低气压试验标准及试验技术分析

详细阐述了低气压环境对装备的各种影响,介绍了我国主要军用、民用环境试验标准中规定的试验程序及其应用对象,分析了有关低气压试验条件,包括低气压贮存、工作和快速/爆炸减压的试验条件和变化速率,最后简单介绍了低气压试验设备的一般要求、特别是快速减压和爆炸减压设备的使用和低气压试验技术。     

A product analysis-based study on the mechanism of inflammable gas explosion suppression

To study the mechanism of the suppressing effect of Expanded Aluminium (EA) on the premixed gas explosion, premixed methane-air and propane-air gases were undergone explosion reaction in the presence of EA in a self-designed closed pipeline with the overpressures and the compositions, rates and sensitivities of products analyzed. The results showed that the 9.5% methane-air and 5% propane-air explosions produced peak pressures decreased by 79.3% and 65.6%, and residual methane and propane contents increased by 270% and 560% respectively than without EA. In addition, the results revealed that the explosions of propane in the presence of EA produced less methane and carbon oxides contents, but more ethylene and propylene contents. The simulation showed that H, O, and OH are the key factors affecting the rate of products. The product compositions, together with other parameters, suggested that EA decreased temperature, inhibited chain initiation and propagation reaction, but facilitated chain termination reaction by advancing and accelerating the gas phase and wall destruction reaction of radicals, especially collisions and concentration of key free radicals. This new research method based on the analysis of explosion products can be used for in-depth research into gas explosion features and shed light on the suppressing mechanism of EA in flammable gas explosion.     

受限空间内惰性气体对CH4爆炸抑制特性研究

N2和CO2是常用的惰性抑爆气体,为研究两种气体的抑爆特性,采用20L球形爆炸试验装置,分析了不同浓度配比条件下N2/CH4/空气以及CO2/CH4/空气混合气体的爆炸压力,同时采集爆炸后的气体样品,对比分析爆炸后残留气体的主要成分。结果显示:随CH4浓度从5%增加至12.5%时,完全抑制CH4爆炸需要的惰性气体最小量先增大后降低,CH4浓度在6.5%~7.5%之间时,抑爆需要的惰性气体的量最大;在同一CH4浓度条件下,抑爆需要N2的量大于CO2,并且CH4浓度在5%~6.5%时,抑爆需要两种惰性气体的量值差别最大;当CH4浓度一定时,随着加入惰性气体量的增大,爆炸最大超压逐渐降低,惰性气体浓度和爆炸超压之间基本呈线性关系;在同样条件下,相对于N2,CO2为抑爆气体时,爆炸后腔体内残留的CH4浓度较高。研究成果为惰性气体抑爆技术提供技术支撑,同时为揭示惰性气体抑爆机理有一定作用。     

Water saving effect on integrated water resource management

This study proposes an improved integrated water resource management (IWRM), in which water conservation was analyzed for the entire water use process. A multi-objective optimization method was applied to optimize the IWRM, which investigated the reduction of freshwater consumption and the total water supply cost. Customer's preference for saving water and an end use analysis (EUA) was applied in the water conservation analysis. Taking Tianjin as the study area, a reduction in customer's economic pressure (EP) was utilized to evaluate the degree of the customer's preference for saving water. The results revealed that agriculture had a greater preference for saving water than other sectors, where as the public had the weakest motivation for saving water. Improving the transportation method could contribute 62.1% of the total water savings in the agriculture sector. The optimization of the IWRM demonstrated that the local freshwater savings would be 21.5%, and the total cost for water supplies would decrease by 13%. However, a government subsidy of 87.5 million Yuan would be needed. Additionally, by analyzing the change in the amount of water savings affected by water price, the appropriate water price increase range was suggested to be 1.5–1.7 times the original price.     

Case study of landfill leachate recirculation using small-diameter vertical wells

A case study of landfill liquids addition using small diameter (5 cm) vertical wells is reported. More than 25,000 m³ of leachate was added via 134 vertical wells installed 3 m, 12 m, and 18 m deep over five years in a landfill in Florida, US. Liquids addition performance (flow rate per unit screen length per unit liquid head) ranged from 5.6 × 10^?8 to 3.6 × 10^?6 m³ s^?1 per m screen length per m liquid head. The estimated radial hydraulic conductivity ranged from 3.5 × 10^?6 to 4.2 × 10^?4 m s^?1. The extent of lateral moisture movement ranged from 8 to 10 m based on the responses of moisture sensors installed around vertical well clusters, and surface seeps were found to limit the achievable liquids addition rates, despite the use of concrete collars under a pressurized liquids addition scenario. The average moisture content before (51 samples) and after (272 samples) the recirculation experiments were 23% (wet weight basis) and 45% (wet weight basis), respectively, and biochemical methane potential measurements of excavated waste indicated significant (p < 0.025) decomposition.     

PLC控制系统在钢渣热焖工艺中的应用

利用PLC控制系统,实现在钢渣热焖工艺中的恒压供水和钢渣热焖定时定量喷水的自动控制要求,具有国际先进水平,取得了良好的经济效益、社会效益和环境效益.     

Beyond ‘trees are good’: Disservices,management costs,and tradeoffs in urban forestry

The provision of ecosystem services is a prominent rationale for urban greening, and there is a prevailing mantra that ‘trees are good’. However, understanding how urban trees contribute to sustainability must also consider disservices. In this perspective article, we discuss recent research on ecosystem disservices of urban trees, including infrastructure conflicts, health and safety impacts, aesthetic issues, and environmentally detrimental consequences, as well as management costs related to ecological disturbances and risk management. We also discuss tradeoffs regarding species selection and local conservation concerns, as well as the central role of human perception in the interpretation of ecosystem services and disservices, particularly the uncritical assertion that ‘everybody loves trees’. Urban forestry decision-making that fails to account for disservices can have unintended negative consequences for communities. Further research is needed regarding life cycle assessments, stakeholder decision-making, return-on-investment, and framings of services and disservices in urban forestry.     

辽河流域水环境压力及污染治理模式研究

系统分析了辽河流域近十年社会经济和水污染物排放之间的关系,基于污染物排放强度和人均GDP指标,建立辽河流域COD和氨氮环境学习曲线;结合情景分析法预测在现有治污水平下,辽河流域未来水污染物排放趋势及水环境压力。结果表明,辽河流域水环境压力巨大。根据辽河流域污染治理中存在的实际问题,提出新时期的污染治理模式。     

飞机环控系统典型故障分析

环控系统解决了飞机座舱的供气、调温和增压问题,座舱的压力制度按3个阶段进行。通过典型的飞机环控系统故障,对座舱压力调节机理进行了分析,介绍了座舱压力调节过程,分析了导致飞行员耳膜疼痛、座舱压力持续下降的原因,提出了预防故障发生的建议。     

如何提高压差法测定BOD_5标样考核合格率

针对压差法测定生化需氧量的技术特点,通过总结日常分析、标样考核取得的经验,提出了想要提高压差法测定BOD标样考核合格率应注意的问题。