体育馆建筑内青年学生疏散预动作时间调查和分析

通过组织火灾应急疏散逃生演习、现场问卷调查等方式,统计了体育馆内人员的疏散预动作时间,进而建立多分变量逻辑斯蒂回归模型对该统计数据进行了研究.发现:男生选择疏散预动作时间为＜30 s的可能性是女生的0.886倍,选择疏散预动作时间为30-60 s的可能性是女生的2.818倍.预测人员疏散预动作时间为＜30 s、30 -60 s、＞60s的概率,男生分别为15.45％,75.61％、8.94％,而女生分别为24.14％,39.72％、36.14％;研究结果表明:人员性别的不同对疏散预动作时间有一定的影响,在体育馆类建筑中,青少年人员疏散预动作时间基本上小于60 s.     

Influence of vacuum degree on the effect of gas explosion suppression by vacuum chamber

In order to study the influence of vacuum degree on gas explosion suppression by vacuum chamber, this study used the 0.2 mm thick polytetrafluoroethylene film as the diaphragm of vacuum chamber to carry out a series of experiments of gas explosion suppression by vacuum chamber with the vacuum degree from −0.01 MPa to −0.08 MPa. The experimental results show that: under the condition of any vacuum degree, vacuum chamber can effectively suppress the explosion flame and overpressure; as vacuum degree changes, the effect of gas explosion suppression using vacuum chamber is slightly different. Vacuum chamber has obvious influence on propagation characteristics of the explosion flame. After explosion flame passes by vacuum chamber, the flame signal weakens, the flame thickness becomes thicker, and the flame speed slows down. With the increase of the vacuum degree of vacuum chamber, the flame speed can be prevented from rising early by vacuum chamber. The higher the vacuum degree is, the more obviously the vacuum chamber attenuates the explosion overpressure, the smaller the average overpressure is, and the better effect of the gas explosion suppression is. Vacuum chamber can effectively weaken the explosion impulse under each vacuum degree. From the beginning of −0.01 MPa, the vacuum chamber can gradually weaken explosion impulse as the vacuum degree increases, and the effect of gas explosion suppression gradually becomes better. When the vacuum degree is greater than −0.04 MPa, the increase of vacuum degree can make the explosion overpressure decrease but have little influence on the explosion impulse. Therefore, the vacuum chamber has the preferable suppression effect with equal to or greater than −0.04 MPa vacuum degree.     

Collecting representative dust samples: A comparison of various sampling methods in underground coal mines

Former methods used in the U.S. to assess hazardous and explosible coal dust date back to the 1950s. As mining technologies advanced, so too have the hazards. Given the results of the recent coal dust particle size survey and full-scale experimental mine explosion tests, the National Institute for Occupational Safety and Health (NIOSH) recommended a new minimum standard, in the absence of background methane, of 80% total incombustible content (TIC) be required in the intake airways of bituminous coal mines, replacing the previous 65% TIC requirement. Most important to monitoring and maintaining the 80% TIC is the ability to effectively collect and analyze representative dust samples that would likely disperse and participate in dust explosion propagation. Research has shown that dust suspended on elevated surfaces is usually finer, more reactive, and more readily dispersible while floor deposits of dust are generally coarser and more difficult to disperse given the same blast of air. The roof, rib, and floor portions of the dust samples were collected and analyzed for incombustible content separately and the results were compared to a band sample of the roof, rib, and floor components. Results indicate that the roof and rib dust samples should be kept separate from floor dust samples and considered individually for analyses. The various experimental collection methods are detailed along with preferred sampling approaches that improve the detectability of potentially hazardous accumulations of explosible dust.     

Ammonium nitrate thermal decomposition with additives

Runaway reactions present a potentially serious threat to the chemical process industry and the community; such reactions occur time and time again often with devastating consequences. The main objective of this research is to study the root causes associated with ammonium nitrate (AN) explosions during storage. The research focuses on AN fertilizers and studies the effects of different types of fertilizer compatible additives on AN thermal decomposition. Reactive Systems Screening Tool (RSST) has been used for reactivity evaluation and to better understand the mechanisms that result in explosion hazards. The results obtained from this tool have been reported in terms of parameters such as “onset” temperature, rate of temperature and pressure rise and maximum temperature. The runaway behavior of AN has been studied as a solid and solution in water. The effect of additives such as sodium sulfate (Na₂SO₄) and potassium chloride (KCl) has also been studied. Multiple tests have been conducted to determine the characteristics of AN decomposition accurately. The results show that the presence of sodium sulfate can increase the “onset” temperature of AN decomposition thus acting as AN thermal decomposition inhibitor, while potassium chloride tends to decrease the “onset” temperature thus acting as AN thermal decomposition promoter.     

