烟气脱硫溶液中硫酸根的去除

分别采用石灰乳化学沉淀法和低温结晶法去除烟气脱硫溶液中的SO42-。实验结果表明：在室温、CaO溶液质量分数25%的条件下,石灰乳化学沉淀法对SO42-的去除率仅为59.51%,且向溶液中引入了Ca2+,产生的硫酸钙固体废物难以再生利用;采用低温结晶法处理烟气脱硫溶液,在结晶温度7 ℃、结晶时间3 h、NaOH加入量34.8 g/L的条件下,SO42-的去除率为82.04%、滤液中的ρ（Na+）为3.88 g/L。在现场工业应用试验中,采用低温结晶法去除烟气脱硫溶液中的SO42-,平均SO42-的去除率可达70.00%以上,滤液中的ρ（Na+）小于15.00 g/L。该法可有效抑制烟气脱硫溶液中SO42-含量的增加。     

干式厌氧消化过程挥发酸对硫酸盐还原菌的影响

在牛粪干式厌氧消化过程中,通过添加不同挥发酸(乙酸、丙酸、丁酸),考察消化稳定阶段,挥发性脂肪酸的分布特征,挥发性脂肪酸酸组成变化对硫酸盐还原菌(SRB)的影响,微生物种群组成和种群间关系。实验结果表明,挥发性脂肪酸对SRB还原速率的贡献依次为:丙酸丁酸乙酸。相比乙酸和丁酸,添加一定量的丙酸,更有利于激活SRB的活性,从而加强SRB与产甲烷菌(MB)的种间协同,保证厌氧系统的稳定运行。     

Speciation and transport of arsenic in an acid sulfate soil-dominated catchment, eastern Australia

Factors controlling the transport of geogenically-derived arsenic from a coastal acid sulfate soil into downstream sediments are identified in this study with both solid-phase associations and aqueous speciation clearly critical to the mobility and toxicity of arsenic. The data from both sequential extractions and X-ray adsorption spectroscopy indicate that arsenic in the unoxidised Holocene acid sulfate soils is essentially non-labile in the absence of prolonged oxidation, existing primarily as arsenopyrite or as an arsenopyrite-like species, likely arsenian pyrite. Anthropogenically-accelerated pedogenic processes, which have oxidised this material over time, have greatly enhanced the potential bioavailability of arsenic, with solid-phase arsenic almost solely present as As(V) associated with secondary Fe(III) minerals present. Analyses of downstream sediments reveal that a portion of the arsenic is retained as a mixed As(III)/As(V) solid-phase, though not at levels considered to be environmentally deleterious. Determination of arsenic speciation in pore waters using high performance liquid chromatography/Inductively Coupled Plasma-Mass Spectrometry shows a dominance of As(III) in upstream pore waters whilst an unidentified As species reaches comparative levels within the downstream, estuarine locations. Pore water As(V) was detected at trace concentrations only. The results demonstrate the importance of landscape processes to arsenic transport and availability within acid sulfate soil environments.     

粗MnSO4溶液中MnS2O6的去除条件研究

用软锰矿吸收SO2生成MnSO4时会伴随有副产物MnS2O6生成。产品中MnS2O6的存在会降低硫酸锰产品质量,同时会缓慢释放出SO2气体污染环境。本文用单因素实验方法研究了粗MnSO4溶液中MnS2O6的最优去除条件。研究结果显示,软锰矿用量为12.2 g,硫酸加入量为20 mL、反应温度100℃、反应时间3 h、搅拌速度500 r/min,MnS2O6的去除率可达91%以上。其最终产品能达到GB1622-1986一级品标准。     

硫酸铝渣去除水中磷研究

分别以蒸馏水和太湖水为例,研究了硫酸铝渣去除水中磷的能力,并分析了其对水体Al3+、SO24-以及pH的影响.结果表明:(1)除太湖水pH为9.0、10.0两种条件外,随着磷平衡浓度的增加,硫酸铝渣除磷量趋于某一定值,其规律符合Langmuir吸附等温式;太湖水pH为9.0、10.0两种条件下,硫酸铝渣除磷量符合Fre...     

