The dynamics of landfill diversion: Economic drivers, policy factors and spatial issues: Evidence from Italy using provincial panel data

Waste disposal is an issue that is becoming increasingly important in policy terms in the European Union, and in Italy, a country showing strong geographical heterogeneity in waste management. This paper analyses the process of decoupling/delinking between economic growth and landfilling trends in a framework where economic, policy, geographical elements and spatial issues are all considered as drivers behind the phenomenon. We exploit an original and very rich provincial panel dataset over 1999–2005 for the 103 Italian provinces. Evidence shows that the observed ‘absolute’ decoupling between economic growth and landfilling is driven by a mix of structural factors. Among the main factors, population density, more than the provincial income level, emerges as a crucial driver: local opportunity costs and landfill externalities matter in shaping waste policies and local commitment to a transition away from landfilling of waste (landfill diversion). However, not only structural factors are relevant. If on the one hand landfill taxes are not a significant driver of the phenomenon, waste management tools, such as separated collection for recycling, and the tariff system connected to waste services, bring about significant effect on the amount of landfilled waste. Moreover, regarding the analysis of spatial interrelations across provinces, we note that the presence of incinerators in nearby provinces increases landfill diversion, due probably to free riding behaviour or intra-provinces ‘agreements’ on waste management; this is not true for nearby landfill sites, that cause for a given province a strong lock in effect. Future research could strengthen the analysis of policy effectiveness at regional level, focusing on policy endogeneity, and the full investigation of spatial correlations in waste disposal performances.     

欧盟废物焚烧指令的研究与借鉴

为进一步完善我国废物焚烧标准体系,防控废物焚烧环境风险,本文对欧盟废物焚烧指令与我国焚烧标准体系进行了对比分析。欧盟废物焚烧指令分别对专用焚烧厂和协同焚烧厂从废物运输到处理处置全过程的污染物排放控制做出了相关规定,适用于危险废物和非危险废物的焚烧以及常规污染物和有毒污染物的控制。欧盟废物焚烧指令对不同规模的焚烧设施采用统一标准,以日均值和半小时均值为污染物排放限值,更客观、准确地评价了污染物排放对环境的影响。与欧盟废物焚烧指令相比,我国废物焚烧标准涉及废物联合利用处置的相关条文较少,内容不详,项目缺失。我国烟尘、HCl的排放限值均在欧盟标准限值6倍以上,SO2的排放限值是欧盟标准的4~8倍。除CO、NOx的排放限值外,其他污染物排放限值也明显高于欧盟标准限值。我国采用抽样监测方法,监测结果可能在日常排放值的95%置信区间外,不具备代表性。我国可借鉴欧盟废物焚烧指令的成果制定协同焚烧标准,并严格污染物排放限值,考虑采用日均值或半小时均值的评价方法,提高我国废物焚烧标准的精确性和可执行性。     

Medical waste management in Korea

The management of medical waste is of great importance due to its potential environmental hazards and public health risks. In the past medical waste was often mixed with municipal solid waste and disposed of in residential waste landfills or improper treatment facilities (e.g. inadequately controlled incinerators) in Korea. In recent years, many efforts have been made by environmental regulatory agencies and waste generators to better manage the waste from healthcare facilities. This paper presents an overview of the current management practices of medical waste in Korea. Information regarding generation, composition, segregation, transportation, and disposal of medical wastes is provided and discussed. Medical waste incineration is identified as the most preferred disposal method and will be the only available treatment option in late 2005. Faced with increased regulations over toxic air emissions (e.g. dioxins and furans), all existing small incineration facilities that do not have air pollution control devices will cease operation in the next few years. Large-scale medical waste incinerators would be responsible for the treatment of medical waste generated by most healthcare facilities in Korea. It is important to point out that there is a great potential to emit air toxic pollutants from such incinerators if improperly operated and managed, because medical waste typically contains a variety of plastic materials such as polyvinyl chloride (PVC). Waste minimization and recycling, control of toxic air emissions at medical waste incinerators, and alternative treatment methods to incineration are regarded to be the major challenges in the future.     

工业固体废物的焚烧处理——实例研究

以天津经济技术开发区工业固体废物的处理为例,分析讨论了焚烧技术在处理工业固体废物中的应用。研究结果表明,选择回转窑焚烧炉对开发区的工业固体废物进行焚烧处理是合理的,可较好地实现工业废物的减量化、无害化的目标以及废物处理资源化的目标。      

Evaluating the potential of CNT-supported Co catalyst used for gas pollution removal in the incineration flue gas

