Environmental impacts of iron ore tailings—The case of Tolo Harbour,Hong Kong

Disposal of iron ore tailings along the shore of Tolo Harbour, Hong Kong has altered the adjacent environment. Due to the ever-expanding population, the vast development of various industries, and the lack of sanitary control, the existing pollution problem of Tolo Harbour is serious. The iron ore tailings consist of a moderate amount of various heavy metals, e.g., copper, iron, manganese, lead, zinc, and a lower level of macronutrients. A few living organisms have been found colonizing this manmade habitat. Higher metal contents were also found in the tissue ofPaphia sp. (clam);Scopimera intermedia (crab);Chaetomorpha brychagona (green alga);Enteromorpha crinita (green alga); andNeyraudia reynaudiana (grass). The area can be reclaimed by surface amelioration using inert materials, soils, or organic substrates, and by direct seeding, using nontolerant and tolerant plant materials. Reclamation of the tailings would improve the amenity of the adjacent environment and also mitigate pollution escaping to the sea.     

基于粒子群算法的城市垃圾中转站的空间布局研究

随着城市化的进程，垃圾处理设施成为影响城市化质量的重要指标。依据人们实际所关注的垃圾处理设施的总成本和负效应两个因素，在前人研究的基础上，建立了垃圾收运多目标模型，使得总成本和负效应最优化。根据模型设计了粒子群算法，该算法属于智能算法，且精度高，收敛快，在许多领域也得到广泛应用。用设计的粒子群算法并结合案例求出了Pareto最优解，给出三种决策方案，验证了模型和算法的有效性和可行性，为决策者提供了一种理论参考。     

降解有机污染物的新方法—半导体微粒光催化降解

以半导体颗粒作为光催化剂，用光和氧化剂使有机物彻底转化成二氧化碳和水。这是近十年来正在逐步完善的降解有机物的新方法。许多国家正在投入大量资金和人力进行半导体光催化反应的基础研究及应用基础研究。     

Retrieval of refractive index of ultrafine single particle using hygroscopic growth factor obtained by high sensitive surface plasmon resonance microscopy

When exposed to different relative humidities (RHs), the optical properties of atmospheric aerosols will change because of changes in the aerosol particle size and complex refractive index (RI), which will affect haze formation and global climate change. The potential contributions of ultrafine particles to the atmospheric optical characteristics and to haze spreading cannot be ignored because of their high particle number concentrations and strong diffusibility; measurement of the optical properties of wet ultrafine particles is thus highly important for environmental assessment. Therefore, a surface plasmon resonance microscopy with azimuthal rotation illumination (SPRM-ARI) system is designed to determine the RIs of single particle aerosols with diameters of less than 100 nm in the hygroscopic growth process. Measurements are taken using mixed single particles with different mass ratios. The RIs of mixed single aerosols at different RHs are retrieved by measuring the scattering light intensity using the SPRM-ARI system and almost all the RIs of the bicomponent particles with different mass ratios decrease with increasing water content under high RH conditions. Finally, for each of the bicomponent particles, the maximum standard deviations for the retrieved RI values are only $2.06\times {10}^{-3}$, $3.08\times {10}^{-3}$ and $3.83\times {10}^{-3}$, corresponding to the NaCl and NaNO₃ bicomponent particles with a 3:1 mass ratio at 76.0% RH, the NaCl and glucose particles with a 1:3 mass ratio at 89.0% RH, and the NaCl and OA particles with a 1:1 mass ratio at 78.0% RH, respectively; these results indicate that the high-sensitivity SPRM-ARI system can measure the RI effectively and accurately.     

Blast wave clearing behavior for positive and negative phases

The purpose of the research was to improve prediction of response of buildings to blast waves by including the negative phase and considering clearing of both positive and negative phases. Commonly used structural design practices, which trace their origins to military design manuals, often ignore the negative phase as well as positive phase clearing. For high explosive threats, this approach is conservative in most circumstances. However, negative phase clearing had not previously been studied for blast waves, and the implications for structural response had not been evaluated. This paper presents results of modeling negative phase blast clearing behavior for a typical blast wave and discusses the differences from positive phase clearing. The implications of including positive and negative phase clearing in building blast damage analysis are also investigated through single-degree-of-freedom (SDOF) analyses.Blast waves from explosion sources like a vapor cloud explosion (VCE), pressure vessel burst or high explosive exhibit both positive and negative phases, and the relative magnitude of the positive and negative phases varies among explosion sources and the specific circumstances of each source. A fully reflected blast wave is produced if an incident blast wave were to strike an infinitely tall and wide wall in a normal orientation. Both the positive and negative phases of the blast wave are enhanced by the reflection process. However, when an incident blast wave strikes a wall of finite size in a normal orientation, rarefaction waves are created at the edges of the wall, and the rarefactions sweep down from the roof and inward from sides. The rarefaction waves result in a clearing effect for both the positive and negative phases.Clearing relieves some of the applied blast load on the reflected wall for the positive phase. However, this is not always the case for the negative phase. As shown by the results presented in this paper, clearing may either relieve or enhance the applied negative phase blast load, depending on the duration of the blast wave and the wall dimensions.The impact of negative phase clearing on structural response for generic building components was also investigated. Nonlinear SDOF methods were used to characterize response in terms of peak positive and negative displacements. It was found that the influence of the negative phase is significant and the peak structural response can occur during negative (outward) displacement.     

