Carbonization of johkasou sludge using batch-type equipment

The carbonization of dehydrated johkasou sludge was examined using batch-type equipment. Based on the temperature changes in the carbonization room and the gas combustion room, the carbonization process was divided into three phases: phase I, drying the sludge; phase II, thermal decomposition of the dried sludge; phase III, after phase II. The times required for phases I and II were strongly correlated with the amounts of water and solid matter, respectively, in dehydrated sludge. The reduction rate of the sludge on completion of phase I was about 90% on average, and the decomposition rate of solid matter increased with time during phase II or phase II plus phase III until it reached about 50%. TOC concentration of the eluate from the carbonized sludge was used as an index to evaluate the progress of the carbonization process, and the highest temperature in the carbonization room was recognized as an important operational factor. The specific surface area and pore volume of carbonized sludge were smaller than those of charcoals and activated carbons by 1–3 orders of magnitude and 1–2 orders of magnitude, respectively. No elution of heavy metals was observed from any of the carbonized sludges examined. The reduced amount of carbon in dehydrated johkasou sludge was estimated to be about 25% of the decomposed organic matter.     

Evaluation of a conceptual model for the subsurface transport of plutonium involving surface mediated reduction of PuV to PuIV

A conceptual model is proposed to explain the transport behavior of plutonium in laboratory columns packed with a sandy coastal soil from the U.S. Department of Energy (DOE)'s Savannah River Site. The column transport experiments involved the introduction of a finite step input of plutonium, predominately in the +5 oxidation state, into the columns followed by elution with a low-carbonate solution of 0.02 M NaClO4 at pH 3, 5, and 8. Total plutonium concentrations were measured in the effluent as a function of time. These elution profiles suggest at least two distinct physical/chemical forms of plutonium, each with a different mobility. To explain the observed behavior, the following conceptual model was evaluated: [1] equilibrium partitioning of plutonium (V) and plutonium (IV) between the aqueous and sorbed phases as defined by pH-dependent, oxidation-state specific distribution coefficients and [2] kinetic reduction of plutonium (V) to plutonium (IV) in the sorbed phase. The conceptual model was applied to the column experiments through a one-dimensional advective/dispersive mathematical model, and predictions of the mathematical model were compared with the experimental data. Overall, the model was successful in predicting some of the major features observed in the experiments. It also yielded quantitative estimates of the rate constant for surface mediated reduction of plutonium (V) to plutonium (IV) that were of the same order (10(-4) to 10(-5) s(-1)) as those calculated from batch data both for this soil and for goethite.     

Mechanical analysis of infant carrying in hominoids

In all higher nonhuman primates, species survival depends upon safe carrying of infants clinging to body hair of adults. In this work, measurements of mechanical properties of ape hair (gibbon, orangutan, and gorilla) are presented, focusing on constraints for safe infant carrying. Results of hair tensile properties are shown to be species-dependent. Analysis of the mechanics of the mounting position, typical of heavier infant carrying among African apes, shows that both clinging and friction are necessary to carry heavy infants. As a consequence, a required relationship between infant weight, hair-hair friction coefficient, and body angle exists. The hair-hair friction coefficient is measured using natural ape skin samples, and dependence on load and humidity is analyzed. Numerical evaluation of the equilibrium constraint is in agreement with the knuckle-walking quadruped position of African apes. Bipedality is clearly incompatible with the usual clinging and mounting pattern of infant carrying, requiring a revision of models of hominization in relation to the divergence between apes and hominins. These results suggest that safe carrying of heavy infants justify the emergence of biped form of locomotion. Ways to test this possibility are foreseen here.     

Batch washing of cadmium from soil and sludge by a mixture of Na2S2O5 and Na2EDTA

Washing of cadmium contaminated soil and sludge using a mixture of 0.1 M Na₂S₂O₅ and 0.01 M Na₂EDTA was investigated in the batch mode. Initial Cd concentration in samples was 500 mg kg⁻¹. The sequential extraction was conducted to study of what form that Cd was removed. SPSS program version 9.01 was performed to determine what soil parameter had the greatest influence on the washing. The organic matter in soil was found to be the main factor for the washing. Soil with low organic matter would have high percentage of removing Cd. When adding more washing solution, the Cd removal efficiency was lower. The highest removal efficiency was between 67.83% and 97.3% when using a 1 g:2.5 ml soil to washing solution ratio. The predominant form of the removed Cd was exchangeable form. By contrast for the sludge, the highest Cd removal efficiency was 17.13% when using sludge in washing solution at the ratio of 1 g:7.5 ml. Most of washed Cd was in reducible form.     