Dynamic pressure induced by a methane–air explosion in a coal mine

The hazardous effect of dynamic pressure and strong gas flows induced by a methane–air mixture explosion in underground coal mines is studied. The dynamic pressure effect of a methane–air explosion was analyzed by numerical simulation, in a duct and tunnel. Compared to the overpressure generated by an explosion that can act on a body, the dynamic pressure caused by the high-speed flow of the gaseous combustion products can cause serious damage as well. At the structural opening of a coal mine, the destruction caused by the dynamic pressure induced by a methane–air explosion is more serious than the overpressure. For a tube or tunnel partially filled by a methane–air mixture, the dynamic pressure is lower than the overpressure in the region occupied by the flammable mixture. Beyond the premixed region, the dynamic pressure is of the same order of magnitude as the overpressure.     

Hybrid H2/Al dust explosions in Siwek sphere

Explosion indices and explosion behaviour of Al dust/H₂/air mixtures were studied using standard 20 l sphere. The study was motivated by an explosion hazard occurring at some accidental scenarios considered now in ITER design (International Thermonuclear Experimental Reactor). During Loss-of-Vacuum or Loss-of-Coolant Accidents (LOCA/LOVA) it is possible to form inside the ITER vacuum vessel an explosible atmosphere containing fine Be or W dusts and hydrogen. To approach the Be/H₂ explosion problem, Be dust is substituted in this study by aluminium, because of high toxicity of Be dusts. The tested dust concentrations were 100, 200, 400, 800, and 1200 g/m3; hydrogen concentrations varied from 8 to 20 vol. % with 2% step. The mixtures were ignited by a weak electric spark. Pressure evolutions were recorded during the mixture explosions. In addition, the gaseous compositions of the combustion products were measured by a quadruple mass-spectrometer. The dust was involved in the explosion process at all hydrogen and dust concentrations even at the combination ‘8%/100 g/m3’. In all the other tests the explosion overpressures and the pressure rise rates were noticeably higher than those relevant to pure H₂/air mixtures and pure Al dust/air mixtures. At lower hybrid fuel concentrations the mixture exploded in two steps: first hydrogen explosion followed by a clearly separated Al dust explosion. With rising concentrations, the two-phase explosion regime transits to a single-phase regime where the two fuel components exploded together as a single fuel. In this regime both the hybrid explosion pressures and pressure rise rates are higher than either H₂ or Al ones. The two fuels compete for the oxygen; the higher the dust concentration, the more part of O2 it consumes (and the more H₂ remains in the combustion products). The test results are used to support DUST3D CFD code developed at KIT to model LOCA or LOVA scenarios in ITER.     

Estimating the normal background rate of species extinction

A key measure of humanity's global impact is by how much it has increased species extinction rates. Familiar statements are that these are 100–1000 times pre‐human or background extinction levels. Estimating recent rates is straightforward, but establishing a background rate for comparison is not. Previous researchers chose an approximate benchmark of 1 extinction per million species per year (E/MSY). We explored disparate lines of evidence that suggest a substantially lower estimate. Fossil data yield direct estimates of extinction rates, but they are temporally coarse, mostly limited to marine hard‐bodied taxa, and generally involve genera not species. Based on these data, typical background loss is 0.01 genera per million genera per year. Molecular phylogenies are available for more taxa and ecosystems, but it is debated whether they can be used to estimate separately speciation and extinction rates. We selected data to address known concerns and used them to determine median extinction estimates from statistical distributions of probable values for terrestrial plants and animals. We then created simulations to explore effects of violating model assumptions. Finally, we compiled estimates of diversification—the difference between speciation and extinction rates for different taxa. Median estimates of extinction rates ranged from 0.023 to 0.135 E/MSY. Simulation results suggested over‐ and under‐estimation of extinction from individual phylogenies partially canceled each other out when large sets of phylogenies were analyzed. There was no evidence for recent and widespread pre‐human overall declines in diversity. This implies that average extinction rates are less than average diversification rates. Median diversification rates were 0.05–0.2 new species per million species per year. On the basis of these results, we concluded that typical rates of background extinction may be closer to 0.1 E/MSY. Thus, current extinction rates are 1,000 times higher than natural background rates of extinction and future rates are likely to be 10,000 times higher. Estimación de la Tasa Normal de Extinción de Especies     

