Influence of organic loading on an anaerobic sequencing biofilm batch reactor (ASBBR) as a function of cycle period and wastewater concentration

The effect of organic loading on the performance of a mechanically stirred anaerobic sequencing biofilm batch reactor (ASBBR) has been investigated, by varying influent concentration and cycle period. For microbial immobilization 1-cm polyurethane foam cubes were used. An agitation rate of 500 rpm and temperature of 30+/-2 degrees C were employed. Organic loading rates (OLR) of 1.5-6.0gCODl(-1)d(-1) were applied to the 6.3-l reactor treating 2.0 l synthetic wastewater in 8 and 12-h batches and at concentrations of 500-2000mgCODl(-1), making it possible to analyze the effect of these two operation variables for the same organic loading range. Microbial immobilization on inert support maintained approximately 60 gTVS in the reactor. Filtered sample organic COD removal efficiencies ranged from 73 to 88% for organic loading up to 5.4gCODl(-1)d(-1). For higher organic loading (influent concentration of 2000mgCODl(-1) and 8-h cycle) the system presented total volatile acids accumulation, which reduced organics removal efficiency down to 55%. In this way, ASBBR with immobilized biomass was shown to be efficient for organic removal at organic loading rates of up to 5.4gCODl(-1)d(-1) and to be more stable to organic loading variations for 12-h cycles. This reactor might be an alternative to intermittent systems as it possesses greater operational flexibility. It might also be an alternative to batch systems suspended with microorganisms since it eliminates both the uncertainties regarding granulation and the time necessary for biomass sedimentation, hence reducing the total cycle period.     

用烧结法从沸腾炉渣中提取铝和铁的研究

把沸腾炉渣和石灰及精煤混合制成小球,然后在大约1 000 ℃下烧结.取不同烧结时间的样品用硫酸浸取,得到含有铝离子和铁离子的溶液.试验表明,采用浓度为4 mol/l的硫酸,在80 ℃下浸取烧结球样品(50%沸腾炉渣∶40%精煤∶10%石灰)24 h,可以得到铝和铁的最大提取率,分别为86.50%和94.60%.滤渣可以作为固化材料用于高速公路的路基建设或水泥生产中的添加剂.     

化学事故救援方舱舱室环境安全性模拟研究

运用计算流体动力学(CFD)方法,对具有超压防护功能的某化学事故应急救援手术方舱室内气体污染物运动扩散的规律以及对人员安全的影响进行了数值模拟,其研究结果表明:当大气环境中氢氰酸(HCN)浓度为5mg/L时,前10s从常规进风口进入舱室的HCN在滤毒通风装置开启后,随气流运动逐渐向整个舱室扩散,经净化空气的混合稀释作用,绝大部分通过舱体缝隙排出舱室,30min内舱室HCN浓度的总量下降了95.1%,说明超压防护很好地保证了舱室环境的安全性。     

ESTIMATING THE SUSPENDED SEDIMENT LOAD IN RESERVOIRS1

ABSTRACT: The total suspended sediment loads of four north Mississippi reservoirs were determined from measurements of concentrations of suspended sediment in a vertical profile at several locations on each reservoir made during the year. These data were combined with the stage-height and known stage-volume relationships for each reservoir in a numerical integration to determine the total suspended sediment in the water body. Total suspended sediments were estimated using the product of the suspended sediment concentration in the surface water by the appropriate reservoir volume. The averaged ratios of the estimated to measured suspended sediment loads for each reservoir exceeded 0.90. Since the concentration of suspended sediments in surface waters of north Mississippi reservoirs has been shown as highly correlated with spectral reflectance, estimating the total suspended sediment of these reservoirs using remotely sensed spectral reflectance data is possible.     

皮革铬鞣废水回收利用中铬渣的铬量测定

本文研究了皮革铬鞣废水中铬的定性特征曲线。利用吸光度加合定律对大量实测数据进行统计处理。建立测定铬的实验室校准直线方程，相关系数γ＝０．９９６０．以此作为测定铬鞣废水及回收铬渣中铬量的实验室回归直线方程。并对本法的可靠性进行研究，结果令人满意。本法不仅大大简化了铬量测定的步骤．而且在提高分析效率的同时获得同等的检测结果。     

环境空气颗粒物来源解析受体采样频率优选方法初探

环境空气颗粒物来源解析受体样品化学组成的时空差异,除受采样点位分布制约外,主要还受采样时间的制约。如何选取时间段及采样周期显得尤为重要。通过青岛市空气自动监测系统近几年获取的颗粒物连续时均值数据,采用统计优化组合选择法,筛选出日均值、年均值的最佳采样时段,可供类似研究参考。     