油田回注水中优势硫酸盐还原菌的分离鉴定与生理特性研究

从胜利油田回注水中筛选得到一株硫酸盐还原菌,命名为zsz1209。经过16SrDNA序列分析,鉴定zsz1209为梭菌属（Clostridium）。实验研究了zsz109的生理特性,并对通过调节环境pH来抑制菌株zsz1209生长繁殖的可行性进行了探讨。实验结果表明：菌株zsz1209的理想碳源为乙酸钠,在30～60℃之间可较好地生长;SOi浓度低至50mg／L时,生长未受到明显抑制。当培养环境pH高至8．5～9．0或低至3．5～4．0时,检测菌株zsz1209对SO4^2-和碳源（COD）的利用情况,发现zsz1209的生长受到明显抑制,结果表明利用改变环境pH来抑制微生物对油田的腐蚀具有可行性。     

超声波-铁粉协同降解五氯酚

通过超声波-铁粉联合体系协同降解废水中的五氯酚(PCP).实验结果表明:降解120 min后,PCP去除率可达90.4％;在该体系中铁粉被逐渐腐蚀成Fe2+,随降解时间的延长,Fe2+浓度逐渐增加;体系中的Fe2+可以促进·OH的产生,并且可以与超声空化作用下产生的H2O2发生Fenton试剂氧化反应降解PCP;超声波...     

壳聚糖衍生物-镁盐复配去除中性兰模拟废水色度的研究

研究了有机高分子絮凝剂NCTS-M对中性兰染料的絮凝性能。通过测量絮体的Zeta电位以及对絮体进行彩色电视显微扫描初步探讨了该絮凝过程的絮凝机理。结果表明,当投加量为30 mg/L,pH=6时,絮凝效果最明显,脱色率可达93.1%。其絮凝机理主要是压缩双电层以及高分子吸附架桥作用,以压缩双电层为基础。絮凝剂中镁离子在中性条件下对絮凝过程也起到了较强的助凝作用。     

聚硅酸锌铝的制备及其性能研究

以硅酸钠、硫酸锌、硫酸铝为原料,通过共聚法制备了无机高分子絮凝剂聚硅酸锌铝（PSZAS）,研究了Na₂SiO₃的摩尔浓度、活化时间、Al/Si、Zn/Si 配比及絮凝剂的投加量对絮凝效果的影响,用X-射线衍射（XRD）和电子扫描电镜（SEM）对该絮凝剂的结构及形貌进行了表征。结果表明：当硅酸钠的浓度为0.4 mol/L,硅酸活化时间为2 h,Si∶Al∶Zn=1∶1∶1.5,絮凝剂投加量为20 mL/L废水时,絮凝剂的电中和能力和吸附架桥能力最强,絮凝剂对含H-酸染料模拟废水的絮凝效果最好。     

Removal of arsenic from wastewater using iron compound: Comparing two different types of adsorbents in the context of LCA

A study was carried out in order to compare the environmental performance of two different types of adsorbents in removing arsenic (As) from wastewater. A FeCl₃-based adsorbent and a poly-Fe-based adsorbent were first synthesized and their abilities in adsorbing As from wastewater were investigated in terms of the adsorption density and the rate of adsorption. Here, it should be noted that the main material being used in the synthesis of the poly-Fe-based adsorbent was a waste product, known as polyferric sulfate or poly-Fe in short, which exits the manufacturing process of titanium dioxide.Both adsorbents were then compared in the context of life-cycle assessment (LCA). In other words, the experimental results (i.e. the value of the adsorption density and the rate of adsorption) were input into the LCA model in order to assess the environmental performance of each adsorbent in removing arsenic. An estimate for the environmental burden of each option was finally calculated as the sum of the depletion of abiotic resources (ADP), the global warming potential (GWP), the acidification potential (AP), the photo-oxidant formation potential (POCP), the eutrophication potential (EP), and the human toxicity potential (HTP). The main finding of this study was that the adsorption of arsenic by using the poly-Fe-based adsorbent is more attractive treatment option in the environmental protection point of view than the adsorption by using the FeCl₃-based adsorbent, which generates a relatively larger environmental burden.