反硝化微生物燃料电池的基础研究

在启动双室型反硝化微生物燃料电池的基础上,研究了阴极溶解氧及外电阻对其产电性能和污染物去除效果的影响.结果表明,以乙酸钠为阳极电子供体,硝酸钠为阴极电子受体,在25℃的环境温度下,采用先间歇后连续培养的方式,42d内成功启动了反硝化微生物燃料电池.在阴极进水含氧的情况下,氧和硝酸盐可共同用作阴极电子受体.在较小电流密度区域内,氧是阴极的主要电子受体,相应的最大功率密度为26.0W/m3NC;电流密度增加到一定程度后,硝酸盐逐步变为阴极的主要电子受体,相应的最大功率密度为20.9W/m3NC.外阻变化对COD去除及反硝化程度影响较小,阳极COD去除负荷维持在1.2kg/(m3NC·d)左右,出水NO-2-N保持在0.05mg/L以下;但外阻减小有利于提高阴极脱氮效果,外阻为5 Ω时NO-3-N去除负荷达0.111kg/(m3NC·d).     

污泥为燃料的微生物燃料电池运行特性研究

实验采用单室无膜悬浮阴极微生物燃料电池(MFC),考察了运行特性对污泥为燃料的MFC(SMFC)的影响.研究表明,相对于未搅拌情况,搅拌时SMFC最大输出功率由45.94mW/m2分别增加到124.03mW/m2(1300r/min)和136.5mW/m2(2600 r/min),主要是由于搅拌有利于改善SMFC内物质的传递. 温度对SMFC的产电特性影响较明显,但在一定区间内(如20~25℃;30~40℃;45~50℃)变化不明显,说明产电微生物有一定的温度适应范围,这也可能是在不同温度下产电微生物不同导致.相对于采用未经处理的剩余污泥为燃料,微波处理后的污泥和微波处理过滤后的上清液做燃料时SMFC输出功率迅速增加,这主要是由于污泥中的微生物竞争作用引起.阴极面积的增加有利于降低阴极电势,降低SMFC内阻,从而促进功率密度的增加.     

Validation of liquid nitrogen vaporisation rate by small scale experiments and analysis of the conductive heat flux from the concrete

The vaporisation of a liquid nitrogen pool spilled on concrete ground was investigated in small scale field experiments. The pool vaporisation rate and the heat transfer from the concrete ground were measured using a balance and a set of embedded heat flux sensors and thermocouples. The ability to predict the concrete's thermal properties based on these measurements was investigated. This work showed that a simple, one-dimensional theoretical model, assuming heat conduction through a semi-infinite ground with ideal contact between the cryogenic liquid and the ground, commonly used to describe the heat transfer from a ground to the LNG, can be used to match the observed vaporisation rate. Though estimated parameters, thermal conductivity and thermal diffusivity, do not necessary represent real values. Although the observed vaporization rate follows a linear trend, and thus can be well represented by the model, the overall model prediction seems to be overestimated. The temperature profile inside the concrete is slightly over-predicted at the beginning and under-predicted at later stage of the spill. This might be an effect of the dependence of the concrete's thermal properties on the temperature or may indicate an incorrect modelling and a varying temperature of the ground surface.     

Mycelial culture of wild Inonotus hispidus parasitizing the jujube tree and the cultivation conditions of its fruit body on rice medium北大核心CSCD

Inonotus hispidus is a kind of rare medicinal fungus, and its natural resources are very scarce. Currently, the artificial cultivation technology of I. hispidus is not completely developed, and this reflects on its extremely low biological conversion rate and long cultivation period. In order to improve the bioconversion rate and shorten the production cycle of I. hispidus, we first analyzed the mycelia culture conditions of the collected I. hispidus, and then we further explore the method of domesticated cultivation of its fruiting body in rice medium. During the process of mycelial culture, the suitable temperature, pH, carbon source, and nitrogen source for mycelial growth were selected using the mycelial growth rate as index. During the domesticated cultivation of the fruiting body, the suitable culture medium for its growth was selected using the bioconversion rate as index. Screening results of mycelial culture conditions showed that the optimal culture conditions for the growth of mycelium of the wild I. hispidus were: temperature of 25 °C, initial pH of 6.0, glucose as the carbon source, and yeast extract powder as the source of nitrogen. The results of the domesticated cultivation showed that the biotransformation rate of I. hispidus was higher when using rice as the main medium substrate. The optimal cultivation conditions were: a 0.2% yeast extract content in the nutrient solution, a 1:1.6 ratio of rice to nutrient solution, and a 4 mL inoculum of the liquid strain. Under these conditions, it took about 4 days for the mycelium to grow over the cultivation medium. The time required for the differentiation of the primordium to form fruit bodies was about 20 days, and the bioconversion rate reached 28.70% ± 5.05%. The results of this study indicate the feasibility of using rice as the main substrate for the cultivation of I. hispidus, and it also provide new insights for the finding of new cultivation substrates for other rare medicinal fungi. © 2018 Science Press. All rights reserved.     

