电解Fenton法处理生活垃圾焚烧厂渗滤液的动力学研究

采用三元电极,对垃圾焚烧厂渗滤液的生化-混凝出水进行了电解Fenton法处理COD反应动力学研究.结果表明:电解Fenton反应的COD降解曲线符合拟三级反应动力学,t时间的COD出水浓度可表示为:c_t=(2kt+c₀^-2)^-0.5.通过对不同工艺条件下电解Fenton法对渗滤液的COD降解曲线的统计分析,得出以电流密度、pH值、进水COD浓度为影响因子的k值经验模型.并将动力学模拟的COD出水值与实际运行的测量值进行比较,认为该模型可以较好地模拟电解Fenton法进行垃圾焚烧厂渗滤液后续处理的效果.     

膜生物反应器水力停留时间的确定及其影响因素分析

根据微生物反应动力学模型,推导了分离式膜生物反应器水力停留时间公式,并以此公式为基础,分析与探了膜生物反应器的影响因素。分析结果表明,对膜生物反应器影响程度由大到小的因素为底物最大比降解速度常数Ｋ,饱和常数Ｋｓ,维持常数ｍ,真产率系数ＹＧ,最大比增殖速率μｍ,最后简化了水力停留时间公式,其简化形式为：Ｔ＝１．１×（１／β－１）（Ｋｓ＋Ｌ）／ＫＳ。     

动力学光度法测定环境样品中微量钒

本文研究了V(Ⅳ)对Cr_2O_7~(2-)-I~--淀粉氧化还原反应体系的诱导作用,以此为基础提出了一种测定微量钒的动力学新方法,并建立了测定最佳条件:[Cr_2O_7~(2-)]=8.4×10~(-5)mol·L~(-1),[I~-]=2.1×10~(-3)mol·L~(-1),pH=2.1,585nm。在此条件下,钒(Ⅳ)含量在0—6.6μg·ml~(-1)范围内符合比尔定律,方法检测限为0.02μgV(IV)·ml~(-1)。除Fe~(3+),Fe~(2+),Sn~(2+),Ti~(3+)外,其它共存离子不影响测定。用本方法测定了几种环境样品中的微量钒,结果满意,标准加入回收率为95.1—98.3％。     

高分子除氯剂对水中氯离子的吸附机理

采用高分子除氯剂吸附水中的氯离子,考察了除氯剂投加量、反应时间、反应温度、竞争离子等对氯离子去除率的影响。实验结果表明:随着除氯剂投加量增加,氯离子去除率不断提高;吸附动力学符合拟二级动力学模型,表明化学吸附可能是氯离子吸附过程的速率控制步骤;Elovich模型表明除氯剂表面吸附的氯离子存在非均相扩散的吸附-脱附过程;Freundlich等温吸附模型能更好地描述吸附过程,结合热力学计算表明该过程是一个自发进行的吸热熵增的化学吸附过程,温度越高自发程度越大。     

Trends in Raindrop Kinetic Energy with Modeled Climate Warming in the Lake Tahoe Basin

Two means by which climate change may increase surface soil erosion in mountainous terrain are: (1) increasing the frequency of extreme rainfall events and (2) decreasing the duration of snow cover on bare soil. We used output from four general circulation models (GCMs) and two greenhouse gas trajectories to produce a suite of hydrologic variables at a daily time‐step for historic and projected 21st Century conditions. We statistically disaggregated the daily rainfall to hourly, using hourly rainfall from a network of nine weather stations in the Tahoe Basin, and filtered out rain falling on a snowpack. We applied published equations to convert hourly intensity to raindrop kinetic energy (KE) for each day and grid cell in the Basin, averaged across grid cells, and created time series of total annual and maximum annual hourly kinetic energy (TKE and MKE) on snow‐free ground. Using the Generalized Extreme Value distribution, we calculated the significance of long‐term trends in KE on snow‐free ground, and estimated energy levels for return periods of 2, 20, and 100 years. We then detrended the snowpack data and compared the resulting trends in KE with the trends resulting from changes in both rainfall energy and snowpack under two GCMs. Principal findings include (1) upward trends in MKE, (2) stronger upward trends in TKE; and (3) an effect of increasing rainfall intensities on KE in some cases, and a strong effect of reduced snowpack in all cases examined.     

