A Monte Carlo study of radon detection in cylindrical diffusion chambers

The functioning of radon diffusion chambers was studied using the Monte Carlo code RAMMX developed here. The alpha particles from radon are assumed randomly produced in the volume of the cylinder, and those from the progeny are assumed to originate randomly at the cylindrical surface. The energy spectrum, the distribution of incident angles, and the distribution of path lengths of the alpha particles on the detector were obtained. These quantities vary depending on input parameters such as initial alpha particle energy, radius and depth of the diffusion chamber, detector size and atmospheric pressure. The calculated energy spectrum for both ²²²Rn and ²²⁰Rn was compared with experiment, permitting the identification of each peak and its origin, and a better understanding of radon monitoring. Three aspects not considered in previous calculations are progeny alphas coming from surfaces of the monitor, taking into account the atmospheric pressure, and including the isotope ²²⁰Rn.     

Bioaccumulation and biological effects in the earthworm Eisenia fetida exposed to natural and depleted uranium

The accumulations of both natural (U) and depleted (DU) uranium in the earthworms (Eisenia fetida) were studied to evaluate corresponding biological effects. Concentrations of metals in the experimental soil ranged from 1.86 to 600 mg kg⁻¹. Five biological endpoints: mortality, animals’ weight increasing, lysosomal membrane stability by measuring the neutral red retention time (the NRRT), histological changes and genetic effects (Comet assay) were used to evaluate biological effects in the earthworms after 7 and 28 days of exposure. No effects have been observed in terms of mortality or weight reduction. Cytotoxic and genetic effects were identified at quite low U concentrations. For some of these endpoints, in particular for genetic effects, the dose (U concentration)-effect relationships have been found to be non-linear. The results have also shown a statistically significant higher level of impact on the earthworms exposed to natural U compared to depleted U.     

Factors influencing on the bioaccessibility of polybrominated diphenyl ethers in size-specific dust from air conditioner filters

Size-specific concentrations and bioaccessibility of polybrominated diphenyl ethers (PBDEs) in dust from air conditioner filters were measured, and the factors influencing the PBDE bioaccessibility were determined. Generally, the PBDE concentrations increased with decreasing dust particle size, and BDE209 (deca-BDE) was generally the predominant congener. The bioaccessibility ranged from 20.3% to 50.8% for tri- to hepta-BDEs, and from 5.1% to 13.9% for BDE209 in dust fractions of varied particle size. The bioaccessibility of most PBDE congeners decreased with increasing dust particle size. The way of being of PBDE (adsorbed to dust surface or incorporated into polymers) in dust significantly influenced the bioaccessibility. There was a significant negative correlation between the tri- to hepta-BDE bioaccessibility and organic matter (OM) contents in dust. Furthermore, tri- to hepta-BDE bioaccessibility increased with increasing polarity of OMs, while with decreasing aromaticity of OMs. The tri- to hepta-BDE bioaccessibility significantly positively correlated with the surface areas and pore volumes of dust. Using multiple linear regression analysis, it was found that the OM contents and pore volumes of dust were the most important factors to influence the tri- to hepta-BDE bioaccessibility and they could be used to estimate the bioaccessibility of tri- to hepta-BDEs according to the following equation: bioaccessibility (%) = 45.05 − 0.49 × OM% + 1.79 × pore volume. However, BDE209 bioaccessibility did not correlate to any of these factors.     

沿面放电氧化液相亚硫酸铵

为了解决湿式氨法烟气脱硫生成不稳定亚硫酸铵（（NH4）2SO3）副产物的问题,设计了以不锈钢弹簧和溶液分别作为高压和低压电极的沿面放电系统,对液相（NH4）2SO3的氧化进行了研究。空气从反应器上方进入后经放电区域形成活性物质,再由底部的曝气头鼓入溶液并与（NH4）2SO3发生反应。比较了沿面放电处理与传统曝气处理的氧化效率,考察了放电电压、载气气量和初始浓度等因素对（NH4）2SO3氧化的影响。结果表明,沿面放电对（NH4）2SO3有显著的氧化效果;优化条件下的（NH4）2SO3氧化率接近100%;溶液中（NH4）2SO4与（NH4）2SO3的浓度比小于1时有利于（NH4）2SO3的氧化。     

季节性城市生活垃圾成分分析及厌氧消化特性研究

城市生活垃圾的成分及特性随着季节和人类在不同季节的生活习惯而变化,针对我国北方城市研究了一年中不同季节的城市生活垃圾成分特点,对影响厌氧发酵过程的相关成分如总有机碳（TOC）、总氮（TN）、蛋白质、脂肪和还原糖等进行了测定分析。通过厌氧消化实验,测得不同季节城市生活垃圾pH值、日产气量、沼气甲烷含量、甲烷累积量、挥发性脂肪酸（VFAs）和氧化还原电位（ORP）等参数的变化规律,分析相应变化的影响因素。结果表明,二、三季度的含水率分别为64．81％和67．50％,高于一、四季度,一季度发酵原料中蛋白质和脂肪含量分别为12．56％和8．86％,明显高于其他3个季度。一季度甲烷累积量最高,达到17616mL,单位发酵原料的产气量为204．8mL／g,也是4个季度中最高的,说明蛋白质、脂肪等有机成分含量对厌氧发酵过程及结果影响比较明显。为进一步的城市生活垃圾厌氧消化制取生物燃气的工艺条件提供依据。     

