面向2035的节能与新能源汽车全生命周期碳排放预测评价

发展节能与新能源汽车是降低交通运输行业碳排放的重要技术路径.为量化预测节能与新能源汽车的全生命周期碳排放,利用全生命周期评价方法,以汽车相关技术路线和政策为参考,选取燃油经济性、整车轻量化水平、电力结构碳排放因子和氢能碳排放因子为关键参数,构建传统燃油汽车(ICEV)、轻度混合动力汽车(MHEV)、重度混合动力汽车(HEV)、纯电动汽车(BEV)和燃料电池汽车(FCV)的数据清单并对其全生命周期碳排放进行量化预测评价,对电力结构碳排放因子和不同制氢方式碳排放因子进行了敏感性分析和讨论.结果发现,2022年ICEV、 MHEV、 HEV、 BEV和FCV的全生命周期碳排放量(以CO₂-eq计)分别为208.0、 195.5、 150.0、 113.5和205.0 g·km^-1.到2035年,BEV和FCV相比于ICEV具有较为显著的减碳效益,分别降低69.1%和49.3%.电力结构的碳排放因子对BEV的全生命周期碳排放的影响最显著.关于燃料电池汽车的不同制氢方式,短期应以工业副产氢提纯为主供应FCV氢能需求,长期以可再生能源电解水制氢和化石能源...     

全程自养颗粒污泥快速启动及混合营养型脱氮性能分析

在连续流条件下,基于颗粒污泥全程自养脱氮（CANON）工艺的快速启动和混合营养条件下高效脱氮,是CANON工程应用的重要环节.本研究在气提内循环反应器（AIR）中,以老化的CANON颗粒污泥经机械破碎至0.3 mm作为种泥,实现混合营养型单级颗粒污泥同步脱氮除碳.启动26 d,通过控制DO,系统出现稳定的部分硝化,再缩短HRT提升氨氮负荷至5.65 kg ·（m³ ·d）^-1,促进颗粒化和厌氧氨氧化;第68 d,总氮去除率达到58%之后,进水加入有机物,C/N从0提升到0.25和0.5,促进AOB、AMX和异养微生物的协同,氨氮去除率达95%,总氮去除率达85%,COD去除率达80%左右.COD浓度增加,能较好地抑制Nitrospira菌属等NOB的活性,q（NH₄⁺-N）和q（TN）稳定在0.4 g ·（g ·h）^-1和0.34 g ·（g ·h）^-1,q（NO₃^--N）约为0.02 g ·（g ·h）^-1.采用MiSeq高通量测序对微生物多样性分析,表明有机物对污泥中Nitrosomomas和Candidutus_Kuenenia丰度未产生显著影响,增加了Candidutus_Brocadia菌属以及具有反硝化功能Denitratisoma等菌属的丰度.这对于快速启动连续流CANON颗粒污泥工艺处理低C/N比废水提供思路.     

温度对自养型同步脱氮工艺处理猪场废水厌氧消化液性能及微生物群落的影响

通过运行4个不同温度条件下(30、25、20和15℃)的自养型同步脱氮反应器,研究了不同温度下自养型同步脱氮工艺处理猪场废水厌氧消化液的性能差异及其微生物机制.结果表明,30℃条件下反应器脱氮性能最佳.当温度由30℃降为25℃时,反应器总氮去除率从73%降低到66%,总氮去除速率从2. 29 kg·(m~3·d)~(-1)降低到1. 72 kg·(m~3·d)~(-1),污泥的形态和粒径变化不明显(SMD由80. 85μm降为79. 95μm).当温度低于20℃时,总氮去除率降低到42%,总氮去除速率降低到1. 18 kg·(m~3·d)~(-1),同时发现污泥出现解体现象,粒径减小(SMD为63. 21μm).而当温度为15℃时,总氮去除率降低至37%,总氮去除速率低至1. 00 kg·(m~3·d)~(-1),反应器运行困难.微生物群落结构分析表明,温度对厌氧氨氧化细菌的影响明显大于氨氧化细菌,因此低温条件下反应器脱氮性能下降的主要原因是厌氧氨氧化细菌对温度更敏感.     

中国不同城市群的经济社会与环境可持续发展协调度分析

采用定量为主和定量定性相结合的分析方法,研究了中国不同城市群的经济社会与环境协调度。通过分析发现：第一,中国城市经济社会环境整体协调度不高,绝大部分属于轻度失调类,经济发展是其主要影响因素;第二,协调度呈现出由东部沿海城市向内陆城市递减的梯度变化,而社会与经济的滞后性影响力却呈现出东高西低的现象;第三,协调度呈现＂三高两低＂的城市集聚格局,其中3个协调度高值城市集聚群分别位于珠三角、长三角、环渤海地区;2个协调度低值城市集聚群位于内陆中部地区。     

降尘对棉花叶片解剖结构的影响

根据模拟降尘的盆栽试验,通过显微技术,研究了受自然降尘影响和未受影响的棉花（Gossypium hirsutumL.）叶片解剖结构的特点。结果表明：受降尘影响的棉花叶片栅栏组织排列不规则,部分栅栏组织细胞收缩、变短,甚至弯曲。栅栏组织细胞之间空隙增大,海绵组织细胞中内含物减少;但在出现伤害症状的叶片中,维管束仍保持原状。用石英砂替代降尘处理的和未受降尘影响的棉花叶片的组织结构保持正常。     

