Accidental release: Fuzzy selection of adequate formal model

Risk assessment of a chemical process plant requires the application of a variety of consequence models in order to estimate the potential physical effects of accidental releases. The types of models required vary depending upon the substance under consideration and the circumstances of a release. The objective of this study was the development and application of a system based upon ‘fuzzy logic’, for the selection of a computer model to be used in consequence analysis in specific situations where only certain types of consequence models can be used. The collection of data for modelling purposes from different kinds of computer model and application of fuzzy methods were also important aims of the study.     

南京理工大学高压实验室及其研制高压水射流切割机

南京理工大学高压实验室自８０年代初建立以来，在高压容器及武器发射管的自紧理论和工程应用、高压零部件研制、高压传感器和信号放大显示系统、高压介质等方面做了大量的工作。９３年以来，进行了水射流切割机的研制工作，解决了超高压缸体的动态密封、高压缸体的自增强、无触点式换向传感器、内衬不锈钢组合型高压容器等诸多问题，试制成功了水射流切割机样机。     

Investigation the effect of adding graphene oxide into diesel/higher alcohols blends on a diesel engine performance

ABSTRACT

This article aims to study the influence of the addition of graphene oxide nanoparticles (GO) to diesel/higher alcohols blends on the combustion, emission, and exergy parameters of a CI engine under various engine loads. The higher alcohols mainly n-butanol, n-heptanol, and n-octanol are blended with diesel at a volume fraction of 50%. Then, the 25 and 50 mg/L concentrations of GO are dispersed into diesel/higher alcohols blends using an ultrasonicator. The GO structures are examined using TEM, TGA, XRD and FTIR. The findings show that there is a reduction in p_max. and HRR when adding higher alcohols with diesel fuel. Regarding engine emission, there is a significant improvement in emissions formation with adding higher alcohols. The addition of GO into diesel/higher alcohols blends improves the brake thermal efficiency by 15%. Moreover, the p_max. and HRR are both enhanced by 4%. The CO, UHC and smoke formation are reduced considerably by 40%, 50 and 20%, respectively, while NO_x level is increased by 30% with adding GO. Finally, adding high percentages of n-butanol, n-heptanol, and n-octanol with diesel fuel with the presence of GO has the potential to achieve ultra-low CO, UHC, and smoke formation meanwhile keeping high thermal efficiency level.     

Thermal cracking of oils from waste plastics

Thermal cracking of decomposed waste plastic oil produces a good yield of olefins. The solvent extraction of such waste plastic oil seems to be efficient for increasing gas yields and recycling monomers. To assess the potential of monomer recovery from municipal waste plastics, the oils were cracked using a laboratory-scale quartz-tube reactor. The waste plastic oils were provided by two commercial plants of the Sapporo Plastic Recycle Co. and the Dohoh Recycle Center Co. in Japan. A model waste plastic oil made in a laboratory was also examined. Yields of ethene, propene, and other products were measured at different temperatures. Two-step pyrolysis reduces coking compared with the direct thermal degradation of plastics. The raffinates from waste plastic oils extracted by sulfolane were also cracked. The primary products were almost the same as those from nontreated oils. The maximum total gas yield was 78wt%–85wt% at 750°C, an increase of about 20wt% compared with that of nonextracted oil. Solvent extraction removes stable aromatic hydrocarbons such as styrene, which is more coked than cracked.     

潮湿巷道风流温度与湿度变化规律分析

通过对矿井风流与围岩热湿交换理论的研究,提出理论上更可靠的风流温、湿度计算方法,编制了模拟解算矿井风流与围岩热湿交换的计算机程序,解算出潮湿巷道风流温度及湿度的变化规律,并分析通风时间、湿度系数等参数对风流温度及湿度变化规律的影响;沿风流流动方向,风流温度及湿度不断增加;巷道风流温度及湿度随着通风时间的增加而不断减小,通风时间越长减小的幅度越小;围岩壁面湿度系数对风流温度及湿度的影响较大,其他参数不变时,壁面湿度系数越大,风流温度越小,风流湿度越大。     

液化四氟乙烷小孔泄漏试验研究

采用高速摄影技术,考察了液化四氟乙烷发生小孔泄漏时,其水平泄漏和垂直泄漏的初始云团演化行为、泄漏的质量流率、喷射速度和喷射角,并与理论计算公式进行了对比。结果表明:水平喷射两相云团尾部出现涡流,涡流大幅加快了云团向空气中扩散的速率;垂直喷射的两相云团在地面形成液池,液池大幅增加了液化气体向空气中蒸发的速率。水平泄漏试验的喷射角与容器内超压变化规律相似,泄放初期喷射角逐渐增大,经历一段平坦期,到泄放末期喷射角减小。水平泄漏和垂直泄漏的初始喷射速度分别为25 m/s和20 m/s,与理论值26.6 m/s基本吻合。水平泄漏的质量流率的试验值和理论值分别为0.0598 kg/s和0.0684 kg/s,垂直泄漏的分别为0.0472 kg/s和0.059 6 kg/s,结果对比基本吻合,推荐的泄漏质量流率和小孔喷射速度公式可以用于液化四氟乙烷小孔泄漏。     

