水平管内不同煤质煤尘爆炸火焰传播特性实验研究

为研究水平管道空间不同煤质煤尘爆炸火焰传播特性,选取褐煤、长焰煤、不粘煤、气煤4种煤尘,对爆炸火焰焰峰特性、火焰加速传播特性、火焰传播距离与持续时间展开研究。研究结果表明:褐煤在500 ms内焰峰的形状由尖锐向平滑再向钝化不断演变,长焰煤与不粘煤在375 ms时焰峰前端出现明显焰体分离现象,分析认为这与管体冷壁效应、空间尺度效应及空间氧气消耗直接相关;气煤在375 ms时焰峰出现大面积火焰碎纹,说明气煤爆炸火焰猛烈传播的持续时间相对较短,整体爆炸强度相对较弱;褐煤与长焰煤爆炸火焰存在2次间断性加速,分析认为这与管体空间受限、常温管壁散热、局部助燃氧气瞬间不足等因素有关;褐煤在爆炸后400～600 ms内火焰2次加速完全,火焰传播距离达740 mm,明显大于长焰煤、不粘煤与气煤,说明低变质褐煤爆炸火焰持续时间更长,火焰传播距离更远且传播更剧烈;虽然气煤火焰最远传播距离比长焰煤大30 mm,但由于气煤火焰在375 ms左右出现大片火焰碎纹,因此气煤整体的爆炸强度小于长焰煤。     

石化装置安全仪表系统KooN表决结构的误跳车率定量分析

为了更准确量化安全仪表系统的误跳车率,基于联锁回路SIF中传感器、逻辑解算器、执行机构引发误跳车的不同失效机理和模型,考虑共因失效对误跳车率的影响,提出1种更符合实际并适用于异型KooN结构的新子系统误跳车率计算模型（STR of Non-identical Redundant System,SNRS）。针对SIF回路的误跳车率计算,建立了1种分析安全联锁SIF回路误跳车率（Reliability based Spurious Trip,RST）的计算框架。研究结果表明:以某聚丙烯装置第三反应器保护系统为例,将SNRS和RST方法与目前主流的多种计算方法进行数值计算对比,验证了方法的有效性,能够有效进行定量分析。     

基于尾涡强度的无人机与民机纵向安全间隔评估研究

为了解决无人机频频入侵机场净空,与民航客机发生危险接近的问题,以碰撞风险为量化指标,对无人机与民机需要保持的纵向安全间隔进行评估研究。分析民机尾涡流场对无人机运行的影响,利用Crow近场涡强度消散理论,得到实际尾迹影响区改进Reich碰撞模板,据此建立CNS/GPS性能环境下的纵向间隔评估模型,通过Matlab进行间隔值求解。研究结果表明:模型可以较为准确地反映民机起飞初始爬升阶段无人机尾随运行时导航性能和尾涡迹对所需最小间隔值的影响,并得到给定安全目标水平的计算结果。     

MoS_2/Bi_2S_3异质结光催化剂的制备及其光催化性能

以五水硝酸铋为铋源、钼酸钠为钼源、硫脲为硫源,采用简单的一步水热法合成了MoS_2/Bi_2S_3异质结光催化剂,采用XRD,SEM,TEM,BET,UV-Vis DRS技术对其进行了表征。表征结果显示,MoS_2纳米片在Bi_2S_3微棒表面生长,增加了比表面积和活性位点,并形成异质结构,促进了光生载流子的迁移,抑制了电子-空穴对的再复合。实验结果表明:钼酸钠与五水硝酸铋的质量比为1∶2时制备的复合光催化剂性能最好,反应180min时对亚甲基蓝的去除率可达96.4%,明显高于MoS_2和Bi_2S_3,且具有较高的稳定性;该催化剂对罗丹明B、甲基橙和4-硝基苯酚的去除率分别为97.1%、93.1%和90.5%,表明其对污染物具有普适性。     

Supporting Diverse Data Providers in the Open Water Data Initiative: Communicating Water Data Quality and Fitness of Use

Shared, trusted, timely data are essential elements for the cooperation needed to optimize economic, ecologic, and public safety concerns related to water. The Open Water Data Initiative (OWDI) will provide a fully scalable platform that can support a wide variety of data from many diverse providers. Many of these will be larger, well‐established, and trusted agencies with a history of providing well‐documented, standardized, and archive‐ready products. However, some potential partners may be smaller, distributed, and relatively unknown or untested as data providers. The data these partners will provide are valuable and can be used to fill in many data gaps, but can also be variable in quality or supplied in nonstandardized formats. They may also reflect the smaller partners' variable budgets and missions, be intermittent, or of unknown provenance. A challenge for the OWDI will be to convey the quality and the contextual “fitness” of data from providers other than the most trusted brands. This article reviews past and current methods for documenting data quality. Three case studies are provided that describe processes and pathways for effective data‐sharing and publication initiatives. They also illustrate how partners may work together to find a metadata reporting threshold that encourages participation while maintaining high data integrity. And lastly, potential governance is proposed that may assist smaller partners with short‐ and long‐term participation in the OWDI.     

