室内皮带上煤机除尘系统改造设计

针对某公司热电厂皮带上煤机除尘系统所存在的问题,进行了全面的改造设计,取得了良好的除尘效果。     

除尘管道磨损与防磨措施

讲述了除尘管道磨损的危害,对磨损的形成机理及其影响因素进行了分析,提出了防止磨损的技术措施,提供了一种新型结构的防磨弯头.     

On the transient flow in the 20-liter explosion sphere

The turbulence level in the 20-l explosion sphere, equipped with the Perforated Dispersion Ring, was measured by means of laser Doppler anemometry. The spatial homogeneity of the turbulence was investigated by performing velocity measurements at various locations in the transient flow field. Directional isotropy was investigated by measuring two independent components of the instantaneous velocity. The transient turbulence level could be correlated by a decay law of the form

in which the exponent, n, assumes a constant value of 1.49±0.02 in the period between 60 and 200 ms after the start of the injection process. In this time interval the turbulence was also observed to be homogeneous and practically isotropic. The results of this investigation imply that the turbulence level in the 20-l explosion sphere at the prescribed ignition delay time of ms is not equal to the turbulence level in the 1 m³-vessel. Hence, these results call into question the widely held belief that the cube-root-law may be used to predict the severity of industrial dust explosions on the basis of dust explosion severities measured in laboratory test vessels.     

Cornstarch explosion experiments and modeling in vessels ranged by height/diameter ratios

Height to diameter (H/D) ratio is one of the important parameters affecting premixed particle–air combustion characteristics. This paper focuses on the behavior of cornstarch combustion in closed vessels with changed H/D ratios and fixed volumes; and a combustion model is employed to simulate the experiments. An Eulerian–Lagrangian approach for two-phase flows was used in the model and conservation equations of unsteady turbulent two-phase reacting flows were solved in two-dimensional domains. Heat loss to the vessel walls was taken into consideration in the model. The simulation results have a good agreement with those of experiments. Further simulations were carried out for higher H/D ratios from 8 to 15. These results show that H/D=8 is a changing point. When H/D<8, the maximum pressure and the rate of maximum pressure rise decrease with increasing H/D ratios. While H/D>8, the both have an increasing tendency with increasing H/D ratios.     

酯类化合物对四膜虫毒性的拓扑研究

提出了拓扑方法,即考虑分子图顶点的性质,直接用酯类化合物的分子碎片的特征值为主元来构建邻接矩阵。定义并计算了酯类化合物的修正的氢连接性指数^mHA及其倒指数^mHB,分析了30个酯化合物对四膜虫的毒性与分子结构之间的关系,结果表明由酯化合物对四膜虫毒性与^mH的回归方程得出的估算值与实验测定值之间能较好地吻合,平均误差为0．22。     

荷电水雾除尘器捕尘效率的实验研究

实验分析了影响荷电水雾除尘器除尘效率的主要因素,在此基础上提出了一种新的除尘效率数学模型,该模型明确地表达了过滤风速、喷雾量以及雾滴荷质比对除尘效率的贡献情况。对实验结果及数学模型的分析表明,对于带有振弦栅的荷电水雾除尘系统,喷雾量对除尘效率的影响比过滤风速及荷质比更为显著,新除尘效率模型的提出对指导生产具有重要意义。实验中同时确定了荷电水雾除尘器最佳操作参数,在粉尘入口浓度为412 mg/m3的情况下,当过滤风速为16 m/s,喷雾量为12×10-3 m3/min,雾滴荷质为3.5×10-4 c/kg时,除尘效率可达99.5%。     

Experimental study on the influence of the nitrogen concentration in the air on the minimum ignition energies of combustible powders due to electrostatic discharges

As a useful method of preventing dust explosions, nitrogen (N₂), an incombustible gas, has been applied to an explosive atmosphere. This paper is a report that quantitatively determines whether the minimum ignition energy of powder depends on the nitrogen (or oxygen) concentration in the air. Hartman vertical-tube apparatus and six sample powders were used in this study. The results show that the minimum ignition energies of all of the powders used in this study increased with increased amounts of N₂ in the air. However, the effects were different in all of the sample powders. We finally suggest that the N₂ concentration of 84% (or above) prevents dust explosions due to electrostatic discharges in the industrial process with the sample powders used in this experiment.     

