大连海域远洋船舶排放清单

为准确评估船用柴油机实际排放,利用船舶自动识别系统(automatic identification system,AIS)采集远洋船舶的船速、航行时间、地理位置信息等实时航行数据,采用动力法对2012年大连港远洋船舶的排放清单进行计算. 结果表明:2012年大连港远洋船舶PM₁₀、NO_x、SO_x、CO、HC、CO₂总排放量分别为5 785(包括4 628 t PM_2.5)、51 451、49 437、4 677、2 010及2 885 388 t. 在4种运行工况中系泊工况排放量最大,受船舶类型和污染物种类影响,系泊工况污染物排放所占比例有所不同,但其分担率均在75.0%左右. 船舶排放污染物的空间分析表明,船舶系泊停靠的港口区域是污染物排放最密集的区域. 从船舶类型来看,散货船、集装箱船、邮轮和油轮是污染物主要排放船型,在整个船舶排放清单中,这4类船舶对DPM(柴油机颗粒物)、NO_x、SO_x、CO、CO₂的排放分担率之和分别为90.9%、91.4%、91.9%、91.5%、91.9%. 在船舶的主机、辅机和锅炉3种排放源中,主机是主要排放源,集装箱船和滚装船的主机分担率为90.0%,货船和邮轮的辅机排放分担率达到40.0%.      

连通容器气体密闭爆炸与泄爆过程的实验研究

利用球型容器与管道组合,开展连通容器气体爆炸与泄爆实验,分析连通条件下,火焰在管道中的传播过程及其对起爆容器和传爆容器的压力影响。实验结果表明:连通容器气体爆炸中,火焰从起爆容器到传爆容器传播经历了一段不断加速,但加速度不断减小的过程;泄爆过程中,火焰传播过程与密闭爆炸时基本一致。管道中火焰加速传播,使得传爆容器的爆炸压力和强度相较于作为起爆容器时均明显增加,危险更大,采用与起爆容器相同的泄爆面积,无法满足对连通容器中传爆容器的泄爆。同时,泄爆是一个快速的能量泄放过程应选择合理的泄爆方式,防止二次危害。     

烟气脱硫过程中添加剂对石灰石的促溶作用

以双搅拌釜为实验设备,研究了烟气脱硫过程中硫酸钠、硫酸镁和腐殖酸钠对石灰石的促溶作用.结果表明,分别采用3种不同添加剂时,pH值等随脱硫反应时间的变化规律类似;与非强化石灰石脱硫过程对比,在相同pH值下,3种添加剂均使石灰石颗粒体积占初始体积的分率rp减小,即均能促进石灰石的溶解,改善浆液的传质性能.通过理论分析,导出了r_p与浆液pH值之间的关系式,该方程能很好地关联双搅拌釜实验数据.     

光生物反应器培养紫球藻及藻粉降血脂的研究

研究了搅拌式光生物反应器中搅拌速度、通气量对紫球藻生长、胞外多糖和藻细胞超微结构的影响．实验结果表明：在特定光照(1000μmolm^-2s^-1)和培养温度(25℃)条件下，当搅拌转速为200r／min、通气量为0．71vvm时，藻生长速度和胞外多糖含量最高；增加通气量有利于藻细胞胞外多糖及生物量的提高．对藻细胞超微结构的观察发现，与摇床培养相比，搅拌式光生物反应器使藻细胞淀粉颗粒明显增多，粘质鞘层变薄，光合片层增多．动物实验表明，紫球藻能明显降低摄食高脂饲料SD大鼠血脂TC、TG、LDL-C水平，并提高HDL-C含量．实验结果预示，紫球藻对预防动脉粥样硬化和冠心病的发生有一定的意义．图2表3参26     

Effects of a gradually increased load of fish waste silage in co-digestion with cow manure on methane production

This study examined the effects of an increased load of nitrogen-rich organic material on anaerobic digestion and methane production. Co-digestion of fish waste silage (FWS) and cow manure (CM) was studied in two parallel laboratory-scale (8 L effective volume) semi-continuous stirred tank reactors (designated R1 and R2). A reactor fed with CM only (R0) was used as control. The reactors were operated in the mesophilic range (37 °C) with a hydraulic retention time of 30 days, and the entire experiment lasted for 450 days. The rate of organic loading was raised by increasing the content of FWS in the feed stock. During the experiment, the amount (volume%) of FWS was increased stepwise in the following order: 3% – 6% – 13% – 16%, and 19%. Measurements of methane production, and analysis of volatile fatty acids, ammonium and pH in the effluents were carried out. The highest methane production from co-digestion of FWS and CM was 0.400 L CH4 gVS^?1, obtained during the period with loading of 16% FWS in R2. Compared to anaerobic digestion of CM only, the methane production was increased by 100% at most, when FWS was added to the feed stock. The biogas processes failed in R1 and R2 during the periods, with loadings of 16% and 19% FWS, respectively. In both reactors, the biogas processes failed due to overloading and accumulation of ammonia and volatile fatty acids.     