Recent Changes in Stream Flashiness and Flooding,and Effects of Flood Management in North Carolina and Virginia

The southeastern United States has undergone anthropogenic changes in landscape structure, with the potential to increase (e.g., urbanization) and decrease (e.g., reservoir construction) stream flashiness and flooding. Assessment of the outcome of such change can provide insight into the efficacy of current strategies and policies to manage water resources. We (1) examined trends in precipitation, floods, and stream flashiness and (2) assessed the relative influence of land cover and flow‐regulating features (e.g., best management practices and artificial water bodies) on stream flashiness from 1991 to 2013. We found mean annual precipitation decreased, which coincided with decreasing trends in floods. In contrast, stream flashiness, overall, showed an increasing trend during the period of study. However, upon closer examination, 20 watersheds showed stable stream flashiness, whereas 5 increased and 6 decreased in flashiness. Urban watersheds were among those that increased or decreased in flashiness. Watersheds that increased in stream flashiness gained more urban cover, lost more forested cover and had fewer best management practices installed than urban watersheds that decreased in stream flashiness. We found best management practices are more effective than artificial water bodies in regulating flashy floods. Flashiness index is a valuable and straightforward metric to characterize changes in streamflow and help to assess the efficacy of management interventions.     

A study on oxidative degradation of polyacrylamide in wastewater with UV/FENTON/C4H4O62−

The degradation of polyacrylamide (PAM) in simulate wastewater was studied in UV/Fenton/C₄H₄O₆^2? system. The factors such as molecular ratio of H₂O₂/Fe²⁺/C₄H₄O₆^2?, pH, and the dosage of Fenton reagent that could affect the PAM degradation in the UV/Fenton/C₄H₄O₆^2? system were investigated. The experimental results showed that adding C₄H₄O₆^2? to UV/Fenton system could form photosensitive ferrous complexes, which led to higher degradation efficiency of PAM. The degradation rate of PAM could be up to 95.2% under the following conditions: the concentration of H₂O₂, Fe²⁺, and C₄H₄O₆^2? were 22.5, 2.25, and 2.25 mmol/L, respectively (i.e., molecular ratio of H₂O₂/Fe²⁺/C₄H₄O₆^2? was 10:1:1), the pH value was 3.0.     

Comparative study on performances of a heat-pipe PV/T system and a heat-pipe solar water heating system

The heat-pipe solar water heating (HP-SWH) system and the heat-pipe photovoltaic/thermal (HP-PV/T) system are two practical solar systems, both of which use heat pipes to transfer heat. By selecting appropriate working fluid of the heat-pipes, these systems can be used in the cold region without being frozen. However, performances of these two solar systems are different because the HP-PV/T system can simultaneously provide electricity and heat, whereas the HP-SWH system provides heat only. In order to understand these two systems, this work presents a mathematical model for each system to study their one-day and annual performances. One-day simulation results showed that the HP-SWH system obtained more thermal energy and total energy than the HP-PV/T system while the HP-PV/T system achieved higher exergy efficiency than the HP-SWH system. Annual simulation results indicated that the HP-SWH system can heat the water to the available temperature (45°C) solely by solar energy for more than 121 days per year in typical climate regions of China, Hong Kong, Lhasa, and Beijing, while the HP-PV/T system can only work for not more than 102 days. The HP-PV/T system, however, can provide an additional electricity output of 73.019 kWh/m², 129.472 kWh/m², and 90.309 kWh/m² per unit collector area in the three regions, respectively.     

The determination and matching analysis of pinch point temperature difference in evaporator and condenser of organic rankine cycle for mixed working fluid

Exergo-economic analysis of the pinch point temperature difference (PPTD) in both evaporator and condenser of sub-critical organic Rankine cycle system (ORCs) are performed based on the first and second laws of thermodynamics. Taking mixture R13I1/R601a as a working fluid and the annual total cost per net output power Z as exergo-economic performance evaluation criterion, the effects of PPTD in evaporator ΔT_e, and the PPTD ratio of condenser to evaporator y, on the exergo-economic performance of ORCs are analyzed. Moreover, how some other parameters influence the optimal PPTD in evaporator ΔT_e,opt and the optimal PPTD ratio of condenser to evaporator y_opt are also discussed. It has been found that the exergo-economic performance of ORCs is remarkably influenced by ΔT_e and y, and there exists ΔT_e,opt and y_opt. In addition, ΔT_e,opt and y_opt are affected by heat transfer coefficient ratio of condenser to evaporator ß, the temperature of working fluid at dew point in condenser T_1a, and composition of R13I1/R601a: larger ß and T_1a lead to lower ΔT_e,opt and y_opt; by contraries, larger mass fraction of R13I1 makes ΔT_e,opt and y_opt increase, and y_opt increases linearly. The effects of the temperature of working fluid at bubble point in evaporator T_3a, mass flow rate of exhaust flue gas m_g, and inlet temperature of exhaust flue gas T_gi on ΔT_e,opt and y_opt are very slight. For comparison, three additional working fluids, namely R601a, R245fa, and 0.32R245fa/0.68R601a, are also taken into account.     

Photovoltaic-thermal (PV/t) panel to minimize electrical and air conditioning energy consumption of a typical office in Beirut

A combined photovoltaic–thermal (PV/t) panel is proposed to produce simultaneously electricity and heat from one integrated unit. The unit utilizes effectively the solar energy through achieving higher PV electrical efficiency and using the thermal energy for heating applications. To predict the performance of the PV/t at a given environmental conditions, a transient mathematical model was developed. The model was integrated in a heating application for a typical office space in the city of Beirut to provide the office needs for electricity, heating during winter season, and dehumidification and evaporative cooling during the summer season. To minimize the yearly office energy (electrical and heat) needs, the PV/t panel cooling air flow rate and the dehumidification regeneration temperature were determined for opimal unit operation. Thermal energy savings of up to 85% in winter and 71% in summer were achived compared to conventional systems at a payback period of 8 years for the panels.