清洁发展机制对我国节能减排的作用

清洁发展机制（CDM）是《京都议定书》发达国家和发展中国家就减排温室气体进行交易的合作机制。我国“十一五”规划《纲要》提出了节能减排的目标,而我国还是一个发展中国家,要实现节能减排面临很多的困难。CDM项目大部分是与提高能效和开发利用新能源直接有关,因此,CDM能为此提供一定的推动力,能够促进我国的节能减排。文章分析了当前我国节能减排面临的困难,探讨了CDM在我国节能减排所起的作用,提出我国对积极开发CDM项目应采取的相应对策。     

石油储罐油气蒸发损耗的成因、危害及对策

油气蒸发威胁安全,蒸发的油蒸气易引发爆炸,从而导致油罐爆炸着火。油蒸气是气相烃类,属有毒物品,漂浮地面易致人窒息。油蒸气还易形成光化学烟雾的二次污染物。由于油蒸气的蒸发损耗,全世界每年散失于大气中的油气约为１×１０８吨,折合人民币２４００亿元。因其所蒸发的都是油料中的最轻组分且油气蒸发还严重影响成品油质量。笔者分析了油气蒸发损耗的危害、产生原因及各种影响因素,并提出了降低油气蒸发损耗的对策     

Microbiological reduction of hexavalent chromium by indigenous chromium-resistant bacteria in sand column experiments

Indigenous bacteria that are resistant to high concentrations of Cr(VI) were isolated from a Cr-contaminated sediment. Sand column experiments were conducted using the isolated bacteria to investigate microbial effects on Cr(VI) reduction in open systems that simulated subsurface conditions. The indigenous Cr-resistant bacteria appeared to reduce Cr(VI) in the column experiments. When 12 mg/L of Cr(VI) was injected into the columns, the removal efficiencies of Cr(VI) by the isolated bacteria were 39.1%, 62.5%, and 63.6% at 24, 48, and 72 h retention times of Cr(VI) solution, respectively. These results imply that the linear velocity of groundwater or pore water should be less than 0.63 cm/h for effective removal of Cr(VI) in subsurface conditions. In comparison, the noninoculated control column did not show a significant variation in dissolved Cr(VI) concentration. The results indicated that reduction of Cr(VI) was occurring in the column due to the activity of the indigenous bacteria.     

Concurrent nitrate and Fe(III) reduction during anaerobic biodegradation of phenols in a sandstone aquifer

The biodegradation of phenols (5, 60, 600 mg l⁻¹) under anaerobic conditions (nitrate enriched and unamended) was studied in laboratory microcosms with sandstone material and groundwater from within an anaerobic ammonium plume in an aquifer. The aqueous phase was sampled and analyzed for phenols and selected redox sensitive parameters on a regular basis. An experiment with sandstone material from specific depth intervals from a vertical profile across the ammonium plume was also conducted. The miniature microcosms used in this experiment were sacrificed for sampling for phenols and selected redox sensitive parameters at the end of the experiment. The sandstone material was characterized with respect to oxidation and reduction potential and Fe(II) and Fe(III) speciation prior to use for all microcosms and at the end of the experiments for selected microcosms.The redox conditions in the anaerobic microcosms were mixed nitrate and Fe(III) reducing. Nitrate and Fe(III) were apparently the dominant electron acceptors at high and low nitrate concentrations, respectively. When biomass growth is taken into account, nitrate and Fe(III) reduction constituted sufficient electron acceptor capacity for the mineralization of the phenols observed to be degraded even at an initial phenols concentration of 60 mg l⁻¹ (high) in an unamended microcosm, whereas nitrate reduction alone is unlikely to have provided sufficient electron acceptor capacity for the observed degradation of the phenols in the unamended microcosm.For microcosm systems, with solid aquifer materials, dissolution of organic substances from the solid material may occur. A quantitative determination of the speciation (mineral types and quantity) of electron acceptors associated with the solids, at levels relevant for degradation of specific organic compounds in aquifers, cannot always be obtained. Hence, complete mass balances of electron acceptor consumption for specific organic compounds degradation are difficult to confine. For aquifer materials with low initial Fe(II) content, Fe(II) determinations on solids and in aqueous phase samples may provide valuable information on Fe(III) reduction. However, in microcosms with natural sediments and where electron acceptors are associated with the sediments, complete mass-balances for substrates and electron acceptors are not likely to be obtained.     

Airborne particulate matter from livestock production systems: A review of an air pollution problem

Livestock housing is an important source of emissions of particulate matter (PM). High concentrations of PM can threaten the environment, as well as the health and welfare of humans and animals. Particulate matter in livestock houses is mainly coarse, primary in origin, and organic; it can adsorb and contain gases, odorous compounds, and micro-organisms, which can enhance its biological effect. Levels of PM in livestock houses are high, influenced by kind of housing and feeding, animal type, and environmental factors. Improved knowledge on particle morphology, primarily size, composition, levels, and the factors influencing these can be useful to identify and quantify sources of PM more accurately, to evaluate their effects, and to propose adequate abatement strategies in livestock houses. This paper reviews the state-of-the-art of PM in and from livestock production systems. Future research to characterize and control PM in livestock houses is discussed.     

A Comparative Study on the Implementation of CDM Projects in India

Since the Clean Development Mechanism(CDM) under the Kyoto Protocol was initiated,China and India have overwhelmingly led other developing countries regarding CDM projects development.A comparative study of the CDM in India and China is conducted as there are many similarities between both India and China with regard to the CDM implementation due to the fact that India is another major developing country with a large population and a potential source of GHG emissions rivaling China in the near future.Through examining the development of and legal issues for CDM projects in India,its experience and lessons regarding developing and managing CDM projects that China can critically learn are discussed.