Biodegradation of chlorpyrifos by either single or combined cultures of some soilborne plant pathogenic fungi

Abstract

Biodegradation of chlorpyrifos was studied in liquid culture media amended with either single or combined eight different plant pathogenic fungi isolated from the continuous cropping wheat fields. The average recovery of chlorpyrifos from the liquid media was found to be 86.1%. The detection limit of chlorpyrifos by the analytical method used was 19 ppb. Data showed that the growth of mixed fungi at concentrations up to 200 ppm of chlorpyrifos was higher than in the control treatment. Chlorpyrifos concentrations declined in the medium of combined fungi more than it did in the medium of any single fungus with increase in the incubation period. The amount of chlorpyrifos recovered was 79.8 ppm (39.9%) in the combined fungal cultures after 21 days. However, those recovered from the media of Fusarium graminearum, F. oxysporum, Rhizoctonia solani, Cladosporhim cladosporiodes, Cephalosporium sp., Trichoderma viridi, Alternaria alternata, and Cladorrhinum brunnescens, ranged from 48.0 to 74.8%. The half‐life value (T_1/2) for chlorpynfos was 15.8 day in the medium amended with mixed fungi. However, for the single cultures it ranged from 19.3 to 33.0 day.     

Liquid household hazardous wastes in the United States: Identification,disposal, and management plan

Present methods of disposal of today's hazardous household chemicals in the United States are frequently not acceptable because of pathways to groundwater, surface water, and the atmosphere. This report identifies potentially hazardous liquid waste in the household, notes current disposal practices, and recommends an improved management plan that utilizes consumer education, manufacturer cooperation, and governmental intervention. Laws requiring uniform disposal labeling on packaging are critical. Local, county, and state governments must be encouraged to coordinate the necessary infrastructure. Managing hazardous household wastes now will mitigate potential disposal problems.     

地面水中叶枯灵的高效液相色谱测定

本文采用反相高效液相色谱法，在质控条件下，对河水，塘水两种地面水中叶枯灵的检验方法进行了测试，用Shimapck ODS柱为分析柱，以甲醇：水＝50：50为流动相，并用冰醋酸调PH至4－5，紫外检测波长281nm，两种水样的平均回收率分别为91．7－96．3％，90－95．8％，相对标准偏差为4．3％，最低检出限为0．0261mg/l，为地面水中叶枯灵卫生标准的实施提供了简便，灵敏，正确的配套测试手段。     

氯化法处理医院废水的研究

介绍了次氯酸钠法和液氯法2种目前常用的处理医院废水的方法.对2家医院的废水处理过程进行了测试及实验研究.结果表明,这2家医院的废水处理后细菌总数和余氯量未达到国家规定的排放标准.主要原因是加氯量不精确,加氯后的停留时间不足,不能有效杀死废水中的病菌.对加氯量和停留时间的实验研究表明,每吨医院废水中次氯酸钠和液氯的最佳投入量分别为90 g和9 g,加氯后的停留时间不少于60min.     

环境水样阴离子表面活性剂光度测定法

本文通过实验研究,提出了对河水及生活废水阴离子表面活性剂的水相直接测定方法,此方法具有简便、快速的特点,且有良好的准确性和再现性。     

球壳孢菌和胶孢炭疽菌的液体培养特性研究

对银杏叶内生真菌球壳孢科菌株A114和胶孢炭疽菌菌株05—27的液体培养特性的初步研究得出：两种菌株均在马铃薯葡萄糖液体培养基中生长最好、菌丝产量最高，在pH4．0-8．5的马丁氏液体培养基中均能生长。A114菌株和05—27菌株的最佳氮、碳源分别为酵母粉和葡萄糖，A114菌株最适pH为6．6，05—27菌株最适pH为6．9。     

离子液体对CO2吸收性能的研究进展

CO2引起的气候变暖已成为全球最关注的环境问题之一,利用离子液体固定CO2引起了众多学者的关注。介绍了近年来离子液体吸收CO2的研究进展,包括常规离子液体和含氨基离子液体、氨基酸离子液体、聚离子液体及其他离子液体等4种功能化离子液体,并简要分析了吸收机理。综合分析了每种离子液体的吸收性能,离子液体对CO2的吸收能力均随温度上升而减小,随压力升高而增加。烷基链的增长以及含氟基团的增加有利于对CO2的吸收。功能化离子液体由于引入了功能化基团,相同条件下,其对CO2的吸收力几乎是常规离子液体的两倍。此外,将离子液体与有机溶液(特别是醇胺溶液)混合能提高离子液体对CO2的吸收能力,且能降低生产费用。最后指出了高吸收性能、低黏度、低毒以及低成本是未来离子液体的研究方向。     

