全文获取类型
收费全文 | 2981篇 |
免费 | 198篇 |
国内免费 | 366篇 |
专业分类
安全科学 | 381篇 |
废物处理 | 90篇 |
环保管理 | 814篇 |
综合类 | 1252篇 |
基础理论 | 274篇 |
环境理论 | 19篇 |
污染及防治 | 200篇 |
评价与监测 | 65篇 |
社会与环境 | 383篇 |
灾害及防治 | 67篇 |
出版年
2024年 | 12篇 |
2023年 | 62篇 |
2022年 | 78篇 |
2021年 | 92篇 |
2020年 | 139篇 |
2019年 | 105篇 |
2018年 | 108篇 |
2017年 | 187篇 |
2016年 | 207篇 |
2015年 | 160篇 |
2014年 | 127篇 |
2013年 | 308篇 |
2012年 | 225篇 |
2011年 | 281篇 |
2010年 | 192篇 |
2009年 | 155篇 |
2008年 | 124篇 |
2007年 | 144篇 |
2006年 | 118篇 |
2005年 | 88篇 |
2004年 | 71篇 |
2003年 | 76篇 |
2002年 | 62篇 |
2001年 | 62篇 |
2000年 | 58篇 |
1999年 | 56篇 |
1998年 | 29篇 |
1997年 | 27篇 |
1996年 | 23篇 |
1995年 | 18篇 |
1994年 | 25篇 |
1993年 | 10篇 |
1992年 | 11篇 |
1991年 | 8篇 |
1990年 | 10篇 |
1989年 | 7篇 |
1988年 | 5篇 |
1987年 | 3篇 |
1986年 | 5篇 |
1985年 | 7篇 |
1984年 | 5篇 |
1982年 | 4篇 |
1981年 | 5篇 |
1980年 | 7篇 |
1979年 | 12篇 |
1978年 | 8篇 |
1977年 | 4篇 |
1976年 | 3篇 |
1974年 | 3篇 |
1971年 | 2篇 |
排序方式: 共有3545条查询结果,搜索用时 106 毫秒
101.
将生活垃圾焚烧厂从整体到局部分为场站-工艺-单元三个层次,通过现场调查,获取了北京市生活垃圾焚烧设施在2009~2011年不同层次耗能排污数据。分析表明,在焚烧工艺中焚烧单元处理单位垃圾的电耗达到60.83 kW·h,余热发电单元水耗最大,尾气处理单元的电耗和水耗相对较小。不同场站在处理单位垃圾时烟气和炉渣产量比较接近,但飞灰排放差异较大,在2.92~24.78 kg/t垃圾之间。渗沥液水量年际变化较大,水质相对稳定,MBR单元对污染物的去除效果最好,但其耗电量较大,占渗沥液处理工艺总耗电量的87.55%。焚烧工艺发电最优值为423.77 kW·h/t垃圾,产生的电能除满足自身需求外,还剩余1.8×108 kW·h的电能,可用于渗沥液处理工艺或输向场站外部。每吨渗沥液处理最多可产生中水0.962 t,全北京市每年产生中水196456 t/a,使用潜力大。 相似文献
102.
澳大利亚新南威尔士州1997年出台的《污染土地管理法》核心内容包括污染土地责任人的界定、初步调查令、重大污染土地的认定、治理令、自愿治理方案、继续治理令,以及污染土地治理费用的偿还,即环保署支付费用的偿还、公共权力机构执行命令时支付费用的偿还、当事人之间费用的偿还和统一基金拨款的偿还。《污染土地管理法》实施以来,效果较好。 相似文献
103.
104.
