Leaching of arsenic from coal fly ashes 2. Arsenic pre‐leaching with sodium gluconate solution

The present study deals with the development of an efficient and reliable process for safe disposal of coal fly ash to remove arsenic that has been found to be the most easily leachable and hazardous heavy metal in coal fly ash. Pre‐leaching of fly ash prior to disposal by a natural chelating agent, sodium gluconate (SG), was proposed and studied. Several operational factors influencing arsenic leachability, such as concentration of SG solution, liquid to solid ratio, pH, length of leaching time and leaching temperature were examined. Arsenic was found to leach out substantially with SG, but almost no further release was observed from the ash pre‐leached by SG. After the pre‐leaching treatment, the desirable high buffering capacity of the ash was well sustained. SG solution was effectively regenerated by activated alumina adsorption so that it could be successfully reused for multiple leaching/adsorption cycles.     

反渗透法处理土霉素结晶母液的研究

土霉素结晶母液经调节ｐＨ值后的水经预滤后进行反渗透处理,可使污染物去除率达９９％以上,排放水ＣＯＤｃｒ１５３ｍｇ／Ｌ、ＢＯＤ１０７ｍｇ／Ｌ水可以回用或达标排放。     

矿井通风网络数据可靠性检验

进行矿井通风阻力测定时,由于受环境的温度、湿度、压力传递存在时间差以及测点处标高不准确等因素的影响,根据实测数据,计算所得矿井巷道基础数据存在一定的误差,常用的测量数据检验方法只能对若干条通路进行闭合回路检验,而不能对全矿井通风网络基础参数进行可靠性检验。本文中所介绍的检验方法将风网基础数据输入通风网络解算软件,以实测风量和经过计算所得巷道风阻为基准,实测风量为目标条件,进行计算机通风网络模拟,对全矿井巷道风阻进行连续的优化调整,使通风网络模拟结果与实际测定各巷道风量基本符合,从而实现全矿井风网基础数据的可靠性检验。该方法在某矿进行了实际应用,实践证明此方法科学、准确的获得了全矿巷道风阻参数,为矿井的通风改造奠定了技术基础。     

Ce/Zr系列催化剂上碳颗粒物燃烧行为

分别在TG和TPO上考察了CeO₂,ZrO₂及不同Ce/Zr比的CexZr1-xO₂固溶体催化剂上soot的燃烧性能,同时考察了反应气氛对活性的影响.结果表明:Ce基催化剂能明显降低soot的起燃温度,Ce/Zr比的不同导致Ce_xZr_1-xO₂催化剂性能的差异.反应的速度控制步骤随O₂浓度的不同而改变;H₂O对Ce_0.5Zr_0.5O₂上soot的氧化活性基本没有影响;由于NO氧化产生的NO₂具有更强的的氧化能力,因此NO对soot的燃烧具有促进作用,起燃温度降低了30℃.催化剂上的β氧种参与了soot燃烧过程.     

利用蚀刻废液生产碱式氯化铜过程中二英类污染物的去除

针对蚀刻废液及其回收后生产的碱式氯化铜产品中二英(PCDD/Fs)和二英类多氯联苯(dl-PCBs)进行了分析研究,并比较了采用去除工艺前后两类污染物含量水平的变化特征.利用高分辨气相色谱/高分辨质谱对样品中PCDD/Fs和dl-PCBs进行分析,结果表明,氯化铜废液中PCDD/Fs和dl-PCBs的平均总浓度分别为264、139 pg·mL-1,而铜氨液中浓度分别为0.09、0.50 pg·mL-1;碱式氯化铜产品中浓度分别为106 pg·g-1(2.79 pg WHO-TEQ2005·g-1)和27.8 pg·g-1(0.69 pg WHO-TEQ2005·g-1);而经过吸附和过滤等去除工艺后,产品中PCDD/Fs和dl-PCBs的TEQ浓度水平分别降低至0.10—0.25 pg WHO-TEQ2005·g-1和0.05—0.72 pg WHO-TEQ2005·g-1,满足欧盟对于矿物源性饲料添加剂中PCDD/Fs和dl-PCBs的限量标准要求.研究表明该工艺能够有效去除利用蚀刻废液生产碱式氯化铜过程中的二英类污染物.     

