聚丙烯环生物滴滤塔去除实际市政污水厂硫化氢性能及微生物群落分析

在非稳态条件下,采用AAO剩余污泥为种泥、聚丙烯环为填料启动生物滴滤塔,处理实际市政污水厂细格栅H2S恶臭气体.研究了生物滴滤塔的启动、稳定阶段的运行模式,在空床停留时间为14 s,进气浓度2. 02～319. 19 mg·m-3,环境温度为7. 8～32. 5℃条件下,平均出气浓度为13. 08 mg·m-3,平均去除率达到91. 8%,最高去除负荷达到78. 37 g·(m3·h)-1.在247d运行中,监测到生物滴滤塔压降在长期运行中维持稳定在96 Pa·m-1.高通量测序表明,生物滴滤塔内的微生物群落发生了改变,Shannon指数由4. 99降低至3. 75,但Pseudomonas和Thiobacillus等功能菌的存在解释了生物滴滤塔较好的去除性能.结果表明,在非稳态条件下,以AAO剩余污泥为种泥的生物滴滤塔可实现H2S的高效去除;聚丙烯环作为填料可以在长期运行中维持稳定的压降;微生物群落在长期高浓度的H2S环境中,多样性降低,但降解性能可以得到提高.     

高速列车隧道会车流场的CFD分离涡数值模拟

目的研究高速列车隧道会车压力波及列车尾流特性。方法建立某型高速列车三节车模型,采用脱体涡方法数值模拟两列车以350km/h在隧道内等速会车的流场。数值模拟的空间离散化压力项、密度项及修正的湍流黏度项使用二阶迎风格式,动量项使用有界中心差分格式,时间离散采用预处理二阶精度差分格式,用壁面函数处理隧道壁,使用雷诺时均法作方法对比。计算列车车头、侧墙及尾车等部位的压力时间历程,然后使用傅里叶变换对尾车测点进行频谱分析,最后对尾流中不同位置的湍流强度进行分析。结果头车所受压力波动最为剧烈,中间车次之,尾车最小。列车侧墙同一垂向位置不同高度压力变化相差不大。列车尾涡主频在3.85Hz附近,其可能对列车横向振动有一定的影响。结论尾涡是两个不断向后发展的中等强度涡旋,在充分发展段,其湍流强度会有一个较为明显的抬升,之后逐渐减弱。会车侧涡流由于横向发展较为迅速,导致其强度较小且减弱速度较快。     

跨膜压差和膜面流速对磁絮凝延缓陶瓷微滤膜通量衰减的影响

为克服陶瓷微滤膜净化微污染水体时产水量不高、通量衰减迅速的难题,采用磁絮凝预处理工艺延缓陶瓷膜的污染。对比了磁絮凝预处理与传统絮凝预处理对陶瓷微滤膜膜污染的影响,结果显示:磁絮凝预处理后陶瓷膜的稳定产水量高于传统絮凝预处理,验证了磁絮凝预处理工艺延缓膜污染的可行性。同时,研究了跨膜压差和膜面流速对2种组合工艺膜通量的影响,结果表明:随着跨膜压差和膜面流速的增加,膜通量均提高但增幅逐渐放缓,其优化运行参数如下:跨膜压差为0.20 MPa,膜面流速为2.0 m/s。     

气室连通管调压技术调控矿井采空区瓦斯涌出实践

在煤矿无煤柱开采过程中,采煤工作面及其作业空间往往因处于空气压能相对低位,受到邻近采空区内瓦斯等有害气体侵入的威胁。通过研究和实施气室连通管调压技术,合理改变采煤工作面邻近老空区外围的压能关系,调控老空区瓦斯涌出方向和涌出量,有效阻止老空区高浓度瓦斯侵入回采工作面作业空间。     

液体危化品罐车卸货防喷技术研究

液体危化品大量地通过罐车运输,目前液体危化品罐车卸货完成后从通用卸货管道上拔掉卸货软管时,发生软管内残余液体危化品外喷伤人现象,其原因是液体危化品罐车卸货完毕,关闭罐车上的卸货阀门后,软管内压力大于管口大气压,在从通用卸货管道上拔掉卸货软管时,造成管内残余液体危化品从管口外喷,拔管时出现的外喷现象的动力,就是来自于这种压差.提出解决该问题的方法是对罐车的卸货装置进行简单改造,增加一个调节装置来平衡卸货软管内与外界大气压,消除液体外喷的动力.并在一家危险化学品经营企业的浓硝酸运输罐车上进行了实践应用,证明了该方法安全可行,提高了浓硝酸卸货时的安全性.     

