基于Shear Damage模型的剪切闸板防喷器剪切性能研究

为揭示剪切闸板在纯剪切工况条件下(无压差、无悬重)剪切钻杆时剪切力特征,以及悬重、内外压差等复杂工况条件对剪切钻杆时剪切力和油压的影响规律。本文基于Shear Damage断裂损伤模型,通过显示动力学方法开展剪切过程仿真研究。研究结果表明：在纯剪切工况条件下,剪切力随时间增加先逐渐增加再急剧下降为0;在有悬重工况条件下,剪切力和油压随悬重增加而呈减小趋势;在钻杆内压大于外压工况条件下,剪切力和油压均随压差增大而增大;在钻杆内压小于外压工况条件下,剪切力随压差增大而减小,5in(壁厚14.50 mm)、5 in(壁厚12.70 mm)规格钻杆油压随压差增大呈先增加后减小趋势,5in(壁厚10.54 mm)规格钻杆油压随压差变化不明显,其余钻杆油压随压差增大均呈上升趋势。研究结果可为剪切闸板防喷器油压配置、结构优化、关井工艺改进等提供关键技术支撑。     

冷冻取芯过程煤芯瓦斯解吸特性试验研究

为探究冷冻取芯过程煤芯瓦斯解吸特性,基于模拟试验的相似性,依托自主研发的含瓦斯煤冷冻取芯响应特性测试平台,开展不同变质程度煤样(长焰煤、贫瘦煤、无烟煤)及不同吸附平衡压力(1.0,2.0,3.0,4.0 MPa)下冷冻取芯过程煤芯瓦斯解吸特性试验研究。研究结果表明：冷冻取芯过程中,煤芯瓦斯解吸量与吸附平衡压力及煤变质程度呈正相关关系;在煤芯瓦斯解吸过程中存在倒吸现象,煤与瓦斯初始吸附平衡压力越大,煤的变质程度越高,倒吸开始时间越迟;冷冻取芯过程中,瓦斯解吸速度与吸附平衡压力及煤变质程度呈正相关关系,且瓦斯解吸速度随吸附平衡压力及煤变质程度变化曲线符合幂函数关系。     

基于氧化还原分析的硫化矿尘爆炸压力预测

为探究可应用于生产现场的硫化矿尘爆炸压力预测方法,基于硫化矿尘爆炸反应机理和粉尘引爆试验数据对硫化矿尘的氧化还原成分与其爆炸压力的相关关系进行分析。研究结果表明：硫化矿尘的还原成分指数与其爆炸压力的相关性极高,尤其是与其爆炸压力峰值的相关性系数高达0.993。整合研究结果形成的硫化矿尘爆炸压力和爆炸压力峰值计算和预测模型,可为金属矿山的硫化矿尘爆炸预防提供决策依据。     

考虑脉动压力相关性的自由体随机振动分析

目的 获得自由体在脉动压力载荷作用下的结构响应.方法 采用有限元方法 ,建立锥壳自由体结构的随机振动分析有限元模型,根据自由体的脉动压力载荷和随机振动分析理论,计算自由体在脉动压力下的加速度响应均方根值.结果 载荷为一定程度相关时的计算结果 在完全相关和不相关之间,最小相差约15％,最大相差约50％.结论 在进行自由体...     

Effect of flame propagation regime on pressure evolution of nano and micron PMMA dust explosions

Experiments using an open space dust explosion apparatus and a standard 20 L explosion apparatus on nano and micron polymethyl methacrylate dust explosions were conducted to reveal the differences in flame and pressure evolutions. Then the effect of combustion and flame propagation regimes on the explosion overpressure characteristics was discussed. The results showed that the flame propagation behavior, flame temperature distribution and ion current distribution all demonstrated the different flame structures for nano and micron dust explosions. The combustion and flame propagation of 100 nm and 30 μm PMMA dust clouds were mainly controlled by the heat transfer efficiency between the particles and external heat sources. Compared with the cluster diffusion dominant combustion of 30 μm dust flame, the premixed-gas dominant combustion of 100 nm dust flame determined a quicker pyrolysis and combustion reaction rate, a faster flame propagation velocity, a stronger combustion reaction intensity, a quicker heat release rate and a higher amount of released reaction heat, which resulted in an earlier pressure rise, a larger maximum overpressure and a higher explosion hazard class. The complex combustion and propagation regime of agglomerated particles strongly influenced the nano flame propagation and explosion pressure evolution characteristics, and limited the maximum overpressure.     

