Experimental research into effects of obstacle on methane-coal dust hybrid explosion

An experimental system including pressure transducer, data acquisition card, computer and electric spark ignition device was set up to research methane-coal dust hybrid explosions in closed tubes with different types of obstacles inside. Its dynamic response time was less than a millisecond and the test precision was 0.1%. The experimental results show that the obstacles had great effects on the explosion characteristics in the tube. Hollow obstacles linked with inner wall of the tube induced faster pressure rising than installed center blocked solid obstacles. Obstacles with more sharp corner induce more violent explosions. The most dangerous explosion occurred when spacing between obstacles almost equaled the inner diameter of the tube for the same size obstacle.     

干燥条件下高硫煤低温氧化特性研究

为进一步揭示不同环境条件下高硫煤的低温氧化特性,选取含硫量较低、自燃倾向性较高的褐煤,向其添加不同比例的FeS2,配制成含量分别为3%,5%,7%的混合高硫煤样,利用中国矿业大学自行研制的煤氧化模拟试验系统,测试分析干燥混合煤样在低温氧化过程中,交叉温度和指标气体CO产生量体积的变化。试验结果表明,在低温干燥的条件下,随着FeS2含量的增加,煤样的氧化特性受到抑制:交叉点温度升高;指标气体CO产生量在相同温度时体积降低。因此,在高硫煤层自燃火灾防治过程中,应尽量控制煤层周围环境的干燥度。     

理化因素对锰细菌Arthrobacter chlorophenolicus MN1409氧化Mn2+的影响

Arthrobacter chlorophenolicus MN1409是1株分离自锰矿样品的高效锰氧化细菌。为了建立该菌株氧化Mn2+的适宜条件,研究了接种量、装液量、摇床转速、温度、pH值、Fe2+初始质量浓度和Mn2+初始质量浓度等理化因素对其锰氧化效率的影响。结果表明,接种量、装液量、转速和Mn2+初始质量浓度在一定范围内变化对锰氧化率影响不大;而温度、pH值和Fe2+初始质量浓度变化对锰氧化率有较大影响。当接种量为4%,装液量为60 mL,温度为25℃,摇床转速为100r/min,pH值为7,且有一定的Fe2+存在时,Arthrobacter chlorophenolicusMN1409对锰的氧化效率最高。     

高铁酸盐对藻类肝毒素的降解

研究高铁酸盐对悦目颤藻(Oscillatoria amoena)肝毒素(Microcystin-LR)的降解效能及其与pH的关系. 结果表明,处理有机质含量很高的藻类肝毒素粗提液,当高铁投加量增到40mg/L,pH控制在6～10,肝毒素几乎被完全降解.同时高铁的还原产物Fe³⁺、Fe(OH)₃发挥其助凝、絮凝的作用,对水体中有机质吸附沉降去除,TOC去除率达到50%左右,铁几乎无残留.高效液相色谱分析发现,作用机制可能是高铁氧化或异构化Adda基团的共轭双键,使Adda基团的结构发生变化,从而降低其毒性.     

Collecting representative dust samples: A comparison of various sampling methods in underground coal mines

Former methods used in the U.S. to assess hazardous and explosible coal dust date back to the 1950s. As mining technologies advanced, so too have the hazards. Given the results of the recent coal dust particle size survey and full-scale experimental mine explosion tests, the National Institute for Occupational Safety and Health (NIOSH) recommended a new minimum standard, in the absence of background methane, of 80% total incombustible content (TIC) be required in the intake airways of bituminous coal mines, replacing the previous 65% TIC requirement. Most important to monitoring and maintaining the 80% TIC is the ability to effectively collect and analyze representative dust samples that would likely disperse and participate in dust explosion propagation. Research has shown that dust suspended on elevated surfaces is usually finer, more reactive, and more readily dispersible while floor deposits of dust are generally coarser and more difficult to disperse given the same blast of air. The roof, rib, and floor portions of the dust samples were collected and analyzed for incombustible content separately and the results were compared to a band sample of the roof, rib, and floor components. Results indicate that the roof and rib dust samples should be kept separate from floor dust samples and considered individually for analyses. The various experimental collection methods are detailed along with preferred sampling approaches that improve the detectability of potentially hazardous accumulations of explosible dust.     