大中型商场PM10、PM2.5污染水平与来源分析

利用便携式气溶胶监测仪,对平顶山市区的中原商场、商业大楼、食品城总店三家大型商场不同楼层空气PM10和PM2.5进行了现场测定。结果显示,平顶山市大中型商场可吸入颗粒物污染严重,PM10、PM2.5污染平均超标率分别为13.7%和48.0%;PM10、PM2.5的质量浓度在时间和空间分布上存在很大差异;PM10中PM2.5所占比例为83%。     

辽宁省典型城市道路尘PM2.5成分谱研究

为构建辽宁省典型城市道路尘源成分谱，分别采集了鞍山市和盘锦市道路尘样品，分析了其化学组分特征，用富集因子法和比值法分析了其主要来源，用分歧系数法分析了两个城市成分谱的相似度.结果表明：盘锦市和鞍山市道路尘PM_2.5中的化学组成以有机碳组分（OC）和地壳类元素（Al、Ca、Mg、Fe和K）为主.除Cu和V元素外，其余元素均表现为鞍山市的富集因子大于盘锦市.由比值法可得，盘锦市和鞍山市OC/EC分别为（13.20±6.26）和（3.94±0.63），均存在二次污染现象；NO₃^-/SO₄^2-的均值分别为（0.52±0.55）和（0.46±0.13），说明其道路尘PM_2.5受固定源影响更大.盘锦市与鞍山市道路尘成分谱分歧系数为0.354，说明两个源成分谱可能相似.     

A methodological framework for improving air quality monitoring network layout. Applications to environment management

This work aims to provide a methodology framework which allows to improve the performance and efficiency of an air quality monitoring network (AQMN). It requires to be constituted by a minimum and reliable number of measurement sites. Nevertheless, the AQMN efficiency should be assessed over time, as a consequence of the possible emergence of new emission sources of air pollutants, which could lead to variations on their spatial distribution within the target area. PM₁₀ particles data monitored by the Community of Madrid's (Spain) AQMN between 2008 and 2017 were used to develop a methodology to optimize the AQMN performance. The annual spatial distribution of average PM₁₀ levels over the studied period monitored by all current stations vs those more representative was provided by a geographic information system (GIS), and the percentage of similarity between both postulates was quantified using simple linear regression (> 95%). As one innovative tool of this study, the practical application of the proposed methodology was validated using PM₁₀ particles data measured by AQMN during 2007 and 2018, reaching a similitude degree higher than 95%. The influence of temporal variation on the proposed methodological framework was around 20%.The proposed methodology sets criteria for identifying non-redundant stations within AQMN, it is also able to appropriately assess the representativeness of fixed monitoring sites within an AQMN and it complements the guidelines set by European legislation on air pollutants monitoring at fixed stations, which could help to tackle efforts to improve the air quality management.     

天津市夏季PM10浓度及组成元素垂直分布特征

通过天津市气象局大气边界层观测站高255 m的气象铁塔,获得了10m、40m、120m和220 m 4个高度共80个PM10样品,分析了PM10的日均质量浓度及其元素的垂直分布特征.结果表明,4个高度处PM10质量浓度时序变化基本一致;PM10质量浓度及其组成元素总量随高度增加递减;10 m、40m和120m3个高度处的PM10质量浓度时间序列分布的相关性较好,组分分歧系数较小,而220 m处的PM10质量浓度时间序列分布与其他3个高度处的相关性较差,组分分歧系数较大.样品中元素质量浓度由高到低依次是Si、Al、Ca、Fe、Na、Mg、K、Zn、Ti、Cu、Mn、Pb、Cr、Ni、Co、V、As、Cd和Hg.其中,Si、Al、Na、K质量分数随高度变化不大;Ca、Fe、Mg质量分数随高度增加递减明显;Zn、Cu、Mn、Pb、Cr在10m、40m和120 m3个高度处质量分数接近,而在220m处明显降低;Ti元素在4个高度处的质量浓度接近,质量分数总体上随高度增加递增;Ni、Co、V、As、Cd、Hg质量分数随高度的变化不同,其中与燃煤有密切关系的Hg在120 m处质量分数明显高于其他高度处,而在220m处最低.Al、Fe、Na、K等元素相对富集因子小于或接近1,其质量浓度与PM10质量浓度时序分布的相关性较好,其中Al、Na相关系数随高度增加显著递减;Zn,Cu、Pb、Cr、As、Ni的相对富集因子显著大于1,其质量浓度与PM10质量浓度时序分布的相关性较差,相关系数随高度增加变化不大.