Effect of impeller type and mechanical agitation on the mass transfer and power consumption aspects of ASBR operation treating synthetic wastewater

The effect of flow type and rotor speed was investigated in a round-bottom reactor with 5 L useful volume containing 2.0 L of granular biomass. The reactor treated 2.0 L of synthetic wastewater with a concentration of 800 mgCOD/L in 8-h cycles at 30 degrees C. Five impellers, commonly used in biological processes, have been employed to this end, namely: a turbine and a paddle impeller with six-vertical-flat-blades, a turbine and a paddle impeller with six-45 degrees -inclined-flat-blades and a three-blade-helix impeller. Results showed that altering impeller type and rotor speed did not significantly affect system stability and performance. Average organic matter removal efficiency was about 84% for filtered samples, total volatile acids concentration was below 20 mgHAc/L and bicarbonate alkalinity a little less than 400 mgCaCO3/L for most of the investigated conditions. However, analysis of the first-order kinetic model constants showed that alteration in rotor speed resulted in an increase in the values of the kinetic constants (for instance, from 0.57 h(-1) at 50 rpm to 0.84 h(-1) at 75 rpm when the paddle impeller with six-45 degrees -inclined-flat-blades was used) and that axial flow in mechanically stirred reactors is preferable over radial-flow when the vertical-flat-blade impeller is compared to the inclined-flat-blade impeller (for instance at 75 rpm, from 0.52 h(-1) with the six-flat-blade-paddle impeller to 0.84 h(-1) with the six-45 degrees -inclined-flat-blade-paddle impeller), demonstrating that there is a rotor speed and an impeller type that maximize solid-liquid mass transfer in the reaction medium. Furthermore, power consumption studies in this reduced reactor volume showed that no high power transfer is required to improve mass transfer (less than 0.6 kW/10(3)m3).     

CSTR和MBR反应器的短程硝化快速启动

为实现短程硝化的快速启动,采用完全混合反应器(CSTR)和膜生物反应器(MBR)进行短程硝化启动性能对比研究,考察两个反应器在启动时间、氮素转化和污泥性能3个方面的差异.结果表明在进水C/N=1,温度为30℃±1℃,pH为7.5~8.0,DO为0.6~1.0 mg·L~(-1),结合缺氧/好氧比为1∶3(15 min∶45 min)和缩短HRT,CSTR和MBR分别运行56 d和44 d成功启动短程硝化,MBR启动周期较短.运行至第14 d、第28 d和第56 d时,CSTR和MBR亚硝累积率平均为51%、66%、89%和50%、71%、93%,硝酸盐氮生成速率(以NO_3~--N/MLVSS计)依次为7.4、4.0、1.7和7.6、3.5、1.0 mg·(g·h)~(-1),MBR在第28 d和第56 d表现出较高的亚硝累积率和较低的NO_3~--N产率,有利于短程硝化的快速启动.整个运行过程中,两个反应器内的亚硝化污泥均呈黄色,SVI在55~110 mL·g~(-1),MLVSS/MLSS稳定在0.6~0.8左右,良好的污泥性能为CSTR和MBR短程硝化的快速启动创造了有利条件.MBR在短程硝化快速启动中展现出更明显的优势.     

柱形连通容器内预混气体爆炸过程的火焰传播模拟

为研究连通容器内气体爆炸规律,采用Fluent(经典流体动力学软件)对柱形连通容器内预混气体爆炸过程进行模拟,模拟了不同点火位置和火焰传播方向条件下连通容器内火焰传播过程和压力变化,并分析了连通容器内不同时刻的速度场.结果表明:火焰面在传播过程中并非完全对称,当火焰到达传爆容器后,湍流燃烧剧烈,火焰不规则变形显著;端面点火后在传爆容器内产生的压力峰值和压力波动比中心点火时更大;当起爆容器为大容器时,传爆容器内气体预压缩程度更大,压力峰值更高.