Comparative study of explosion processes controlled by homogeneous and heterogeneous combustion mechanisms

The dust explosion behaviors induced by two different combustion mechanisms (homogeneous and heterogeneous mechanisms) were comparatively investigated, based on the experiments under different dust concentrations, particle sizes and initial pressures in Siwek 20-L chamber. Based on the thermo-gravimetric analysis (TGA), sweet potato dust and magnesium dust were selected as the representative dusts with homogeneous and heterogeneous combustion mechanisms, respectively. Experiments find that these two dusts have different behaviors in the explosion kinetics due to different combustion mechanisms. For sweet potato dust, the explosion pressure p_max, the pressure rise rate (dp/dt)_max and the combustion fraction η exhibit similar variation trends as dust concentration increases and they all reach to the maximum values at the worst-case concentration; while for magnesium dust, the variation of (dp/dt)_max is somewhat different from that of p_max, that is, the (dp/dt)_max will achieve the maximum at the concentration higher than the worst-case and keep stabilized with further increase of dust concentration. As the particle size decreases, the (dp/dt)_max for sweet potato dust will increasingly rise and gradually approach to a stabilized value, but for magnesium dust, the increase of (dp/dt)_max becomes pronounced only in the range of smaller particle sizes. To account the effect of initial pressure on p_max under different combustion mechanisms, a dimensionless pressure P_R was introduced to denote the relative intensity of explosion. It is found that, for sweet potato dust, the increased initial pressure will promote the explosion process (or with high P_R) for the dust cloud with high concentration due to the augmented oxygen concentration, but for the dust cloud with low concentration, the increased initial pressure will suppress the explosion process due to the increased resistance in devolatilization. For magnesium dust, the rise of initial pressure will generally promote the explosion process even for the dust cloud with low concentration; however, in the case of small particle size, the promotion of increased initial pressure to the explosion process is not so pronounced.     

Advances in air pollution control for key industries in China during the 13th five-year plan

Industrial development is an essential foundation of the national economy, but the industry is also the largest source of air pollution, of which power plants, iron and steel, building materials, and other industries emit large amounts of pollutants. Therefore, the Chinese government has promulgated a series of stringent emission regulations, and it is against this backdrop that research into air pollution control technologies for key industrial sectors is in full swing. In particular, during the 13th Five-Year Plan, breakthroughs have been made in pollution control technology for key industrial sectors. A multi-pollutant treatment technology system of desulfurization, denitrification, and dust collection, which applies to key industries such as power plants, steel, and building materials, has been developed. High-performance materials for the treatment of different pollutants, such as denitrification catalysts and desulfurization absorbers, were developed. At the same time, multi-pollutant synergistic removal technologies for flue gas in various industries have also become a hot research topic, with important breakthroughs in the synergistic removal of NO_x, SO_x, and Hg. Due to the increasingly stringent emission standards and regulations in China, there is still a need to work on the development of multi-pollutant synergistic technologies and further research and development of synergistic abatement technologies for CO₂ to meet the requirements of ultra-low emissions in industrial sectors.     

Microbial and size characterization of airborne particulate matter collected on sticky tapes along US–Mexico border

Particulate matter(PM) emissions from various sources can affect significantly human health and environmental quality especially in the Chihuahuan Desert region along US–Mexico border. The objective of this study was to use the low-cost sticky tape method to collect airborne PM for size characterization and identification of fungal spores. Sticky tape samplers were placed at 1.0 and 2.0 m above the ground surface at experimental sites in Ciudad Juárez, Mexico and at 0.6, 1.2 and 1.8 m at New Mexico sites, USA. Soil samples were collected in both countries to determine fungal diversity, texture and moisture content Dust particles collected from all of the experimental sites had a dominant texture of clay( 0.002 mm). The dominant textures identified from soil samples collected from the US and Mexican sites were loam and sandy clay loam, respectively. Alternaria, Penicillium and Fusarium were frequently found funguses in the US sites while Alternaria and Aspergillus were commonly observed in the Mexican sites. The sticky tapes also showed a similar diversity of fungal microorganisms present in the airborne PM at both Mexico and US sites Alternaria, Penicillium and Aspergillus were the three groups of airborne fungal microorganisms consistently present in the US and Mexican sites. The low-cost sticky tape method has the potential to be used for characterizing different airborne microorganisms and dust particles.