脉冲电解法预处理酸性染料废水

研究了脉冲电解法预处理酸性偶氮类染料废水的处理效果,考察了不同工艺条件对废水COD去除率、脱色率和可生化性的影响。结果表明,脉冲电源峰值电压12 V,频率600 Hz,占空比50%的条件下电解40 min后,COD去除率可达59%,废水脱色率达91.4%,BOD5/COD由0.09提高至0.34。在相同条件下,脉冲电解法的电流效率是直流电解法的2倍左右。与现行常用的铁/碳反应床相比,脉冲电解法在成本上也具有一定的优势,应用前景较好。     

丁酸胁迫对产氢污泥以厨余为底物的产氢影响

采用丁酸对产氢污泥进行胁迫处理,经胁迫后的污泥接种厨余垃圾进行产氢实验,考察丁酸胁迫对提高产氢性能的影响。结果表明,低浓度胁迫能提高产氢污泥的耐丁酸性,从而提高产氢量,而胁迫浓度过高则抑制产氢污泥活性,胁迫浓度呈"horm esis"效应。实验采用的4 g/L胁迫浓度为最佳,反应结束后,丁酸浓度和产氢量分别为8 417.1 mg/L和63.72 mL/g VS,比空白提高了31.3%和114%。产氢过程中SCOD的主要来源是有机酸。对产氢污泥胞外多聚物(EPS)的测定表明,厨余垃圾酸化速率、氢气产生速率和EPS总量成正相关。     

组合工艺处理填埋场渗滤液中溶解性有机污染物的去除特性

以采用"SBR+混凝+Fenton氧化+BAF"组合工艺处理的晚期垃圾渗滤液各级出水为研究对象,考察了HA、FA和HyI等溶解性有机物(DOM s)在各个工艺处理过程中的变化。结果表明,组合工艺COD和NH3-N去除率分别达到98.4%和99.3%;对DOM s的去除率为98.3%,其中胡敏酸(HA)、富里酸(FA)和亲水性有机物(HyI)的去除率分别为98.3%、99.5%和95.7%。各处理工艺中SBR和混凝工艺对HA和HyI的去除贡献较大,Fenton氧化工艺对FA去除率较高。Fenton氧化和BAF联用,可以有效去除难降解的溶解性有机污染物,使出水达到《生活垃圾填埋污染控制标准》(GB16889-2008)排放标准。     

酸雨对建筑材料的影响及防治研究综述

综合分析了酸雨对建筑外墙的涂料、石材、混凝土等主要建筑构件的腐蚀原理,并提出了防治措施,来预防酸雨对建筑材料的侵害。     

Electrochemical Monitoring of Methylparathion Degradation in an Acid Aqueous Medium in Presence of Cu(II)

Abstract

A study was undertaken to determine the effect of Cu(II) in degradation of methylparathion (o,o-dimethyl o, 4-nitrophenyl phosphoriotioate) in acid medium. Initial electrochemical characterization of Cu(II) and methylparathion was done in an aqueous medium at a pH range of 2–7. Cu(II) was studied in the presence of different anions and it was observed that its electroactivity depends on pH and is independent of the anion used. Methylparathion had two reduction signals at pH ≤ 6 and only one at pH > 6. The pesticide's transformation kinetic was then studied in the presence of Cu(II) in acid buffered aqueous medium at pH values of 2, 4, and 7. Paranitrophenol appeared as the only electroactive product at all three pH values. The reaction was first order and had k values of 5.2 × 10^?3 s^?1 at pH 2, 5.5 × 10^?3 s^?1 at pH 4 and 9.0 × 10^?3 s^?1 at pH 7. It is concluded that the principal degradation pathway of methylparathion in acid medium is a Cu(II) catalyzed hydrolysis reaction.     

