

氯代挥发性有机物(CVOCs)因其性质稳定、反应性差且毒性高,成为目前大气污染物净化技术中的难点。催化氧化法是去除CVOCs最有效的方法之一。对CVOCs催化氧化的研究进行综述,列举实例介绍了各类催化剂对常见CVOCs的催化研究现状,对催化性能、催化剂失活、反应机理等方面进行了详细分析,总结出积碳和氯中毒是催化剂失活的两大主要因素,而载体性质、活性组分分散度、水等对催化性能产生很大影响。最后,展望了未来催化剂的研究重点。     

三种流速下高强钢与微弧氧化钛电偶腐蚀研究

目的研究三种流速下微弧氧化钛和高强钢的电偶腐蚀行为。方法在面积比为1:1情况下进行1,3,7 m/s流速下的电化学测试和电偶腐蚀试验研究。结果随着流速的增大,偶合电流、总腐蚀速率和电偶腐蚀速率增大。当流速为7 m/s时,高强钢总腐蚀速率和电偶腐蚀速率分别达到8.64 mm/a和0.39 mm/a,与静态相比分别增大146倍和15.6倍,与1 m/s流速下相比分别增大8.6倍和5倍。结论在面积比为1:1时,冲刷腐蚀速率远大于电偶腐蚀速率。     

工业园区综合难降解废水深度处理实验研究

某工业园区综合废水处理厂设计规模5.0×104m3/d,原设计出水执行《城镇污水处理厂污染物排放标准》(GB 18918-2002)一级B标准,需将出水标准提高到一级A排放标准.分别采用混凝沉淀法和高级氧化法深度处理二级生化出水.小试试验结果表明:二级生化出水CODcr在62~75 mg/L左右,PAC、Al2(SO4)3及PFS三种絮凝沉淀药剂处理出水CODcr去除效果均不明显,不能稳定达到一级A排放标准.芬顿催化氧化的pH=5,FeSO4+H2O2投加量为(200+100)mg/L;臭氧氧化的O3投加量33 mg/L,其出水CODcr均能达到一级A排放标准.