Research on different venting performance between flat and curved bursting panels

There is a noticeable discrepancy in the ability to control reduced explosion overpressure between flat bursting panels and curved bursting panels with the same static activation overpressure. Flat bursting plates were observed to leak at approximately 80% of the static activation overpressure lower than curved bursting plates. A new experimental technique is proposed in our paper. Three different vent areas of flat and curved bursting panels were tested, there was significant difference in structural stiffness between flat bursting panels and curved bursting panels, which is the reason the discrepancy in the ability to control reduced explosion overpressure. The structural stiffness of the flat bursting panels is poorer than that of the other, and a greater deformation of the flat bursting panels occurs under the same load. The membrane stress caused by the explosion overpressure therefore produces a larger value in the flat bursting panels which causes it to open prematurely. Moreover, the smaller the vent area that is, the more significant discrepancy in controlling the reduced explosion overpressure between both bursting panels is. This experimental and theoretical result in our paper provides some useful experience for the method of explosion venting.     

活化后钾改性正硅酸锂吸附CO2的性能评价及动力学研究

制备了钾改性正硅酸锂(K-Li4SiO4),并对其进行了自活化,考察了活化后K-Li4SiO4吸附剂在不同温度和CO2浓度气氛中吸附CO2的性能及动力学行为。总体而言,吸附剂的CO2吸附能力随着温度的升高、CO2浓度的增加而提升。在700℃、100%体积分数CO2气氛中吸附剂的吸附量最大,可达7.9 mmol/g,吸附剂的利用率为95.2%。利用双指数模型能够很好地描述吸附剂在各个温度以及各个CO2浓度气氛下的CO2吸附过程。吸附活化能随着CO2气氛浓度的升高而降低,CO2体积分数为20%,50%,100%时的吸附活化能分别为26448,14035,6178 J/mol。     

废水中2,6-二硝基酚厌氧毒性和降解动力学研究

在中温(35℃±1℃)厌氧条件下,以葡萄糖为共基质,采用间歇实验方法,研究了2,6-二硝基酚(2,6-DNP)的厌氧产甲烷毒性和厌氧降解动力学.厌氧毒性试验(ATA)以累计产甲烷量和相对活性(RA)为指标,评价了不同浓度2,6-DNP对产甲烷菌的抑制程度;结果表明,2,6-DNP浓度＜20 mg/L时,对产甲烷菌没有抑制作用,浓度为40 mg/L时产生轻度抑制,浓度为80～120 mg/L时产生重度抑制;24 h 2,6-DNP的75%、50%、25%相对抑制浓度分别为30、70和＞120 mg/L.2,6-DNP降解动力学可用Haldane方程来描述,利用非线性拟合求得动力学参数Ks、Rm、Ki分别为179.7 mg/L、4.84 mg/g VSS·h、206.5 mg/L,方差R2=0.94,拟合效果很好.     

Growth factors, kinetics and biodegradation mechanism associated with Pseudomonas nitroreducens TX1 grown on octylphenol polyethoxylates

The growth properties and biodegradation mechanism of a Gram-negative bacterium, Pseudomonas nitroreducens TX1 that was able to grow on branched octylphenol polyethoxylates (OPEO(n), average n=9.5) as the sole carbon source over a wide concentration range (1-100,000 mgl(-1)) were studied. Analysis of growth factors indicated the highest specific growth rate (micro) of 0.53 h(-1) was obtained at an initial concentration of 5,000 mgl(-1) OPEO(n). An optimal C/N ratio of 12 was obtained for (NH(4))(2)SO(4) as the nitrogen source in a cultivated medium at pH 7. The kinetic analysis demonstrated that bacterial growth and OPEO(n) degradation followed the Monod equation and were based on a substrate concentration inhibition model and pseudo-first-order reaction, respectively. The substrate inhibition coefficient was over 18,000 mgl(-1) and this indicates that the strain has an ability to sustain growth at high concentrations of OPEO(n) and use it as the sole carbon source under such a stress condition. Furthermore, LC-MS analysis showed that the biodegradation mechanism of dodecyl octaethoxylate (AEO8) by P. nitroreducens TX1 was the sequential cleavage of the ethoxylate chain.     