不同pH值对磷矿废石磷素浸出特性影响的实验研究

采用EPA 1314pH酸碱预滴定实验和pH浸出实验,研究了pH对磷矿废石磷元素浸出特性的影响,以及磷矿废石的酸碱缓冲容量。实验结果表明:磷矿废石的碱缓冲容量小,pH从8.75上升到13.50消耗了0.1mmol/g的NaOH,磷矿废石酸的缓冲容量较大,pH从5.50到1.00,共消耗2.2mmol/g的H2SO4;浸提液的酸碱性是影响磷矿废石中磷元素浸出的重要参数,酸性条件下很大程度上促进了磷元素的浸出,随着H+离子浓度的增加,总磷浓度随之升高。相反在碱性条件下的反应过程中,OH-阻碍磷元素的浸出,消耗正磷酸根离子和羟基磷酸根离子,使其生成沉淀,有一定的固磷作用,为磷元素的固化提供了更多途径。     

外源有机酸添加对风化煤矸石污染释放及重金属有效性的影响

为评价不同类型有机酸对风化煤矸石污染释放的影响,通过在风化煤矸石中添加不同种类的外源有机酸(腐殖酸、柠檬酸、草酸、水杨酸)进行处理,分析稳定7d后煤矸石浸出液的特征污染组分及TCLP提取态重金属含量。结果表明:对照处理组的风化煤矸石浸出液具有典型的酸性矿山废水特征。添加少量柠檬酸、草酸和水杨酸能显著(p0.05)降低风化煤矸石浸出液的pH和Eh值、明显增加浸出液的盐度、亚铁、总铁和硫酸盐含量,然而腐殖酸处理对浸出液pH、EC、Eh无明显影响,且可降低浸出液硫酸盐含量。少量外源有机酸添加均能不同程度促进风化煤矸石中Fe、Mn、Cu、Zn元素溶出,其中水杨酸处理对4种金属元素的溶出量较大。然而4种外源有机酸处理则能有效抑制Pb溶出,其中柠檬酸、水杨酸处理抑制效果最明显。有机酸添加对风化煤矸石的重金属有效性影响表现为4种外源有机酸处理均能明显增加风化煤矸石中Mn元素的有效性,降低Zn元素的有效性,但对Fe元素的有效性影响不明显。4种外源有机酸添加对煤矸石中Cu元素有效性具有不同程度的影响,其中腐殖酸、草酸处理能明显降低Cu元素有效性,而柠檬酸和水杨酸处理则明显增加Cu的有效性。     

Effect of particle size on CO adsorption and thermodynamic analysis

The liquid nitrogen adsorption method was used to characterize the pore structure of non-cohesive coal in the 061,404 working face of the Lingxin coal mine. The amount of specific surface area of micropores in the sample continuously rose as particle sizes reduced. The volumetric method was used to measure the CO isothermal adsorption curves of three samples (sample I, 0.425–0.25 mm, sample II, 0.18–0.25 mm, and sample III, 0.15–0.18 mm). The experimental results were fitted by the Langmuir model. According to the experimental results, it was conducive to CO adsorption with the conditions of high pressure and low-temperature. The decrease in grain diameter increased the number and volume of micropores in the sample, which improved the adsorption capacity of the sample. In addition, according to the adsorption data, the CO adsorption thermodynamics of three samples were analyzed, including surface potential (Ω), Gibbs free energy change (ΔG) and entropy change (ΔS). The results demonstrated that CO adsorption by coal was a spontaneous process. Sample III has the most substantial adsorption capacity, whereas the sample I has the weakest adsorption capacity.     

城市河网区河流沉积物磷形态分布特征及释放贡献

以嘉兴城市河网区为研究区域,在调查区域水质和沉积物磷空间变化特征的基础上,分析沉积物中各形态磷的垂直与空间赋存状态,通过吸附释放参数计算EPC₀值,明确了沉积物-水界面磷迁移影响因素和沉积物中活跃磷素的释放风险和贡献.结果表明,研究区域水质氮磷污染较为严重,沉积物TP含量均值呈北部河网区>西部河网区>南部河网区,基于单因子指数法的生态风险评价为Ⅱ、Ⅲ和Ⅳ级的样本比例分别为10.91%、25.45%和63.64%.沉积物各形态磷整体呈现TP>IP>HCl-P>NaOH-P>OP,沉积物生物有效磷（BAP）整体呈现Olsen-P>AAP>WSP>RDP;在沉积物垂直剖面中,部分位点受到外界因素的强烈影响垂向波动较大,整体上是随深度的递增而减小,这与近年来研究区域接收的外源磷积累过程在加重有关.相关性分析表明,沉积物磷吸附容量（Q_max）与铁铝氧化物呈显著相关性 （p<0.05）;释放参数EPC₀与TP、IP与HCl-P呈显著相关性 （p<0.05）.结合BAP形态,研究区域河流沉积物NaOH-P、HCl-P、AAP、Olsen-P及WSP存在较高的释放潜力.南部河网区沉积物主要呈现磷“源”角色,西部和北部河网区部分区域沉积物充当磷“源”角色.南部河网区在长短时间尺度下的磷主要释放形态为NaOH-P、HCl-P和OP,北部河网区在长时间尺度下主要释放磷形态为NaOH-P、HCl-P,西部河网区在短时间尺度下主要释放形态以HCl-P为主,在长时间尺度下3种磷形态的释放风险仍然较高.