干硝化好氧颗粒污泥对Pb2+的吸附特性与机理

硝化好氧颗粒污泥具有孔隙率高、比表面积大、沉淀性能好等特征,为考察其在重金属废水处理中的应用效果,以干硝化好氧颗粒污泥为吸附剂,研究其对水溶液中Pb2+的吸附特性及影响因素. 结果表明,Langmuir等温吸附方程可以很好地拟合干硝化好氧颗粒污泥对Pb2+的吸附过程,说明Pb2+在干硝化好氧颗粒上的吸附属于单分子层吸附,25 ℃下的饱和吸附容量为79.58 mg/g,R2为0.990 1. 吸附动力学分析结果表明,该动态吸附平衡过程遵循伪二级动力学方程,废水初始ρ(Pb2+)分别为20、40、60 mg/L时,R2分别为1.000 0、1.000 0、0.999 9,同时颗粒内扩散方程RC(关联系数,分别为30.706%、28.019%、24.188%)均低于50%,表明颗粒内扩散是控制Pb2+吸附速率的关键步骤. 红外扫描分析(FTIR)结果表明,吸附过程中Pb2+主要与干硝化好氧颗粒污泥表面的O—H、N—H、CO、CC、C—OH、C—O—C等基团发生了作用. 吸附前、后的pH_ZCP(零点电荷)由2.5升至3.1,说明Pb2+在干硝化好氧颗粒污泥上的吸附属于专性吸附,即发生了紧密层吸附. 研究显示,干硝化好氧颗粒污泥对Pb2+具有较好的吸附效果,吸附机制主要包括无机微沉淀、表面络合、内层络合反应和离子交换等.      

SNAD生物膜厌氧氨氧化活性的氨氮抑制动力学研究

通过批试实验研究了氨氮浓度对SNAD生物膜厌氧氨氧化性能的影响.SNAD生物膜反应器以生活污水为进水.进水NH₄⁺-N和COD浓度平均值分别为70mg/L和180mg/L,出水NH₄⁺-N,NO₂^--N,NO₃^--N和COD浓度平均值分别为2mg/L,2mg/L,7mg/L和50mg/L.SNAD生物膜具有良好的厌氧氨氧化活性.初始NH₄⁺-N和NO₂^--N浓度都为70mg/L时,厌氧氨氧化批试NH₄⁺-N、NO₂^--N和TIN去除速率分别为0.121kg N/（kg VSS·d）,0.180kg N/（kg VSS·d）和0.267kg N/（kg VSS·d）.采用Haldane模型可以很好的拟合氨氮浓度对厌氧氨氧化活性的影响.在高FA和低FA工况下氨氮浓度对厌氧氨氧化活性的抑制动力学常数相差不大.M1（FA浓度为0.7~20.4mg/L）和M2（FA浓度为6.3~190.5mg/L）的最大NO₂^--N理论去除速率r_max分别为0.209kg N/（kg VSS·d）和0.221kg N/（kg VSS·d）,氨氮半饱和常数Ks分别为9.5mg/L和6.1mg/L,氨氮自身抑制常数K_I分别为422mg/L和597mg/L.氨氮（而不是游离氨）对SNAD生物膜的厌氧氨氧化活性起主要抑制作用.     

不同结构主扇扩散器局部阻力研究

在大主扇通风系统中多采用低压大流量风机,在风机出风段多安装扩散器,主要作用是降低出口动压提高风机静压而达到回收出风口断面动能的效果。重点分析风流在流经不同结构扩散器时的流场以及出口的动能损失,叙述了紊流过程中产生阻力的原因,实验测定风流在扩散器后的静压和出口断面的速度。通过数值模拟和实验证明:流线型扩散器局部阻力较小,且具有较高的动能回收率和扩散器效率。结果表明此内容研究对研究扩散器的最优设计参数和通风节能具有一定的指导作用。     

A numerical study of the auto-ignition temperatures of CH4–Air,C3H8–Air,CH4–C3H8–Air and CH4–CO2–Air mixtures

The auto-ignition temperature (AIT) is an important parameter in the process industries. In order to ensure a safe working environment in process industries, it is important to predict the AIT of combustible gases or vapors. In this study, the AITs of natural gas mixtures (CH₄–Air, C₃H₈–Air, CH₄–C₃H₈–Air and CH₄–CO₂–Air) are calculated based on a detailed kinetic model. To create a more practical model, different ignition criteria and convective heat transfer coefficients are investigated and compared against one another, resulting in the temperature criterion and a convective heat transfer coefficient of h = 50 W/(m² K). The results showed that the AITs of CH₄–Air and C₃H₈–Air decrease with an increase of equivalence ratios. While the propane ratio increasing, the AIT of CH₄–C₃H₈–Air decreasing. Reaction path analysis of natural gas mixtures (CH₄–C₃H₈) was also carried out to explain this phenomenon, yielding results showing that C₃H₈ is the main reaction during the ignition induction period. In addition the AIT of CH₄ increases slowly in positive correlation with CO_2, which plays a role of an inert gas. Comparing the results with literature work revealed a deviation of about 10%. Thus, it can be reasonably concluded that the AIT of a low hydrocarbons mixtures such as natural gas can be reliably predicted with detailed kinetic model.     