电增强活性炭纤维吸附有机污染物的动力学研究

研究了在电极化条件下,几种具有代表性污染物质在活性炭纤维上的电吸附动力学特性.结果表明,各种污染物的电吸附动力学比较好地符合Lagergren一级吸附动力学,其平衡吸附量在电极化下的增加量各不相同.在400mV的极化电位下,苯酚钠的吸附量从开路时的0.008 3mmol·g^-1增加到0.18 mmol·g^-1,增加了17倍;而对硝基苯酚的吸附量从开路时的2.93mmol·g^-1降到2.65 mmol·g^-1.在-400mV的极化电位下,苯胺的吸附量从开路时的3.60 mmol·g^-1增加到3.88 mmol·g^-1;而十二烷基苯磺酸钠的吸附量从开路时的2.20 mmol·g^-1降到1.59 mmol·g^-1.说明不同取代基的苯衍生物,电吸附改变量不相同,供电子基团的单取代苯,正极化都能明显增强其吸附量;但是吸电子基团的单取代,正负极化对吸附量的影响都很小;供体-共轭桥键-受体型结构的苯衍生物,正负极化都使其吸附减弱但吸附速率加快.静电作用在离子型污染物的电吸附中表现明显.     

氯化消毒过程对抗生素的降解行为及其毒性效应的影响研究进展

抗生素的大量使用导致其通过各种途径进入到污水处理厂、地表水甚至饮用水源水中.在污水处理厂二级出水排放之前以及自来水的生产和供应过程中,都必须进行氯化消毒处理以杀灭病原微生物.在此过程中,抗生素一方面可能被氯化降解,另一方面也可能转化成毒性更高的降解产物.因此,了解抗生素在氯化消毒过程中的降解行为对于明确其生态和健康风险...     

化工园区生化出水氯代烃污染物的臭氧氧化降解

以化工园区污水处理厂生化出水为背景水样,考察了臭氧氧化对2,4,6-三氯酚、氯苯、1,2-二氯苯、对硝基氯苯、四氯酞酸5种特征氯代烃污染物的降解效果,并对其降解动力学进行了分析。实验结果表明:臭氧对2,4,6-三氯酚和氯苯的降解效果最好,反应30 min时的去除率均接近100%,其次为1,2-二氯苯和对硝基氯苯,反应30 min时的去除率分别为95.7%和36.0%,最差为四氯酞酸,反应30 min时的去除率仅为8.9%;臭氧对2,4,6-三氯酚和对硝基氯苯的降解符合零级动力学方程,对氯苯和1,2-二氯苯的降解符合一级动力学方程,对四氯酞酸的降解符合二级动力学方程。     

锐钛矿-金红石混合晶型TiO2降解气相苯

用溶胶-凝胶法并通过控制煅烧温度合成不同晶相比的混合晶型纳米TiO_2,在紫外光光照下降解气相苯。考察了苯初始质量浓度、紫外灯光照强度和催化剂加入量对苯去除率的影响;探究了光催化降解气相苯的动力学特征。结果表明:450℃煅烧制备的催化剂降解苯效率最高,此催化剂金红石相质量分数为6.30%;在苯初始质量浓度为74.39 mg/m~3、催化剂加入量为7 g、光照强度为2.18 klux的最佳条件下反应84 min,苯去除率达99.73%;光催化降解率与光照强度之间符合0.5级动力学特征;当催化剂加入量为3 g时,单位时间单位质量催化剂降解苯的质量最多;苯的光催化降解反应均符合一级动力学方程。     

钢渣吸附Pb2+的动力学研究

采用批式振荡吸附法研究了钢渣吸附Pb^2＋的动力学。研究结果表明,钢渣吸附Pb^2＋的动力学控制步骤（简称动力学控制步骤）随实验条件的变化而变化：钢渣粒径大于120μm、振荡器转速小于150r/min或Pb^2＋初始质量浓度小于150mg/L时,孔扩散是动力学控制步骤;钢渣粒径小于120μm、振荡器转速大于150r/min或Pb^2＋初始质量浓度大于150mg/L时,表面扩散是动力学控制步骤;钢渣对Pb^2＋的吸附反应是二级反应,其吸附速率为13.26g/（mg.min）。     

有机改性粘土对赤潮藻絮凝沉降的动力学研究

采用分光光度计法和活体荧光计法,研究了吉米奇类表面活性剂双烷基聚氧乙烯基三季铵盐（DPQAC）改性粘土对2种赤潮生物赤潮异弯藻和锥状斯氏藻的絮凝沉降动力学,比较了2种实验方法的不同,并对几种影响絮凝沉降的因素进行了研究.结果表明,传统的分光光度计法进行动力学研究时,有机粘土对赤潮藻的絮凝沉降较好地符合双分子反应动力学模型,而采用活体荧光计法进行实验时,有机粘土对赤潮藻的絮凝沉降很好地符合双曲线动力学模型,利用活体荧光计法进行实验时避免了前者由于粘土沉降导致的体系透光率的快速变化,更好地反映了赤潮藻细胞絮凝沉降实质.2种动力学实验方法都表明,高岭土体系的沉降速率要略高于膨润土体系,提高粘土、改性剂的用量以及体系的pH值都能加快沉降速率,其中提高改性剂的用量是增加去除率和加快沉降速率的最有效方法.