微曝气Fenton氧化法处理模拟双酚A废水的效果及其生物验证

研究了微曝气Fenton氧化法关键工艺参数对模拟双酚A（BPA）废水处理效果的影响,并从活性污泥性质和污染物去除率两方面,采用膜生物反应器(membrane bioreactor, MBR)对微曝气Fenton氧化法的处理效果进行了实验验证,为实现BPA废水的生物处理奠定基础。结果表明,初始pH值、反应时间、H₂O₂/COD(质量浓度比)、H₂O₂/Fe²⁺ (摩尔浓度比)、反应温度及曝气量均对预处理效果有较大影响,在最佳条件下,COD去除率可达70%,BOD/COD值则由原废水的0.02提高到0.50以上。MBR处理上述出水的结果表明,经微曝气Fenton氧化处理BPA的废水,可较好地适应后续的生化处理。     

新型转式垃圾焚烧过程中脱氯脱硫机理的研究

为了探讨有机垃圾焚烧过程钙基添加剂对HCl,SO_x生成特性的影响,分别在自行设计的中空水冷转式垃圾焚烧炉和固定床加热炉中进行了一系列的实验,研究结果表明新型转式焚烧炉具有强化传热传质特性,能提高HCl、SO_x的脱除率,可抑制有害气体的生成;同时也研究了 HCl,SO₂气体同时存在时,钙基添加剂对脱氯脱硫效率的影响规律。     

可靠性技术的发展与应用

本文介绍了可靠性标准体系与参数体系,可靠性的分析与设计方法,可靠性试验的发展趋势,指出可靠性管理是产品可靠性工作的核心,以及提高电子设备可靠性的发展策略。     

PHAST软件在丁腈反应釜定量后果分析中的应用

丁腈反应釜运行过程中若发生泄漏事故,不仅厂区内部,而且附近区域的人员生命与财产都将遭受巨大的损失和危害.过去对一些物质的泄漏后果,人们提出了一些可靠的数学模型,但模型计算量大,容易出错.而采用后果软件PHAST具有很强的操作性.以某化工厂1台丁腈反应釜为例,用DNV公司的PHAST软件预测反应釜中丙烯腈和1,3-丁二烯的混合物发生泄漏后,对周围环境造成的影响.分别讨论了火灾、爆炸和毒性的影响,预测事故危害程度和范围.可为识别主要危险因素,采取相应的安全对策措施,发生事故后的现场控制等提供科学的参考依据.     

电袋复合除尘器的应用研究

针对我国燃煤电厂的除尘现状,指出电袋复合除尘器的技术经济优势.电袋复合除尘器在新建及改扩建电厂的成功应用取得了良好的经济、环境效益,并有广阔的发展前景.其研究重点是静电除尘单元和布袋除尘单元之间的结合.     

吨量煤体的自燃过程实验模拟研究

为更好地弄清矿井实际的煤自然发火规律,利用装煤量达5吨的大型实验台对两种烟煤分别进行了自燃模拟实验。大煤量的实验能够很好地模拟煤矿中煤低温氧化和传热传质共同作用导致的发火过程,实验得到的自然发火期与煤矿实际发火期也是一致的。实验中煤样从缓慢氧化变为快速氧化的临界温度为100～110℃。当煤温低于,临界温度时,煤样的升温受到空气流带走热量和向外界散热的影响很大,因此夹层水的保温作用就很关键。当煤温超过临界温度后,反应加快,温度急剧上升,散热的影响明显降低,反应主要受限于氧气的供应情况。     

新疆阜康冶炼厂无污染工艺及环境治理

介绍了阜康冶炼厂无污染新工艺和环境治理的有关情况 ,从理论上阐述了无污染工艺和污水治理的技术原理 ,对有色金属冶炼工业逐步采用湿法精炼清洁工艺有一定的指导作用     

污染物排放总量监测存在问题和对策

指出了目前总量监测中存在问题,如技术规范不够完善、监测能力和人员素质难以满足变化的生产工况、企业的配合不到位以及环评预测总量与实际情况出入太大,且不合理等。提出,应尽快制定和完善相关监测技术规范;加强在线监测监控体系的建设;加强监测人员自身专业素质的建设,以提高总量监测质量,更好地为环境管理服务。     

海洋纤毛虫——巨大拟阿脑虫的实验生态研究Ⅲ.pH对种群生长的影响

就水环境中pH对巨大拟阿脑虫Paranophys magna（纤毛门,盾纤目）种群生长的影响及后者的应答与适应进行了探讨,结果表明,虫体生存的pH阈值约为5－9．6,最适范围为7.0-9.0;pH对巨大拟阿脑虫的种群生长有显著影响,种群自然增长率及种群所达最大种群密度均随pH的不同而明显改变。     

Experimental Study of the Criteria of Flow Laminarization in Two-Dimensional Dense Gas Plumes

Laminarization of flow in a two-dimensional dense gas plume was experimentally investigated in this study. The plume was created by releasing CO₂ through a ground-level line source into a simulated turbulent boundary layer over an aerodynamically rough surface in a meteorological wind tunnel. The bulk Richardson number (Ri_*), based on negative plume buoyancy, plume thickness, and friction velocity, was varied over a wide range so that the effects of stable stratification on plume laminarization could be observed. A variety of ambient wind speeds as well as three different sizes of roughness arrays were used so that possible effects of roughness Reynolds number (Re_*) on plume laminarization could also be identified. Both flow visualization methods and quantitative measurements of velocity and intermittency of turbulence were used to provide quantitative assessments of plume laminarization.Flow visualization provided an overall picture of how the plume was affected by the negative buoyancy. With increasing Ri_*, both the plume depth and the vertical mixing were significantly suppressed, while upstream propagation of the plume from the source was enhanced. The most important feature of the flow revealed by visualization was the laminarization of flow in the lower part of the plume, which appeared to be closely related to both Ri_* and Re_*.Measurements within the simulated dense gas plumes revealed the influence of the stable stratification on mean velocity and turbulence intensity profiles. Both the mean velocity and turbulence intensity were significantly reduced near the surface; and these reductions systematically depended on Ri_*. The roughness Reynolds number also had considerable influence on the mean flow and turbulence structure of the dense gas plumes.An intermittency analysis technique was developed and applied to the digitized instantaneous velocity signals. It not only confirmed the general flow picture within the dense plume indicated by the flow visualization, but also clearly demonstrated the changes of flow regime with variations in Ri_* and Re_*. Most importantly, based on this intermittency analysis, simple criteria for characterizing different flow regimes are formulated; these may be useful in predicting when plume laminarization might occur.