印制电路板工艺涂层防湿热、防霉菌、防盐雾试验标准的对比与分析

本文对现有标准中印制电路板工艺涂层的防湿热、防霉菌、防盐雾试验方法进行了对比,分析了各标准在标准试样制备、试验依据方法及表征参数等方面的要求,对比分析结果可为印制电路板工艺涂层三防性能验证试验方案设计提供指导。     

Polymer coating of copper oxide nanoparticles increases nanoparticles uptake and toxicity in the green alga Chlamydomonas reinhardtii

Copper oxide nanoparticles (CuO NPs) are frequently used in a polymer-coated form, to be included in paints or fabrics for antimicrobial properties. Their application in antifouling paints may lead to the contamination of aquatic ecosystems. However, the toxicological risk of NPs in the environment is hard to evaluate due to a lack of knowledge on the mechanisms of NP interaction with biological systems. In this study, we investigated the effect of polymer coating on CuO NP toxicity in the green alga Chlamydomonas reinhardtii by comparing bare and polymer-coated CuO NPs prepared from the same CuO nanopowder. Both CuO NP suspensions were toxic to C. reinhardtii after 6 h treatment to concentrations of 0.005-0.04 g L⁻¹. Bare and polymer-coated CuO NPs induced a decrease of Photosystem II activity and the formation of reactive oxygen species. Polymer-coated CuO NP was found to be more toxic than the uncoated CuO NP. The higher toxicity of CS-CuO NP was mainly associated with the increased capacity of polymer-coated CuO NP to penetrate the cell compared to bare CuO NPs. These results indicates that the high toxicity of polymer-coated CuO NPs in algal cells results of intracellular interactions between NPs and the cellular system.     

氯盐对含汞土壤热脱附的影响

采用管式电阻炉对不同氯盐调理的含汞土壤进行热脱附实验,研究氯盐种类和炉温等对汞脱除效果的影响,分别从汞脱除率、热重测试和XRD汞形态分析3个方面进行评价.结果表明,不同温度下添加氯盐均对汞脱除率有明显提升.230℃时,添加氯化铁、氯化镁和氯化钙调理相比对照组(不添加氯盐),汞脱除率分别提升66.2％、49.3％和15.8％,即促进效果:FeCl3＞MgCl2＞CaCl2.在300℃下加热25 min时,添加氯化铁调理的汞脱除率为96.1～96.2％,与对照组相比,最高提升了68.3％.热重测试结果显示,载气对汞的挥发影响较小,湿法投加氯盐效果比干法投加更明显.炉尾晶体XRD分析结果表明,在低温条件下氯盐促进样品中汞向氯化汞转变从而提高了汞脱除率.添加氯盐调理提高了汞脱除率,同时缩短了汞热脱附达到稳定的时间.     

胺液脱硫系统再生性能下降原因分析及对策

中国石化茂名分公司两套胺液集中再生装置出现异常,再生后贫液中ρ(H_2S)达到2.0~3.0 g/L,远高于1.2g/L的工艺设计值。通过在实验室模拟装置上考察新鲜脱硫剂的吸收和再生性能、分析工厂胺液脱硫系统贫液的杂质组成和来源、对比实验室净化前后的效果,查明胺液脱硫系统脱硫剂再生性能下降的原因。据此对工厂胺液脱硫系统提出相应的操作建议,包括采取胺液净化技术将系统热稳盐含量(w)从2.35%降至0.95%、规范操作以降低Na~+含量等措施,使得胺液脱硫系统在整改后的两个月运行中,贫液中ρ(H_2S)从原来的最高1.68 g/L降至0.66 g/L以下,达到胺液脱硫系统稳定运行的目的。     

吸湿性尘粒人工模拟试验与盐雾试验的对比研究

介绍了吸湿性尘粒人工模拟试验方法与盐雾试验方法。通过分析、对比两种试验方法的试验设备、腐蚀效果控制、失效机理和符合性评价之间的区别,为试验人员使用吸湿性尘粒人工模拟试验方法和盐雾试验给出建议。     