Effects of release pressure on the transportation characteristics in pipeline and the diffusion behaviors in enclosure space of typical gas extinguishing agent

Reducing the release pressure of fire extinguishing systems can decrease potential safety hazards in large transport airplanes. To explore whether reducing the release pressure can achieve the release effect required by the airworthiness standards or not, the transportation characteristics in the pipeline and diffusion behaviors in the enclosure space of a typical fire extinguishing agent (Halon 1301) were investigated under five release pressures in the present study. The effects of the release pressure on the degree of superheat, injection duration, jet structure, and concentration distribution of Halon 1301 were analyzed. The results show that both of the degree of superheat and the injection duration decrease with an increase in the release pressure. The supplement of bubble expansion in the fire extinguishing agent can slow down the pressure decrease in the vessel. Both of the maximum and mean values of the pipeline differential pressure increase with an increase in release pressure. The maximum value of the jet angle decreases linearly with the increase in release pressure, and the jet deflects upward owing to the effects of buoyancy. The maximum concentration value decreases with an increase in the distance from the nozzle. The maximum concentration values in the near field from the nozzle increase with an increase in the release pressure. Under five release pressures, the concentration and holding time (duration above 6% volume concentration) of Halon 1301 on the centerline of the jet meet the requirements of airworthiness provisions.     

煤矿照度对人反应时间和可靠度的影响研究

煤矿综采工作面狭窄,工作环境昏暗,照明环境普遍不好,是近年来井下事故多发的重要因素之一。针对目前煤矿综采工作面存在的照度问题,通过控制光照时间和操作难度,利用舒尔特表测算反应时间和操作可靠度,使用SPSS20. 0和Excel进行数据处理,设计试验组和对照组来进行对比试验。结果表明,1)从反应时间来看,0～25 min,试验组平均反应时间的变化趋势与对照组相反,被试者的注意力先下降后上升; 25～55 min,被试者逐渐适应低照度环境,反应时间也在逐渐缩短;被试者在低照度条件下操作55 min后,反应时间随光照时间增加而大幅度增加,超过劳动时间临界值后,视觉疲劳度迅速增加,反应急速减慢,从而可能导致安全事故的发生,影响生产效率,此时应合理安排工人休息。2)从操作难度来看,在简单及正常操作难度时,试验组和对照组操作可靠度变化比较接近,表明低照度条件对一般操作的可靠度影响不明显;在极难操作难度时,低照度条件对可靠度影响明显,在井下生产过程中,低照度环境下应尽量避免安排复杂的机械化操作。3)反应时间与光照时间呈二次函数关系,通过建立回归方程量化了两者的关系,为以后合理安排煤矿工人劳动休息时间提供了理论依据。     

空区隐患爆破治理方案及延期时间的数值模拟分析

为了防止矿山空区引起地表塌陷造成建构（筑）物的破坏以及降低矿柱塌落振动对井下开采的威胁,采用现场试验与数值模拟相结合的方法,优选爆破治理方案和延期时间。根据炮孔布置和爆破参数,建立实际比例数值模型;在岩石物理力学指标测试的基础上,确定模型材料参数;采用LS-DYNA数值模拟软件,对比分析方案优劣以及确定爆破延期时间。研究结果表明:在满足空区隐患爆破治理效果的前提下,同一节点处A方案质点振速峰值为0.923 9 m/s小于B方案质点振速峰值1.225 3 m/s;而且当延期时间为100 ms时,通过模型垂直方向的位移云图可知岩石的破坏范围最大,塌落区域更加分散。现场应用结果显示空区隐患治理工程爆破效果良好,形成了隔离缓冲层,可以保证露天和井下的安全。