Development and application of LC–APCI–MS method for biomonitoring of animal and human exposure to imidacloprid

Imidacloprid (IMI) is a relatively new neuro-active neonicotinoid insecticide and nowadays one of the largest selling insecticides worldwide. In the present study a LC–APCI–MS based method was developed and validated for the quantification of imidacloprid and its main metabolite 6-chloronicotinic acid (6-CINA) in urine and hair specimens. The method was tested in biomonitoring of intentionally exposed animals and subsequently applied for biomonitoring of Cretan urban and rural population.     

养殖固体废物在硝酸和磷酸溶液中的水解特性

养殖固体废物掺杂磷肥工艺中养殖固体废物与酸的反应直接影响其有机组成。以鸡粪为研究对象,采用L16(45)正交试验研究了鸡粪粒径、酸浓度、鸡粪与酸溶液质量比、反应温度和反应时间对鸡粪在硝酸和磷酸溶液中水解过程的影响。结果表明,硝酸溶液中影响因素显著性依次为鸡粪与硝酸质量比、反应时间、硝酸浓度、鸡粪粒径、反应温度,最优工艺条件为鸡粪粒径0.20mm、硝酸质量分数15%、鸡粪与硝酸质量比0.2∶1.0、反应温度95℃、反应时间4h;在磷酸溶液中影响因素显著性依次为鸡粪与磷酸质量比、反应温度、鸡粪粒径、磷酸浓度、反应时间,鸡粪水解率与反应温度间呈正相关关系,最优工艺条件为鸡粪粒径0.40mm、磷酸质量分数60%、鸡粪与磷酸质量比0.1∶1.0、反应温度95℃、反应时间8h。鸡粪比表面积及其单位质量耗酸量、美拉德反应是制约鸡粪在硝酸和磷酸中水解反应的内因。研究结果为养殖固体废物掺杂有机磷肥的研发和推广提供了理论基础。     

废LCD面板有机材料水热资源化产乙酸

LCD面板主要由附着偏光片及液晶等有机材料的玻璃面板构成。有机材料的去除及资源化利用是废LCD面板处理的第一步。在水热条件下对废LCD面板进行了降解产酸研究。研究考察了反应温度、反应时间、氧化剂用量、水用量及pH值等对水热产乙酸产率及选择性的影响。通过正交实验确定了水热产乙酸的最佳操作条件：反应温度325℃,反应时间5min,氧化剂（30％H2O2）0．6mL,用水量2mL,近中性环境（pH6-6．5去离子水）。此条件下,乙酸产率及选择性分别为68．83％及70．56％。结果表明,以废LCD面板有机材料为原料,采用水热技术进行产乙酸反应,可实现其资源化再利用。     

季节性城市生活垃圾成分分析及厌氧消化特性研究

城市生活垃圾的成分及特性随着季节和人类在不同季节的生活习惯而变化,针对我国北方城市研究了一年中不同季节的城市生活垃圾成分特点,对影响厌氧发酵过程的相关成分如总有机碳（TOC）、总氮（TN）、蛋白质、脂肪和还原糖等进行了测定分析。通过厌氧消化实验,测得不同季节城市生活垃圾pH值、日产气量、沼气甲烷含量、甲烷累积量、挥发性脂肪酸（VFAs）和氧化还原电位（ORP）等参数的变化规律,分析相应变化的影响因素。结果表明,二、三季度的含水率分别为64．81％和67．50％,高于一、四季度,一季度发酵原料中蛋白质和脂肪含量分别为12．56％和8．86％,明显高于其他3个季度。一季度甲烷累积量最高,达到17616mL,单位发酵原料的产气量为204．8mL／g,也是4个季度中最高的,说明蛋白质、脂肪等有机成分含量对厌氧发酵过程及结果影响比较明显。为进一步的城市生活垃圾厌氧消化制取生物燃气的工艺条件提供依据。     

重庆市大气污染对锌材料腐蚀的经济损失分析

简要介绍了材料大气腐蚀经济损失的估算方法,并以2002年为基准年,选择了重庆市主城中心的6个功能区作为代表性区域,运用腐蚀破坏剂量响应函数和使用寿命计算公式对锌材料的腐蚀经济损失进行了定量估算.结果表明,由大气污染腐蚀破坏锌材料造成的年直接经济损失约为4061.7万元,约为同期GDP的0.1%.其中,干沉降对经济损失总量的贡献率在71%～99%之间,均值为92%.     