盐类对模拟胞外聚合物(EPS)膜污染的影响

实验旨在研究盐类对模拟胞外聚合物(EPS)溶液在超滤和微滤过程中膜污染影响,通过添加与无添加盐类的模拟溶液的比较,研究盐类对EPS膜过滤在死端过滤过程的影响。实验考察了不同模拟溶液的膜通量衰减情况和滤饼比阻,并利用Hermia模型对实验数据进行拟合分析验证膜污染机理。实验结果表明,在超滤过程中,Ca2+和Al3+能在一定程度上提高膜通量,降低滤饼比阻,延缓膜污染;在微滤过程中,两者的添加反而降低了初始通量,添加Ca2+后滤饼比阻值反而有所增大;Na+对超/微滤过程影响很小。通过Hermia模型拟合分析发现,在超滤过程中,添加盐和无添加的溶液均以滤饼堵塞机理为主,而在微滤过程中则是以中间堵塞和滤饼堵塞机理为主。     

Toxic Environmental Releases from Medical Waste Incineration: A Review

Toxic releases from medical waste incineration comprising organic emissions such as polychlorinated dibenzo-dioxin/furan (PCDD/Fs) and polycyclic aromatic hydrocarbons (PAHs), inorganic emissions and ashes containing toxic metals have been reviewed. Attempts made by various investigators to reduce/eliminate emissions have also been included. Legislations concerning emission standards for medical waste incinerators have been discussed.     

Impact of degradation on nitrogen transformation in a forest ecosystem of India

A study was performed selecting one protected forest and an adjacent degraded forest ecosystem to quantify the impact of forest degradation on soil inorganic nitrogen, fine root production, nitrification, N-mineralization and microbial biomass N. There were marked seasonal variations of all the parameters in the upper 0–10 and lower 10–20 cm depths. The seasonal trend of net nitrification and net N-mineralization was reverse of that for inorganic nitrogen and microbial biomass N. Net nitrification, net N-mineralization and fine root biomass values were highest in both forests during rainy season. On contrary, inorganic nitrogen and microbial biomass N were highest during summer season. There was a marked impact of forest degradation on inorganic nitrogen, fine root production nitrification, N-mineralization and microbial biomass observed. Soil properties also varied with soil depth. Fine root biomass, nitrification, N-mineralization and microbial biomass N decreased significantly in higher soil depth. Degradation causes decline in mean seasonal fine root biomass in upper layer and in lower depth by 37% and 27%, respectively. The mean seasonal net nitrification and N-mineralization in upper depth decreased by 42% and 37%, respectively and in lower depth by 42.21% and 39% respectively. Similarly microbial biomass N also decreased by 31.16% in upper layer 33.19% in lower layer.     

镁盐和炉渣对印染废水的脱色处理

实验研究了不同pH、温度：Mg2＋投量和沉降时间下,镁盐、炉渣、镁盐＋炉渣3种处理对模拟和实际印染废水的脱色效果。结果表明,在pH为11～11．5、沉降30rain、30℃及Mg2＋投加量为500～600mg／L的最优脱色条件下,3种处理对艳红FXC模拟废水的最大脱色率分别为98．41％、98．43％和99．37％,对实际印染废水的最大脱色率分别为90．18％、89．63％和93．33％,其中,镁盐＋炉渣脱色效果最好,这可能与炉渣吸附和起到协同增强Mg（OH）2沉淀效果的作用有关。对水样的液相色谱初步检测分析表明,实际废水脱色处理前后染色基团峰高和种类发生了变化。该研究对盐田富镁卤水和炉渣等废物的资源化开发有重要参考价值。     

镁盐和炉渣对印染废水的脱色处理简

实验研究了不同pH、温度、Mg²⁺投量和沉降时间下,镁盐、炉渣、镁盐+炉渣3种处理对模拟和实际印染废水的脱色效果。结果表明,在pH为11~11.5、沉降30 min、30℃及Mg²⁺投加量为500~600 mg/L的最优脱色条件下,3种处理对艳红FXC模拟废水的最大脱色率分别为98.41%、98.43%和99.37%,对实际印染废水的最大脱色率分别为90.18%、89.63%和93.33%,其中,镁盐+炉渣脱色效果最好,这可能与炉渣吸附和起到协同增强Mg（OH）₂沉淀效果的作用有关。对水样的液相色谱初步检测分析表明,实际废水脱色处理前后染色基团峰高和种类发生了变化。该研究对盐田富镁卤水和炉渣等废物的资源化开发有重要参考价值。