Application of CGP-cross route process for microstructure refinement and mechanical properties improvement in steel sheets

A modified method of severe plastic deformation (SPD) entitled constrained groove pressing-cross route (CGP-CR) was introduced for imposing a high magnitude of equivalent strain of about 2.32 per pass on the sheet form samples. The major benefit of this improved route compared to previous common route was the more homogeneity of strain in the rolling (RD) and transverse (TD) directions of sheets. In this study, low carbon steel samples were used for examination of evolutions in microstructure and mechanical properties during SPD via CGP-CR process. Mechanical properties improvement were measured by tensile and macro hardness tests. The results indicate that CGP-CR process can effectively improve tensile strength; and also, yield stress and hardness of as-received low carbon steel samples were improved up to about 100% after two deformation passes. Also, high magnitude of inhomogeneity can be observed in hardness distribution through first pass of the process which diminishes in the subsequent passes. Microstructural evolutions during process were monitored by optical microscopy observations and X-ray diffraction analysis. The results demonstrate that initial ferritic microstructure with grain size of about 30 μm was refined to a 225 nm cell structure after two passes of CGP-CR process.     

Ionic composition of submicron particles (PM1.0) during the long-lasting haze period in January 2013 in Wuhan, central China

In January 2013, a long-lasting severe haze episode occurred in Northern and Central China; at its maximum, it covered a land area of approximately 1.4 million km². In Wuhan, the largest city in Central China, this event was the most severe haze episode in the 21st century. Aerosol samples of submicron particles (PM_1.0) were collected during the long-lasting haze episode at an urban site and a suburban site in Wuhan to investigate the ion characteristics of PM_1.0 in this area. The mass concentrations of PM_1.0 and its water-soluble inorganic ions (WSIIs) were almost at the same levels at two sites, which indicates that PM_1.0 pollution occurs on a regional scale in Wuhan. WSIIs (Na⁺, NH₄⁺, K⁺, Mg²⁺, Ca²⁺, Cl^-, NO₃^- and SO₄^2-) were the dominant chemical species and constituted up to 48.4% and 47.4% of PM_1.0 at WD and TH, respectively. The concentrations of PM_1.0 and WSIIs on haze days were approximately two times higher than on normal days. The ion balance calculations indicate that the particles were more acidic on haze days than on normal days. The results of the back trajectory analysis imply that the high concentrations of PM_1.0 and its water-soluble inorganic ions may be caused by stagnant weather conditions in Wuhan.     

低温条件下污水处理运行研究

低温是造成寒冷地区冬季生活污水生化处理效果差的主要原因。当温度降低至4cC左右时,活性污泥中大多数微生物的生长活性受到抑制,只有少数的耐冷微生物可以存活下来并保持一定的活性。本课题组以往的研究结果证明：在我国北方地区,完全可以分离到在低温下高效降解污水中有机物的耐冷细菌。通过投加耐冷茵可使污水的去除效率大大提高。但由于投加的耐冷茵的流失等原因,必须隔一定时间再次投菌,既费时费力,又增加投资。     

具有自动清洗功能的低温等离子油烟净化装置设计与实现

为了克服现有的油烟净化器清洗困难、清洗成本高的不足,提供一种具有自动清洗功能的低温等离子油烟净化器,该具有自动清洗功能的低温等离子油烟净化器可随时清洗吸附的油烟,并且清洗容易、成本低。     

后京都议定书时代的二氧化碳排放格局与中国面临的发展挑战

阐述了近期世界主要国家的温室气体排放状况,以及2012年<京都议定书>第一承诺期到期后,全球二氧化碳可能的排放格局.分析了气候变化对中国发展带来的挑战.指出气候变化是人类共同面临的挑战,世界各国都在采取各种措施努力减少额外的二氧化碳排放量;作为发展中的温室气体排放大国,中国面临巨大的减排压力,为此,中国必须尽快做出调整,向低碳经济转型.     

低碳高氮污水处理应用技术研究

针对碳氮比小于7的污水,其碳源不能满足硝化与反硝化的要求这一问题,通过改变SBR工艺的运行方式、调解工艺参数等技术手段,使其能够达标处理此类工业废水,并通过某淀粉厂的工程实例进行了验证:采用改良的SBR工艺可以对低碳高氮污水进行有效的处理。     

上海市大气总汞季节变化特征及与气象条件的关系

2008年到2010年对上海市西南部大气中总汞(TGM———Total Gaseous Mercury)的污染水平进行监测,结果表明TGM日均浓度为ND~57.23ng/m(3(7.79±3.29)ng/m)3。TGM呈现出一定的季节性变化特征,浓度最高的是秋季,然后依次是冬季、春季、夏季,平均浓度分别为(9.30±2.48)、(8.32±2.79)、(7.78±2.33)、(2.16±3.29)ng/m3。TGM浓度受东南风向影响最大,其次为西北和东北风向。在置信水平为95%的情况下,TGM浓度与日平均温度呈正相关性,而与日温差、相对湿度、日相对湿度差、风速无显著相关性。但TGM浓度分别与日均O3浓度和NO2浓度均呈显著正相关。利用HYSPLIT_4模型对TGM浓度高值与低值几天的空气气团来源轨迹进行反演,结果发现高低浓度日的气团来源略有差别,总体上看,冬季、春季和秋季受北方气团影响较大,夏季则受我国东部海域影响,具体的局部和长距离输送的贡献需要进一步研究。     

基于ANFIS模型的基坑工程位移反分析

在软土地基深基坑开挖支护工程的设计与施工中,岩土体力学参数的取值问题是关键。基于MATLAB(R2007a)模糊工具箱中的自适应神经模糊推理系统(ANFIS)对基坑岩土体力学参数进行了位移反演分析,并结合汉口火车站出站厅基坑工程实例,动态反演了具体参数,检验了反演精度,从而验证了该方法用于基坑工程位移反分析的可行性及工程适用性。     

氧化塘合理的设计与操作

氧化塘不但可以低费用的降解废水，而且可以提供有用的生物量，其关键是进行合理的设计、操作和去除污泥．本文综合国外的文献资料，提出合理的设计和操作方案，并且引用国外试验者开发的预测模型；同时提出操作过程加入适当的ＣａＣｌ２化学添加剂可以促进藻类生物量的絮凝，以保证出水的质量和提供可利用的生物量．     

“W型低NOx环保燃烧器”特点及应用状况

“W型低NOx环保燃烧器”采用先进的复合多级混合式雾化技术，强化喷射、混合和扩散，燃烧充分从而控制NOx生成。