对某高层酒店建筑给水和消火栓系统设计的体会与思考

生活给水系统设计时,将室内外给水管网分成两套,结合实际情况从安全、经济以及维护管理等因素考虑,在地下室布置成立体双环状给水系统;生活热水采用一台容积式浮动盘管热交换器换热供给热水;从理论上论证了组合型消防栓箱在本工程中的适用性和优越性,提出可将灭火器和消火栓位置设于一处的观点供大家在设计上参考。     

水平管道内铝粉爆炸特性的试验研究

为研究铝粉在密闭空间内爆炸特性,降低其爆炸造成的损害,利用自行设计的水平管道式可燃气体-粉尘爆炸装置,在室温下对粒度为6～8μm,9～12μm,15～17μm的铝粉在100～800 g/m3浓度范围内的爆炸特性进行试验研究。结果表明:铝粉在浓度为600 g/m3时,最大爆炸压力和最大压力上升速率最大,爆炸时间最小;铝粉浓度较低时,由于氧气充足,随着铝粉浓度增大,最大爆炸压力和最大压力上升速率增大,爆炸时间减小;当铝粉浓度超过600 g/m3,受到氧气浓度限制,最大爆炸压力和最大压力上升速率随浓度增大而减小,爆炸时间增大;相同浓度的铝粉,粒度越小,最大爆炸压力和最大压力上升速率越大,爆炸时间越小。粒度越小的铝粉,爆炸的可能性和危险性越大。     

斜拉索风雨激振三维模型试验研究

为研究风雨共同作用下拉索的气动力特性,以之江大桥为背景,通过对斜拉索的三维刚性节段模型做测力、测压风洞试验,得到4种表面形态下的拉索在不同风向角时的平均和脉动风压系数,结果表明:水线位置强烈影响拉索表面的风压系数分布,靠近水线附近气流的分离点会产生明显的改变,仅当上水线处于某些特定位置时,气动力系数变化明显,拉索才可能发生振动;用测压试验的风压系数积分得到的阻力系数要比测力试验的小10%左右,这是测压试验无法获得气动力中的摩擦分量所导致的。     

利用冲击力信号判断泥石流颗粒垂向分选的试验研究

分别提出根据冲击力数据的波动强度和峰值情况进行泥石流颗粒垂向分选研究的系统方法,并配置了三组不同容重(2 095 kg/m3、2 008 kg/m3和1 960 kg/m3)的粘性泥石流样品开展泥石流冲击试验。两种方法的分析结果基本一致,即容重为2 095 kg/m3的泥石流分选不明显,其他两组泥石流呈现出正粒序分布且容重越小分选越显著。量纲分析表明,开展的试验粘滞力在运动中起主导作用,颗粒之间作用力较小,不容易发生反粒序分选,这与通过冲击力分析颗粒垂向分选的结果一致,因此提出的利用冲击力信号判断泥石流颗粒垂向分选的系统方法具有适用性。     

Evaluating weather effects on interannual variation in net ecosystem productivity of a coastal temperate forest landscape: A model intercomparison

Forest productivity is strongly affected by seasonal weather patterns and by natural or anthropogenic disturbances. However weather effects on forest productivity are not currently represented in inventory-based models such as CBM-CFS3 used in national forest C accounting programs. To evaluate different approaches to modelling these effects, a model intercomparison was conducted among CBM-CFS3 and four process models (ecosys, CN-CLASS, Can-IBIS and 3PG) over a 2500 ha landscape in the Oyster River (OR) area of British Columbia, Canada. The process models used local weather data to simulate net primary productivity (NPP), net ecosystem productivity (NEP) and net biome productivity (NBP) from 1920 to 2005. Other inputs used by the process and inventory models were generated from soil, land cover and disturbance records. During a period of intense disturbance from 1928 to 1943, simulated NBP diverged considerably among the models. This divergence was attributed to differences among models in the sizes of detrital and humus C stocks in different soil layers to which a uniform set of soil C transformation coefficients was applied during disturbances. After the disturbance period, divergence in modelled NBP among models was much smaller, and attributed mainly to differences in simulated NPP caused by different approaches to modelling weather effects on productivity. In spite of these differences, age-detrended variation in annual NPP and NEP of closed canopy forest stands was negatively correlated with mean daily maximum air temperature during July-September (T_amax) in all process models (R² = 0.4-0.6), indicating that these correlations were robust. The negative correlation between T_amax and NEP was attributed to different processes in different models, which were tested by comparing CO₂ fluxes from these models with those measured by eddy covariance (EC) under contrasting air temperatures (T_a). The general agreement in sensitivity of annual NPP to T_amax among the process models led to the development of a generalized algorithm for weather effects on NPP of coastal temperate coniferous forests for use in inventory-based models such as CBM-CFS3: NPP′ = NPP − 57.1 (T_amax − 18.6), where NPP and NPP′ are the current and temperature-adjusted annual NPP estimates from the inventory-based model, 18.6 is the long-term mean daily maximum air temperature during July-September, and T_amax is the mean value for the current year. Our analysis indicated that the sensitivity of NPP to T_amax was nonlinear, so that this algorithm should not be extrapolated beyond the conditions of this study. However the process-based methodology to estimate weather effects on NPP and NEP developed in this study is widely applicable to other forest types and may be adopted for other inventory based forest carbon cycle models.