高浓度氨氮废水的短程硝化研究

采用普通好氧活性污泥驯化培养启动亚硝化反应器，探索了在实验室条件下，亚硝化反应的最适宜条件。结果表明．在温度（T）为35℃，pH值为7．5左右，初始污泥浓度0．7g／L时，控制较高的初始进水氨氨浓度和较低的DO浓度，有利于亚硝化反应的启动：驯化后，反应器内氨氮处理效果良好，即使进水氨氮浓度高达2400mg／L时，氨氮去除率也能达到95％以上;在实验中，亚硝化的最适宜条件为，温度：29～35℃．pH值：7．0～8．0。同时．实验结果表明，在一定范围内，溶解氧浓度越高，亚硝化反应速率越快：C／N比过高会严重抑制亚硝化反应。     

谷氨酸生产废水的治理工程实例

本文对谷氨酸生产废水和味精生产废水的性质作了简要介绍，针对该类废水提出了蒸发浓缩＋接触氧化为核心的治理工艺。结果表明，经该处理工艺，废水中的COD、BOD5、NH3-N等指标均能够达到《味精工业污染物排放标准》（GB19431—2004）中的标准要求。工艺流程简便可行，效果明显。在实际中有较大应用前景，具有显著的环境和经济效益。本文重点介绍了工程的实际运行情况和运行成本，并进行了简要分析。     

假单胞菌XD-1(Pseuomonas XD-1)的产表面活性剂性能研究

从含油废水中分离到1株表面活性剂产生菌,经鉴定为假单胞菌(Pseuomonassp.),命名为XD 1.对假单胞菌XD 1的产表面活性剂性能进行研究,实验结果表明,在正交优化的培养基中发酵培养时,菌XD 1可将培养液的表面张力从70 0mN·m-1降至30 2mN·m-1,其产表面活性剂方式为生长相关型;经提取分析,菌XD 1所产表面活性剂为脂肽类和糖脂类物质的混合物,脂肽类物质为主要成分;菌XD 1所产表面活性剂的CMC值为50mg·L-1,在pH=6 0时表面活性剂表现出最佳活性;菌XD 1所产表面活性剂主要积累在胞内特定的细胞器中,并在细胞壁上产生一层粘附的表面活性剂膜,膜厚140nm,在生长过程中,菌体会将细胞器和细胞壁上的表面活性剂释放到胞外.将培养72h的菌体浸入双蒸水中,6h后菌体能把积累在细胞器和细胞壁上的表面活性剂释放到水体中.     

秸秆焚烧对玉溪市大气PM10的影响解析研究

以水溶性钾为示踪元素,解析秋收季节秸秆焚烧对玉溪市大气PM10的贡献.结果表明,2001年秋收季节(10月)水溶性钾浓度(7.68μg/m3)比夏季水溶性钾浓度(2.38μg/m3)高3.2倍,与7月至12月份PM10浓度变化呈显著相关,相关系数为0.810.很显然,秋收季节秸秆焚烧对玉溪市大气PM10有负面影响.     

Molecular cytogenetic analysis of term placentae suspected of mosaicism using fluorescence in situ hybridization

In first-trimester chorionic villus sampling (CVS) for prenatal diagnosis, abnormal chromosomal findings, such as mosaicism, trisomies, or suspect abnormal karyotypes, are found more frequently than at amniocentesis. The fact that these chromosomal abnormalities do not always reflect the fetal karyotype but may be restricted to the placenta is a major problem in diagnosis and counselling. In this paper we present the results of fluorescence in situ hybridization (FISH) studies on interphase nuclei of three term placentae investigated because of false-positive findings at first-trimester CVS. The chorionic villi of the first case showed a mosaic chromosome pattern involving a trisomy 10 cell line and a normal cell line, those of the second case a total trisomy 8 cell line, while in the third case a complete monosomy X was found. Follow-up amniocentesis in each of these three cases revealed a normal karyotype. By using FISH, we were able to confirm the presence of the aberrant cell lines, which were all confined to one part of the placenta. FISH on interphase nuclei allows the investigation of large numbers of cells for the existence of numerical chromosome aberrations in a quick and reliable way.     

Particle emissions of a railway line determined by detailed single particle analysis

The goal of this study was to identify and quantify particles emitted from railway traffic. For that purpose PM10 samples were collected near a busy railway line using a wind direction and speed controlled sampling equipment consisting of five devices. Measurements taken perpendicular to the railway lines at 10, 36 and 120 m distance enable an identification and separation of particles caused by the railway traffic from background particles. Morphology and chemistry of more than 11,000 particles were analysed by computer controlled scanning electron microscopy (CCSEM). Based on chemical composition five particle classes are defined and assigned to their sources. The mass of the individual particles is determined by multiplying their volumes, calculated based on their morphology with a density assigned specifically to each particle class. The density of the particle classes is derived from their chemical composition. To estimate the PM10 contributions of the railway lines, the mass of PM10 at 120 m (background, not influenced by the railway lines) is subtracted from the mass of PM10 at 10 m. The emissions of the railway lines are dominated by ‘iron’ particles, which contribute 2.9 μg m⁻³ or 67% to the railway related PM10. In addition, ‘aluminium’ and ‘calcium’ particles contribute also to the railway related PM10 (1.0 μg m⁻³ or 23% for the ‘aluminium’ and 0.4 μg m⁻³ or 10% for the ‘calcium’ particles). These particles are assigned to abrasion of the gravel bed and re-suspension of mineral dust.Long-term gravimetric results of the contribution of iron to the mass of railway related PM10 from a study performed earlier at the same site are in good agreement with the data presented in this study.     

采用泥回流处理彩色显像管含氟废水

本文通过中和、混凝沉降法除氟过程,研究了彩色显像管工业废水除氟的适宜工艺条件。现场试验表明:应用泥回流处理技术,采用高效絮凝剂处理含氟废水,排放废水氟含量可稳定在4-6mg/L之间,低于排放标准（10mg/L）,同时废水处理的成本大大降低。     

氧化-混凝法处理碱性高砷废水的实验研究

对碱性高砷废水的处理进行了研究 ,针对常规混凝法除砷的缺点提出了氧化 混凝工艺。结果表明 ,用氧化 混凝工艺除砷效果显著 ,废水经处理后砷含量低于 0 5mg/L ,符合国家排放标准。氧化 混凝除砷的最佳工艺条件为 :pH值为 6— 7,H2 O2 用量为 2 5 % ,氧化时间为 10min ,Fe2 (SO4) 3 用量为 2 5g/L ,PAM用量为 11 2 5mg/L。     

城市生活污水厌氧生物处理发展现状

回顾了国内外污水厌氧生物处理工艺的发展情况,着重分析了中国城市污水的特点以及厌氧生物处理工艺在城市生活污水处理中的应用情况。     

PM10冲击采样器切割头设计参数对切割粒径的影响

本文从颗粒在气流中的受力情况分析入手 ,得到冲击采样器中喷嘴喷出后颗粒的运动轨迹方程以及运动轨迹与采样器切割头设计参数的关系式。分析了PM10空气采样器的切割原理 ,并利用数值计算研究颗粒在不同的流量、喷嘴尺寸及喷嘴与冲击板的距离下的运动轨迹 ,从而得到切割头设计参数对切割粒径的影响