This study investigated the use of Cu/Al₂O₃, Co/Al₂O₃, Fe/Al₂O₃, and Ni/Al₂O₃ catalysts for the growth of carbon nanotubes (CNTs). These CNTs were used as support for Co catalyst preparation and Co/CNT catalysts were applied to a catalytic reaction to remove BTEX, PAHs, SO₂, NO, and CO simultaneously in a pilot-scale incineration system. The analyzed results of EDS and XRD showed low metal content and good dispersion characteristics of the Al₂O₃-supported catalysts by excess-solution impregnation. FESEM analyzed results showed that the CNTs that were synthesized from Co, Fe, and Ni catalysts had a diameter of 20 nm, whereas those synthesized from Cu/Al₂O₃ had a diameter of 50 nm. Pilot-scale test results demonstrated that the Co/CNT catalyst effectively removed air pollutants in the catalytic reaction and that there was no obvious deactivation by Pb, water vapor, and coke deposited in the process. The thermal stabilization at 250 °C and hydrophobicity properties of CNTs enhanced the application of CNT catalysts in flue gas.     

Hazardous waste incinerators under waste uncertainty: Balancing and throughput maximization via heat recuperation

Hazardous waste incinerators (HWIs) differ substantially from thermal power facilities, since instead of maximizing energy production with the minimum amount of fuel, they aim at maximizing throughput. Variations in quantity or composition of received waste loads may significantly diminish HWI throughput (the decisive profit factor), from its nominal design value. A novel formulation of combustion balance is presented, based on linear operators, which isolates the wastefeed vector from the invariant combustion stoichiometry kernel. Explicit expressions for the throughput are obtained, in terms of incinerator temperature, fluegas heat recuperation ratio and design parameters, for an arbitrary number of wastes, based on fundamental principles (mass and enthalpy balances). The impact of waste variations, of recuperation ratio and of furnace temperature is explicitly determined. It is shown that in the presence of waste uncertainty, the throughput may be a decreasing or increasing function of incinerator temperature and recuperation ratio, depending on the sign of a dimensionless parameter related only to the uncertain wastes. The dimensionless parameter is proposed as a sharp a’ priori waste ‘fingerprint’, determining the necessary increase or decrease of manipulated variables (recuperation ratio, excess air, auxiliary fuel feed rate, auxiliary air flow) in order to balance the HWI and maximize throughput under uncertainty in received wastes. A 10-step procedure is proposed for direct application subject to process capacity constraints. The results may be useful for efficient HWI operation and for preparing hazardous waste blends.     

医疗废物焚烧处置厂改扩建环评问题的分析

为解决改扩建项目环评中"以新带老"的重点和难点问题,结合医疗废物焚烧处置厂项目环评实例,说明如何利用实测数据和现场调查相结合的方式分析和解决"以新带老"问题,结果表明这两种方式缺一不可。     

内核烧结法-生活垃圾焚烧炉技术

通过对“内核烧结法”工艺在不同焚烧状态下的应用研究，开发出了不同类型的垃圾焚烧炉，不断完善生活垃圾焚烧技术。     

二噁英催化降解技术在废物焚烧领域的应用

焚烧是常用的废物处置方法,中国每年需要处量理的废物随社会发展和经济增长不断增加,由此产生的二噁英排放问题已引起社会广泛的关注。选择性催化氧化(SCO)技术可降解烟气中二噁英,在国外已有广泛工业应用,是最佳可行技术的重要组成部分,是我国斯德哥尔摩公约履约过程中的关键技术。为落实我国斯德哥尔摩公约履约责任,减少废物焚烧过程中二噁英类污染物的排放,促进行业全面推广应用以选择性催化氧化为代表的最佳可行技术,文章主要从SCO技术的发展、原理和影响因素出发选择合适的催化剂,结合国内工程案例验证分析了SCO技术对二噁英的去除效果,讨论了SCO技术应用的现状和前景,进一步说明在国内的废物焚烧领域推广和普及SCO技术的紧迫性和可行性。     

Review and prospect of emerging contaminants in waste – Key issues and challenges linked to their presence in waste treatment schemes: General aspects and focus on nanoparticles

The presence in waste of emerging pollutants (EPs), whose behaviours and effects are not well understood, may present unexpected health and environmental risks and risks for the treatment processes themselves. EP may include substances that are newly detected in the environment, substances already identified as risky and whose use in items is prohibited (but which may be present in old or imported product waste) or substances already known but whose recent use in products can cause problems during their future treatment as waste. Several scientific studies have been conducted to assess the presence of EP in waste, but they are mostly dedicated to a single category of substance or one particular waste treatment. In the absence of a comprehensive review focused on the impact of the presence of EP on waste treatment schemes, the authors present a review of the key issues associated with the treatment of waste containing emerging pollutants. This review presents the typologies of emerging pollutants that are potentially present in waste along with the major challenges for each treatment scheme (recycling, composting, digestion, incineration, landfilling and wastewater treatment). All conventional treatment processes are affected by these new pollutants, and they were almost never originally designed to consider these substances. In addition to these general aspects, a comprehensive review of available data, projects and future R&D needs related to the impact of nanoparticles on waste treatment is presented as a case study.