TOTAL ARSENIC ACCUMULATION IN EDIBLE PODS AND SEEDS OF PHASEOLUS VULGARIS

The main objective of this study was to evaluate whether arsenic accumulated in the edible pods and seeds of Phaseolus vulgaris, cv. Helda, above the Spanish maximum recommended concentration for food crops, 1 mg kg^?1 on a fresh weight basis. Only organic arsenicals were used because they are: a) the only arsenic species allowed for agricultural applications and b) more mobile than inorganic species. Selection of French beans, a sensitive plant to arsenic, was based on the fact that arsenic upward translocation is higher in sensitive than in tolerant plants. A 2 × 3 factorial experiment was conducted with two organic arsenic species: methylarsonic acid (MAA) or dimethylarsinic acid (DMAA) and three arsenic concentrations: 0.2, 0.5, or 1.0 mg L^?1. Arsenic phytotoxicity was primarily determined by soluble arsenic concentration. Experimental results showed that the low bean plant tolerance to arsenic is possibly due to the high arsenic upward transport to shoots, which could result in profound negative metabolic consequences. Even under extremely adverse conditions, arsenic residues in edible beans were below the maximum statutory limit set by the Spanish legislation. It can be concluded that the major danger of organic arsenical herbicides is that of decreased productivity rather than high arsenic uptake by consumers.     

Development and application of LC–APCI–MS method for biomonitoring of animal and human exposure to imidacloprid

Imidacloprid (IMI) is a relatively new neuro-active neonicotinoid insecticide and nowadays one of the largest selling insecticides worldwide. In the present study a LC–APCI–MS based method was developed and validated for the quantification of imidacloprid and its main metabolite 6-chloronicotinic acid (6-CINA) in urine and hair specimens. The method was tested in biomonitoring of intentionally exposed animals and subsequently applied for biomonitoring of Cretan urban and rural population.     

养殖固体废物在硝酸和磷酸溶液中的水解特性

养殖固体废物掺杂磷肥工艺中养殖固体废物与酸的反应直接影响其有机组成。以鸡粪为研究对象,采用L16(45)正交试验研究了鸡粪粒径、酸浓度、鸡粪与酸溶液质量比、反应温度和反应时间对鸡粪在硝酸和磷酸溶液中水解过程的影响。结果表明,硝酸溶液中影响因素显著性依次为鸡粪与硝酸质量比、反应时间、硝酸浓度、鸡粪粒径、反应温度,最优工艺条件为鸡粪粒径0.20mm、硝酸质量分数15%、鸡粪与硝酸质量比0.2∶1.0、反应温度95℃、反应时间4h;在磷酸溶液中影响因素显著性依次为鸡粪与磷酸质量比、反应温度、鸡粪粒径、磷酸浓度、反应时间,鸡粪水解率与反应温度间呈正相关关系,最优工艺条件为鸡粪粒径0.40mm、磷酸质量分数60%、鸡粪与磷酸质量比0.1∶1.0、反应温度95℃、反应时间8h。鸡粪比表面积及其单位质量耗酸量、美拉德反应是制约鸡粪在硝酸和磷酸中水解反应的内因。研究结果为养殖固体废物掺杂有机磷肥的研发和推广提供了理论基础。     

废LCD面板有机材料水热资源化产乙酸

LCD面板主要由附着偏光片及液晶等有机材料的玻璃面板构成。有机材料的去除及资源化利用是废LCD面板处理的第一步。在水热条件下对废LCD面板进行了降解产酸研究。研究考察了反应温度、反应时间、氧化剂用量、水用量及pH值等对水热产乙酸产率及选择性的影响。通过正交实验确定了水热产乙酸的最佳操作条件：反应温度325℃,反应时间5min,氧化剂（30％H2O2）0．6mL,用水量2mL,近中性环境（pH6-6．5去离子水）。此条件下,乙酸产率及选择性分别为68．83％及70．56％。结果表明,以废LCD面板有机材料为原料,采用水热技术进行产乙酸反应,可实现其资源化再利用。     

萃取净化电镀含镉废水

研究了二壬基萘磺酸(DNNSA)形成的微乳液从模拟含镉废水中萃取镉离子的工艺条件。分别考察了相体积比(O/A)、萃取时间、温度及萃取剂浓度对废水中镉离子萃取的影响。结果表明,萃取平衡时间为10 mim,降低温度及增加萃取剂浓度均有利于萃取。紫外光谱证实当DNNSA萃取镉时,所形成萃合物对萘环的结构无影响,且不会破坏微乳相的结构;分子荧光光谱表明镉离子对配体DNNSA有荧光猝灭作用。