铁炭微电解工艺处理采油废水的研究

随着采油废水产生量的逐渐增大以及排放标准的日益严格,寻找一种经济、高效的处理方法显得十分必要。采用铁炭微电解技术对冀东油田采油废水进行了处理。考察了铁屑粒径、pH值、Fe/C质量比和反应时间对COD去除率的影响并设计了正交实验,结果表明,影响微电解工艺的因素主次关系为:pH>Fe/C质量比>反应时间,在最佳条件pH=5,Fe/C质量比为7∶1,反应时间50 min下,原水COD由170 mg/L降至95.6 mg/L,去除率达43.85%,出水满足国家二级排放标准。     

k-C*模型的人工湿地模拟研究

采用自由表面流人工湿地,对广东省中山市某小区对应段的河涌进行生态修复改造。基于k-C*模型的计算结果表明,在对现有河涌的面积的利用下,TP和NH4+-N的去除效果受到限制。采用多因素正交实验对模型的计算结果进行实验验证和分析,研究了4种植物、4种基质,分别在2、4、6和8 d水力停留时间(HRT)下对TP和NH4+-N的去除效果,得到影响TP和NH4+-N去除效果的因素主次顺序分别为基质→植物→HRT和基质→HRT→植物;各因素的最佳水平条件分别为:风车草、颗粒活性炭、4 d(HRT)。在最佳水平条件下进行实验,结果表明,TP和NH4+-N的浓度均可达到出水排放标准浓度指标。k-C*模型的计算值总是比实验值偏高,但两者之间的误差在一个数量级范围内。     

生物膜填料塔净化模拟烟气和电厂烟气中SO2和NOx的对比实验

对生物膜填料塔对模拟烟气和电厂烟气的净化效果进行了实验研究。实验对比分析了在相同的实验条件下生物膜填料塔对不同烟气中SO2和NOx的净化效率。实验结果表明,在循环液温度在24～35℃、空床停留时间（EBRT）为60s、喷淋量为8～10L／h、脱硫塔的pH为0．8～1．5、脱氮塔的pH为7．5～8．0的条件下,生物膜填料塔对模拟烟气和电厂烟气中SO2的净化效率都很高,但模拟烟气条件下的总脱氮率的平均值为80％,而在电厂烟气条件下只有35％。经分析认为,脱氮率产生差异的主要原因是电厂烟气中杂质的影响,以及烟气中氧气含量的不同,同时因为生长条件不同从而驯化出的微生物群体组成也不同。     

对普光气田油菜的二氧化硫熏气实验

为探讨普光气田废气对周围农作物的影响和生物监测方法,选择气田周边油菜作为受试样本,对其进行二氧化硫现场熏气实验。结果表明,油菜在受到1.43 mg/m3浓度、3小时二氧化硫熏气后,植株耐受,不产生明显受害症状;叶片含硫量、MDA含量、可溶性蛋白含量等指标的测定结果与二氧化硫熏气浓度、熏气时间存在显著的相关关系。     

铬渣秸秆共热解产物铬稳定性研究

生物质铬渣共热解工艺是新型的铬渣处理工艺,该工艺能有效地将铬渣中的Cr(Ⅵ)还原为Cr(Ⅲ).而由于共热解产物总铬含量较高,因此考察了铬渣与秸秆共热解过程中铬稳定性.通过考察共热解产物成分及形态分析、pH影响实验、淋洗实验及长期稳定性实验,对共热解铬渣的铬环境安全性进行评估.结果表明:(1)共热解温度对铬渣形态有较大影响,可交换态及碳酸盐结合态铬含量随共热解温度升高而逐渐降低,800℃时候可交换态铬降至＜0.1％(质量分数,下同),碳酸盐结合态铬为1.2％;共热解后最稳定的残渣态铬含量随共热解温度升高而逐渐升高.(2)当pH＞7时,两种共热解产物总铬溶出量极低,基本都小于6mg/kg;当pH≤7时,总铬的溶出量显著增加,最高超过500 mg/kg.但由于解毒铬渣的酸中和能力极强,因此铬释放风险较低.(3)共热解产物的总铬累积溶出量极低,根据拟合结果计算出其100年填埋时间的总铬溶出量不超过1.3 mg/kg.长期稳定性实验表明,自然堆置过程中共热解产物的Cr(Ⅵ)含量逐渐降低.     

