NOx存在条件下相对湿度对甲苯氧化产物的影响

利用流动管反应器模拟甲苯与氧化剂×OH在NO_x存在条件下的反应,定量测定了不同相对湿度条件下（17.5%、35%、50%、70%）反应生成的部分气相产物和颗粒相产物,计算了不同相中产物产率,测量了不同相对湿度下的颗粒相有机碳（OC）产率,推导了相对湿度对甲苯氧化反应的影响机制.结果表明,相对湿度不仅对甲苯与×OH反应途径比例有影响,还对产物的产率及氧化程度有影响.     

色氨酸对生物成因铁硫酸盐次生矿物形成的影响

采用氧化亚铁硫杆菌催化合成铁硫酸盐次生矿物,研究不同L-色氨酸添加浓度对矿物合成体系pH、氧化还原电位（ORP）、Fe²⁺氧化率、总Fe沉淀率,以及次生矿物产量、化学组成及矿物相的影响.结果表明,随着体系色氨酸浓度的增加,pH降低幅度越小,ORP上升越不明显.色氨酸对铁硫酸盐次生矿物合成的影响依赖于其浓度,当色氨酸浓度低于1.67 g·L^-1时,色氨酸对铁硫酸盐次生矿物的形成起促进作用,表现为总Fe沉淀率及矿物产量随着色氨酸浓度升高而增加.而当色氨酸浓度升高至6.67 g·L^-1时,Fe²⁺氧化率、总Fe沉淀率和矿物产量远低于对照组,表明高浓度色氨酸会抑制铁硫酸盐次生矿物的形成.次生矿物内Fe/S比介于施氏矿物和黄钾铁矾的理论值之间,表明不同合成体系所得次生矿物均为黄钾铁矾和施氏矿物的混合物.矿物学特征分析表明,随着色氨酸浓度的升高,矿物的合成表现为黄钾铁矾向施氏矿物转移.     

典型脱硫工艺对燃煤锅炉烟气颗粒物的影响

脱硫是燃煤锅炉的重要除污环节,为探究脱硫工艺对烟气颗粒物的影响,选取4台不同脱硫工艺（石灰石/石膏法、炉内喷钙法、氨法和双碱法）的燃煤锅炉,利用再悬浮采样法和稀释通道采样法分别采集脱硫前后烟气颗粒物样品,并测定颗粒物中的水溶性离子、无机元素和碳组分.结果表明,脱硫剂对烟气PM_2.5的组分构成产生影响,烟气经过石灰石/石膏法脱硫后,PM_2.5中的Ca由5.1%提高至24.8%;经过氨法脱硫后,PM_2.5中NH₄⁺的质量分数由0.8%提高到7.3%;双碱法脱硫则使烟气PM_2.5中Na由0.9%提高到1.7%.湿法和干法脱硫工艺的作用显著不同,湿法脱硫排放颗粒物的离子含量较高,经过石灰石/石膏法和氨法脱硫,PM_2.5中SO₄^2-的质量分数分别由2.0%和6.7%提高到9.6%和11.9%,Cl^-分别由0.4%和1.2%提高到3.8%和5.2%,而Cr、Pb、Cu、Ti和Mn等重金属经过湿法脱硫出现含量下降;相对湿法脱硫,干法脱硫燃煤锅炉排放的PM_2.5中富含Al、Si和Fe等地壳元素.湿法脱硫同样对碳组分产生影响,石灰石/石膏法和氨法脱硫后,烟气PM_2.5的元素碳EC质量分数分别从6.1%降至0.9%和从3.6%降至0.7%,但是有机碳OC的含量并没有下降.     

小型燃煤机组烟气重金属排放特征研究

100 MW以下燃煤机组呈单台容量小、总台数大的特点,是燃煤重金属污染的主要排放源之一.选择7台12 MW燃煤机组,采用美国环境保护局Method 29法现场检测燃煤机组烟气重金属排放浓度,分析烟气中Hg、Pb、Cr、As的排放特征;采集机组产生的飞灰和底灰,分析除尘技术对重金属的富集特性.结果表明:100 MW以下燃煤机组烟气中重金属经脱硝除尘脱硫装置协同控制后,ρ（Hg）为0.20~0.44 μg/m3,烟气Hg以气态形式存在,其占比为100.0%;ρ（Pb）为0.5~2.6 μg/m3,烟气Pb主要以气态形式存在,其占比为38.7%~92.1%;ρ（As）为0.6~3.0 μg/m3,烟气As主要以气态形式存在,其占比为67.8%~100.0%;ρ（Cr）为3.6~23.9 μg/m3,烟气Cr主要以颗粒态形式存在,其占比为65.8%~99.2%.飞灰富集Hg、Pb、Cr、As的能力大于底灰.重金属主要富集于飞灰中的细颗粒物中,采取除尘技术可有效协同控制烟气中的Hg、Pb、Cr、As;飞灰中重金属元素Hg、Pb相对富集系数均与煤中硫含量呈负相关,半干法脱硫+袋式除尘技术对飞灰富集Hg有促进作用.小型燃煤机组烟气重金属Hg、Pb、Cr、As的排放因子分别为0.002 2~0.005 1、5~17、42~160、7~24 mg/t.研究显示,100 MW以下燃煤机组与100 MW及以上燃煤机组烟气重金属Hg、Pb、Cr、As排放特征不同,100 MW以下燃煤机组烟气Hg排放浓度较小,二者烟气Pb、Cr、As排放浓度相近,选用湿式电除尘技术可进一步降低烟气Hg、Pb、Cr、As的排放浓度.      

