燃煤电厂应对新标准的烟尘控制对策研究

回顾了电力工业烟尘排放标准及除尘技术的发展,总结了烟尘排放状况,根据新修订排放标准的要求,有针对性地提出了现有未达标除尘器改造方向,以及2010年以后新建电厂实现30mg/m3排放的控制对策。     

火电厂运煤系统抑尘控制因素探讨

火电厂运煤系统主要工艺过程包括卸煤、贮存、掺烧、煤输送到煤仓等。运煤系统设备及转运站扬尘污染严重,分析了污染发生的原因及解决办法,阐述了运煤系统的优化设计方案。     

SCR蜂窝式脱硝催化剂抗磨损性能研究

利用自制抗磨损性能模拟试验装置对SCR蜂窝式催化剂进行了抗磨损性能的试验研究。结果表明,催化剂的磨损强度主要受空速和磨损剂浓度的影响,尤其以空速影响较大。随着催化剂孔数的增加,催化剂磨损强度和抗磨损性能提高。     

Per- and polyfluorinated compounds in house dust and indoor air from northern Norway - a pilot study

Polyfluorinated compounds (PFCs) are an extremely versatile class of compounds and are used in a variety of consumer applications and products. Recent studies have suggested that PFCs in indoor air and dust could act as sources of human exposure and outdoor air contamination. This study presents method development and analysis of a wide range of PFCs in dust and air using active sampling techniques with commercially available sampling equipment (forensic nozzles with filter housings for dust collection and polyurethane foam (PUF)-XAD₂-PUF sandwich-tubes for air sampling) using both liquid and gas chromatography mass spectrometry. The developed method was validated and tested for applicability to analyze dust and air samples at both low and high concentrations (0.5 ng and 25 ng per analyte per air sample, respectively). Samples from private households and an office building were analyzed to explore differences in distribution patterns and concentrations. Perfluorooctane sulfonate, perfluorodecane sulfonate, perfluoroheptanoate, perfluorooctanoate and perfluorononanoate were observed in all samples of dust from private households, in the range from 1 to 80.1 ng g⁻¹. Fluorotelomer alcohols (FTOHs) were the predominant PFCs in indoor air samples with ∑FTOHs ranging between 4.7 and 17.9 ng m⁻³. The concentrations found in the present study are generally lower than those previously reported. This variation may be due to differences associated with geographical locations and lifestyles. However, use of different sampling techniques and strategies among studies can introduce large variations in PFC concentration found, making direct comparisons challenging.     

Evaluation of surface runoff and road dust as sources of nitrogen using nitrate isotopic composition

Stable nitrogen and oxygen isotope ratios of nitrate (δ¹⁵N-NO₃ and δ¹⁸O-NO₃) have recently been used to identify nitrogen sources in water environments. However, there have been no investigations designed to determine nitrate isotopes in non-point sources in urban areas for evaluating the impact of surface deposits on nitrogen in surface runoff. In this study, we collected rainwater, surface runoff and surface deposits (road dust, roof dust and soil) to evaluate the nitrogen sources in surface runoff using nitrate isotopes. There were no large differences in δ¹⁵N-NO₃ among rainwater (−0.3‰ to 1.5‰), surface runoff (−2.7‰ to 0.4‰), leachates from road dust (−5.8‰ to 6.2‰) and soil (−11.5‰ to 0.6‰). In contrast, the δ¹⁸O-NO₃ in surface runoff (28.5-47.9‰) was lower than that in rainwater (62.7-78.6‰), and higher than that in leachates from road dust (6.1-27.6‰) and soil (−1.1‰ to 6.6‰). δ¹⁸O-NO₃ is a useful indicator for evaluating the NO₃-N sources in surface runoff. Using this indicator, NO₃-N from road dust was estimated to account for more than half of the NO₃-N in surface runoff. This is consistent with a result based on a comparison of their loads per unit surface between rainwater and surface runoff, which also showed that most of the nitrogen in surface runoff was derived from surface deposits.     

电除尘器斜气流状态下粉尘沉降试验研究

针对电除尘器在实际运行过程中出现的除尘效率下降问题,提出斜气流这一新型技术,对均匀气流与斜气流分布状态进行可视化研究;在两种气流状态下进行粉尘沉降试验,对试验结果进行对比分析、总结相应规律;对我国电除尘器气流技术的发展提出了建议。     

半干法烟气脱硫袋式除尘器设计初探

介绍了半干法烟气脱硫工艺及脱硫后烟尘的特点,针对半干法脱硫后烟尘的特点,袋式除尘器设计时采取了一系列的技术措施,从而保证了脱硫系统的正常运行。     

电石炉烟气除尘系统设计探讨与实践

介绍了电石炉的生产工艺和除尘系统的工艺特点,以及电石炉除尘系统设计前和实际工程设计中需要注意的一些问题。     

袋式除尘器运行中常见问题浅析

已广泛应用于各行业中的袋式除尘器在运行中存在如滤袋损坏、结露、箱体破损、运行阻力高、清灰装置失灵等诸多问题,本文就袋式除尘器在实际运行中存在的问题进行了详细的分析讨论。     

Consequence analysis by means of characteristic curves to determine the damage to buildings from bursting spherical vessels

Since the damage suffered by buildings as a consequence of explosions usually affect the people inside them, it is important to take it into account when performing consequence analysis. The aim of this paper is to provide a methodology to estimate consequences to buildings from pressure waves produced by spherical vessel burst. This is done by combining characteristic overpressure–impulse–distance curves [González Ferradás, E., Diaz Alonso, F., Sanchez Perez, J.F., Miñana Aznar, A., Ruiz Gimeno, J. and Martinez Alonso, J., 2006, Characteristic overpressure–impulse–distance curves for vessel burst, Process Safety Progress, 25(3): 250–254] with PROBIT equations. The main advantage of this methodology is that it allows an overview of all the magnitudes involved, as damage is shown in the same graph as the overpressure, impulse and distance. In this paper diagrams and equations are presented to determine minor damage to buildings (broken windows, displacement of doors and window frames, tile displacement, etc.), major structural damage (cracks in walls, collapse of some walls) and collapse (the damage is so extensive that the building is partially or totally demolished).