Effects of salinity on soil bacterial and archaeal community in estuarine wetlands and its implications for carbon sequestration: verification in the Yellow River Delta

Soils from two typical tidal salt marshes with varied salinity in the Yellow River Delta wetland were analysed to determine possible effects of salinity on soil carbon sequestration through changes in soil microbiology. The mean soil respiration (SR) of the salt water–fresh water mixing zone (MZ) was 2.89 times higher than that of the coastal zone (CZ) (4.73 and 1.63?μmol?m^?2?s^?1, respectively, p?Pseudomonas sp. and Limnobacter sp. that might have led to its higher dehydrogenase activity and respiratory rates. Additionally, the CZ possessed more Halobacteria and Thaumarchaeota with the ability to fix CO₂ than the MZ. Significantly lower soil salinity in MZ (4.25?g?kg^?1) was suitable for β-Proteobacteria, but detrimental for Halobacteria compared with CZ (7.09?g?kg^?1, p?相似文献   

Influence of pore structure on biologically activated carbon performance and biofilm microbial characteristics

• Pore structure affects biologically activated carbon performance. • Pore structure determines organic matter (OM) removal mechanism. • Microbial community structure is related to pore structure and OM removal. Optimizing the characteristics of granular activated carbon (GAC) can improve the performance of biologically activated carbon (BAC) filters, and iodine value has always been the principal index for GAC selection. However, in this study, among three types of GAC treating the same humic acid-contaminated water, one had an iodine value 35% lower than the other two, but the dissolved organic carbon removal efficiency of its BAC was less than 5% away from the others. Iodine value was found to influence the removal of different organic fractions instead of the total removal efficiency. Based on the removal and biological characteristics, two possible mechanisms of organic matter removal during steady-state were suggested. For GAC with poor micropore volume and iodine value, high molecular weight substances (3500–9000 Da) were removed mainly through degradation by microorganisms, and the biodegraded organics (soluble microbial by-products,<3500 Da) were released because of the low adsorption capacity of activated carbon. For GAC with higher micropore volume and iodine value, organics with low molecular weight (<3500 Da) were more easily removed, first being adsorbed by micropores and then biodegraded by the biofilm. The biomass was determined by the pore volume with pore diameters greater than 100 μm, but did not correspond to the removal efficiency. Nevertheless, the microbial community structure was coordinate with both the pore structure and the organic removal characteristics. The findings provide a theoretical basis for selecting GAC for the BAC process based on its pore structure.     

Property-performance relationship of core-shell structured black TiO2 photocatalyst for environmental remediation

● Properties and performance relationship of CSBT photocatalyst were investigated. ● Properties of CSBT were controlled by simply manipulating glycerol content. ● Performance was linked to semiconducting and physicochemical properties. ● CSBT (W:G ratio 9:1) had better performance with lower energy consumption. ● Phenols were reduced by 48.30% at a cost of $2.4127 per unit volume of effluent. Understanding the relationship between the properties and performance of black titanium dioxide with core-shell structure (CSBT) for environmental remediation is crucial for improving its prospects in practical applications. In this study, CSBT was synthesized using a glycerol-assisted sol-gel approach. The effect of different water-to-glycerol ratios (W:G = 1:0, 9:1, 2:1, and 1:1) on the semiconducting and physicochemical properties of CSBT was investigated. The effectiveness of CSBT in removing phenolic compounds (PHCs) from real agro-industrial wastewater was studied. The CSBT synthesized with a W:G ratio of 9:1 has optimized properties for enhanced removal of PHCs. It has a distinct core-shell structure and an appropriate amount of Ti³⁺ cations (11.18%), which play a crucial role in enhancing the performance of CSBT. When exposed to visible light, the CSBT performed better: 48.30% of PHCs were removed after 180 min, compared to only 21.95% for TiO₂ without core-shell structure. The CSBT consumed only 45.5235 kWh/m³ of electrical energy per order of magnitude and cost $2.4127 per unit volume of treated agro-industrial wastewater. Under the conditions tested, the CSBT demonstrated exceptional stability and reusability. The CSBT showed promising results in the treatment of phenols-containing agro-industrial wastewater.     

环境模型参数识别与不确定性分析

在对水文模型实例的参数不确定性分析基础上,分别采用传统灵敏度分析方法、HSY算法、线性回归等方法对模型参数特性进行了识别与比较研究.结果表明参数优化算法与传统灵敏度分析方法不能解释模型结构复杂性特征,采用不确定性分析方法对环境模型参数进行识别提供了深入分析与理解模型系统的有效途径.     

循环水养殖系统（RAS）生物载体上微生物群落结构变化分析

为研究循环水养殖系统(recirculating aquaculture systems,RAS)生物滤池挂膜及运行过程中生物载体上微生物群落结构的变化及其脱氮机制,采用传统微生物培养方法,对不同时期生物载体上的异养细菌、氨氧化细菌及硝化菌进行堵养计数.并通过变性梯度凝胶电泳技术,对细菌的16S rDNA V3可变区的...