Sources of underground CO: Crushing and ambient temperature oxidation of coal

As a harmful gas in underground coal mine, CO seriously threatened the safety of miners. Currently, the spontaneous combustion of residual coal in goaf is generally considered as the main source of underground CO. CO gas is also widely used as an indicator gas in fire prediction in mines. However, high concentrations of CO are also detected in some mines without spontaneous combustion of coal. Therefore, in the paper, with four ranks of coal, we studied other two potential CO sources: crushing and oxidation at ambient temperature. The more completely crushed coal produces more CO. The concentration of generated CO is inversely proportional to moisture content in coal. Therefore, the addition of water can inhibit the generation process of CO during the crushing process of coal. Lignite with low metamorphic grade can be oxidized to produce CO at ambient temperature (25 °C), and anthracite with high coal rank can be only oxidized to produce CO at 60 °C. Infrared spectra indicated that the coal with rich aliphatic hydrocarbons and oxygen-containing functional groups are more susceptible to oxidation at room temperature. Moreover, the smaller particle size of coal is more beneficial to the oxidation at ambient temperature to generate CO. CO generation during coal oxidation is also closely related to the ventilation rate.     

金属负载活性炭催化氧化法处理ZPT生产废水

研究了金属负载活性炭催化剂在常温常压下催化氧化处理吡啶硫酮锌(ZPT)废水的技术，在探讨影响催化氧化效果诸因素的基础上，确定出中和预处理、后接两级催化氧化处理该废水的工艺流程，该流程的COD的去除率最高可达92％，处理出水达到国家污水综合排放标准二级指标。     

液相催化氧化吸收烟气中SO_2的研究

本文报告了水溶液催化氧化吸收烟气中的SO_2对各种因素,包括催化剂浓度和种类、反应温度、SO_2浓度和烟气流量,以及烟气中氧气含量和反应后溶液中SO_3~(2-)和SO_4(2-)浓度与催化剂浓度的定量关系进行了研究。当催化剂浓度为0.05mol/l,SO_2浓度1000—2000ppm,温度25℃时,SO_2吸收率85％以上。并初步讨论了液相催化氧化吸收SO_2反应机理。     

催化剂对甲醛废水湿式氧化的增效作用

在设定的湿式氧化条件下 ,从若干种金属盐中筛选了Cu(NO3) 2 作为氧化甲醛废水的催化剂 ,考察了Cu(NO3) 2 用量、废水的初始浓度及温度对有机物去除率的影响 ,结果表明 :Cu(NO3) 2 以 5mg·l- 1 Cu2 计量投加为宜 ,甲醛初始浓度在 480mg·l- 1 — 1 5 0 0mg·l- 1 范围内一直保持较高的去除率 ,反应的适宜温度为 1 40℃以上 ;根据反应过程数据建立了该催化氧化反应的分段一级动力学模型 ,求得甲醛氧化动力学模型快、慢步骤的表观活化能分别为7 2 9kJ·mol- 1 和 1 4 45kJ·mol- 1 ;而COD降解动力学模型快、慢步骤的表观活化能则分别为2 0 47kJ·mol- 1 和 2 9 5 2kJ·mol- 1 .     

衍生化气相色谱法测定黄磷诱发氧化水中苯酚降解产物

利用衍生化气相色谱法对黄磷诱发氧化苯酚降解产物进行了研究，在磷酸存在下，以甲醇作酯类衍行生试剂，分别和ＳＥ－５２和ＨＰ－１７石英毛细管双柱结合ＧＣ－ＭＳ进行分离定性定量，黄磷诱发氧化苯酚降解产物以羧酸为主，在反应温度５０℃时，表现为一级反应特征，速率常数（Ｋ）：０．０７７ｍｉｎ＾－１，半衰期（ｔ１／２）：９．０ｍｉｎ。