为研究燃料氢气泄漏、爆炸的特性和规律,预防高压储氢系统中氢气泄漏爆炸事故发生,以加氢站为背景,数值仿真45 MPa高压储罐氢气泄漏并引发爆炸事故,分析泄漏爆炸动力学性质以及爆炸波在非均匀氢气浓度中的传播机制。同时,基于泄漏爆炸事故演化的力学机理,开展氢气泄漏爆炸动态风险分析,针对氢气不同泄漏量,建立泄漏扩散形成的气云体积、气云爆炸产生的冲击波与空间x,z方向上危害距离之间关系。研究结果表明:氢气泄漏过程中,气云氢气浓度变化与流场雷诺数具有较好一致性;氢气扩散受到高压储氢罐周围装置影响,流场中氢气浓度分布不均匀;当发生燃烧爆炸事故时,冲击波参数和湍动能变化梯度大;得到复杂布局区域冲击波超压峰值与比例距离之间关系式,其相比于理论方法更精细、计算结果更准确。研究结果可为降低高压储氢系统泄漏爆炸事故后果、采取有效防护措施提供一定依据。 相似文献
105.
106.
107.
为提高长大隧道施工及运营通风过程中竖井通风效率,实现隧道节能通风。依托实际隧道工程,基于Fluent软件,选用RNG k-ε湍流模型,对无竖井风塔、圆柱风塔、矩形风塔和凸台状风塔4种结构、不同环境风速工况下的流场进行数值模拟,并对模拟结果进行交叉比对分析,提出最优化的竖井风塔结构形式。研究结果表明:采用风塔结构竖井出流量要远大于无风塔结构竖井出流量;对于不同竖井风塔外型结构,竖井出流量与环境风速关系呈多项式函数;当倾斜角为45°、圆心角为90°时,凸台结构对应竖井出流量最大,且受环境风影响波动较小,通风稳定性较好。建议竖井出口结构选用矩形或凸台状,实现对环境风的高效利用,提高竖井通风效率。 相似文献
108.
实验测定了林西矿肥煤样品30~900℃煤自燃全过程热动力学特征参数,得出:TG/DTG曲线显示煤样DTG初始临界温度45℃,干裂温度122℃,活性温度195℃,增速温度265℃,质量极大值温度342℃,着火温度465℃,最大热失重速率温度515℃和燃尽温度690℃;DSC曲线显示,煤样初始放热温度60℃、最大热释放速率温度511℃。结合TG-DTG-DSC曲线综合分析可知,煤温达到510℃左右时煤样反应最剧烈。由煤自燃标志气体测定实验系统得出:煤温130℃后CO,CO 2释放量迅速增加,210℃增加速度下降;CH 4,C 2 H 6含量变化具有规律性且两者变化相近;C 2 H 4出现温度为130℃;C 2 H 4/C 2 H 6比值在190~350℃有较强的规律性,呈上升趋势且上升速度较快;350℃之后,CH 4,C 2 H 6,C 2 H 4体积分数均开始急剧增大;C 2 H 4/CO与C 2 H 4/CO 2变化趋势大致相同,在130~350℃时缓慢增长,达到350℃后比值呈指数形式上升。经拟合曲线,得到活化能的3个突变点温度:70,180,220℃,其中180℃与交叉点温度相吻合。通过以上研究,得到了肥煤自燃全过程的热力学特征参数,为实际生产中防治煤自燃提供了理论依据。 相似文献
109.
110.
ABSTRACT Refrigerant pressure drop and temperature change in pipes are normally ignored in the thermodynamic analysis of traditional vehicle air conditioning system, this will result in serious errors. In this Paper, pressure drop and temperature difference are simulated in different pipes of electric vehicle (EV) heat pump system to analysis the effects of pipes in the actual EV heat pump system. The results indicate that the greater the mass flow, the faster pressure drop increases, the temperature difference decreases. Pressure drop of saturated liquid refrigerant is smaller than that of saturated gas refrigerant at the same saturation pressure and mass flow rate. The higher the refrigerant pressure (no phase change), the slower pressure drop decreases, the faster the temperature difference decreases. Pressure drop decreases with the increment of bending angle of the pipe. For EV heat pump system, suitable valves and less branches are helpful for energy saving of the system. Shortening the pipe between compressor and condenser can reduce temperature change obviously. Pressure drop per unit length in the pipe between evaporator and compressor is large especially in heating mode because of lower refrigerant density. It even reaches to over 100 times of that in the pipe between condenser and throttle valve in heating mode and has negative effects on the performance of the system. If the evaporator is closer to the compressor and the number of branches is less, then pressure drop will decrease a lot, which will be advantageous for energy saving of the heat pump system. 相似文献