煤与瓦斯突出的物理模拟和数值模拟研究

利用自行设计的实验装置,通过现场采集具有突出倾向的煤样,分别向实验装置煤样中充入吸附能力较大的CO2和吸附能力较小的N2来模拟不同级别的煤与瓦斯突出现象,物理试验结果表明:瓦斯压力越大,突出强度越大;当瓦斯压力相近时,吸附和解吸能力大的瓦斯突出强度大。通过数值模拟对煤与瓦斯突出进行研究,数值模拟再现了煤矿开采过程中诱发的煤与瓦斯突出全过程,同时验证了煤与瓦斯突出是瓦斯压力、地应力及煤岩体的力学性质综合作用的结果,该验证对进一步深入理解认识煤与瓦斯突出的机理具有重要的理论和实践意义。     

TEOM法与实验室称重法监测大气中TSP的对比研究

用数理统计的方法计算出TEOM法与称重法监测结果的偏差,用F检验法检验TEOM法与称重法监测结果之间的致性,用r检测法检验TEOM法与称重法监测结果之间的相关性,用t检验法检验TEOM法与称重法监测结果之间的差异,通过对比研究,找出TEOM法与称重法之间的相互关系和规律。     

Experimental Study of the Criteria of Flow Laminarization in Two-Dimensional Dense Gas Plumes

Laminarization of flow in a two-dimensional dense gas plume was experimentally investigated in this study. The plume was created by releasing CO₂ through a ground-level line source into a simulated turbulent boundary layer over an aerodynamically rough surface in a meteorological wind tunnel. The bulk Richardson number (Ri_*), based on negative plume buoyancy, plume thickness, and friction velocity, was varied over a wide range so that the effects of stable stratification on plume laminarization could be observed. A variety of ambient wind speeds as well as three different sizes of roughness arrays were used so that possible effects of roughness Reynolds number (Re_*) on plume laminarization could also be identified. Both flow visualization methods and quantitative measurements of velocity and intermittency of turbulence were used to provide quantitative assessments of plume laminarization.Flow visualization provided an overall picture of how the plume was affected by the negative buoyancy. With increasing Ri_*, both the plume depth and the vertical mixing were significantly suppressed, while upstream propagation of the plume from the source was enhanced. The most important feature of the flow revealed by visualization was the laminarization of flow in the lower part of the plume, which appeared to be closely related to both Ri_* and Re_*.Measurements within the simulated dense gas plumes revealed the influence of the stable stratification on mean velocity and turbulence intensity profiles. Both the mean velocity and turbulence intensity were significantly reduced near the surface; and these reductions systematically depended on Ri_*. The roughness Reynolds number also had considerable influence on the mean flow and turbulence structure of the dense gas plumes.An intermittency analysis technique was developed and applied to the digitized instantaneous velocity signals. It not only confirmed the general flow picture within the dense plume indicated by the flow visualization, but also clearly demonstrated the changes of flow regime with variations in Ri_* and Re_*. Most importantly, based on this intermittency analysis, simple criteria for characterizing different flow regimes are formulated; these may be useful in predicting when plume laminarization might occur.     

精密度--偏性分析质控试验数据处理系统

结合环境监测实验实质量控制数据处理的实际要求,用计算机高级语言,设计开发成功了《精密度－偏性分析质控试验数据处理系统》,该系统具有数据输入,查询,修改,统计分析和打印报告等功能,在实际应用中,取得良好效果。     

冲击实验装置环境振动影响评价

本文计算和分析了冲击实验装置运行对环境造成的振动干扰，所用数据为实测分析参数，计算结果表明，冲击实验装置在运行期间对周围环境造成的振动影响是可接受的。