汶川地震灾区小流域洪水计算方法初探

汶川地震灾区小流域山洪不仅造成巨大损失,同时也是泥石流等灾害的激发因素,探寻一种准确且可操作的洪水峰值流量计算方法对防灾减灾具有重要意义。本文选择不同产流和汇流计算方法,组合成不同水文模型,进行小流域洪水过程计算,对模拟结果和参数选择进行对比,旨在探究最适合该地区的小流域水文计算方法。分别选择SCS曲线法、Green-Ampt入渗法、初损稳渗法进行坡面产流计算,应用SCS单位线法、Snyder单位线法和运动波方程进行坡面和沟道汇流计算,组合成5种小流域产汇流计算模型,利用6场洪水进行参数率定和结果验证。模拟结果对比分析,得出SCS曲线法是最适宜的产流模型,其与SCS单位线、运动波汇流计算方法组合而成的SCS和SKK模型,峰现时间的模拟误差最小,在0~25 min之间;洪峰流量模拟的相对误差较小,平均误差不超过4%;洪水总量模拟误差在10%左右。另外,这两种模型参数设置及确定较简单,更适合在数据稀缺的小流域中进行洪水模拟应用。研究可为汶川地震灾区小流域山洪和泥石流等灾害的流量估算提供方法和参数借鉴。     

沿面放电氧活性物质注入协同SCR脱除烟气中NO_x

为了提高选择性催化还原(SCR)在低温区(200℃)的脱硝性能,提出利用插在烟道中的沿面放电反应器生成氧活性物质,部分氧化NO以实现低温快速SCR脱硝过程.同时,研究了氧活性物质注入实现快速SCR的脱硝性能,考察了氧活性物质注入降低二氧化硫和水蒸汽对SCR反应的影响.实验结果表明:在模拟烟气温度为150℃时,采用氧活性物质注入,部分氧化烟气中的NO以实现快速SCR反应条件下(NO/NO2浓度比为1),脱硝效率为51.9%,比标准SCR提升23%;当模拟烟气中存在SO2或H2O时,氧活性物质注入可有效降低SO2、H2O对SCR脱硝效率的影响.     

介质阻挡放电对氯苯的降解特性及其产物分析

鉴于生物法对难生物降解性、低水溶性的VOCs去除效果不佳,因此开发高效的前处理技术来提高生物法的净化能力已成为新的热点.本实验以生物可降解性差的氯苯为目标污染物,以介质阻挡放电低温等离子体(DBD)为生物法的前处理技术,通过调节DBD反应器的工艺参数,研究其对氯苯的降解效果,考察了进气浓度、停留时间、湿度、峰值电压等因素对去除率的影响,并对尾气进行初步分析.结果表明,DBD能有效去除氯苯废气,氯苯去除率随峰值电压的升高而增大;当电压≥12k V时,停留时间对氯苯的降解影响较小;65%~75%为氯苯降解的最佳湿度范围.通过产物分析,发现产物的种类和浓度随着放电电压的升高而增多增大,主要是以有机酸类和氯代烃为主.产物的水溶性较好;可生化性随着电压升高而增强;随电压升高,小球藻受到的生长抑制作用越来越小,当电压达到20k V时,反而有促进作用.降解过程中产生的O3量随着电压的升高而增多,并且在同一电压下臭氧产生量随着湿度的增大而增多.     

浙江省农村生活污水处理现状及其对策

基于浙江省67个县的农村生活污水处理设施的问卷调查结果,统计分析浙江农村生活污水处理设施现状,包括动力情况、处理工艺、执行标准、运维模式、经费来源等,并探讨分析了农村生活污水处理设施排放标准及运维管理的长效性.结果表明:目前浙江农村生活污水处理设施以中小规模(30～60 t·d-1)为主,约80％的设施采用了无动力厌氧+人工湿地处理技术,出水一般执行GB 18918-2002《城镇污水处理厂污染物排放标准》中的一级B标准,以村镇自管的运维模式为主,年均运维成本为1.3万元·座-1.从省级管理层面应加快制订符合浙江省情的农村生活污水处理设施排放标准,其指标项目数量不宜过多,指标限值可略宽于GB 18918-2002中的一级A标准;并应尽快形成针对责任主体、资金保障、第三方运维的农村生活污水处理设施长效管理机制.     