QuEChERS: a sample preparation for extraction of carbaryl from rat feces

Carbamate compounds are an important group of cholinesterase inhibitors. There is a need for creating awareness regarding the risks of the inadequate carbamate use in the residential areas due to potential adverse human effects. Carbaryl is a commonly used pesticide worldwide. A simple, fast, and high-throughput method was developed employing liquid chromatography with fluorescence detector to determine carbaryl residues in rat feces. The extraction was performed by using a rapid, easy, cheap, effective, reliable, and safe (QuEChERS) method, using acetonitrile as the extracting solvent. The parameters for the performance of the extraction method were optimized, such as ratio of mass of sample per volume of extraction solvent, QuEChERS content, and cleanup columns. Linear response was obtained for all calibration curves (solvent and matrix-matched) over the established concentration range (5–500 μg/L) with a correlation coefficients higher than 0.999. The achieved recovery was 97.9% with relative standard deviation values of 1.1% (n = 4) at 167 μg/kg fortified concentration level and the limits of detection and quantification were 27.7 and 92.3 µg/kg, respectively.     

Phosphorus recovery from biogas fermentation liquid by Ca–Mg loaded biochar

Shortage in phosphorus (P) resources and P wastewater pollution is considered as a serious problem worldwide. The application of modified biochar for P recovery from wastewater and reuse of recovered P as agricultural fertilizer is a preferred process. This work aims to develop a calcium and magnesium loaded biochar (Ca–Mg/biochar) application for P recovery from biogas fermentation liquid. The physico-chemical characterization, adsorption efficiency, adsorption selectivity, and postsorption availability of Ca-Mg/biochar were investigated. The synthesized Ca–Mg/biochar was rich in organic functional groups and in CaO and MgO nanoparticles. With the increase in synthesis temperature, the yield decreased, C content increased, H content decreased, N content remained the same basically, and BET surface area increased. The P adsorption of Ca–Mg/biochar could be accelerated by nano-CaO and nano-MgO particles and reached equilibrium after 360 min. The process was endothermic, spontaneous, and showed an increase in the disorder of the solid–liquid interface. Moreover, it could be fitted by the Freundlich model. The maximum P adsorption amounts were 294.22, 315.33, and 326.63 mg/g. The P adsorption selectivity of Ca–Mg/biochar could not be significantly influenced by the typical pH level of biogas fermentation liquid. The nano-CaO and nano-MgO particles of Ca–Mg/biochar could reduce the negative interaction effects of coexisting ions. The P releasing amounts of postsorption Ca–Mg/biochar were in the order of Ca–Mg/B600 > Ca–Mg/B450 > Ca–Mg/B300. Results revealed that postsorption Ca–Mg/biochar can continually release P and is more suitable for an acid environment.     

Analysis of trace dicyandiamide in stream water using solid phase extraction and liquid chromatography UV spectrometry

An improved method for trace level quantification of dicyandiamide in stream water has been developed. This method includes sample pretreatment using solid phase extraction. The extraction procedure (including loading, washing, and eluting) used a flow rate of 1.0 mL/min, and dicyandiamide was eluted with 20 mL of a methanol/acetonitrile mixture (V/V = 2:3), followed by pre-concentration using nitrogen evaporation and analysis with high performance liquid chromatography–ultraviolet spectroscopy (HPLC–UV). Sample extraction was carried out using a Waters Sep-Pak AC-2 Cartridge (with activated carbon). Separation was achieved on a ZIC^®-Hydrophilic Interaction Liquid Chromatography (ZIC-HILIC) (50 mm × 2.1 mm, 3.5 μm) chromatography column and quantification was accomplished based on UV absorbance. A reliable linear relationship was obtained for the calibration curve using standard solutions (R² > 0.999). Recoveries for dicyandiamide ranged from 84.6% to 96.8%, and the relative standard deviations (RSDs, n = 3) were below 6.1% with a detection limit of 5.0 ng/mL for stream water samples.