低温等离子体协同催化降解废气污染物的研究进展

阐述了低温等离子体协同催化工艺流程与反应机理,探讨了反应温度、废气进口组分、废气中水蒸气含量、气体流速、气溶胶等因素对降解效果的影响。分析认为:一段式低温等离子体协同催化可改变低温等离子体特征及催化剂催化特性,但尚未解决尾气臭氧逃逸、副产物产生及放电稳定性等问题;两段式低温等离子体协同催化可提高污染物分子降解效率并减少尾气臭氧逃逸,但未能有效利用等离子体的能量,气体中的水蒸气、粉尘及反应过程中产生的气溶胶均能影响后置催化剂的催化性能;两段式低温等离子体协同催化已具备工程应用条件,还需配套高效预处理单元以降低废气中水蒸气、粉尘等对催化剂的影响。     

油气集输管道内防腐技术应用进展

针对油气田集输管道的内腐蚀问题,分别介绍了耐蚀材料、衬里技术、涂镀层技术与药剂防腐技术等管道内防腐技术及其现场应用效果,指出了耐蚀金属材料防腐效果显著,但存在经济效益差的缺点。为降低成本,选用双金属复合管替代耐蚀金属材料,但其焊缝位置腐蚀失效频发,成为制约其应用的薄弱环节。耐蚀非金属材料防腐效果显著,但耐高温性能与力学性能较差,受温度、压力与CO_2、H_2S、固体颗粒等介质成分的影响,衬里技术与涂镀层技术的应用范围受到限制。药剂防腐技术的防护效果与药剂类型、加药工艺密切相关,需要根据腐蚀工况监测结果进行实时调整。针对上述内防腐技术存在的问题,提出了未来内防腐技术的发展方向为改进现有内防腐技术存在的不足,提升其防护效果。同时,应开发防腐效果显著、经济成本低、施工简便、易于推广应用的防腐材料与防腐工艺技术。     

毛细柱气相色谱法测定废水中的三氯乙醛

讨论了用毛细柱气相色谱法测定废水中三氯乙醛的方法。该方法用(2+1)石油醚-乙醚萃取废水中的三氯乙醛,方法的相对标准偏差4.9％,回收率91.2％～101.1％,最低检出限4×10~(-2)ng。     

Determination of organophosphorus pesticides and related compounds in water samples by membrane extraction and gas chromatography

A membrane extraction-gas chromatography method was developed fordetermination of organophosphorus pesticides and related compounds including methamidophos, DDVP, dimethoate, methyl parathion, parathion, thiophosphoric acid trimethyl ester, and thiophosphoramidic acid dimethyl ester in water samples. In thismethod, surface-modified acetic cellulose membranes were used to extract the target analytes in water samples, the extracted analytes were back-extracted into a small amount of methanol, andgas chromatography with pulsed flame photometric detector (GC-PFPD) was used to determine the concentrations of targetanalytes in the extracts. The recoveries obtained for thetarget analytes spiked into the water samples ranged from 66to 94%. The method detection limit for each target analyte was 0.05 g L^-1. The method developed in this study had shown the advantages of being cheap, simple, fast, and reliable. It had been used successfully to determine the concentrations of target analytes in river water samples.     

Monitoring of Butter and Ghee (Clarified Butter Fat) for Pesticidal Contamination from Cotton Belt of Haryana, India

Butter (45) and ghee (55) samples were collected from rural and urban areas of cotton growing belt of Haryana and analysed for detecting the residues of organochlorine, synthetic pyrethroid and organophosphate insecticides. The estimation was carried out by using multi residue analytical technique employing GC-ECD and GC-NPD systems equipped with capillary columns. Butter samples were comparatively more contaminated (97%) than ghee (94%), showing more contamination with organochlorine insecticides from urban samples. About 11% samples of butter showed endosulfan residues above MRL value and 2% samples had residues of synthetic pyrethroids and organophosphates each above their respective MRL values. In ghee, residues of HCH & DDT both and of endosulfan exceeded the MRL values in 5 and 20% samples, respectively. Among organophosphates, only chlorpyriphos was detected with 9% samples showing its residue above MRL value. Irrespective of contamination levels, residues above the MRL values were more in ghee. More extensive study covering other agricultural regions/zones of Haryana has been suggested to know the overall scenario of contamination of milk products.     

Application of a systemic approach to the study of pollution of the Tinto and Odiel rivers (Spain)

The province of Huelva in the SW of Spain presents high environmental contrasts: together with the great abundance of natural spaces, it shows the impacts of historical natural resources exploitation processes. In the Ria of Huelva, the effluents of the chemical industries must be added to the contaminating inputs of the Tinto and Odiel rivers, coming from the acid drainage of the mines located in the Iberian Pyrite Belt. This forced the Environmental Agency (AMA) to elaborate in 1987 an Effluent Remediation Plan in order to negate unacceptable environmental impacts. The application of a grey box systemic analysis to the AMD pollution, undergone by the Tinto and Odiel rivers has allowed to set a conclusive explanation of the sampling results observed for a period of 11 years, thus making available an overall view of the polluting process and, above all, an explanation of its partial aspects.