Recent advances in three typical configurations and applications of bioelectrochemical systems北大核心CSCD

As the world's freshwater resources and available energy are alarmingly decreasing, the bioelectrochemical system (BES) is a cutting-edge technology for the resolution of the resource and energy issue. Researchers have paid much attention to t he application of t he BES configuration. Based on t he brief i ntroduction of m icrobial f uel cell a nd m icrobial electrolytic cell structure, principles, and domestic and foreign research, the BES and its influencing factors are introduced, specifically including: microbial activity, electrode materials, and configuration. Three important aspects (i.e., the electrode chamber, the reaction chamber, and micro-sensor) are summarized, and the advantages and disadvantages of single-electrode and multi-electrode chambers are compared, based on the microbial desalination cell. Microbial electrolysis desalination cell: Microbial electrolysis desalination and chemical-production cell have been discussed to introduce increasing reaction chamber configuration; this review focuses on the research of BES monitoring with regards to biochemical oxygen demand. The potential applications of the research progress are explored. The results show that the configuration of multi-chamber microbial fuel cell is complex and its efficiency is low, while the single chamber configuration is advantageous. The reaction chamber added is mainly aimed at desalination, and the study of the desalination pool still needs to be focused on optimizing the cation exchange membrane to maintain the anode pH balance and reduce the air cathode dissolved oxygen. Microbial electrode sensor can be applied in more areas, and its sensitivity and long-term stability need to be further improved. However, there is relatively less research on the abundance and activity of electricigen communities; the configurations and scopes of application of BES are still the research priority. © 2018 Science Press. All rights reserved.     

个人乘用车用可替代燃料与我国未来的选择

个人乘用车排放量占道路交通运输二氧化碳(CO2)排放量的三分之一。因此,逐步实现其燃料由传统石化燃料汽柴油向新能源转变是交通运输行业低碳减排和绿色发展的重要抓手之一。本文对当前可供个人乘用车使用的4大类新能源即生物燃油、燃料乙醇、氢和电的属性,特别是其CO2减排效果和使用成本进行了分析和对比,并对新能源加注(充电)设施在欧盟和美国的布局战略和实施成果进行了介绍。结合欧美的实践和中国的实际,本文提出了未来个人乘用车用可替代燃油布局的建设,建议我国直接从传统石化汽油跨越至氢和/或电,并将其作为未来个人乘用车的燃料。     

Combination of biodiesel-ethanol-diesel fuel blend and SCR catalyst assembly to reduce emissions from a heavy-duty diesel engine

In this study, the efforts to reduce NOx and particulate matter （PM） emissions from a diesel engine using both ethanol-selective catalytic reduction （SCR） of NOx over an Ag/Al2O3 catalyst and a biodiesel-ethanol-diesel fuel blend （BE-diesel） on an engine bench test are discussed. Compared with diesel fuel, use of BE-diesel increased PM emissions by 14% due to the increase in the soluble organic fraction （SOF） of PM, but it greatly reduced the Bosch smoke number by 60%-80% according to the results from 13-mode test of European Stationary Cycle （ESC） test. The SCR catalyst was effective in NOx reduction by ethanol, and the NOx conversion was approximately 73%. Total hydrocarbons （THC） and CO emissions increased significantly during the SCR of NOx process. Two diesel oxidation catalyst （DOC） assemblies were used after Ag/Al2O3 converter to remove CO and HC. Different oxidation catalyst showed opposite effect on PM emission. The PM composition analysis revealed that the net effect of oxidation catalyst on total PM was an integrative effect on SOF reduction and sulfate formation of PM. The engine bench test results indicated that the combination of BE-diesel and a SCR catalyst assembly could provide benefits for NOx and PM emissions control even without using diesel particle filters （DPFs）.     

城市高污染燃料禁燃区规划方法及案例研究

在总结高污染燃料禁燃区实际规划过程中的经验、参考已有的大气污染控制规划方法的基础上,针对目前高污染燃料禁燃区规划实践中的不足,将情景分析法、模型分析法以及地理信息系统技术(GIS)应用于规划中,提出并发展了一套解决城市或地区高污染燃料禁燃区规划的整体技术方案,并通过该方法体系在珠海市高污染燃料禁燃区规划中的实际案例分析,显示了该方法的可行性与可操作性,为全国其他城市的高污染燃料禁燃区的合理规划提供了一个实例和参考。     

养殖废水中9种大环内酯及林可酰胺类抗生素的同时测定及分析方法研究

采用固相萃取-超高效液相色谱三重四极杆质谱联用法,建立了同时测定养殖废水中9种大环内酯及林可酰胺类抗生素的方法,并对样品pH值、保存时间、洗脱溶剂、上样流速及过滤材质等进行了优化。测定结果表明,pH值为6,过滤材质为聚丙烯（GHP）,上样速度为5 mL/min时,9种抗生素的加标回收率最优,为71.4%～126%,相对标准偏差最小,为2.4%～7.1%,标准曲线的线性最好,相关系数为0.998 5～0.999 5,检出限为0.78～1.22 ng/L。该方法灵敏度高、检出限低、测定结果准确,能够广泛应用于养殖废水中大环内酯及林可酰胺类抗生素残留量的监测分析。     

Pre-feasibility study of stand-alone hybrid energy systems for applications in eco-houses

In light of rising cost of fossil fuels and fears of its depletion, coupled with the increase in energy demand and the rise in pollution levels, governments worldwide have had to look at alternative energy resources. Combining renewable energy generation like solar power with superior storage and conversion technology such as hydrogen storage, fuel cells and batteries offers a potential solution for a stand-alone power system. The aim of this paper was to assess the techno-economic feasibility of using a hybrid energy system with hydrogen fuel cell for application in an eco-house that will be built in Sultan Qaboos University, Muscat, Oman. Actual load data for a typical Omani house of a similar size as the eco-house was considered as the stand-alone load with an average energy consumption of 40 kW/day and 5 kW peak power demand. The National Renewable Energy Laboratory's Hybrid Optimisation Model for Electric Renewable software was used as a sizing and optimisation tool for the system. It was found that the total annual electrical energy production is 42,255 kW and the cost of energy for this hybrid system is 0.582 $/kW. During daylight time, when the solar radiation is high, the photovoltaics (PV) panels supplied most of the load requirements. Moreover, during the evening time the fuel cell mainly serves the house with the help of the batteries. The proposed system is capable of providing the required energy to the eco-house during the whole year using only the solar irradiance as the primary source.