肥煤自燃全过程热动力学特征参数研究

实验测定了林西矿肥煤样品30~900℃煤自燃全过程热动力学特征参数,得出:TG/DTG曲线显示煤样DTG初始临界温度45℃,干裂温度122℃,活性温度195℃,增速温度265℃,质量极大值温度342℃,着火温度465℃,最大热失重速率温度515℃和燃尽温度690℃;DSC曲线显示,煤样初始放热温度60℃、最大热释放速率温度511℃。结合TG-DTG-DSC曲线综合分析可知,煤温达到510℃左右时煤样反应最剧烈。由煤自燃标志气体测定实验系统得出:煤温130℃后CO,CO 2释放量迅速增加,210℃增加速度下降;CH 4,C 2 H 6含量变化具有规律性且两者变化相近;C 2 H 4出现温度为130℃;C 2 H 4/C 2 H 6比值在190~350℃有较强的规律性,呈上升趋势且上升速度较快;350℃之后,CH 4,C 2 H 6,C 2 H 4体积分数均开始急剧增大;C 2 H 4/CO与C 2 H 4/CO 2变化趋势大致相同,在130~350℃时缓慢增长,达到350℃后比值呈指数形式上升。经拟合曲线,得到活化能的3个突变点温度:70,180,220℃,其中180℃与交叉点温度相吻合。通过以上研究,得到了肥煤自燃全过程的热力学特征参数,为实际生产中防治煤自燃提供了理论依据。     

硫化废气污泥活性炭净化处理技术研究

以污泥厂剩余活性污泥作为原料,采用KOH为活化剂制备污泥活性炭,探讨了活化温度及时间、热解温度、洗涤温度及方式在污泥活性炭制备过程中的最佳工艺条件。以品红吸附量及产率作为污泥活性炭的考察指标,采用单因素实验筛选出了制备污泥活性炭的最佳工艺条件,并对污泥活性炭脱硫剂的脱硫性能进行了实验研究。实验研究结果显示,烟气中O2、水蒸气含量的多少及脱硫温度的高低会影响污泥活性炭脱硫剂的脱硫性能。     

单轴应力对煤自燃特性参数和导热系数的影响研究

为探究单轴应力作用下煤氧化和传热特性,利用自制荷载加压煤自燃特性参数测定装置对炉体内长焰煤煤样进行程序升温。结合程序升温过程中煤临界温度Tc和Tg,对其进行阶段划分:阶段1为30℃~Tc;阶段2为Tc~Tg。计算了不同单轴应力下2个阶段煤表观活化能和平均耗氧速率。根据能量守恒得出程序升温过程煤导热系数随温度的变化,进一步分析煤导热系数与单轴应力的关系。结果表明:阶段1单轴应力为4 MPa时为临界轴压,煤表观活化能最大,平均耗氧速率最小;阶段2煤表观活化能和平均耗氧速率随单轴应力增大均呈抛物线变化,单轴应力为2.7 MPa时为临界轴压,煤表观活化能最大,平均耗氧速率最小;阶段1和2煤导热系数随温度升高均先减小后增大,并且煤导热系数随单轴应力增大呈三次函数变化。     

磷酸活化植物基活性炭对水溶液中铅的吸附

以棉秆与互花米草为原料,采用磷酸活化法制备了低成本的植物基活性炭,通过静态实验研究了其对重金属铅的吸附性能。结果表明,在活化温度为500℃、活化时间为2 h条件下,制备的棉秆和互花米草活性炭比表面积为1 570m2/g和856 m2/g,含氧酸官能团含量分别为1.43 mmol/g和1.27 mmol/g。在25℃下,两种活性炭对重金属铅的Langmuir最大吸附量分别为119 mg/g和111 mg/g,吸附最佳pH为4.3,吸附平衡符合Freundlich方程,离子交换在吸附过程中发挥了重要作用。     

微波活化过硫酸钾深度处理印染废水

为了深度处理印染废水生化出水,使其达到工业回用要求,利用微波活化过硫酸钾产生具有强氧化性的硫酸根自由基·SO-4,降解印染废水生化出水中的有机污染物。考察了硫酸亚铁的投加量,过硫酸钾的浓度及pH的影响,并通过对比实验讨论了微波活化作用效果。结果表明,过硫酸钾微波组合能够有效地去除生化出水中的TOC和色度。对于某印染废水生化出水,处理效果在pH=10时最好,当过硫酸钾浓度为14 g/L时,TOC去除率达57.60%,脱色率为98.28%。研究结果表明,过硫酸钾微波组合对于印染废水的深度处理效果良好,有较好的应用前景。     

罐底含油泥热解动力学参数计算方法的优选

在化学反应设计中反应动力学是较重要的因素。为得到更合理的污泥热解动力学参数计算方法,利用热重分析仪,在氮气气氛下对罐底含油污泥的热解特性进行研究。根据热重实验数据,分别采用Coats-Redfern法、Kissinger法、FWO法和Popescu法计算污泥热解动力学参数,并获取罐底泥热解制油的主要阶段(第2阶段)的反应活化能E、频率因子A并分析各种方法反应机理。通过对比不同计算方法得到动力学参数及拟合曲线与实验曲线的相关性,确定了最佳罐底含油污泥热解动力学参数计算方法。研究表明,Popescu法得到罐底泥的热解过程符合Jander方程,活化能E为101.43 kJ/mol,与FWO法得到的91.20 kJ/mol相近,且预测曲线与实验曲线有较好的相关性(0.9816),说明Popescu法计算罐底泥热解动力学参数更合适。     

