废铜催化剂的综合利用

研究了以湿法回收利用废铜催化剂中的铜、锌制取氧化亚铜和氧化锌的原理以及最佳工艺条件。该工艺可同槽进行浸取、蒸氨、还原、中和水解等操作,生产成本低,产品质量好,工艺过程中无三废排放,具有很好的综合效益。     

DS-Ⅰ催化剂脱硫脱氮技术的实验研究

以纯ＳＯ２及燃煤电厂烟气作实验气,利用积分法固定床ＣＦＢ方式进行了ＤＳ－Ⅰ型催化剂与活性炭催化性能的对比试验,对不同还进行了不同烟气温度、ＳＯ２浓度、湿度、烟气流速等工艺参数对ＤＳ-Ⅰ型催化剂催化性能的影响试验。对不同催化剂进行优化组合,可在除尘器后直接脱硫、脱氮,其脱硫率达８６％、脱氮率达６８％。催化剂经再生,可反复使用。     

低SO_2氧化率脱硝催化剂的开发

介绍了SCR脱硝催化剂中V2O5对SO2的氧化及SO2氧化对脱硝催化剂及其下游设备的危害,分析了脱硝催化剂中V2O5对SO2氧化的原理和影响因素,探讨了低SO2氧化率脱硝催化剂开发方面的研究成果。     

全白土催化剂生产废水的处理

用4种无机絮凝剂和3种有机絮凝剂进行了脱除全白土催化剂生产废水（简称废水）中固体悬浮物（SS）的实验研究。实验结果表明：在废水pH6．8条件下,无机絮凝剂和有机絮凝剂脱除废水中SS的效果均较差,用无机絮凝剂时的SS去除率低于26％,用有机絮凝剂时的SS去除率低于18％;废水pH对SS去除率的影响较大,当调节废水pH为8．0时,无机絮凝剂中硫酸铝脱除废水中的SS效果最好,在硫酸铝加入量为0．02mg／L、沉降时间为2h的最佳操作条件下,SS的去除率可达93％。     

Effect of barium sulfate modification on the SO2 tolerance of V2O5 /TiO2 catalyst for NH3-SCR reaction

Sulfur poisoning of V_2O_5/BaSO_4–TiO_2(VBT),V_2O_5/WO_3–TiO_2(VWT) and V_2O_5/BaSO_4–WO_3–TiO_2(VBWT) catalysts was performed in wet air at 350℃ for 3 hr,and activities for the selective catalytic reduction of NO_x with NH_3 were evaluated for 200–500℃.The VBT catalyst showed higher NO_x conversions after sulfur poisoning than the other two catalysts.The introduction of barium sulfate contributed to strong acid sites for the as-received catalyst,and eliminated the redox cycle of active vanadium oxide to some extent,which resulted in a certain loss of activity.Readily decomposable sulfate species formed on VBT-S instead of inactive sulfates on VWT-S.These decomposable sulfates increased the number of strong acid sites significantly.Some sulfate species escaped during catalyst preparation and barium sulfate was reproduced during sulfur poisoning,which protects vanadia from sulfur oxide attachment to a great extent.Consequently,the VBT catalyst exhibited the best resistance to sulfur poisoning.     

SO2和H2O对Mn-Ce/TiO2催化剂低温SCR活性的影响

采用溶胶凝胶法制备Mn-Ce/TiO_2低温SCR催化剂并考察其活性,研究了SO_2和H_2O对Mn-Ce/TiO_2低温脱硝催化剂的影响,并运用XRD、BET、SEM和FT-IR对中毒前后的催化剂进行表征。结果表明,催化剂在无SO_2和H_2O条件下具有良好的脱硝性能,在140℃时NO_x去除率达到84%。但若向模拟烟气中加入SO_2和H_2O,则随其体积分数增大对催化剂活性产生明显抑制作用。当H_2O的体积分数为5%、SO_2为700×10-6时,反应4 h后,NO_x去除率降为53%。H_2O对催化剂的抑制作用随H_2O的除去而消除,H_2O主要通过与NO_x的竞争吸附来抑制催化剂的活性。低浓度的SO_2对催化剂活性影响较小,SO_2体积分数为100×10~(-6)时,稳定后NO_x去除率仍能维持在80%以上,但较高体积分数的SO_2引起的催化剂失活不可自行恢复。SO_2毒化作用主要是引起了硫酸铵盐覆盖催化剂的表面活性位,以及造成活性组分MnO_x的晶化,并破坏了MnO_x与TiO_2间的强相互作用。H_2O和SO_2共同存在时,H_2O可以弱化SO_2对催化剂的毒化作用,主要因为H_2O与SO_2的竞争吸附作用而使SO_2对催化剂活性的影响减弱。     

催化分解臭氧的方法及催化剂性能概述

臭氧作为一种有毒物质广泛存在于人们生活环境中,当其浓度超过0.06mg/m^3时,对人体就有害了。因此对臭氧的分解十分必要。本文介绍了多种分解臭氧的方法,并着重介绍 催化分解法。对各种氧分解催化剂的组成、制备方法及活性作一综述。     

好氧触媒在造纸法再造烟叶污水处理中的应用分析

本文围绕好氧触媒在造纸法再造烟叶污水处理中的应用展开分析。如对好氧触媒在再造烟叶污水处理中的应用必要性及好氧触媒作用原理予以介绍,并对好氧触媒在造纸法再造烟叶污水处理中应用展开试验。     

石油化工催化剂生产过程中的职业病防治及应急处理

石化企业使用了大量的催化剂,催化剂开发、生产过程复杂,有许多原料和生产工艺,存在许多潜在的安全隐患和职业病危害因素。为预防催化剂生产过程中的事故,通过分析催化剂生产过程中的职业病危害分析,提出了相应的职业病防范及应急处置措施,加强催化剂生产过程中的职业病防治和应急处置能力,创造良好的经济、生态和社会效益,有效防止催化剂生产过程中发生安全事故和职业病。     

Platinum (IV) recovery from chloride solution by functionalized acrylic copolymers

Two acrylic adsorbents with different morphological structures and bearing amidoethylenamine and thiol groups were obtained and used for platinum sorption from chloride solution by the batch method. Physico-chemical parameters that influence adsorption such as initial Pt(IV) concentration, stirring time, pH, and adsorbent amount were investigated. The thermodynamic parameters of Pt(IV) sorption on the synthesized adsorbent were also evaluated based on Langmuir and Freundlich isotherms. Thermodynamic parameters estimated from Langmuir constants indicated that the adsorption is spontaneous, exothermic and there is a disordered state at the molecular level. The models used to analyze the sorption rate led to the conclusion that the most important step in the sorption of Pt(IV) could be both particle diffusion and chemical reaction of [PtCl₆]⁻ with amine functional groups. Thus, both the ion exchange and complex formation mechanisms can occur via nitrogen atoms in the recovery of Pt(IV) on the studied adsorbent.