Life cycle assessment of waste paper management: The importance of technology data and system boundaries in assessing recycling and incineration

The significance of technical data, as well as the significance of system boundary choices, when modelling the environmental impact from recycling and incineration of waste paper has been studied by a life cycle assessment focusing on global warming potentials. The consequence of choosing a specific set of data for the reprocessing technology, the virgin paper manufacturing technology and the incineration technology, as well as the importance of the recycling rate was studied. Furthermore, the system was expanded to include forestry and to include fossil fuel energy substitution from saved biomass, in order to study the importance of the system boundary choices. For recycling, the choice of virgin paper manufacturing data is most important, but the results show that also the impacts from the reprocessing technologies fluctuate greatly. For the overall results the choice of the technology data is of importance when comparing recycling including virgin paper substitution with incineration including energy substitution. Combining an environmentally high or low performing recycling technology with an environmentally high or low performing incineration technology can give quite different results. The modelling showed that recycling of paper, from a life cycle point of view, is environmentally equal or better than incineration with energy recovery only when the recycling technology is at a high environmental performance level. However, the modelling also showed that expanding the system to include substitution of fossil fuel energy by production of energy from the saved biomass associated with recycling will give a completely different result. In this case recycling is always more beneficial than incineration, thus increased recycling is desirable. Expanding the system to include forestry was shown to have a minor effect on the results. As assessments are often performed with a set choice of data and a set recycling rate, it is questionable how useful the results from this kind of LCA are for a policy maker. The high significance of the system boundary choices stresses the importance of scientific discussion on how to best address system analysis of recycling, for paper and other recyclable materials.     

The greenhouse gas balance of the Province of Siena

There is a profound debate over how to assign greenhouse gas (GHG) responsibilities; therefore, we have decided to follow IPCC guidelines, as they offer the only standardized method. We have identified each type of greenhouse emission and its level of absorption. We have studied the province and its districts and municipalities. We have determined that the energy sector is that with the highest level of emissions, even if the per capita emissions of the Province of Siena are very low. This is caused by a very low level of industrialization and the presence of a local geothermal production of energy. In order to highlight this aspect, we have considered scenarios both with and without geothermal production. Our research was then focused on single districts (groups of homogenous municipalities) and municipalities, where we found great differences among the greenhouse emissions of the areas. We have constructed a map of the greenhouse emissions of the whole province. It has been interesting to note that there are 14 municipalities with net negative emissions, seven with low positive emissions, 12 with medium positive emissions and three with elevated positive emissions. These latter correspond to the main city and to two of the most industrialized municipalities.     

不同物质对垃圾渗滤液中腐殖酸的吸附研究

垃圾渗滤液是一种有毒有害的高浓度有机废水,其中含大量腐殖酸。腐殖酸具有离子交换能力、吸附能力和脱除杂质能力,因此在很多方面有实用价值。活性碳、土壤、堆肥对废水中的有机物有一定的吸附能力。本文采用正交设计的方法,研究了活性碳、土壤、堆肥在不同温度,液／固,腐殖酸初始浓度的条件下对垃圾渗滤液中腐殖酸的吸附效果。实验结果表明：四种实验因素对吸附剂的吸附能力的影响程度为：吸附剂类型〉腐殖酸的初始浓度〉吸附反应温度〉液固比。在温度为25℃,液固比为50／0．5（mL/g）,腐殖酸初始浓度为41．99（mg／L）,吸附剂类型为活性碳时,腐殖酸吸附量最大,为40．86mg。同时分析了响应指标随因素的变化趋势。     

放射源使用中潜在照射危险的评价与控制浅述

文章介绍了潜在照射的主要来源及危害。结合实际应用中的具体情况,对其使用实践中可能导致的潜在危害作了简单的分析,并根据ICPLP的相关建议和国家相关的具体要求,提出在放射源应用领域潜在照射控制的主要原则和措施。     

河北省钢铁工业主要大气污染物减排潜力分析

通过对河北省钢铁工业存在问题的分析,得出我省钢铁行业主要大气污染物为二氧化硫和粉尘.结合我省钢铁企业的实际情况,从工程技术、政策管理等方面提出相应治理措施,并对"十一五"期间我省钢铁行业二氧化硫和粉尘减排效益进行预测.预测结果显示:采用所建议的减排措施后,我省钢铁工业二氧化硫减排量对全省"十一五"减排计划的贡献率为81.4%;粉尘可减排60%.