高气速间歇式生物过滤去除高负荷H2S

采用生物过滤法,以鸡粪堆肥和PE混合物为填料,在高气速条件下间歇式处理高负荷H2S废气。空床停留时间为20、15、10、6.7和5 s时,入口浓度3 000 mg/m3下的平均去除率分别为100%、100%、96.5%、89.2%和90.5%。高气速EBRT为5 s时,高入口负荷2 147 g/(m3.h)时的去除负荷为2 023 g/(m3.h),去除率达94%。采用Michaelis-Ment-en模型进行生物降解宏观动力学研究,其中Ks为550 mg/m3,Vm为6.8×104g/(m3.d)。结果表明,在实验温度17～24℃,湿度30%～50%下,生物过滤法间歇式处理高气速高负荷H2S的去除性能好。     

利用废弃物衍生燃料的热化学处理法制富含氢气合成气

为了探讨利用热化学方式从城市垃圾中制取富含氢气合成气过程的要素影响,解析氢气发生特性及其与主要影响要素之间的关系。在分析了城市生活垃圾组分特性的基础上,将其加工成组分均一的废弃物衍生燃料(refuse de-rived fuel,RDF),并在700、800和900℃等3个温度条件下,分别开展了RDF的热解、气化及水蒸汽气化等实验。研究表明,RDF的加工不但可有效降低垃圾含水率,还可将垃圾热值提高近1倍。温度和添加水蒸汽是从RDF中制取富含氢气合成气过程中的关键影响要素。其中,温度对氢气生成起到至关重要的决定作用,温度的提高对促进H2浓度的提高有利,同时,在气化过程中添加水蒸汽,可有效促进CO和H2等有价气体组分生成。在900℃的高温水蒸汽气化处理过程中,可获得H2浓度最高为34.13%的合成气。另外,800℃热解过程所产生的合成气热值最高,达到14 509 kJ/Nm3。     

间歇运行式生物滴滤池处理油漆废气中试研究

为研究间歇运行式生物滴滤池对油漆生产厂废气净化能力,建立一座中试规模生物滴滤池（BTF）,接种降解菌群,采用8 h/d运行方式净化某油漆厂包装车间废气,并用PCR-DGGE技术揭示BTF细菌群落结构与工艺运行条件间的联系。油漆厂包装车间废气中挥发性有机物（VOCs）主要为甲苯、乙苯、混合二甲苯（间、对和邻二甲苯）,BTF对甲苯、乙苯、混合二甲苯最大去除率分别为88.8%、83.7%和86.3%。DGGE分析显示,BTF稳定运行时,主要优势菌相对丰度较为稳定（F,P>0.05）,其细菌多样性显著低于启动期（F,P>0.05）;同时,下层填料细菌多样性高于上层填料,其细菌结构变化也较上层明显;另外,提升培养液浓度至2倍和4倍对菌群结构亦无显著影响。     

NiO-CuO/ZSM-5催化剂对催化裂化烟气的脱硫脱硝性能

采用浸渍法制备了不同NiO和CuO质量分数的NiO-CuO/ZSM-5催化剂,并以CH4为还原剂研究了NiO-CuO/ZSM-5催化剂对催化裂化烟气的脱硫脱硝活性。XRD分析结果表明,NiO质量分数为4%、CuO质量分数为6%的催化剂4%NiO-6%CuO/ZSM-5中的ZSM-5结构完好,CuO和NiO高度分散在ZSM-5骨架中,表明具有较好的催化活性。4%NiO-6%CuO/ZSM-5的脱硫脱硝起活温度均较低,无氧条件下最高NO转化率和SO2转化率分别为94.7%和95.9%,O2体积分数为1.0%时的NO转化率和SO2转化率分别为97.7%和89.0%。     

Evaluation of a classification method for biodegradable solid wastes using anaerobic degradation parameters

We studied the biochemical and anaerobic degradation characteristics of 29 types of materials to evaluate the effects of a physical composition classification method for degradable solid waste on the computation of anaerobic degradation parameters, including the methane yield potential (L₀), anaerobic decay rate (k), and carbon sequestration factor (CSF). Biochemical methane potential tests were conducted to determine the anaerobic degradation parameters of each material. The results indicated that the anaerobic degradation parameters of nut waste were quite different from those of other food waste and nut waste was classified separately. Paper was subdivided into two categories according to its lignin content: degradable paper with lignin content of <0.05 g g VS^?1, and refractory paper with lignin content >0.15 g g VS^?1. The L₀, k, and CSF parameters of leaves, a type of garden waste, were similar to those of grass. This classification method for degradable solid waste may provide a theoretical basis that facilitates the more accurate calculation of anaerobic degradation parameters.