Technologically enhanced 210Pb and 210Po in iron and steel industry

Iron and steel manufacture has been ranked as the largest industrial source of environmental contamination in the USA; the wastes generated in their production processes contain heavy elements that can be a source of contamination, and natural radionuclides that can produce an occupational and/or public radiological impact. In this work the potential occupational effective dose rate (μSv/y) due to inhalation in four integrated steel-making factories from Egypt has been evaluated, by assuming a well defined scenario and with basis in the ²¹⁰Pb and ²¹⁰Po activity concentrations determined in ore and wastes collected in the aforementioned factories. Activity concentrations, in Bq/kg, of ²¹⁰Pb and ²¹⁰Po, and leachable Pb and Fe were measured using gamma-ray spectrometry based on HPGe detector, alpha particle spectrometry based on PIPS detector, and inductively coupled plasma-mass spectrometry (ICP-MS). Levels of ²¹⁰Pb and ²¹⁰Po in the range of <DL-4238 and 1-5660 Bq/kg, respectively, were found. According to the assumed scenarios, the occupational exposures by inhalation are much lower than the recommended annual effective dose limit, although the environmental impact due to waste storage and/or use should be considered based on case by case evaluation.     

X70钢在碳酸氢钠溶液中的腐蚀行为研究

通过电化学试验方法对X70钢在NaHCO3溶液中的腐蚀行为进行了研究.实验结果表明,当NaHCO3质量分数低于0.10%时,极化曲线呈现阳极活化溶解过程,高于0.10%时阳极极化出现钝化过程,并且在-0.6 V(vs.SCE)左右出现了一个新的小电流峰.通过对交流阻抗谱分析发现,高频区均是由略偏离半圆的容抗弧组成,并且实部有所收缩.HCO3-的还原反应在阴极过程中起主要作用,整个过程受极化控制.X70钢在NaHCO3溶液中的腐蚀速度随着NaHCO3质量分数的增大而增大,在试验结束后,对试样表面的腐蚀形貌进行了观察,并利用XRD分析出腐蚀产物主要为FeO(OH)和Fe3O4.     

汽车镀锌板泥浆附着研究初探

介绍了镀锌板在大气和土壤中的研究结果;简要讨论了镀锌板通常出现的腐蚀形式;分析了镀锌板在泥浆状态中的腐蚀状况.其腐蚀是大气与土壤腐蚀的一个衔接过程,影响因素很多,可控性差.针对汽车板泥浆附着的腐蚀问题,设计了一种简化的研究模型,尝试性地做了一些实验室的研究,提出了几种可行的研究方法.     

神经网络在海水腐蚀预测中的应用

根据我国材料自然环境腐蚀网站长期以来积累的海水腐蚀数据,采用BP人工神经网络算法,建立了碳钢及低合金钢的海水腐蚀预测模型.该模型以合金成分、环境因素为输入参数,以平均腐蚀速率为输出参数.以碳钢、低合金钢的17种钢种在青岛、厦门、榆林海水腐蚀试验站16年腐蚀数据建模.选定A3钢与10CrCuSiV在以上三地16年的腐蚀数据为验证样本.结果表明该网络具有良好的预测精度,能够正确反映海水环境腐蚀性因素及金属材料腐蚀暴露时间与其腐蚀速率的关系,用于碳钢及低合金钢在海洋全浸环境中的腐蚀预测.     

SO2在碳钢初期大气腐蚀中的作用

通过自建的模拟大气腐蚀系统,借助金相显微镜、扫描电镜(SEM/EDX)、X-射线衍射(XRD)和x-射线光电子能谱(XPS),研究了SO2对碳钢初期大气腐蚀行为的影响,并进一步用原子力显微镜从更微观的角度观察了在SO2环境中初期阶段腐蚀形貌变化.研究结果表明:在SO2污染大气环境中,随SO2浓度的升高碳钢腐蚀加快.在体积分数为5×10(-6)SO2的大气环境中,碳钢和耐候钢表面腐蚀主要以条状物生长,随着SO2浓度的升高,腐蚀产物的形貌发生改变,在体积分数为5×10(-5)SO2的大气环境中,条状锈和胞状锈同时生长.在锈层中S元素以FeSO4·4H2O的形式存在,腐蚀产物中还有γ-FeOOH.SO2在初期阶段加速了碳钢的腐蚀,降低了碳钢的耐蚀性.     

湖北省某钢铁厂工业区及周边铅污染调查

为了解湖北省某钢铁厂周边铅污染的现状,通过对钢铁厂工业区及其周边乡村的土壤、蔬菜、居民体内和排污渠污泥中铅元素含量的研究,其结果表明:钢铁厂周围的土壤、蔬菜、居民均受到了一定程度的铅等重金属元素的污染,其含量高于国家标准或正常范围;钢铁厂工业区周边土壤铅污染主要由于工业废气(烟尘)扩散沉降和废水灌溉引起;污染区人体尿样中铅元素含量(116～160 ng/mL)普遍超标,头发样(2.09～12.04 μg/g)基本正常,尿样比头发样更能显示铅等重金属元素在人体内的分布特征.     

塑烧管除尘器在冶金精轧线的应用

冶金精轧线烟气烟尘含油含水，采用传统的布袋除尘等方式难以治理。塑烧管具有刚性结构、高过滤效率、压降稳定、疏水疏油性、防静电等特性，适合于治理含油含水的烟气。塑烧管除尘器在冶金精轧线的应用取得了良好的效果。     

DESIGN OF DESALTING PLANTS FOR CONJUNCTIVE OPERATION1

ABSTRACT The selection of an evaporator design must reflect the balancing of captial cost (primarily in heat exchanger surface and vessels) against operating cost (primarily steam cost) to achieve minimum cost. In a conjunctive plant the tendency is to select a low-capital cost, high-operating cost plant. In addition, it is advantageous to use a high-capacity plant which needs to be operated much less of the time than a plant which is sized just at the needed rate. For example, in the study of a possible system to satisfy a future increase of 450 MGD in water supply to New York Qty, a plant of 750 MGD capacity was selected as optimum. This plant, of the advanced VTE-MSF process type, would have a performance ratio of 9 lb product/1000 Btu as compared to 10-13 normally used for base-loaded plants. Steam would be supplied by a multi-unit dual-purpose nuclear power plant. The most economical type of energy supply would be “interruptible”; the steam would be used by a low pressure turbine to generate electricity during periods of peak electrical demand but would be available to the desalting plant at other times. The low pressure turbine would be available as spinning reserve during desalting plant operation. It is estimated that the desalting plant would have a load factor of 27 per cent over its life.     

高喷灌浆加固抛石填海软基

高压旋喷灌浆法是本世纪７０ 年代发展起来的地基处理新技术,在砂性土和粘性土等软弱地层加固工程中已得到广泛应用,但在含有碎石的淤泥质土及穿过它对其下淤泥的加固尚少见,笔者简要介绍了采用钻灌分开两大工序的新双管法及其成功完成加固任务的事例。