Mutual effects between dynamic leakage behavior and the pressure/temperature in a LNG tank with external heat fluxes

The objective of this work is to investigate and model the mutual effects between the dynamic pressure/temperature in the LNG tank and the leakage behavior with external heat fluxes. The results suggest that the pressure and temperature in tank during leakage change with the comparison results between the heat flux consumed in liquid boil-off and the external heat flux supplied. At the liquid leakage stage, when the external heat flux is not very high, the pressure in tank tends to increase significantly, even results in tank explosion. It increases more and more heavily with higher and higher external heat fluxes. At the vapor leakage stage, large amount of vapor spray out, which results in a high generation rate of vapor by the liquid boil-off. The pressure in tank normally decreases to be low, which is unfavorable for the LNG tank explosion. Therefore, at this vapor leakage stage, blocking the leakage hole as soon as possible is not always a right choice for fire fighters. Finally, it is suggested that reducing the heat flux into the tank, either at the liquid leakage stage or in vapor one, is key to the tank safety.     

高压水射流卸压防治复合动力灾害机理及应用

为研究高压水射流卸压防治复合动力灾害的可行性,以余吾煤业高瓦斯矿井东翼采区内首采N2105工作面工程地质条件为背景,通过现场调研、理论分析、数值模拟和工业性试验等方法,对N2105进风平巷两帮采取高压水射流卸压防治效果进行了研究。结果表明:对巷帮煤体采取高压水射流卸压技术,煤体在高压水射流的冲击力和扰动应力波共同作用下瞬间发生破坏;巷帮侧支承应力分布曲线由原有的“单高峰值”转变为“内低外高双峰值”,受以上支承应力变化的影响,底板煤岩体内难以形成范围较大且连续的塑性应力状态区;现场电磁辐射和矿压监测结果表明高压水射流技术对煤层卸压增透效果显著,降低了巷道发生复合动力灾害的可能性。研究结果可为同类矿井复合动力灾害的防治提供参考和借鉴。     

玻璃纤维-砂浆管试件动态拉伸破坏特性试验研究

为了探究动载作用下GFRP（玻璃纤维）-砂浆管的动态拉伸破坏特性,采用分离式SHPB试验装置对2种空心率的水泥砂浆管和GFRP-砂浆管进行动态拉伸试验。结果表明:空心率越小、冲击气压和壁厚越大,试件峰值抗拉强度越大;GFRP-砂浆管的峰值抗拉强度随GFRP管壁厚的增大而不断增大,在空心率为0.292时,峰值抗拉强度随GFRP管壁厚增大呈对数函数递增,而在空心率0.187时,峰值抗拉强度随GFRP管壁厚增大呈指数函数递增;无GFRP管时水泥砂浆管呈对称四块破碎,GFRP-砂浆管在0.5~0.7 MPa冲击气压下仅有细小裂纹产生,在0.8 MPa冲击气压下,与入射杆接触部分产生“楔形”破坏,但总体保持为管状、破坏程度仍低于水泥砂浆管,表明GFRP管对水泥砂浆管具有较好的保护作用,可有效提高其动态抗拉强度。     

多元可燃性气体爆炸压力与中间产物发射光谱特性的耦合研究

工业生产中爆炸事故往往是由多元可燃气体与空气混合后遇到明火而引起的,为研究乙烷（C₂H₆）、乙烯（C₂H₄）、一氧化碳（CO）、氢气（H₂）对甲烷爆炸特性的影响,选取多组分可燃气体甲烷爆炸压力特性和自由基发射光谱的影响进行研究,利用陕西省工业过程安全与应急救援工程技术研究中心重点实验室搭建的多功能球形气体/粉尘爆炸实验装置和单色仪进行爆炸实验测试,同步采集时间—压力曲线、中间产物（OH,CH₂O）的发射光谱信号,考察多组分可燃气体浓度对甲烷爆炸压力特性和中间产物的影响。结果表明:在富氧状态下,多组分可燃气体加剧了甲烷—空气混合体系的爆炸剧烈程度,随着体系中氧气含量的减少、由富氧状态变为贫氧状态、促进作用逐渐减弱转变为阻尼作用,爆炸压力特性与中间产物发射光谱参数的影响规律基本保持一致,均呈高度正相关;多元混合体系爆炸剧烈程度越大,自由基发射光谱达到峰值的速度越快,自由基更早、更快的积累是加剧爆炸程度的原因之一。