关于生活垃圾焚烧发电厂污染物排放标准分析

本文对新修订的《生活垃圾焚烧污染控制标准》(GB18485-2014)与《生活垃圾焚烧污染控制标准》(GB18485-2001)及欧盟标准进行比较,从焚烧烟气排放标准、运行控制过程要求、渗滤液处理及排放要求等方面进行了分析,以此说明新标准的进步。     

Toluene decomposition performance and NOx by-product formation during a DBD-catalyst process

Characteristics of toluene decomposition and formation of nitrogen oxide (NO_x) by-products were investigated in a dielectric barrier discharge (DBD) reactor with/without catalyst at room temperature and atmospheric pressure. Four kinds of metal oxides, i.e., manganese oxide (MnOx), iron oxide (FeOx), cobalt oxide (CoOx) and copper oxide (CuO), supported on Al₂O₃/nickel foam, were used as catalysts. It was found that introducing catalysts could improve toluene removal efficiency, promote decomposition of by-product ozone and enhance CO₂ selectivity. In addition,NO_xwas suppressedwith the decrease of specific energy density (SED) and the increase of humidity, gas flow rate and toluene concentration, or catalyst introduction. Among the four kinds of catalysts, the CuO catalyst showed the best performance in NO_x suppression. The MnOx catalyst exhibited the lowest concentration of O₃ and highest CO₂ selectivity but the highest concentration of NOx. A possible pathway for NOx production in DBD was discussed. The contributions of oxygen active species and hydroxyl radicals are dominant in NOx suppression.     

Experimental study of NO2 reduction in N2/Ar and O2/Ar mixtures by pulsed corona discharge

Non-thermal plasma technology has been regarded as a promising alternative technology for NOx removal. The understanding of NO2 reduction characteristics is extremely important since NO2 reduction could lower the total NO oxidation rate in the plasma atmosphere. In this study, NO2 reduction was experimentally investigated using a non-thermal plasma reactor driven by a pulsed power supply for different simulated gas compositions and operating parameters. The NO2 reduction was promoted by increasing the specific energy density （SED）, and the highest conversion rates were 33.7%, 42.1% and 25.7% for Ar, N2/Ar and O2/Ar, respectively. For a given SED, the NO2 conversion rate had the order N2/Ar 〉 Ar 〉 02/Ar. The highest energy yield of 3.31 g/kWh was obtained in N2/Ar plasma and decreased with increasing SED; the same trends were also found in the other two gas compositions. The conversion rate decreased with increasing initial NO2 concentration. Furthermore, the presence of N2 or O2 led to different reaction pathways for NO2 conversion due to the formation of different dominating reactive radicals.     

安顺煤矿超前排放钻孔有效排放半径研究及应用

为了解决瓦斯排放孔半径测定过程中由于方法选择和操作等原因而出现的测定结果不够准确,以及由此而导致的空白带出现问题,通过现场试验,采用钻屑解吸指标法测定的方法,通过对测定结果进行综合分析、修正,确定安顺煤矿Φ42 mm直径的排放钻孔有效作用半径为R0.25 m,Φ90 mm直径的排放钻孔有效作用半径为R0.55 m,经实践证明是准确和可靠的,排放钻孔措施在实施过程中有效地避免了空白带的出现。     

公路交通噪声防治措施

随着交通运输业的发展及公路等级的不断提高,公路交通噪声越来越引起人们的关注,因此,解决公路交通噪声污染成为一个急待解决的问题,本文论述公路交通噪声造成的危害,并有针对性地提出降低公路交通噪声防治措施。     

ANALYSIS AND EXTRACTION OF LOW FLOW RECESSION CHARACTERISTICS1

ABSTRACT: It is important to extract and assess low flow recession characteristics for water resources planning in the upper reaches of streams. However, it is very difficult to express synthetically the low flow recession characteristics for a stream flow. In this paper, first a new method of constructing the master recession curve based on the exponential expression is proposed and applied with the restriction that there are no regulation or diversion structures in the upper reaches above the measurement station. Daily precipitation and stream flow were used for the analysis. Second, analysis for a recession constant was conducted and the relationship between the recession constant and low flow and/or geology was qualitatively examined. In conclusion, the application of the proposed method indicated that it is objective and useful for constructing the master recession curve. It became apparent that the recession constant of a master recession curve may be defined as the total index of low flow characteristics. In addition, it was found that baseflow value increases in the order of Paleozoic, Mesozoic, Tertiary, and Quaternary.