三维点云基础上排土场垮塌影响范围研究

高台阶排土场下游常分布有居民区、厂房等,一旦垮塌,后果严重,因此完善的防治与应急准备工作十分关键,而排土场垮塌影响范围的预测是这些工作的重要前提依据。为提升高台阶排土场垮塌影响范围的预测准确性,需要获取准确的地形边界基础数据。通过利用三维激光扫描仪对新建排土场及其下游地形精细扫描,对获取的三维点云数据去噪、拼接、建模等处理,生成精度更高的数字高程模型与三维实体模型。在此基础上,结合新建高台阶排土场地质勘查与设计资料,建立颗粒离散元数值模型,利用PFC3D计算高台阶排土场垮塌影响范围,并与经验公式法计算结果对比分析,结果表明排土场颗粒离散元数值模型精度符合要求,可快速、准确地计算影响范围,从而为相关部门提供科学决策依据。     

喷嘴直径对降尘效果影响的试验研究

为提高喷雾降尘效率,以改善作业环境,有必要研究喷嘴直径与降尘效果间的关系。基于自行设计的喷雾降尘试验系统,采用马尔文实时高速喷雾粒度分析仪、高速摄像仪及粉尘浓度测定仪对不同直径喷嘴的雾化特性参数和降尘效率进行测定。结果表明,在相同喷雾压力下,随着喷嘴直径的增大,全尘降尘效率持续增加,而呼吸性粉尘降尘效率先增加后减小,并在喷嘴直径为1.5 mm时达到最大值;在耗水量相同的情况下,随着喷嘴直径的增大,全尘和呼吸性粉尘降尘效率均下降。在井下喷雾降尘中,当耗水量不受限制时,为同时确保全尘和呼吸性粉尘降尘效率,宜选择直径为1.5 mm的喷嘴;当耗水量受限制时,宜选择直径为1.2 mm的喷嘴。     

Detonations and vapor cloud explosions: Why it matters

The methods used to evaluate the consequences of a vapor cloud explosion assume deflagrations within congested process pipework regions and consequently a significant effort has been invested in developing models to estimate the severity of these deflagrations. Models range from the simpler screening approaches to detailed Computational Fluid Dynamics. There is clear evidence from large scale experiments and incidents that transition from deflagration to detonation is credible and has occurred and it is the contention of this paper that deflagration is only the first stage in many major vapor cloud explosions and that detonation is readily foreseeable. Why does this matter? The methods currently used in the design and location of buildings on and around process sites are based on an incomplete picture of vapor cloud explosions. Whilst this might not have a significant effect in some cases, it is shown that there is the potential to significantly underestimate the explosion hazard. This will result in occupied buildings either being placed in the wrong location or under-designed for the explosion threat, increasing the risks to personnel on these sites.     

Deflagration to detonation transition in a vapour cloud explosion in open but congested space: Large scale test

The paper reviews large scale experiments with various fuels in air where successful deflagration to detonation transition (DDT) took place. This includes a recent experiment disclosed in the Buncefield R&D program, where DDT developed in the propane/air mixture. The DDT occurred in branches of deciduous trees in a premixed stagnant mixture. An internal R&D investigation programme was initiated to better understand the phenomena. A large scale experiment in an open space with ethane air mixture is presented in the paper. The premixed mixture was ignited at the edge of the congested three-dimensional rigs which consisted of vertical and horizontal pipes. After ignition, the flame accelerated in the congestion and transitioned to detonation at the end of congestion. Stable detonation propagated through the remaining open and uncongested space.The flame acceleration process leading to DDT is scale dependent. It also depends on many parameters leading to a large investigation array and, significant cost. However, such R&D efforts aimed toward a safer plant design, i.e. the prevention of occurrence of a major accident, are a small fraction of a real accident cost.     

Hg0 removal from flue gas over different zeolites modified by FeCl3

The elemental mercury removal abilities of three different zeolites (NaA, NaX, HZSM-5) impregnated with iron (III) chloride were studied on alab-scale fixed-bed reactor. X-ray diffraction, nitrogen adsorption porosimetry, Fourier transform infrared spectroscopy, X-ray photoelectron spectroscopy, and temperature programmed desorption (TPD) analy-ses were used to investigate the physicochemical properties. Results indicated that the pore structure and active chloride species on the surface of the samples are the key factors for physisorption and oxidation of Hg⁰, respectively. Relatively high surface area and micropore volume are beneficial to efficient mercury adsorption. The active Cl species generated on the surface of the samples were effective oxidants able to convert elemental mercury (Hg⁰) into oxidized mercury (Hg²⁺). The crystallization of NaCl due to the ion exchange effect during the impregnation of NaA and NaX reduced the number of active Cl species on the surface, and restricted the physisorption of Hg⁰. Therefore, the Hg⁰ removal efficiencies of the samples were inhibited. The TPD analysis revealed that the species of mercury on the surface of FeCl₃-HZSM-5 was mainly in the form of mercuric chloride(HgCl₂), while on FeCl₃-NaX and FeCl₃-NaA it was mainly mercuri coxide(HgO).