用煤矸石合成4A沸石分子筛处理氨氮废水

以煤矸石为原料,采用碱熔-水热法合成4A沸石分子筛。由于煤矸石中铝、硅主要以高岭土形式存在,其活化过程是合成4A沸石分子筛关键环节。为提高4A沸石分子筛钙离子的交换能力,增加对模拟废水氨氮的去除率,实验考察了碳酸钠与煤矸石质量比、活化温度、活化时间、晶化温度和晶化时间对4A沸石分子筛钙离子交换能力的影响,同时也考察了模拟废水的pH、4A沸石分子筛加入量及吸附时间对氨氮去除率的影响。结果表明,最佳工艺条件为,碳酸钠与煤矸石质量比为0.9、活化温度为800℃、活化时间1.5 h、晶化温度90℃和晶化时间3 h。合成4A沸石分子筛的钙离子交换能力为310 mg/g,在pH为6的100 mL模拟氨氮废水中加入6 g 4A沸石分子筛吸附40 min后,废水中氨氮的去除率达到86%。通过最佳工艺条件合成4A沸石分子筛,在处理氨氮废水方面具有一定的应用前景。     

Phenol depletion by thermally activated peroxydisulfate at 70°C

The ability of thermal activated peroxydisulfate (PS) of mineralizing phenol at 70 °C from contaminated waters is investigated. Phenol in concentrations of 10⁻⁴ to 5 × 10⁻⁴ M is quantitatively depleted by 5 × 10⁻³ to 10⁻² M activated PS in 15 min of reaction. However, mineralization of the organic carbon is not observed. Instead, an insoluble phenol polymer-type product is formed. A reaction mechanism including the formation of phenoxyl radicals and validated by computer simulations is proposed. High molecular weight phenolic products are formed by phenoxyl radical H-abstraction reactions. This is not the case for the room temperature degradation of phenol by sulfate radicals where sulfate addition to the aromatic ring mainly leads to the generation of hydroxycyclohexadienyl radicals leading to hydroxybenzenes and oxidized open chain products. Therefore, a change in the reaction mechanism is observed with increasing temperature, and thermal activation of PS at 70 °C does not lead to the mineralization of phenol. Thus PS activation at 70 °C may be considered a potential method to reduce the load of phenol in polluted waters by polymerization.     

Batch sorption dynamics and equilibrium for the removal of lead ions from aqueous phase using activated carbon developed from coffee residue activated with zinc chloride

Lignocellulosic materials are good precursors for the production of activated carbon. In this work, coffee residue has been used as raw material in the preparation of powder activated carbon by the method of chemical activation with zinc chloride for the sorption of Pb(II) from dilute aqueous solutions.The influence of impregnation ratio (ZnCl₂/coffee residue) on the physical and chemical properties of the prepared carbons was studied in order to optimize this parameter. The optimum experimental condition for preparing predominantly microporous activated carbons with high pore surface area (890 m²/g) and micropore volume (0.772 cm³/g) is an impregnation ratio of 100%. The developed activated carbon shows substantial capability to sorb lead(II) ions from aqueous solutions and for relative impregnation ratios of 75 and 100%, the maximum uptake is practically the same. Thus, 75% represents the optimal impregnation ratio.Batch experiments were conducted to study the effects of the main parameters such as contact time, initial concentration of Pb(II), solution pH, ionic strength and temperature. The maximum uptake of lead(II) at 25 °C was about 63 mg/g of adsorbent at pH 5.8, initial Pb(II) concentration of 10 mg/L, agitation speed of 200 rpm and ionic strength of 0.005 M. The kinetic data were fitted to the models of pseudo-first order and pseudo-second order, and follow closely the pseudo-second order model. Equilibrium sorption isotherms of Pb(II) were analyzed by the Langmuir, Freundlich and Temkin isotherm models. The Freundlich model gives a better fit than the others.Results from this study suggest that activated carbon produced from coffee residue is an effective adsorbent for the removal of lead from aqueous solutions and that ZnCl₂ is a suitable activating agent for the preparation of high-porosity carbons.     

过硫酸钾去除水中的TCE

以地水中的氯代烃污染物三氯乙烯(TCE)为目标污染物,以过硫酸钾溶液为氧化剂,探讨了不同条件下过硫酸钾对TCE的去除效果。实验结果表明,在40℃,过硫酸钾初始浓度为2.43 g/L条件下,反应2 h后,TCE的去除率就可达到96.8%;过硫酸钾对TCE的去除符合一级反应动力学方程,速率常数(K)为1.3364 h-1,半衰期(t1/2)为0.51 h;过硫酸钾对TCE的去除速率在pH为中性附近时最大,其后无论pH升高或降低去除速率均减小;受温度和pH影响较明显,并且反应温度越高,受pH的影响越明显;随离子强度的增加而减小;反应活化能为119.6 kJ/mol;过硫酸钾溶于水生成过硫酸根离子(S2O28-),S2O28-会进一步生成硫酸根自由基(SO4-.),在碱性条件下,SO4-.与OH-反应会进一步生成羟基自由基(.OH)。过硫酸钾对于TCE的去除主要源自SO4-.和.OH的强氧化性。