Uncertainties in a risk management context in early phases of offshore petroleum field development

The current risk management approach for the Norwegian offshore petroleum industry came into effect in 2001 and has been stable with minor changes for 15 years. Relatively few new installations were slated for development until quite recently, and several new projects have been started in the last few years. The paper considers the risk management approach in the pre-FEED phase and builds on two case studies selected from the most recent cases. These case studies have been evaluated with respect to how uncertainties are considered in the early phase, based on the submission of the Plan for Development and Operation, their evaluations by authorities and the supporting documents. Both case studies involve new concepts for which there is no experience from similar environments and/or water depths. In spite of what could have been expected, the case studies conclude that uncertainties have not been in focus at all during concept development. This appears to be definitely the case for the licensees, but also to be the case for the authorities. Some suggestions are presented for what could have been considered by the licensees and authorities.     

高温碱间歇式处理对互花米草厌氧发酵特性的影响

以互花米草为原料,采用中温(35±1)℃批式发酵的方式,考察了NaOH高温碱间歇式处理对互花米草厌氧消化过程的影响.结果表明,互花米草一次发酵至产气停止,单位TS产气量为263mL/g,发酵过程中出现酸化现象, pH值最低为5.17.二次发酵原料为一次发酵后的固体残余物,主要组分为可分解有机物以及一些难分解有机物,过程中未出现酸化现象, pH值经短暂下降后很快稳定在7.5左右,累积产气量在一次发酵的基础上提高了46%.互花米草单位TS产气量为383mL/g.消化液中有机酸乙酸含量最大,丙酸和丁酸含量相当.     

Leaching characteristics of bisphenol A from epoxy-resin pavement materials

We investigated the leaching characteristics of bisphenol A (BPA) from two kinds of epoxy-resin pavement materials, one containing epoxy resins (EPs) and the other containing epoxy-acrylate resins (EPAs). Both samples contained residual BPA monomer, at levels of 9.0?µg?g^?1 for the EP resin sample and 4.4?µg?g^?1 for the EPA resin sample. These amounts were larger than amounts previously measured for polycarbonate samples. The amount of BPA leached from the samples increased with temperature. The leaching of BPA from EP was more strongly affected by temperature than the leaching from EPA. The pH also affected the amount of leached BPA. The maximum leached amount was observed under alkaline conditions (pH 10.8) for both sample types. The amounts of BPA that might leach from pavement materials during 1?h of heavy rain were estimated to be 0.9?µg?m^?2 for EP and 3.5?µg?m^?2 for EPA. Our results indicate that EPs disposed of in waste landfills without any treatment may be a source of BPA in leachate at landfill sites.     

以缓释肥的形式回收污泥溶解液中磷的研究

以聚合硫酸铁(PFS)为絮凝剂,单宁酸为助凝剂回收污泥溶解液中的磷。研究结果表明:在铁盐投加量为160mg/L,pH为8,单宁酸投加量为10 mg/L条件下,磷酸盐的回收率可达到97.0%。单宁酸促进了混凝沉淀物中磷的释放,表明利用该方法回收磷作为缓释肥的可行性。将沉淀物作为缓释磷肥施用于土壤中能够明显促进黑麦草的生长。     

P-25纳米TiO2在含酚废水处理方面的应用

采用室内模拟研究,以P-25纳米TiO2作为光催化剂进行了苯酚水溶液的光催化降解性能探讨,初步考察了溶液的pH、P-25纳米TiO2用量对光催化降解苯酚过程的影响,以获得P-25纳米TiO2光降解含酚废水的较好反应条件.实验结果表明,当溶液pH=8时,降解水体中苯酚效果最佳,强酸和强碱条件均不利于苯酚的降解;在pH 8的反应体系中,当光催化剂用量为0.4g/L时,催化水体中苯酚降解的效果最好.