煤低温氧化热解的热分析实验研究

在热分析动力学的基础上,对阳泉煤样运用同步热分析仪进行150℃下的氧化以及热解实验,得出该煤样相应的TG-DSC曲线。通过两者的TG-DSC曲线,对比分析煤样的热量释放情况,并结合曲线设定多项式形式的机理函数以分析其动力学特性。实验研究得出:该煤的低温氧化过程较之热解过程是个明显的氧化放热过程;该煤低温氧化和热解过程的最佳机理函数都为多项式,并且相应过程中的TG曲线和DSC曲线适用于同一个机理函数,这与一般所定义的机理函数不同;热解过程较之氧化过程所需的表观活化能较大,相同条件下较易发生煤的氧化自燃。     

微乳液增敏罗丹明B氧化褪色光度法测定微量亚硝酸根

基于微乳液对亚硝酸根催化溴酸钾氧化罗丹明B褪色反应具有增敏作用的原理,建立了催化动力学光度法测定痕量亚硝酸根的新方法。实验结果表明：该方法的最佳反应条件为1×10^-4 mol/L的罗丹明B溶液加入量0.60 mL,1 mol/L的稀磷酸加入量1.50 mL,0.1 mol/mL的溴酸钾溶液0.50 mL,反应温度20 ℃,反应时间15 min;对亚硝酸根测定的线性范围为ρ（NO₂^-）= 0.048~0.800 μg/mL,检出限为0.003 0 μg/mL;加入微乳液后催化反应的灵敏度增大了3倍。     

船舶垃圾燃烧失重特性研究

在不同升温速率和不同O2气氛下对船舶垃圾(CSW)的燃烧特性进行热重分析,并使用不同方法对其进行动力学参数求解。根据船用焚烧炉的特点,选择温度范围为100~1 100℃,结果表明:CSW燃烬物较少,只有6.02%(质量分数);根据微分热重(DTG)曲线,燃烧的温度区间分为3段,其中在200~600℃反应基本完成,在600~800℃反应的物质较少。CSW在气氛O2/N2(体积比)=30∶70下的燃烧性能是3种气氛中最好的。在气氛O2/N2=30∶70下,通过FWO法计算得CSW的平均活化能为162.588kJ/mol,通过KAS法计算得CSW的平均活化能为160.677kJ/mol。     

MnO2催化Fenton试剂降解苯酚废水

实验对MnO2催化Fenton试剂氧化高浓度苯酚废水的动力学特性和去除效果进行了研究。结果表明,MnO2可以提高Fenton试剂体系对苯酚的降解率以及COD的去除率;Fenton试剂以及MnO2催化Fenton试剂氧化苯酚废水体系中苯酚的降解都符合拟一级动力学模型。在MnO2催化Fenton试剂氧化体系中,苯酚的降解速率常数有明显提高,反应活化能也有所降低,说明MnO2的加入可以使反应容易进行。废水降解前后紫外可见吸收光谱和红外谱图表明,Fenton试剂法将苯酚可能降解为羧酸、烯烃等有机物中间体。     

Residues behavior of some fungicides applied on two greenhouse tomato varieties different in shape and weight

The degradation of 12 fungicides (azoxystrobin, cymoxanil, cyproconazole, cyprodinil, fenarimol, fludioxonil, iprovalicarb, mepanipyrim, penconazole, pyrimethanil, tolclofos-methyl, triadimenol), commonly used in pest management strategies on Sardinian greenhouse tomato crops was studied. A different residue behaviour was observed between the studied cultivar. On the smaller, a “cherry” type tomato, field data showed an initial residue mostly higher than the “beefsteak” tomato. In any case, except for penconazole, all pesticide residues were below their maximum residue levels (MRLs) reaching the pre-harvest interval (PHI). On both cultivar, triadimenol and cymoxanil residues completely disappeared reaching their PHI, while iprovalicarb, fenarimol, and fludioxonil disappeared in a time of 17 to 24 days. On the contrary, azoxystrobin, cyproconazole, cyprodinil, penconazole, tolclofos-methyl, mepanipyrim, and pyrimethanil showed a long persistence on both tested cultivar and may have residual problems due to an accumulation effect if repeated field treatments will be performed. The first group of molecules according to their rapid degradation could be used in low pesticide-input management in order to obtain tomatoes with low or no detectable residues.