硝酸铵与硝铵磷热稳定性对比研究

为了研究硝铵磷的热稳定性,用DSC－TG同步热分析仪测试了硝酸铵的热分解过程,根据升温速率分别为5,10,15 K／min的DSC和TG－DTG曲线,利用Ozawa法和Kissinger法求得的硝酸铵的活化能基本一致。用Rogers公式和Arrhenius公式求得指前因子和速率常数分别为1．62×1010 s－1,1．07×10－18 s－1（120℃）;硝酸铵在升温速率为5 K／min时,分解峰值温度的活化焓、活化熵、活化自由能分别为102．76 kJ／mol ,－62．35 J／（K·mol ）,134．98 kJ／mol;对比了硝酸铵和硝铵磷的DSC曲线,结果表明硝铵磷的吸热分解峰值温度低于硝酸铵,热稳定性更好。     

辣根过氧化物酶处理酚和氯酚的催化特性研究

为了研究辣根过氧化物酶处理酚和氯酚的动力学过程,采用人工配不试验,测定了ｐＨ对酶催化反应的影响,Ｈ２Ｏ２抑制酶催化反应的动力学参数和不同度物的酶催化反应动力学参数,结果表明,在试验的ｐＨ范围内,ｐＨ为９时过氧化物酶对苯酚和对氯苯酚的去除效率最高,分别达到９９．５％和９５％。     

几种低分子量有机酸对红壤中DDTs类物质释放动力学的影响

采用自行设计的动力学试验装置,系统研究了3种低分子量有机酸(草酸、酒石酸和柠檬酸)和水对红壤中滴滴涕(DDTs)类物质的释放动力学行为.结果表明:10 mmol/L的低分子量有机酸可使DDTs类物质的释放百分率相对于水提高15～18个百分点,特别在淋洗液的前250mL更为明显.水对DDTs类物质的释放动力学数据可用表观一级动力学方程很好拟合(R²>0.99,p<0.000 1),说明DDTs的释放可能以土壤矿物表面扩散为主,而有机酸存在体系中的该类物质的释放却更好符合抛物线方程、双常数方程,说明低分子量有机酸的存在使DDTs的释放机理复杂化,这可能与有机酸对矿物的溶解、对矿物表面固有有机质结构的干扰有关.     

诱导动力学光度法测定废水中微量砷

依据As(Ⅲ)对Cr(Ⅵ)-Fe(phen)_3~(2+)氧化还原反应在酸性条件下的诱导作用,提出了一种测定微量砷的动力学方法.并建立了测定最佳条件:[Cr(Ⅵ)]=3.2×10~(-4)mol/L;[Fe~(2+)]=1.2×10~(-4)mol/L;[phen]/[Fe~(2+)=5.6;pH=1.2;512nm.线性范围为0-3.0μg/ml As(Ⅲ),方法检测限为0.01μg/ml.除S~(2-)外,多数常见离子均有较大允许共存量.用本法测定工业废水中的微量砷,所得结果满意.样品加标回收率为95.8％—103.3％,变异系数RSD<4.64％.     

复合自养反硝化材料处理低碳氮比硝酸盐污水

作为一种典型的硝酸盐污水,低碳氮比硝酸盐污水的存在具有广泛性,且对生态环境和居民健康带来的危害日益突出.本研究构建了复合硫自养反硝化(CSAD)体系,基于硫-碳酸钙型复合材料与微生物,进行低碳氮比硝酸盐污水的深度处理,分析了材料投加量、粒径以及进水硝酸盐浓度对CSAD的影响,并探究了硝酸盐去除的动力学行为.结果 表明,...     

Performance and modeling studies of rotating biological contactor for treatment of vegetable oil wastewater

This study focuses on a lab-scale rotating biological contactor (RBC) treating vegetable oil wastewater with high BOD and COD. The fabricated RBC was checked for efficiency in degrading polluted wastewater under different operating conditions. The maximum removal efficiencies for BOD and COD were 95.75% and 89%, respectively. This high removal percentage was obtained with 30% submergence of 10 discs rotating at 8 rpm. For the first time, bio-kinetic models were applied to the experimental results for vegetable oil wastewater. The best fit was obtained with the modified Stover-Kincannon and Grau model. The saturation constant (K_s) values were 1.872 and 3.024 g/L/d for BOD and COD, respectively, for the modified Stover-Kincannon and Grau model. For the Grau second-order model, the saturation constant was 1.416 and 3.744 g/L/d for BOD and COD, respectively. The predicted effluent BOD and COD values of the modified Stover–Kincannon model fitted almost exactly with the experimental values. This clearly predicts that this model can be best used to predict effluent BOD and COD concentration in a Rotating Biological contactor treating vegetable oil wastewater. The kinetic parameters determined in this study can be used to improve the design and operation of continuous mode RBC systems.